Purification, general acetals

Scheme 20), these acetals could readily be converted into isofiavones. Unfortunately, very low yields of rearrangement products were obtained using thallium(III) acetate, and separation and purification of acetals such as (XXXIV) was extremely tedious. Reaction of chalcones with TTN, on the other hand, is generally complete within a few hours at room temperature 95), and Farkas et al. (J75) have developed the Ollis procedure into a simple method for the preparation of isofiavones (Scheme 21). 

Manufacture and Uses. Acetoacetic esters are generally made from diketene and the corresponding alcohol as a solvent ia the presence of a catalyst. In the case of Hquid alcohols, manufacturiag is carried out by continuous reaction ia a tubular reactor with carefully adjusted feeds of diketene, alcohol, and catalyst, or alcohol—catalyst blend followed by continuous purification (Fig. 3). For soHd alcohols, an iaert solvent is used. Catalysts used iaclude strong acids, tertiary amines, salts such as sodium acetate [127-09-3], organophosphoms compounds, and organometaHic compounds (5). 

In the case of low temperature tar, the aqueous Hquor that accompanies the cmde tar contains between 1 and 1.5% by weight of soluble tar acids, eg, phenol, cresols, and dihydroxybenzenes. Both for the sake of economics and effluent purification, it is necessary to recover these, usually by the Lurgi Phenosolvan process based on the selective extraction of the tar acids with butyl or isobutyl acetate. The recovered phenols are separated by fractional distillation into monohydroxybenzenes, mainly phenol and cresols, and dihydroxybenzenes, mainly (9-dihydroxybenzene (catechol), methyl (9-dihydtoxybenzene, (methyl catechol), and y -dihydroxybenzene (resorcinol). The monohydric phenol fraction is added to the cmde tar acids extracted from the tar for further refining, whereas the dihydric phenol fraction is incorporated in wood-preservation creosote or sold to adhesive manufacturers. Naphthalene Oils. Naphthalene is the principal component of coke-oven tats and the only component that can be concentrated to a reasonably high content on primary distillation. Naphthalene oils from coke-oven tars distilled in a modem pipe stiU generally contain 60—65% of naphthalene. They are further upgraded by a number of methods. 

The most common method of purification of inorganic species is by recrystallisation, usually from water. However, especially with salts of weak acids or of cations other than the alkaline and alkaline earth metals, care must be taken to minimise the effect of hydrolysis. This can be achieved, for example, by recrystallising acetates in the presence of dilute acetic acid. Nevertheless, there are many inorganic chemicals that are too insoluble or are hydrolysed by water so that no general purification method can be given. It is convenient that many inorganic substances have large temperature coefficients for their solubility in water, but in other cases recrystallisation is still possible by partial solvent evaporation. 

The condensation of nitro compounds and imines, the so-called aza-Henry or nitro-Mannich reaction, has recently emerged as a powerful tool for the enantioselective synthesis of 1,2-diamines through the intermediate /3-amino nitro compounds. The method is based on the addition of a nitronate ion (a-nitro carbanion), generated from nitroalkanes, to an imine. The addition of a nitronate ion to an imine is thermodynamically disfavored, so that the presence of a protic species or a Lewis acid is required, to activate the imine and/or to quench the adduct. The acidic medium is compatible with the existence of the nitronate anion, as acetic acid and nitromethane have comparable acidities. Moreover, the products are often unstable, either for the reversibility of the addition or for the possible /3-elimination of the nitro group, and the crude products are generally reduced, avoiding purification to give the desired 1,2-diamines. Hence, the nitronate ion is an equivalent of an a-amino carbanion. 

After extraction, an extract purification stage is generally reconunended. This is most often done by liquid-solid exchange using resins such as Sephadex, Amber-lite XAD-7, or Cjg mini-columns. ° All the polar compounds are first trapped on the resin, and then in succession the sugars, acids, and other polar compounds (excluding polyphenolic compounds), polyphenolic compounds (excluding anthocyanidins), and anthocyanidins are respectively eluted with acidified water (HCl 0.01% v/v), ethyl acetate, and acidified methanol (HCl 0.01% v/v). 

Previous syntheses An example of this point can be recognized by examination of one known synthesis of thienobenzazepines (Scheme 6.1). This synthetic route involves a key palladinm-catalyzed cross-conpling of stannyl intermediate 3, prepared by method of Gronowitz et al., with 2-nitrobenzyl bromide. Acetal deprotection and reductive cyclization afforded the desired thienobenzazepine tricycle 4. In support of structure activity relationship studies, this intermediate was conveniently acylated with varions acyl chlorides to yield several biologically active componnds of structure type 5. While this synthetic approach does access intermediate 4 in relatively few synthetic transformations for stractnre activity relationship studies, this route is seemingly nnattractive for preparative scale requiring stoichiometric amounts of potentially toxic metals that are generally difficult to remove and present costly purification problems at the end of the synthesis. 

All solvents used for general applications were of reagent grade. For special purposes, purification of solvents was effected using standard procedures. All other reagents were used as supplied commercially except as noted. A solution of chloromethyl methyl ether (6 mmole/mL) in methyl acetate was prepared by adding acetyl chloride (141.2 g, 1.96 mol) to a mixture of dimethoxy methane (180 mL, 2.02 mol) and anhydrous methanol (5.0 mL, 0.12 mol).20 The solution was diluted with 300 mL of 1,1,2,2-tetrachloroethane and used as a stock solution for the chloromethylation experiments. 

The procedure illustrates a general method for the preparation of ketene S,N-acetals via thioamides and their crystalline quaternary iodides some other examples are shown in Table I. 2,2-Dialkyl-substituted ketene S,N-acetals cannot be prepared by this method because the nature of the products makes rigorous purification impractical. Ketene S,N-acctals are useful starting materials for many syntheses.11,13 15... 

General Procedure for the Hydroformylation/Carbonyl ene Reaction/O,O-acetal Forma-tion/Dehydration. Synthesis of Chromane Derivatives. A solution of the substrate (1 eq) RhCl(PPh3)3 (1 mol %) and PPh3 (3 mol %) in dry dioxane was heated for 70 h to 120 °C und an atmosphere of CO/H2 (1 1, 100 bar). The crude product was filtered through basic alumina (eluated with MTBE). After evaporation of the solvent further purification by column chromatography (silica, PE/MTBE) furnished the title compounds. 

Apart from 1,3,4-oxadiazole (b.p. 150°C), its lower alkyl derivatives and some dihydro compounds, 1,3,4-oxadiazoles are generally solids. In synthesis, the common method of purification is by crystallization of the crude reaction product. A few oxadiazoles, for example, alkyl ethers and acetates derived from 2,5-dihydro-2-hydroxy-2,5,5-trialkyl-l,3,4-oxadiazoles (cf. (38)), have been purified by distillation under reduced pressure. In some cases, chromatography over silica gel has been used. 

Liquid-liquid partitioning has been used for many years for Ure purification of sulfonamides and diaminopyrimidine potentiators. When partitioning from an organic into an aqueous phase, the adjustment of the pH of Ure aqueous phase is critical to obtain quantitative recoveries.. Sulfonamides are generally extracted from Ure primary organic sample extract into strong acidic (238, 239, 242, 249, 252-254) or basic (241, 248, 255) aqueous solutions. For better sample cleanup, back-extraction of Ure analyte(s) into dichloromethane (241, 253, 254), or ethyl acetate (256), after pH adjustment of the aqueous phase at values between 5.1... 

Wolfrom and coworkers88-71 were able to prepare various 1-thio-a-D-galactofuranosides, generally isolated as the acetates, after purification by column chromatography. Thus, the Pacsu and Wilson method gave sirupy ethyl 1-thio-a-D-galactofuranoside, and a crystalline acetate. This product was also obtained by treatment of the dithioacetal with dilute hydrochloric acid and then mercuric oxide. Ethyl 2-acetamido-2-deoxy-l-thio-a-D-galactofuranoside was prepared in 32% yield, and the /3-d anomer in 3% yield. 

---