Proportioned estimate

The microstructure at position (ii) consisted of grains of ferrite and colonies of pearlite. It was noticed that the pearlite had started to "spheroidise" (see Problem 5.2). The microstructure at position (i) consisted of grains of ferrite and grains of lower bainite in roughly equal proportions. Estimate the temperatures to which the tube been heated at positions (i) and (ii). Explain the reasoning behind your answers. 

In computing the average of the whole crust the relative proportions estimated by one of us2 some years ago were adopted. The latest estimates of the masses and compositions of the hydrosphere and atmosphere have been used. These relative masses are as follows Lithosphere 93% hydrosphere 7% atmosphere 0.03%. 

For reactants present in the stoichiometric proportion, estimate the percent conversion of each if the reaction comes to equilibrium at 500°C and lObar. 

These estimates provide only ballpark costs and are sometimes required in the very early stages of project development as decisionmaking tools. The basis could be no more than a given capacity of a generic product the estimating procedure, a simple search of existing literature and, if required, the application of the proportioned estimating method. 

Position Knowledge Brokers Clientele Proportion Estimated by Brokers... 

There were missing valnes for some residence locations of the casualties and for some crash locations. These missing values were imputed using simple imputation from proportions estimated on observations without missing-values. The rates for PTW riders by gender, age gronp and location separately were not estimated we are concerned abont the reliability of the estimates because of the small number of PTW trips in the RTS. The mobility data provide information only about residents of the... 

Minimum risk estimates are sometimes used to quantify either maximum exposure in monetary terms or, in the case of an annual work plan containing multiple projects, to help determine the proportion of firm projects. Firm projects are those which have budget cover even if costs overrun. A minimum risk estimate is one with little or no probability of overrun, and can be used to reflect the risk associated with very complex or novel projects. 

The first quantitative studies of the nitration of quinoline, isoquinoline, and cinnoline were made by Dewar and Maitlis, who measured isomer proportions and also, by competition, the relative rates of nitration of quinoline and isoquinoline (1 24-5). Subsequently, extensive kinetic studies were reported for all three of these heterocycles and their methyl quaternary derivatives (table 10.3). The usual criteria established that over the range 77-99 % sulphuric acid at 25 °C quinoline reacts as its cation (i), and the same is true for isoquinoline in 71-84% sulphuric acid at 25 °C and 67-73 % sulphuric acid at 80 °C ( 8.2 tables 8.1, 8.3). Cinnoline reacts as the 2-cinnolinium cation (nia) in 76-83% sulphuric acid at 80 °C (see table 8.1). All of these cations are strongly deactivated. Approximate partial rate factors of /j = 9-ox io and /g = i-o X io have been estimated for isoquinolinium. The unproto-nated nitrogen atom of the 2-cinnolinium (ina) and 2-methylcinno-linium (iiiA) cations causes them to react 287 and 200 more slowly than the related 2-isoquinolinium (iia) and 2-methylisoquinolinium (iii)... 

From the data in Fig. 4.8b, estimate the shift factors required to displace the data at 0 = 0.5 (consider only this point) so that all runs superimpose on the experiment conducted at 128 C at 0 = 0.5. Either a ruler or proportional dividers can be used to measure displacements. Criticize or defend the following proposition Whether a buffered aqueous solution of H2O2 and 1. containing small amounts of S2O3 and starch, appears blue or colorless depends on both the time and the temperature. This standard general chemistry experiment could be used to demonstrate the equivalency of time and temperature. The pertinent reactions for the iodine clock are... 

By combining Eqs. (8.42), (8.49), and (8.60), show that Vi°(52 - 5i) = (l/2)RTj., where T. is the critical temperature for phase separation. For polystyrene with M = 3 X 10, Shultz and Floryf observed T. values of 68 and 84°C, respectively, for cyclohexanone and cyclohexanol. Values of Vi° for these solvents are abut 108 and 106 cm mol", respectively, and 5i values are listed in Table 8.2. Use each of these T. values to form separate estimates of 62 for polystyrene and compare the calculated values with each other and with the value for 62 from Table 8.2. Briefly comment on the agreement or lack thereof for the calculated and accepted 5 s in terms of the assumptions inherent in this method. Criticize or defend the following proposition for systems where use of the above relationship is justified Polymer will be miscible in all proportions in low molecular weight solvents from which they differ in 5 value by about 3 or less. 

Oxygen transfer rate (OTR) is estimated by the foUowiag standard procedure (12), where the rate of mass transfer per unit volume of Hquid is taken to be directly proportional to the driving force of the system... 

Textile Applications. A 1971 estimate of world textile fiber consumption (2) showed that approximately 60% of textile goods are dyed and about 30% are whites. The proportion of white goods (>40%) is highest for cotton. These percentages also hold tme in the 1990s. 

Other methods are also available for the estimation of diesel fuel quaUty. For example, the diesel index (DI) is defined by the relation DI = (A° F X ° API)/100, where A °F is the aniline point in degrees Fahrenheit and °API is the American Petroleum Institute gravity. A high aniline point corresponds to a high proportion of paraffins in the diesel fuel such a fuel has a high diesel index and, therefore, a high cetane number. 

Comparison of these environmental compartment concentrations with the actual measurements made at a variety of locations show reasonable agreement but indicate that emission estimates are rather high. It is likely that the fault Hes with worst case estimates for losses from outdoor appHcations and the washing of PVC flooring. In addition a large proportion of the phthalates lost by these routes will not enter rivers because they will be removed by wastewater treatment plants. 

Total known world resources of platinum-group metals have been variously estimated as between 68,000 (7) and 96,000 metric tons (8). Assuming the former estimate and 1979 levels of demand, these reserves should be sufficient to supply the Western world weU into the twenty-fourth century. Reserves and relative proportions of the PGMs in the larger deposits are given in Tables 5 and 6. Relative amounts of the PGMs vary from deposit to deposit. 

---