Polymer solar cells

Kang Y, Kim D (2006) WeU-ahgned CdS nanorod/conjugated polymer solar cells. Sol Energy Mater Sol Cells 90 166-174... [Pg.205]

Huynh WU, Dittmer JJ, Ahvisatos AP (2002) Hybrid nanorod-polymer solar cells. Science 295 2425-2427... [Pg.307]

M Svensson, F Zhang, SC Veenstra, WJH Verhees, JC Hummelen, JM Kroon, O Inganas, and MR Andersson, High-performance polymer solar cells of an alternating polyfluorene copolymer and a fullerene derivative, Adv. Mater., 15 988-991, 2003. [Pg.42]

Fan, G.-Q., et ah, Plasmonic-enhanced polymer solar cells incorporating solution-processable Au nanoparticle-adhered graphene oxide. Journal of Materials Chemistry, 2012. 22(31) ... [Pg.165]

He, I. Zhong, C. Huang, X. Wong, W.-Y. Wu, H. Chen, L. Su, S. Cao, Y., Simultaneous enhancement of open-circuit voltage, short-circuit current density, and fill factor in polymer solar cells. Adv. Mater. 2011, 23, 4636-4643. [Pg.473]

Jung JW, Lee JU, Jo WH (2009) High-efficiency polymer solar cells with water-soluble and self-doped conducting polyaniline graft copolymer as hole transport layer. J Phys Chem C 114 633... [Pg.62]

Yin B, Liu Q, Yang L et al (2010) Buffer layer of PEDOT PSS/graphene composite for polymer solar cells. J Nanosci Nanotechnol 10 1934-1938... [Pg.173]

Li SS, Tu KH, Lin CC et al (2010) Solution-processable graphene oxide as an efficient hole transport layer in polymer solar cells. ACS Nano 4 3169-3174... [Pg.174]

Helgesen M, Sondergaard R, Krebs PC (2010) Advanced materials and processes for polymer solar cell devices. J Mater Chem 20 36... [Pg.204]

Liang YY, Xu Z, Xia JB, Tsai ST, Wu Y, Li G, Ray C, Yu LP (2010) For the bright future-bulk heterojunction polymer solar cells with power conversion efficiency of 7.4%. Adv Mater 22 E135... [Pg.205]

Krebs FC, Tromholt T, Jorgensen M (2010) Upscaling of polymer solar cell fabrication using full roll-to-roll processing. Nanoscale 2 873... [Pg.205]

Krebs FC (2009) Fabrication and processing of polymer solar cells a review of printing and coating techniques. Sol Energy Mater Sol Cells 93 394... [Pg.205]

Groves C, Reid OG, Ginger DS (2010) Heterogeneity in polymer solar cells local morphology and performance in organic photovoltaics studied with scanning probe microscopy. Acc Chem Res 43 612... [Pg.206]

Ma WL, Yang CY, Gong X, Lee K, Heeger AJ (2005) Thermally stable, efficient polymer solar cells with nanoscale control of the interpenetrating network morphology. Adv Fund Mater 15 1617... [Pg.208]

Lenes M, Wetzelaer G, Kooistra FB, Veenstra SC, Hummelen JC, Blom PWM (2008) Fullerene bisadducts for enhanced open-circuit voltages and efficiencies in polymer solar cells. Adv Mater 20 2116... [Pg.211]

Tvingstedt K, Vandewal K, Gadisa A, Zhang FL, Manca J, Inganas O (2009) Electroluminescence from charge transfer states in polymer solar cells. J Am Chem Soc 131 11819... [Pg.211]

One of the most promising uses of C60 involves its potential application, when mixed with 7r-conjligated polymers, in polymer solar cells. Most often the so-called bulk heterojunction configuration is used, in which the active layer consists of a blend of electron-donating materials, for example, p-type conjugated polymers, and an electron-accepting material (n-type), such as (6,6)-phenyl-Cgi -butyric acid methyl ester (PCBM, Scheme 9.6).38... [Pg.236]

Huynh, W.U. Dittmer, J.J. Alivisatos, A.P Hybrid nanorod-polymer solar cells. Science 2002,295 (5564), 2425-2427. [Pg.345]

For novel devices like the polymer solar cells described in this chapter, measurement procedures are not nearly so well-established as for inorganic devices, ft was reported earlier that all kinds of ill-defined efficiencies can be found in the literature [87]. This makes a meaningful comparison of efficiency values extremely difficult or even impossible, when they are measured at different institutes and using different measuring techniques. This section describes a procedure for obtaining better defined polychromatic efficiencies. [Pg.186]

Experiments show that in high quality Si solar cells the superposition principle is valid to a good approximation. In CdS/Cu2S, amorphous Si [139] and in polymer solar cells some of these approximations are grossly violated. As an example consider the effect of series resistance. In the presence of the series resistance Rs the dark current is given by,... [Pg.121]

P. Schilinsky, C. Waldauf, J. Hauch, C.J. Brabec, Simulation of light intensity dependent current characteristics of polymer solar cells, J. Appl. Phys. 95 (2004) 2816. [Pg.164]

Polymers Enable New Display Technologies with PLEDs/May Hold Key to High Efficiency Polymer Solar Cells (PV)... [Pg.36]

While progress towards more efficient polymer solar cells has been steady and directions for future work are mapped out, there are few reports of cell performance under continuous illumination. Kroon et al. (2002) studied the response of encapsulated MDMO-PPV cells, similar to that illustrated in Fig. 10.23(a), subjected to thermal stress and continuous illumination. A 30-50% decrease in efficiency was observed for cells stored in the dark at... [Pg.437]

See also in sourсe #XX -- [ Pg.110 , Pg.116 ]

See also in sourсe #XX -- [ Pg.5 ]

See also in sourсe #XX -- [ Pg.9 , Pg.152 , Pg.162 , Pg.355 ]

See also in sourсe #XX -- [ Pg.39 , Pg.53 , Pg.174 , Pg.175 , Pg.181 , Pg.267 , Pg.331 , Pg.335 , Pg.336 , Pg.338 , Pg.344 , Pg.417 ]

See also in sourсe #XX -- [ Pg.204 ]

See also in sourсe #XX -- [ Pg.285 ]

See also in sourсe #XX -- [ Pg.285 ]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...