Efficiency values

This figure shows an optimum power input below this value efficiency drops off due to reduced interfacial area above this value efficiency decreases due to increased axial mixing of the continuous and dispersed phases. 

T.J. George, R. RJ James HI, K. D. Lyons, "Multi-Staged Fuel Cell Power Plant (Targeting 80% Lower Heating Value Efficiency)," Power Generation International 1998 Conference, December 9-11, 1998, Orange County Convention Center, Orlando, Florida. 

Care must be taken in the use and interpretation of literature efficiency values. Efficiency values are likely the most incorrectly calculated chromatographic figure of merit. The commonly used equations based on peak width at the base or at half the height of the peak are valid only for perfectly Gaussian shaped peaks. This problem has been realized by chromatographers for some time, but the popularity of these methods continues because until recently the only alternative was computer based moment calculations. Kirkland et al. addressed this problem and recommended that peak symmetry values be reported along with efficiency values (8 ). They further showed that the calculation... 

Potential of material (trash) produced 140 kg dry/tonne cane (average value). Efficiency of the harvester in the separation of trash in the field 68% with the extractor on and 5.5% with the extractor off (values obtained from test results). Trash separation efficiency at the mill 55 to 70% (average value obtained from test results with the dry cleaning station. The station was improved and will be retested). 

Note that all but five elements of F are very small, which signifies that DCT packs the signal energy onto a few coefficients and decorrelates the pixel values efficiently. 

Higher calorific value (MJ/kg) Lower calorific value (MJ/kg) Flue-gas volume (1 bar, 0°C) (m /kg) Flue-gas loss (sensible heat) (MJ/kg) Efficiency based on higher value Efficiency based on lower value Adiabatic combustion temperature (°C)... 

Establishing a best value/efficiency model within the inclusion agenda... 

In my experience, it is important to create a best value/EfFiciency model for inclusion which is simple, easy to understand and effective. I have used the following model in schools and training with great success. 

M j —tangential and radial making speeds of gas, tangential speed of drops both tangential and radial speeds of corpuscles in a drop layer, mps a v-thickness of a drop layer, m J -average diameter of drops, m of corpuscles, m a =2.8 (constant)—skilled values / =0.5 (constant) skilled values —efficiency of capture of corpuscles a single drop. 

---