Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Polarizers/Polarization liquid polarizer

CH2CI2. A colourless liquid with a chloroform-like odour b.p. 4I°C. Prepared by heating chloroform with zinc, alcohol and hydrochloric acid manufactured by the direct chlorination of methane. Decomposed by water at 200°C to give methanoic and hydrochloric acids. Largely used as a solvent for polar and non-polar substances, particularly for paint removal (30%), dissolving cellulose acetate and degreasing (10%). It is more stable than carbon tetrachloride or chloroform especially towards moisture or alkali. It is somewhat toxic. U.S. production 1981 280000 tonnes. [Pg.135]

Edeleanu process An extraction process utilizing liquid sulphur dioxide for the removal of aromatic hydrocarbons and polar molecules from petroleum fractions. [Pg.148]

If maltenes are subjected to liquid chromatography (see 2.1.2.4) the components eluted by the more polar solvents are called resins. Their composition, once again, depends on the procedure used. [Pg.15]

Liquid chromatography is preceded by a precipitation of the asphaltenes, then the maltenes are subjected to chromatography. Although the separation between saturated hydrocarbons and aromatics presents very few problems, this is not the case with the separation between aromatics and resins. In fact, resins themselves are very aromatic and are distinguished more by their high heteroatom content (this justifies the terms, polar compounds or N, S, 0 compounds , also used to designate resins). [Pg.83]

One more experimental result, which is important for PT is as follows. Only polar liquids fill conical capillaries from both sides. We used various penetrants to fill conical defects Pion , LZh-6A , LZhT , LUM-9 etc. It was established that only the penetrants containing polar liquid as the basic liquid component (various alcohols, water and others) manifest two-side filling phenomenon. This result gives one more confirmation of the physical mechanism of the phenomenon, based on liquid film flow, because the disjoining pressure strongly depends just on the polarity of a liquid. [Pg.618]

The gradient model has been combined with two equations of state to successfully model the temperature dependence of the surface tension of polar and nonpolar fluids [54]. Widom and Tavan have modeled the surface tension of liquid He near the X transition with a modified van der Waals theory [55]. [Pg.62]

When both liquids are polar, Fowkes [26] has written... [Pg.109]

Much of chemistry is concerned with the short-range wave-mechanical force responsible for the chemical bond. Our emphasis here is on the less chemically specific attractions, often called van der Waals forces, that cause condensation of a vapor to a liquid. An important component of such forces is the dispersion force, another wave-mechanical force acting between both polar and nonpolar materials. Recent developments in this area include the ability to measure... [Pg.225]

The heat of immersion is measured calorimetrically with finely divided powders as described by several authors [9,11-14] and also in Section XVI-4. Some hi data are given in Table X-1. Polar solids show large heats of immersion in polar liquids and smaller ones in nonpolar liquids. Zetdemoyer [15] noted that for a given solid, hi was essentially a linear function of the dipole moment of the wetting liquid. [Pg.349]

Fig. X-9. Zisman plots of the contact angles of various homologous series on Teflon O, RX , alkylbenzenes (f), n-alkanes , dialkyl ethers , siloxanes A, miscellaneous polar liquids. (Data from Ref. 78.)... Fig. X-9. Zisman plots of the contact angles of various homologous series on Teflon O, RX , alkylbenzenes (f), n-alkanes , dialkyl ethers , siloxanes A, miscellaneous polar liquids. (Data from Ref. 78.)...
Because of the charged nature of many Langmuir films, fairly marked effects of changing the pH of the substrate phase are often observed. An obvious case is that of the fatty-acid monolayers these will be ionized on alkaline substrates, and as a result of the repulsion between the charged polar groups, the film reverts to a gaseous or liquid expanded state at a much lower temperature than does the acid form [121]. Also, the surface potential drops since, as illustrated in Fig. XV-13, the presence of nearby counterions introduces a dipole opposite in orientation to that previously present. A similar situation is found with long-chain amines on acid substrates [122]. [Pg.557]

The first term on the right is the common inverse cube law, the second is taken to be the empirically more important form for moderate film thickness (and also conforms to the polarization model, Section XVII-7C), and the last term allows for structural perturbation in the adsorbed film relative to bulk liquid adsorbate. In effect, the vapor pressure of a thin multilayer film is taken to be P and to relax toward P as the film thickens. The equation has been useful in relating adsorption isotherms to contact angle behavior (see Section X-7). Roy and Halsey [73] have used a similar equation earlier, Halsey [74] allowed for surface heterogeneity by assuming a distribution of Uq values in Eq. XVII-79. Dubinin s equation (Eq. XVII-75) has been mentioned another variant has been used by Bonnetain and co-workers [7S]. [Pg.629]

We discuss classical non-ideal liquids before treating solids. The strongly interacting fluid systems of interest are hard spheres characterized by their harsh repulsions, atoms and molecules with dispersion interactions responsible for the liquid-vapour transitions of the rare gases, ionic systems including strong and weak electrolytes, simple and not quite so simple polar fluids like water. The solid phase systems discussed are ferroniagnets and alloys. [Pg.437]

Another important application of perturbation theory is to molecules with anisotropic interactions. Examples are dipolar hard spheres, in which the anisotropy is due to the polarity of tlie molecule, and liquid crystals in which the anisotropy is due also to the shape of the molecules. The use of an anisotropic reference system is more natural in accounting for molecular shape, but presents difficulties. Hence, we will consider only... [Pg.509]

As it has appeared in recent years that many hmdamental aspects of elementary chemical reactions in solution can be understood on the basis of the dependence of reaction rate coefficients on solvent density [2, 3, 4 and 5], increasing attention is paid to reaction kinetics in the gas-to-liquid transition range and supercritical fluids under varying pressure. In this way, the essential differences between the regime of binary collisions in the low-pressure gas phase and tliat of a dense enviromnent with typical many-body interactions become apparent. An extremely useful approach in this respect is the investigation of rate coefficients, reaction yields and concentration-time profiles of some typical model reactions over as wide a pressure range as possible, which pemiits the continuous and well controlled variation of the physical properties of the solvent. Among these the most important are density, polarity and viscosity in a contimiiim description or collision frequency. [Pg.831]

Corrosion protection of metals can take many fonns, one of which is passivation. As mentioned above, passivation is the fonnation of a thin protective film (most commonly oxide or hydrated oxide) on a metallic surface. Certain metals that are prone to passivation will fonn a thin oxide film that displaces the electrode potential of the metal by +0.5-2.0 V. The film severely hinders the difflision rate of metal ions from the electrode to tire solid-gas or solid-liquid interface, thus providing corrosion resistance. This decreased corrosion rate is best illustrated by anodic polarization curves, which are constructed by measuring the net current from an electrode into solution (the corrosion current) under an applied voltage. For passivable metals, the current will increase steadily with increasing voltage in the so-called active region until the passivating film fonns, at which point the current will rapidly decrease. This behaviour is characteristic of metals that are susceptible to passivation. [Pg.923]

Monson P R and McClain W M 1970 Polarization dependence of the two-photon absorption of tumbling molecules with application to liquid 1-chloronaphthalene and benzene J. Chem. Rhys. 53 29-37... [Pg.1149]

A schematic diagram of the surface of a liquid of non-chiral (a) and chiral molecules (b) is shown in figure Bl.5.8. Case (a) corresponds to oom-synnnetry (isotropic with a mirror plane) and case (b) to oo-symmetry (isotropic). For the crj/ -synnnetry, the SH signal for the polarization configurations of s-m/s-out and p-m/s-out vanish. From table Bl.5.1. we find, however, that for the co-synnnetry, an extra independent nonlinear susceptibility element, is present for SHG. Because of this extra element, the SH signal for... [Pg.1286]


See other pages where Polarizers/Polarization liquid polarizer is mentioned: [Pg.2]    [Pg.136]    [Pg.172]    [Pg.203]    [Pg.203]    [Pg.241]    [Pg.303]    [Pg.319]    [Pg.373]    [Pg.377]    [Pg.404]    [Pg.134]    [Pg.239]    [Pg.244]    [Pg.245]    [Pg.281]    [Pg.370]    [Pg.376]    [Pg.552]    [Pg.724]    [Pg.725]    [Pg.835]    [Pg.840]    [Pg.855]    [Pg.887]    [Pg.1178]    [Pg.1287]    [Pg.1297]    [Pg.1298]    [Pg.1509]    [Pg.1510]   
See also in sourсe #XX -- [ Pg.104 ]




SEARCH



Binary liquid mixtures, polarity

Electronic Nonlinear Polarizations of Liquid Crystals

Ferroelectric liquid crystalline polarization

Ferroelectric liquid crystalline polymers spontaneous polarization

Flammable liquids polarity

General Formalisms for Polarized Light Propagation Through Liquid Crystal Devices

Interactions in Polar Liquids

Ionic liquids polarities

Ionic liquids solvent polarity

Liquid chromatography polarity

Liquid chromatography-mass spectrometry high polarity

Liquid crystals polarized light micrographs

Liquid crystals polarized light microscopy

Liquid polarized backlights

Mercury polar organic liquids

Mobile polar liquids

Non-polar liquids

Polar adsorbents, liquid chromatography

Polar liquid diffusion

Polar liquid phases

Polar liquid, test

Polar liquids

Polar liquids

Polar liquids, capillary

Polar liquids, capillary action

Polar liquids, molecular orientation

Polar liquids, penetration

Polar liquids, solubility

Polar organic liquids, clays

Polar vapor-liquid equilibria

Polarity of organic liquids and adsorbents

Polarity, liquid membranes

Polarity, of ionic liquids

Polarity,liquid phases

Polarization in Polar Liquids

Polarizer cholesteric liquid crystal

Polarizing light microscopy liquid crystals studied using

Polarizing microscopy liquid crystalline polymer

Reverse phase liquid chromatography most polar solvent

Solvation properties, ionic liquids solvent polarity

Solvent polarity, ionic liquids constant

Solvent polarity, ionic liquids partitioning

Spontaneous Polarization Behavior of FLCPs (Ferroelectric Liquid Crystal Polymers)

The Ion-Continuum Interaction in Polar Liquids

The Solvated Electron in Alcohols and Other Polar Liquids

What Constitutes a Polar Liquid

© 2024 chempedia.info