Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Phosphorous acid, Chemical properties

The important chemical properties of acetyl chloride, CH COCl, were described ia the 1850s (10). Acetyl chloride was prepared by distilling a mixture of anhydrous sodium acetate [127-09-3J, C2H202Na, and phosphorous oxychloride [10025-87-3] POCl, and used it to interact with acetic acid yielding acetic anhydride. Acetyl chloride s violent reaction with water has been used to model Hquid-phase reactions. [Pg.81]

The detergent range alcohols and their derivatives have a wide variety of uses ia consumer and iadustrial products either because of surface-active properties, or as a means of iatroduciag a long chain moiety iato a chemical compound. The major use is as surfactants (qv) ia detergents and cleaning products. Only a small amount of the alcohol is used as-is rather most is used as derivatives such as the poly(oxyethylene) ethers and the sulfated ethers, the alkyl sulfates, and the esters of other acids, eg, phosphoric acid and monocarboxyhc and dicarboxyhc acids. Major use areas are given ia Table 11. [Pg.449]

It is important to emphasize that often — but not always — the performance of a product with a chemical depends heavily on the manufacturer and a specific product model. A model that performs well with one chemical may perform poorly with another chemical, even when the chemicals are in the same chemical class. This is illustrated by the Edmont Model 37-165 glove which was tested against all five acids. This glove shows good protective properties with hydrochloric, perchloric, and phosphoric acids, but exhibits degradation in nitric and sulfuric acids. [Pg.64]

Fhosphoric acid does not have all the properties of an ideal fuel cell electrolyte. Because it is chemically stable, relatively nonvolatile at temperatures above 200 C, and rejects carbon dioxide, it is useful in electric utility fuel cell power plants that use fuel cell waste heat to raise steam for reforming natural gas and liquid fuels. Although phosphoric acid is the only common acid combining the above properties, it does exhibit a deleterious effect on air electrode kinetics when compared with other electrolytes ( ) including such materials as sulfuric and perchloric acids, whose chemical instability at T > 120 C render them unsuitable for utility fuel cell use. In the second part of this paper, we will review progress towards the development of new acid electrolytes for fuel cells. [Pg.576]

A number of carboxylic acids other than acetic were investigated as solvents or promoters. All of these acids which were stable to reaction conditions were found to be effective in promoting glycol ester production (e.g., propionic, pivalic, benzoic, etc.). However, other Br nsted acids of non-carboxylic nature were not found to be effective promoters. Thus penta-chlorophenol, although it has a pKa value (4.82) very close to that of acetic acid (4.76), is not a comparable promoter (Table I, reaction 13). Likewise, phosphoric acid (pK 2.15) is not an effective solvent or co-solvent with acetic acid (Table I, reaction 8). Experiments with lower concentrations of these acids in sulfolane solvent also showed that carboxylic acids are unique in promoting glycol formation. The promoter function of carboxylic acids thus appears not to be dependent (only) upon their acidity, but on some other chemical or structural property. [Pg.216]

Strong base anion exchangers, 74 395, 411 Strong inversion, in silicon-based semiconductors, 22 239 Strong nitric acid process, materials of construction for, 77 187-188 Strong phosphoric acids, equilibrium composition of, 78 827t Strontianite, 23 317, 321 Strontium (Sr) 23 316-325 chemical properties of, 23 318 economic aspects of, 23 320-321 effect of micro additions on silicon particles in Al-Si alloys, 2 311-312 in ferrites, 77 59... [Pg.891]

The solids analysis described above can be taken to yet another level by correlating the color measurement to chemical properties. An excellent model system is vanadium pyrophosphate (VPO), which is a well-known catalyst for butane oxidation to maleic anhydride. During the synthesis of the catalyst precursor, solid V2O5 particles are dispersed in a mixture of benzyl alcohol and i-butanol. In this slurry phase, the vanadium is partly reduced. Addition of phosphoric acid leads to a further reduction and the formation of the VPO structure. With a diffuse reflectance (DR) UV-vis probe by Fiberguide Ind., the surface of the suspended solid particles could be monitored during this slurry reaction. Four points can be noted from Figure 4.4 ... [Pg.97]

Acyl residues are usually activated by transfer to coenzyme A (2). In coenzyme A (see p. 12), pantetheine is linked to 3 -phos-pho-ADP by a phosphoric acid anhydride bond. Pantetheine consists of three components connected by amide bonds—pantoic acid, alanine, and cysteamine. The latter two components are biogenic amines formed by the decarboxylation of aspartate and cysteine, respectively. The compound formed from pantoic acid and p-alanine (pantothenic acid) has vitamin-like characteristics for humans (see p. 368). Reactions between the thiol group of the cysteamine residue and carboxylic acids give rise to thioesters, such as acetyl CoA. This reaction is strongly endergonic, and it is therefore coupled to exergonic processes. Thioesters represent the activated form of carboxylic adds, because acyl residues of this type have a high chemical potential and are easily transferred to other molecules. This property is often exploited in metabolism. [Pg.106]

The chemical properties o orthophosphoric add.—W. Muller-Erzbach21 has discussed the affinity of the metals for phosphoric acid. J. Thomsen found the avidity of a mol. of phosphoric acid for one of sodium hydroxide to be a quarter of the value of that for hydrochloric acid. The affinity of phosphoric acid for the bases is greater than that of carbonic acid, boric acid, phosphorous acid, and hypophosphorous acid. The catalytic action of phosphoric acid on the reaction between bromic and hydriodic acids has been studied by W. Ostwald on the reaction between iodic and sulphurous acids, by R. Hopke and A. Purgotti and L. Zanichelli on hydrazine sulphate, N2H4.H2S04. According to W. Ostwald, the velocity constant for the inversion of cane sugar by phosphoric acid is 6-21 when the value for hydrochloric acid is 100 and J. Spohr showed that the presence of neutral salts at 25° retards, or at 40° completely suppresses,the activity of phosphoric acid. [Pg.962]


See other pages where Phosphorous acid, Chemical properties is mentioned: [Pg.289]    [Pg.330]    [Pg.373]    [Pg.321]    [Pg.483]    [Pg.419]    [Pg.370]    [Pg.977]    [Pg.2409]    [Pg.96]    [Pg.570]    [Pg.76]    [Pg.92]    [Pg.552]    [Pg.268]    [Pg.422]    [Pg.345]    [Pg.75]    [Pg.125]    [Pg.289]    [Pg.554]    [Pg.792]    [Pg.916]    [Pg.419]    [Pg.321]    [Pg.34]    [Pg.941]    [Pg.1280]    [Pg.826]    [Pg.370]    [Pg.836]    [Pg.847]    [Pg.947]    [Pg.1002]    [Pg.1012]    [Pg.1023]    [Pg.1032]    [Pg.1115]    [Pg.1116]    [Pg.103]   
See also in sourсe #XX -- [ Pg.142 , Pg.143 ]




SEARCH



Acidizing chemicals

Chemic acid

Phosphor properties

Phosphoric acid properties

© 2024 chempedia.info