Phosphoric acid properties

It is necessary to discuss four scientific topics for phosphoric acid fuel cells. Those interconnected topics are the design of the precious metal electrocatalyst properties of the phosphoric acid properties of the matrix, and those of the carbon catalyst support. 

Definition Partial ester of dimethicone copolyol and phosphoric acid Properties Anionic... 

Definition Sodium salt of a complex mixt. of esters of lauryl alcohol and phosphoric acid Properties Wh. powd. anionic Uses Surfactant, foaming agent, cleansing... 

Uses Solubilizerfor cleaners containing phosphoric acid Properties Paste 99.8-100% act. 

Cham. Descrip. Sodium salt of sulfonated fatty acid Uses Defoamer for wet process prod, of phosphoric acid Properties Sol. in water, IPA. 

Chem. Descrip. Nonsilicone, water-based Uses Defoamer for mfg. of phosphoric acid Properties Water-disp. 

The detergent range alcohols and their derivatives have a wide variety of uses ia consumer and iadustrial products either because of surface-active properties, or as a means of iatroduciag a long chain moiety iato a chemical compound. The major use is as surfactants (qv) ia detergents and cleaning products. Only a small amount of the alcohol is used as-is rather most is used as derivatives such as the poly(oxyethylene) ethers and the sulfated ethers, the alkyl sulfates, and the esters of other acids, eg, phosphoric acid and monocarboxyhc and dicarboxyhc acids. Major use areas are given ia Table 11. 

Chemistry and Properties. TSP is essentially impure monocalcium phosphate monohydrate, Ca(H2P0 2 20, made by acidulating phosphate rock with phosphoric acid according to... 

Phosphoric Acid. The only inorganic acid used for food appkeations is phosphoric acid [7664-38-2] H PO, which is second only to citric acid in popularity. The primary use of phosphoric acid is in carbonated beverages, especially root beer and cola. It is also used for its leavening, emulsification, nutritive enhancement, water binding, and antimicrobial properties. Eood-grade phosphoric acid is produced by the furnace method. Elemental phosphoms is burned to yield phosphoms pentoxide which is then reacted with water to produce phosphoric acid (see Phosphoric acid and the phosphates) (12). 

The typical acid catalysts used for novolak resins are sulfuric acid, sulfonic acid, oxaUc acid, or occasionally phosphoric acid. Hydrochloric acid, although once widely used, has been abandoned because of the possible formation of toxic chloromethyl ether by-products. The type of acid catalyst used and reaction conditions affect resin stmcture and properties. For example, oxaUc acid, used for resins chosen for electrical appHcations, decomposes into volatile by-products at elevated processing temperatures. OxaUc acid-cataly2ed novolaks contain small amounts (1—2% of the original formaldehyde) of ben2odioxanes formed by the cycli2ation and dehydration of the ben2yl alcohol hemiformal intermediates. 

Properties. Phosphoric acid is a tribasic acid, in which the first hydrogen ion is strongly ionizing, the second moderately weak, and the third very weak. 

Phosphoric acid, aside from its acidic behavior, is relatively unreactive at room temperature. It is sometimes substituted for sulfuric acid because of its lack of oxidising properties (see SuLFURic ACID AND SULFURTRIOXIDe). The reduction of phosphoric acid by strong reducing agents, eg, H2 or C, does not occur to any measurable degree below 350—400°C. At higher temperatures, the acid reacts with most metals and their oxides. Phosphoric acid is stronger than acetic, oxaUc, siUcic, and boric acids, but weaker than sulfuric, nitric, hydrochloric, and chromic acids. 

Extensive hydrogen bonding takes place in phosphoric acid solutions. In concentrated (86% H PO solutions, as well as in the crystal stmctures of the anhydrous acid and the hemihydrate, the tetrahedral H PO groups are linked by hydrogen bonding. At lower (75% H PO concentrations, the tetrahedra are hydrogen-bonded to the water lattice. Physical properties of phosphoric acid solutions of various concentrations are Hsted in Table 2 the vapor pressure of aqueous H PO solutions at various temperatures is given in Table 3. 

Table 2. Physical Properties of Aqueous Solutions of Phosphoric Acid...

Orthophosphate salts are generally prepared by the partial or total neutralization of orthophosphoric acid. Phase equiUbrium diagrams are particularly usehil in identifying conditions for the preparation of particular phosphate salts. The solution properties of orthophosphate salts of monovalent cations are distincdy different from those of the polyvalent cations, the latter exhibiting incongment solubiUty in most cases. The commercial phosphates include alkah metal, alkaline-earth, heavy metal, mixed metal, and ammonium salts of phosphoric acid. Sodium phosphates are the most important, followed by calcium, ammonium, and potassium salts. 

Potassium Phosphates. The K2O—P20 —H2O system parallels the sodium system in many respects. In addition to the three simple phosphate salts obtained by successive replacement of the protons of phosphoric acid by potassium ions, the system contains a number of crystalline hydrates and double salts (Table 7). Monopotassium phosphate (MKP), known only as the anhydrous salt, is the least soluble of the potassium orthophosphates. Monopotassium phosphate has been studied extensively owing to its piezoelectric and ferroelectric properties (see Ferroelectrics). At ordinary temperatures, KH2PO4 is so far above its Curie point as to give piezoelectric effects in which the emf is proportional to the distorting force. There is virtually no hysteresis. 

The general manufacturing scheme for phosphate salts is shown in Figure 11. Condensed phosphates are prepared from the appropriate orthophosphate or mixture of orthophosphates, so the preparation of orthophosphates must be considered first for the manufacture of any phosphate salt. Phosphoric acid is neutralized to form a solution or slurry with a carefully adjusted acid/base ratio according to the desired orthophosphate product. The orthophosphate may be recovered either by crystallization from solution, or the entire solution or slurry may be evaporated to dryness. The dewatering (qv) method is determined by the solubihty properties of the product and by its desired physical properties such as crystal size and shape, bulk density, and surface area. Acid orthophosphate salts may be converted to condensed phosphates by thermal dehydration (calcination). 

The O or S atoms in P=0 and P=S groups may act as electron donors although these groups form relatively weak complexes with electron acceptor compounds such as nonpolarizable, more electropositive (ie, hard) acids, including protons (14). Use is made of this property in the recovery of uranium from wet-process phosphoric acid by extractants such as trioctylphosphine oxide [78-50-2] and di(2-ethylhexyl) hydrogen phosphate [298-07-7]. 

Properties and Reactions. Phosphoms sulfochloride [3982-91-0] (thiophosphoryl chloride), PSCI3, is a colorless fuming Hquid andis made by the reaction of phosphoms trichloride with sulfur and by the reaction of PCI3 with P2S3. Phosphoms sulfochloride is dimorphic in the soHd state. It reacts with water, forming either phosphoric acid or dichlorothiophosphoric acid [14500-94-8] depending on the reaction conditions. 

Properties and Structure. Phosphoms(V) oxide, the extremely hygroscopic acid anhydride of the phosphoric acids, exists in several forms but is often referred to by its empirical formula, P2O3. Three crystalline polymorphs, two distinct Hquids, and several amorphous or glassy soHds are recogni2ed. Some properties of the various forms of phosphoric oxide are Hsted in Table 10. 

Phosphoric Acid. This acid is the primary acidulant in cola beverages. Phosphoric acid is stronger than most organic acids and weaker than other mineral acids. The dibasic properties of phosphoric acid provide minor buffering capacity in the beverage. Food-grade phosphoric acid is commercially available in concentrations of 75%, 80%, and 85% and is one of the most economical acidulants. 

For the properties of these compounds, see Esters, organic. For esters of inorganic acids, see the articles on nitric acid, phosphoric acids, sulfuric acid, etc. 

---