Phosphonium quaternary

The most verstatile and useful type of polyelectro-lyles are the cationic, which are comprised of three classes ammonium (primary [I ], secondary [II ], tertiary [III ] amines, and quaternaries), sulfonium, and phosphonium quaternaries, as shown in Table 2. 

The first IL was discovered in the early twentieth century, soon to be followed by the chloroaluminates, which were primarily targeted for improved battery technology. The problem with chloroaluminates is that they are both moisture and oxygen sensitive, and they are only stable in an inert atmosphere. Much later, at the beginning of the 1990s, Wilkes et al. discovered the first moisture- and air-stabile ILs. Until today, the scope of possible cation-anion combinations and as a new trend, zwitterionic compounds, has expanded tremendously for example, various alkyl-imidazolium, alkyl-pyridium, quaternary phosphonium, quaternary ammonium, and thiazolinium cations can be coupled with a multitude of anions such as [PFe] , [BF4] , [Cl] , [Br], and [A1C1] . Moreover, deep... 

The main single cation ILs are those with the following cations imidazo-lium, quaternary ammonium, piperidinium, quaternary phosphonium, quaternary sulfonium, and pyrrolium. 

Halex rates can also be increased by phase-transfer catalysts (PTC) with widely varying stmctures quaternary ammonium salts (51—53) 18-crown-6-ether (54) pytidinium salts (55) quaternary phosphonium salts (56) and poly(ethylene glycol)s (57). Catalytic quantities of cesium duoride also enhance Halex reactions (58). 

Alkylation of phosphines by alkyl hahdes exhibits reactivity relative to the base strength, ie, PH is the least reactive and tertiary phosphines the most. This reactivity reflects the difficulty in using alkylation to prepare anything except quaternary phosphonium hahdes. 

The addition of P—H bonds across a carbonyl function leads to the formation of a-hydroxy-substituted phosphines. The reaction is acid-cataly2ed and appears to be quite general with complete reaction of each P—H bond if linear aUphatic aldehydes are used. Steric considerations may limit the product to primary or secondary phosphines. In the case of formaldehyde, the quaternary phosphonium salt [124-64-1] is obtained. 

Phosphonium salts are typically stable crystalline soHds that have high water solubiUty. Uses include biocides, flame retardants, the phase-transfer catalysts (98). Although their thermal stabiUty is quite high, tertiary phosphines can be obtained from pyrolysis of quaternary phosphonium haUdes. The hydroxides undergo thermal degradation to phosphine oxides as follows ... 

Quaternary ammonium alkyl ethers are prepared similarly an alkaline starch is reacted with a quaternary ammonium salt containing a 3-chloto-2-hydtoxyptopyl or 2,3-epoxyptopyl radical. Alternatively, such derivatives can be prepared by simple quaternization of tertiary aminoalkyl ethers by reaction with methyl iodide. Sulfonium (107) and phosphonium (108) starch salts have also been prepared and investigated. Further work has explained the synthesis of diethyl aminoethyl starch (109) as well as the production of cationic starches from the reaction of alkaline starch with... 

The reaction of higher alkyl chlorides with tin metal at 235°C is not practical because of the thermal decomposition which occurs before the products can be removed from the reaction zone. The reaction temperature necessary for the formation of dimethyl tin dichloride can be lowered considerably by the use of certain catalysts. Quaternary ammonium and phosphonium iodides allow the reaction to proceed in good yield at 150—160°C (109). An improvement in the process involves the use of amine—stannic chloride complexes or mixtures of stannic chloride and a quaternary ammonium or phosphonium compound (110). Use of these catalysts is claimed to yield dimethyl tin dichloride containing less than 0.1 wt % trimethyl tin chloride. Catalyzed direct reactions under pressure are used commercially to manufacture dimethyl tin dichloride. 

This reaction gives fair-to-good yields of monoorganotin tribromides and trichlorides when quaternary ammonium or phosphonium catalysts are used (149). Better yields are obtained with organic bromides and staimous bromide than with the chlorides. This reaction is also catalyzed by tri alkyl antimony compounds at 100—160°C, bromides are more reactive than chlorides in this preparation (150,151). a,C0-Dihaloalkanes also react in good yield giving CO-haloalkyltin trihaHdes when catalyzed by organoantimony compounds (152). 

Phase-tiansfei catalysis (PTC) is a technique by which leactions between substances located in diffeient phases aie biought about oi accelerated. Typically, one OI more of the reactants are organic Hquids or soHds dissolved in a nonpolar organic solvent and the coreactants are salts or alkah metal hydroxides in aqueous solution. Without a catalyst such reactions are often slow or do not occur at ah the phase-transfer catalyst, however, makes such conversions fast and efficient. Catalysts used most extensively are quaternary ammonium or phosphonium salts, and crown ethers and cryptates. Although isolated examples of PTC can be found in the early Hterature, it is only since the middle of the 1960s that the method has developed extensively. 

The benzylation of a wide variety of aHphatic, aromatic, and heterocycHc amines has been reported. Benzyl chloride is converted into mono-, di-, and tribenzyl amines by reaction with ammonia. Benzylaniline [103-32-2] results from the reaction of benzyl chloride with aniline. Reaction with tertiary amines yields quaternary ammonium salts with trialkylpbospbines, quaternary phosphonium salts and with sulfides, sulfonium salts are formed. 

Reduction in compression set began to be achieved in the late 1960s when it was found that tropolene and phenanthroline not only accelerated amine cures but were also effective with certain bisnucleophiles such as resorcinol, hydroquinone and bis-phenol AF. In due course even better results were obtained with quaternary ammonium or phosphonium salts being used in conjunction with aromatic dihydroxy compounds. 

In the reactions characterized in the general sense above, phenyl and benzyl were the organic residues bound to phosphorus. It is not clear which of these groups is removed in the LAH dealkylation step. It should also be noted that as tetraquaternary phosphonium salts, these species do not qualify as crown analogs in the strictest sense because of the absence of lone pair electrons on phosphorus. Furthermore, the quaternary phosphorus can resist oxidation much better than secondary or tertiary phospho-... 

These quaternary phosphonium fluorides provide a range of activities for the displacement of halogen by fluorine [30] (Table 3)... 

The ylide Ph3P=CH2 can readily be made by deprotonating a quaternary phosphonium halide with n-butyllithium and many such ylides are now known ... 

The quaternary phosphonium salt is prepared by refluxing for 12 hours or longer a mixture of 4.5 g of benzyl chloride and 13 g of triphenylphosphine in 70 ml of xylene. On cooling to approx. 60°, colorless crystals of benzyltriphenylphosphonium chloride can be filtered off, washed with xylene (approx. 50 ml) and dried. The yield is virtually quantitative, mp 310-311°. 

The quaternary salt is now treated with ethoxide ion in the presence of cinnamalde-hyde so that the ylide reacts in situ as it is produced. A solution of sodium ethoxide is prepared by slowly adding 0.75 g of sodium metal to 100 ml of absolute ethanol in a dry Erlenmeyer flask (hood). In a second flask, the phosphonium chloride is dissolved in 150 ml of absolute ethanol, cinnamaldehyde (2.9 g) is added and the flask is swirled while the ethoxide solution is added a transient orange-red color indicates the formation of the ylide. 

However, ionic liquids containing other classes of organic cations are known. Room-temperature ionic liquids containing organic cations including quaternary ammonium, phosphonium, pyridinium, and - in particular - imidazolium salts are currently available in combination with a variety of anions (Figure 3.1-1 provides some common examples) and have been studied for applications in electrochemistry [7, 8] and in synthesis [9-11]. 

An interesting feature of the ring opening polymerization of siloxanes is their ability to proceed via either anionic or cationic mechanisms depending on the type of the catalyst employed. In the anionic polymerization alkali metal hydroxides, quaternary ammonium (I NOH) and phosphonium (R POH) bases and siloxanolates (Si—Oe M ) are the most widely used catalysts 1,2-4). They are usually employed at a level of 10 2 to KT4 weight percent depending on their activities and the reaction conditions. The activity of alkali metal hydroxides and siloxanolates decrease in the following order 76 79,126). 

Quaternary Ammonium or Phosphonium Salts. In the above-mentioned case of NaCN, the uncatalyzed reaction does not take place because the CN ions cannot cross the interface between the two phases, except in very low concentration. The reason is that the Na ions are solvated by the water, and this solvation energy would not be present in the organic phase. The CN ions... 

Sometimes, a direct ion-pairing of the chiral cations and anions 8 or 15 is necessary to maximize the NMR separation of the signals [115,116]. Cationic species as different as quaternary ammonium, phosphonium, [4]heterohelice-nium, thiiranium ions, (rj -arene)manganese, ruthenium tris(diimine) have been analyzed with success (Fig. 23). 

---