Peroxy reaction

However in low NOx conditions peroxy radicals primarily react through self and cross peroxy-peroxy reactions to form methyl hydrogen peroxide (CH3OOH) and hydrogen peroxide (H202). H02 is also recycled back to OH through the reaction with 03 (Reaction 9). 

Termination occurs almost exclusively via peroxy-peroxy reactions (HO2+HO2 and CH3O2+HO2), with very little formation of HNO3, but with a small contribution from OH+HO2. The peroxides (H2O2 and CH3OOH) act as minor sources of OH, slightly reducing the effectiveness of the quadratic terminations. 

Reactions (2) of the organic peroxy reactions are not chain branching since both RO2 and RO are active radicals, but at low temperatures they probably speed up the chain propagation by providing a faster alternative to the main route, through peroxy isomerization (Section 1.10). Another accelerating type of reaction is the hydrogen abstraction reactions of NO2, which are initiation reactions. 

In short, the relative behavior of VOCs and NO, in ozone formation can be understood in terms of competition for the hydroxyl radical. When the instantaneous VOC-to-N02 ratio is less than about 5.5 1, OH reacts predominantly with NO2, removing radicals and retarding O, formation. Under these conditions, a decrease in NO, concentration favors O formation. At a sufficiently low concentration of NO, or a sufficiently high VOC-to-N02 ratio, a further decrease in NO, favors peroxy-peroxy reactions, which retard O3 formation by removing free radicals from the system. 

Comparisons of density function parameters with higher level calculation G2M(RCC,MP2) on the vinyl -I- O2 system from Mebel et al. [180] are also performed for the important transition state of phenyl peroxy reaction to Phenoxy + O atom. 

At lower NQr, peroxy-peroxy reactions become more significant ... 

Epoxides are very easy to prepare via the reaction of an alkene with a peroxy acid This process is known as epoxidation... 

A commonly used peroxy acid is peroxyacetic acid (CH3CO2OH) Peroxyacetic acid is normally used m acetic acid as the solvent but epoxidation reactions tolerate a variety of solvents and are often earned out m dichloromethane or chloroform... 

Epoxidation (Section 6 18) Peroxy acids transfer oxygen to the double bond of alkenes to yield epoxides The reaction IS a stereospecific syn addition... 

Epoxidation of alkenes by reaction with peroxy acids... 

The reaction of ketones with peroxy acids is both novel and synthetically useful An oxygen from the peroxy acid is inserted between the carbonyl group and one of the attached car bons of the ketone to give an ester Reactions of this type were first described by Adolf von Baeyer and Victor Vilhger m 1899 and are known as Baeyer—Villiger oxidations... 

Oxidation. Acetaldehyde is readily oxidised with oxygen or air to acetic acid, acetic anhydride, and peracetic acid (see Acetic acid and derivatives). The principal product depends on the reaction conditions. Acetic acid [64-19-7] may be produced commercially by the Hquid-phase oxidation of acetaldehyde at 65°C using cobalt or manganese acetate dissolved in acetic acid as a catalyst (34). Liquid-phase oxidation in the presence of mixed acetates of copper and cobalt yields acetic anhydride [108-24-7] (35). Peroxyacetic acid or a perester is beheved to be the precursor in both syntheses. There are two commercial processes for the production of peracetic acid [79-21 -0]. Low temperature oxidation of acetaldehyde in the presence of metal salts, ultraviolet irradiation, or osone yields acetaldehyde monoperacetate, which can be decomposed to peracetic acid and acetaldehyde (36). Peracetic acid can also be formed directiy by Hquid-phase oxidation at 5—50°C with a cobalt salt catalyst (37) (see Peroxides and peroxy compounds). Nitric acid oxidation of acetaldehyde yields glyoxal [107-22-2] (38,39). Oxidations of /)-xylene to terephthaHc acid [100-21-0] and of ethanol to acetic acid are activated by acetaldehyde (40,41). 

In the presence of any substantial amount of oxygen this reaction is extremely rapid, but the terminal peroxy radical formed reacts slowly with monomer and has a relatively rapid termination rate. 

Oxidation begins with the breakdown of hydroperoxides and the formation of free radicals. These reactive peroxy radicals initiate a chain reaction that propagates the breakdown of hydroperoxides into aldehydes (qv), ketones (qv), alcohols, and hydrocarbons (qv). These breakdown products make an oxidized product organoleptically unacceptable. Antioxidants work by donating a hydrogen atom to the reactive peroxide radical, ending the chain reaction (17). 

Carbon-centered radicals generally react very rapidly with oxygen to generate peroxy radicals (eq. 2). The peroxy radicals can abstract hydrogen from a hydrocarbon molecule to yield a hydroperoxide and a new radical (eq. 3). This new radical can participate in reaction 2 and continue the chain. Reactions 2 and 3 are the propagation steps. Except under oxygen starved conditions, reaction 3 is rate limiting. 

Under these conditions, a component with a low rate constant for propagation for peroxy radicals may be cooxidized at a higher relative rate because a larger fraction of the propagation steps is carried out by the more reactive (less selective) alkoxy and hydroxy radicals produced in reaction 4. 

Bimolecular reactions of peroxy radicals are not restricted to identical radicals. When both peroxy radicals are tertiary, reaction 15 is not possible. When an a-hydrogen is present, reaction 15 is generally the more effective competitor and predominates. 

Acids are usually the end products of ketone oxidations (41,42,44) but vicinal diketones and hydroperoxyketones are apparent intermediates (45). Acids are readily produced from vicinal diketones, perhaps through anhydrides (via, eg, a Bayer-ViUiger reaction) (46,47). The hydroperoxyketones reportedly decompose to diketones as well as to aldehydes and acids (45). Similar products are expected from radical— radical reactions of the corresponding peroxy radical precursors. 

Higher Hydrocarbons. The VPO of higher hydrocarbons is similar to that of the lower members of the series with two significant additional comphcations (/) the back-bitiag reactions of alkylperoxy radicals (eq. 32), particularly at positions 2 or 3 carbons removed from the peroxy position, and (2) above the NTC region, radical fragmentation (eq. 28). 

Reaction 36 may occur through a peroxy radical complex with the metal ion (2,25,182). In any event, reaction 34 followed by reaction 36 is the equivalent of a metal ion-cataly2ed hydrogen abstraction by a peroxy radical. 

Conversion of Aromatic Rings to Nonaromatic Cyclic Structures. On treatment with oxidants such as chlorine, hypochlorite anion, chlorine dioxide, oxygen, hydrogen peroxide, and peroxy acids, the aromatic nuclei in lignin typically ate converted to o- and -quinoid stmctures and oxinane derivatives of quinols. Because of thein relatively high reactivity, these stmctures often appear as transient intermediates rather than as end products. Further reactions of the intermediates lead to the formation of catechol, hydroquinone, and mono- and dicarboxyhc acids. 

Autooxidation. Liquid-phase oxidation of hydrocarbons, alcohols, and aldehydes by oxygen produces chemiluminescence in quantum yields of 10 to 10 ° ein/mol (128—130). Although the efficiency is low, the chemiluminescent reaction is important because it provides an easy tool for study of the kinetics and properties of autooxidation reactions including industrially important processes (128,131). The light is derived from combination of peroxyl radicals (132), which are primarily responsible for the propagation and termination of the autooxidation chain reaction. The chemiluminescent termination step for secondary peroxy radicals is as follows ... 

Oxidation. AH polyamides are susceptible to oxidation. This involves the initial formation of a free radical on the carbon alpha to the NH group, which reacts to form a peroxy radical with subsequent chain reactions leading to chain scission and yellowing. As soon as molten nylon is exposed to air it starts to discolor and continues to oxidize until it is cooled to below 60°C. It is important, therefore, to minimize the exposure of hot nylon to air to avoid discoloration or loss of molecular weight. Similarly, nylon parts exposed to high temperature in air lose their properties with time as a result of oxidation. This process can be minimized by using material containing stabilizer additives. 

The reaction rate of fumarate polyester polymers with styrene is 20 times that of similar maleate polymers. Commercial phthaHc and isophthaHc resins usually have fumarate levels in excess of 95% and demonstrate full hardness and property development when catalyzed and cured. The addition polymerization reaction between the fumarate polyester polymer and styrene monomer is initiated by free-radical catalysts, commercially usually benzoyl peroxide (BPO) and methyl ethyl ketone peroxide (MEKP), which can be dissociated by heat or redox metal activators into peroxy and hydroperoxy free radicals. 

As the quinone stabilizer is consumed, the peroxy radicals initiate the addition chain propagation reactions through the formation of styryl radicals. In dilute solutions, the reaction between styrene and fumarate ester foUows an alternating sequence. However, in concentrated resin solutions, the alternating addition reaction is impeded at the onset of the physical gel. The Hquid resin forms an intractable gel when only 2% of the fumarate unsaturation is cross-linked with styrene. The gel is initiated through small micelles (12) that form the nuclei for the expansion of the cross-linked network. 

Catalyst Selection. The low resin viscosity and ambient temperature cure systems developed from peroxides have faciUtated the expansion of polyester resins on a commercial scale, using relatively simple fabrication techniques in open molds at ambient temperatures. The dominant catalyst systems used for ambient fabrication processes are based on metal (redox) promoters used in combination with hydroperoxides and peroxides commonly found in commercial MEKP and related perketones (13). Promoters such as styrene-soluble cobalt octoate undergo controlled reduction—oxidation (redox) reactions with MEKP that generate peroxy free radicals to initiate a controlled cross-linking reaction. 

Eor antioxidant activity, the reaction of aminyl radicals with peroxy radicals is very beneficial. The nitroxyl radicals formed in this reaction are extremely effective oxidation inhibitors. Nitroxides function by trapping chain-propagating alkyl radicals to give hydroxylamine ethers. These ethers, in turn, quench chain propagating peroxy radicals and in the process regenerate the original nitroxides. The cycHc nature of this process accounts for the superlative antioxidant activity of nitroxides (see Antioxidants). Thus, antioxidant activity improves with an increase in stabiUty of the aminyl and nitroxyl radicals. Consequendy, commercial DPA antioxidants are alkylated in the ortho and para positions to prevent undesirable coupling reactions. 

Propagation. Propagation reactions (eqs. 5 and 6) can be repeated many times before termination by conversion of an alkyl or peroxy radical to a nonradical species (7). Homolytic decomposition of hydroperoxides produced by propagation reactions increases the rate of initiation by the production of radicals. 

The reaction rate of molecular oxygen with alkyl radicals to form peroxy radicals (eq. 5) is much higher than the reaction rate of peroxy radicals with a hydrogen atom of the substrate (eq. 6). The rate of the latter depends on the dissociation energies (Table 1) and the steric accessibiUty of the various carbon—hydrogen bonds it is an important factor in determining oxidative stabiUty. 

Metal-Catalyzed Oxidation. Trace quantities of transition metal ions catalyze the decomposition of hydroperoxides to radical species and greatiy accelerate the rate of oxidation. Most effective are those metal ions that undergo one-electron transfer reactions, eg, copper, iron, cobalt, and manganese ions (9). The metal catalyst is an active hydroperoxide decomposer in both its higher and its lower oxidation states. In the overall reaction, two molecules of hydroperoxide decompose to peroxy and alkoxy radicals (eq. 5). 

Termination. The conversion of peroxy and alkyl radicals to nonradical species terminates the propagation reactions, thus decreasing the kinetic chain length. Termination reactions (eqs. 7 and 8) are significant when the oxygen concentration is very low, as in polymers with thick cross-sections where the oxidation rate is controlled by the diffusion of oxygen, or in a closed extmder. The combination of alkyl radicals (eq. 7) leads to cross-linking, which causes an undesirable increase in melt viscosity. 

Radical Scavengers Hydrogen-donating antioxidants (AH), such as hindered phenols and secondary aromatic amines, inhibit oxidation by competing with the organic substrate (RH) for peroxy radicals. This shortens the kinetic chain length of the propagation reactions. 

Dialkoxypyrazines and 2,5-dihydroxypyrazines have been shown to add to singlet oxygen to yield peroxy adducts such as (75) in high yields (76CC417, 79JCS(P1)1885 and the reaction is believed to be important in the biosynthesis of the antibiotic bicyclomycin (76)... 

---