Palladium oxidative coupling

A new pyrrole ring synthesis developed by Arcadi involves the addition of ammonia or benzylamine to 4-pentynones, the latter of which are conveniently prepared via a palladium oxidative coupling sequence as shown below for the synthesis of 40 [39,40]. 

With hydrogen sulfide at 500—600°C, monochlorotoluenes form the corresponding thiophenol derivatives (30). In the presence of palladium catalysts and carbon monoxide, monochlorotoluenes undergo carbonylation at 150—300°C and 0.1—20 MPa (1—200 atm) to give carboxyHc acids (31). Oxidative coupling of -chlorotoluene to form 4,4 -dimethylbiphenyl can be achieved in the presence of an organonickel catalyst, generated in situ, and zinc in dipolar aprotic solvents such as dimethyl acetamide (32,33). An example is shown in equation 4. 

The Boekelheide reaction has been applied to the synthesis of non-natural products with the preparation of quaterpyridines serving as an example. The sequence began with the 2,4-linked bipyridyl-N-oxide 25. Execution under the typical reaction conditions produced the expected bis-pyridone 26. Treatment with POCI3 afforded the corresponding dichloride that was submitted to a palladium-catalyzed coupling with 2-stannyl pyridine to produce the desired quaterpyridine 27. 

Phenoxy acetophenone, 46, 94 Phenylacetyleue, oxidative coupling to diphenyldiacetylene, 46, 39 partial reduction to styrene using palladium catalyst, 46, 90 reaction with sodium hypobromite to yield phenylbromoethyne, 46,86... 

The chemistry of vinyl acetate synthesis from the gas-phase oxidative coupling of acetic acid with ethylene has been shown to be facilitated by many co-catalysts. Since the inception of the ethylene-based homogeneous liquid-phase process by Moiseev et al. (1960), the active c ytic species in both the liquid and gas-phase process has always been seen to be some form of palladium acetate [Nakamura et al, 1971 Augustine and Blitz, 1993]. Many co-catalysts which help to enhance the productivity or selectivity of the catalyst have appeared in the literature over the years. The most notable promoters being gold (Au) [Sennewald et al., 1971 Bissot, 1977], cadmium acetate (Cd(OAc)j) [Hoechst, 1967], and potassium acetate (KOAc) [Sennewald et al., 1971 Bissot, 1977]. 

In a Kumada-Corriu reaction, an aryl halide is oxidatively coupled with a homogeneous nickel(ll)-phosphine catalyst [2], This species reacts with a Grignard reagent to give biaryl or alkylaryl compounds. Later, palladium-phosphine complexes were also successfully applied. By this means, stereospecific transformations were achieved. 

Another compound 9 with three heterocyclic rings linearly fused (5 5 5) with two heteroatoms has been prepared from 1,1 -carbonyl diindole 297 <2001T5199>. Palladium-mediated coupling of the 2- and 2 -positions of 297 afforded the 1,1 -carbonyl-2,2 -biindolyl 9. 1,1 -Carbonyl diindole 297 was in turn obtained in 41% yield from 1,1 -carbonyldiimidazole 296 by reaction with indole in DMSO at 125 °C. The palladium-catalyzed coupling step afforded the desired product 9 in low yield and required a stoichiometric amount of palladium acetate. Therefore, it was felt prohibitively expensive. Addition of various co-oxidants (Ac20, Mn02, and Cu(OAc)2, etc) to make the reaction catalytic in palladium did not result in any improvement of the yield of 18 (Scheme 53). 

Under microwave heating, the Heck olefinations were achieved in 30-60 min, as opposed to 10-40 h by conventional heating. The recyclable heterogeneous LDH-Pd(0) catalytic system circumvents the need to use expensive and air-sensitive basic phosphines as ligands in the palladium-catalyzed coupling of chloroarenes. This novel Mg-Al layered double-hydroxide (LDH) support in the catalytic system stabilizes the nanopalladium particles and also supplies adequate electron density to the anchored palladium(O) species and facilitates the oxidative addition of the deactivated electron-rich chloroarenes. 

Palladium-catalyzed oxidative couplings of aromatic compounds with alkenes in air lead to cinnamate products with TONs attaining 280 (Equations (66) and (67)).67,67a,67b... 

In the palladium-catalyzed coupling reactions of arenes with alkenes, the cr-arylpalladium complexes react with CO to give aromatic acids in AcOH, as shown in Scheme u 97>97a 97c This carboxylation reaction of arenes with CO proceeds catalytically with respect to Pd at room temperature under atmospheric pressure of CO, when K2S2O8 is added as an oxidant and TFA is employed as a solvent. 

The 2,3-substituted indols are formed via a palladium-catalyzed coupling reaction of aryl halide, o-alkenylphenyl isocyanide, and amine (Equation (122)).481 Oxidative addition of an aryl halide, insertion of both the isonitrile and alkene moieties of o-alkenylphenyl isocyanide, and 1,3-hydrogen migration may form a 7r-allylpalladium species, which is then attacked by an amine to afford an indol. 

C-C bond formation mediated by silane.6,6a 6f With respect to the development of intramolecular variants, these seminal studies lay fallow until 1990, at which point the palladium- and nickel-catalyzed reductive cyclization of tethered 1,3-dienes mediated by silane was disclosed. As demonstrated by the hydrosilylation-cyclization of 1,3,8,10-tetraene 21a, the /rarcr-divinylcyclopentanes 21b and 21c are produced in excellent yield, but with modest stereoselectivity.46 Bu3SnH was shown to participate in an analogous cyclization.46 Isotopic labeling and crossover experiments provide evidence against a mechanism involving initial diene hydrosilylation. Rather, the collective data corroborate a mechanism involving oxidative coupling of the diene followed by silane activation (Scheme 15). 

Secondary phosphine oxides are known to be excellent ligands in palladium-catalyzed coupling reactions and platinum-catalyzed nitrile hydrolysis. A series of chiral enantiopure secondary phosphine oxides 49 and 50 has been prepared and studied in the iridium-catalyzed enantioselective hydrogenation of imines [48] and in the rhodium- and iridium-catalyzed hydrogenation functionalized olefins [86]. Especially in benzyl substituted imine-hydrogenation, 49a ranks among the best ligands available in terms of ex. 

The oxidative coupling/cyclization process occurs via stoichiometric carbo-palladation using a Pd(II) species, typically Pd(OAc)2. In an early example, submission of diphenylamines 3 to the palladium(II)-promoted oxidative intramolecular cyclization conditions yielded carbazoles 4 [15-... 

In most cases, the oxidative addition process consumes stoichiometric amount of Pd(OAc>2. One of the earliest examples of the use of palladium in pyrrole chemistry was the Pd(0Ac)2 induced oxidative coupling of A-methylpyrrole with styrene to afford a mixture of olefins 18 and 19 in low yield based on palladium acetate [28]. 

Most of the early applications of palladium to indole chemistry involved oxidative coupling or cyclization using stoichiometric Pd(II). Akermark first reported the efficient oxidative coupling of diphenyl amines to carbazoles 37 with Pd(OAc)2 in refluxing acetic acid [45]. The reaction is applicable to several ring-substituted carbazoles (Br, Cl, OMe, Me, NO2), and 20 years later Akermark and colleagues made this reaction catalytic in the conversion of arylaminoquinones 38 to carbazole-l,4-quinones 39 [46]. This oxidative cyclization is particularly useful for the synthesis of benzocarbazole-6,11-quinones (e.g., 40). 

In conclusion, the fantastically diverse chemistry of indole has been significantly enriched by palladium-catalyzed reactions. The accessibility of all of the possible halogenated indoles and several indolyl triflates has resulted in a wealth of synthetic applications as witnessed by the length of this chapter. In addition to the standard Pd-catalyzed reactions such as Negishi, Suzuki, Heck, Stille and Sonogashira, which have had great success in indole chemistry, oxidative coupling and cyclization are powerful routes to a variety of carbazoles, carbolines, indolocarbazoles, and other fused indoles. 

When furan or substituted furans were subjected to the classic oxidative coupling conditions [Pd(OAc)2 in refluxing HOAc], 2,2 -bifuran was the major product, whereas 2,3 -bifuran was a minor product [12,13]. Similar results were observed for the arylation of furans using Pd(OAc)2 [14]. The oxidative couplings of furan or benzo[i]furan with olefins also suffered from inefficiency [15]. These reactions consume at least one equivalent of palladium acetate, and therefore have limited synthetic utility. 

Stille coupling (12, 56).1 The key step in a synthesis of (E)-neomanoalide (4) involves palladium-catalyzed coupling of an allyl halide with an a-stannylfuran. Thus 1 and 2 couple in the presence of Pd(dba)2 and P(C6H5), to form 3 as a 1 1 mixture of (E)- and (Z)-isomers in 66% yield. Conversion of 3 to 4 involves reduction (DIBAH) and selective singlet oxygen oxidation of a 2-silylfuran to a butenolide. 

A molybdenum-mediated oxidative coupling of aniline 1 with cyclohexene 2a provides carbazole 3. Alternatively, the same overall transformation of aniline 1 to carbazole 3 is achieved by iron-mediated oxidative coupling with cyclo-hexa-1,3-diene 2b or by palladium-catalyzed oxidative coupling with arenes 2c. The use of appropriately substituted anilines and unsaturated six-membered hydrocarbons opens up the way to highly convergent organometallic syntheses of carbazole alkaloids. 

An even more direct approach to carbazole-3,4-quinone alkaloids is provided by the palladium(II)-mediated oxidative coupling of ort/zo-quinones with ary-lamines, which gives access to this class of natural products in a three-step route [137]. 

Our second approach for the total synthesis of carbazoquinocin C (274) uses the palladium(II)-catalyzed oxidative coupling of aniline (839) and 2-methoxy-3-methyl-... 

Retrosynthetic analysis of carbazoquinocin C (274) and (+ )-carquinostatin A ( + )-278 based on our highly convergent palladium(II)-mediated intramolecular oxidative coupling of arylamino-l,2-benzoquinones provides aniline (839) and 4-heptyl-3-methyl-l,2-benzoquinone (946) as precursors for 274, and 4-prenylaniline (945) and 4-(2-hydroxypropyl)-3-methyl-l,2-benzoquinone (947) as precursors for ( + )-278 (646) (Scheme 5.126). 

In addition to the aforementioned total syntheses. Shannon et al. observed the formation of an N-C3-linked dimer during the transformation of a 3-bromocarbazole to a 3-cyanocarbazole by reaction with copper(I) cyanide in DMF under reflux (668). Harrity et al. reported the synthesis of non-natural (+ )-N,N -dimethylbismurrayafoline A via a chromium-mediated benzannulation, followed by a palladium-catalyzed oxidative coupling reaction (669). 

The oxidative coupling of CO in the presence of an alcohol to yield oxalate esters is under study by Ube Industries and Union Carbide. As oxidizing agent, oxygen or nitric oxide (Equation 8 and 9) can be used in the presence of a palladium catalyst (7 ). 

---