Double hydroxides, layered

The present paper will describe the results of adsoi ption experiments toward layered double hydroxides (LDH). 

One problem associated with the peroxotungstate-catalyzed epoxidation system described above is the separation of the catalyst after the completed reaction. To overcome this obstacle, efforts to prepare heterogeneous tungstate catalysts have been conducted. De Vos and coworkers employed W catalysts derived from sodium tungstate and layered double hydroxides (LDH - coprecipitated MgCU, AICI3, and NaOH) for the epoxidation of simple olefins and allyl alcohols with... 

The results obtained by Kuila et al. and Acharya et al. [63,64] from the EVA elastomer blended with lamellar-like Mg-Al layered double hydroxide (LDH) nanoparticles demonstrate that MH nanocrystals possess higher flame-retardant efficiency and mechanical reinforcing effect by comparison with common micrometer grade MH particles. Kar and Bhowmick [65] have developed MgO nanoparticles and have investigated their effect as cure activator for halogenated mbber. The results as shown in Table 4.2 are promising. 

Anionic clays, such as hydrotalchite, manasseite, stichtite, etc. are layered double hydroxides (Mg/Al Mg/Fe Mg/Cr2 Ni/Al Ni/Fe, etc.). Anionic clays exhibit poor acidic properties. The thermal decomposition of anionic clays gives rise to mixed oxides of industrial importance as catalysts. 

A number of papers have appeared on the use of layered double hydroxides (e.g. Mg and Al containing oxides). A meixnerite-like catalyst has been reported to give 100% selectivity for diacetone alcohol from acetone at 0 C at close to thermodynamic equilibrium conversion of 23% (Tichit and Fajula, 1999). The side-chain alkylation of toluene with propylene to give isobutyl benzene (for ibuprofen) is a well-known example where Na/K alloy on Na2C03/K2C03 is used as the catalyst. 

Evans DG, Slade RCT (2005) Structural Aspects of Layered Double Hydroxides 119 -87... 

Taviot-Gueho C, Leroux F (2005) In situ Polymerization and Intercalation of Polymers in Layered Double Hydroxides 119 121-159 Teitel baum GB, see Kochelaev BI (2005) 114 205-266 Thessing J, see Peng X (2005) 118 137-177 Trommer K, see Roewer G (2002) 101 59-136 TsuzukiS (2005) Interactions with Aromatic Rings 115 149-193... 

Williams GR, Khan AI, O Hare D (2005) Mechanistic and Kinetic Studies of Guest Ion Intercalation into Layered Double Hydroxides Using Time-resolved, In-situX-ray Powder Diffraction 119 161-192 de Wolff FA, see Berend K (2003) 104 1-58... 

D. G. Evans, R. C. T. Slade, Structural aspects of layered double hydroxides. Struct. Bonding 119 (2000) 1. 

Zinc hydroxy double salts are layered materials similar to layered double hydroxides which show intercrystalline reactivity and incorporate organic compounds between layers.337 Hydroxy double salts of high crystallinity can be obtained by reacting ZnO with organic metal salts in water. Zinc oxide crystals could then be prepared by thermal treatment of hydroxy zinc acetate.338... 

The structure of the layered double hydroxides is the reverse of that of the clays. They are anionic materials in which the sheets are intercalated with anions instead of cations. These ions can be exchanged with several different anions. The cationic nature of the layers lends itself to pillaring by large Keg-gin anions. 

Anionic complexes can easily be prepared by the sulfonation of the aromatic rings in the complexes. Sulfonated cobalt phthalocyanine intercalated in a layered double hydroxide host was a stable catalyst for the oxidation of thiols162,163 and phenol derivatives.164 It was concluded that the complex has been intercalated with the plane of the phthalocyanine ring perpendicular to the sheet of the host (edge-on orientation) (Fig. 7.2). 

The catalyst effectiveness decreased upon increasing the concentration of the intercalated complexes via aggregation of the closely associated complexes.164 Sulfides were also oxidized by heterogeneous Co(II) complexes.163 Catalytic oxidation of thiols was mediated by Mo complex intercalated in a layered double hydroxide.166... 

Similar methods of encapsulation are also observed in pillared clays, which were also introduced as catalysts as long ago as the early 1980s. The field has been thoroughly reviewed up to 2000 [65], Layered double hydroxide structures have also been used for the entrapment of metal coordination compounds [66],... 

An information science research group devised a new model which could explain information storage in the prebiotic phase of the biogenesis process. They assume that layered double hydroxide (LDH) minerals acted as proto-RNA molecules on the young Earth about 4 billion years ago. This hypothesis relates to Cairns-Smith s genetic takeover thesis, which thus again became the subject of discussion. 

Layered materials are of special interest for bio-immobilization due to the accessibility of large internal and external surface areas, potential to confine biomolecules within regularly organized interlayer spaces, and processing of colloidal dispersions for the fabrication of protein-clay films for electrochemical catalysis [83-90], These studies indicate that layered materials can serve as efficient support matrices to maintain the native structure and function of the immobilized biomolecules. Current trends in the synthesis of functional biopolymer nano composites based on layered materials (specifically layered double hydroxides) have been discussed in excellent reviews by Ruiz-Hitzky [5] and Duan [6] herein we focus specifically on the fabrication of bio-inorganic lamellar nanocomposites based on the exfoliation and ordered restacking of aminopropyl-functionalized magnesium phyllosilicate (AMP) in the presence of various biomolecules [91]. 

Evans, D.G. and Duan X. (2006) Preparation of layered double hydroxides and their application as additives, polymers, as precursors to magnetic materials and in biology and... 

Choy, J.H., Kwak, S.Y., Jeong, Y.J. and Park, J.S. (2000) Inorganic layered double hydroxides as nonviral vectors. Angewandte Chemie-Intemational Edition, 39, 4042-4045. 

B. (2006) Self-assembly and characterization of layered double hydroxide/DNA hybrids. Nano Letters, 6, 199-204. 

Layered metal hydroxides can be categorized into several classes according to their structure (Figure 13.1). Layered double hydroxides (LDHs), which have a hydrotalcite-like structure [27-34], can be expressed as [M2+1 xM3+x(0H)2] (Am )x/m,nH20,... 

A) Layered double hydroxide (LDH), (B) hydroxy double salt (HDS) and (C) hydrocalumite. 

D layered double hydroxides [Mn1 xMIII40H)2][X 7,- nH20] + insulating anion variable [23]... 

Layered double hydroxides (LDH), also referred to as anionic clays, are very useful materials due to their anion exchange properties. LDH display a layered structure built on a stacking of positive layers ([MII1 MIII (OH)2] +), separated by inter-lamellar domains constituted of anions and water molecules ([X e nH20]x ) [117]. 

Rives, V. (2001) Layered Double Hydroxides Present and Future, Nova Science Publishers, New York. 

We are studying the glycerol transformation in the presence of different catalysts of porous structure such as layered double hydroxides (hydrotalcites, HT and mixed oxides, MO), modified zeolites (ZSM5) and new type of Raney-Ni (RNi) to find optimal conditions for producing valuable components. 

---