Other Acids

Typical organic acids contain the --C(0)0H group, but many other acid groupings, e.g. the sulphonic -S(0)20H give acidic properties to organic compounds. Phenols have acidic properties and are classified with enols as pseudo-acids. 

Formed K2SO4 plus H2SO4. Other acid salts, e.g. K2S04-3H2S04 are known. 

On concentrating the solution, a solid of formula As40jq. SH O (which may be composed by hydrated arsenic(V) acid) is obtained, and this, on fairly prolonged heating to 800 K, loses water and leaves arsenic(V) oxide. No compounds corresponding to the other acids of phosphorus are formed, but salts are known. 

Ester formation. Add carefully 1 ml. of the liquid to i ml. of ethanol and then warm gently for i minute. Pour into water, make alkaline with aqueous Na2C03 solution (to remove HCl and other acid fumes), and note the odour of ethyl acetate or ethyl benzoate. 

The high sodium ion concentration results in facile crystallisation of the sodium salt. This process of salting out with common salt may be used for recrystallisation, but sodium benzenesulphonate (and salts of other acids of comparable molecular weight) is so very soluble in water that the solution must be almost saturated with sodium chloride and consequently the product is likely to be contaminated with it. In such a case a pure product may be obtained by crystallisation from, or Soxhlet extraction with, absolute alcohol the sul-phonate is slightly soluble but the inorganic salts are almost insoluble. Very small amounts of sulphones are formed as by-products, but since these are insoluble in water, they separate when the reaction mixture is poured into water ... 

XI XI, 1st 1928 1505-1591 Other Acids. Sulphinic acids Benzenesulphinic acid. 

Acid derivatives are made directly from acids or by conversion from other acid derivatives depending on their stabihty. The most important are esters (RCOiEt), amides (RCO2NR2), anhydrides (RCOO COR) and add clilorides (RCOCI). Arrange these in an order of stabilily, the most reactive at the top of the list, the most stable at the bottom. 

The tert butyl group is cleaved as the corresponding carbocation Loss of a proton from tert butyl cation converts it to 2 methylpropene Because of the ease with which a tert butyl group is cleaved as a carbocation other acidic reagents such as trifluoroacetic acid may also be used... 

This approach can be used to sketch titration curves for other acid-base titrations including those involving polyprotic weak acids and bases or mixtures of weak acids and bases (Figure 9.8). Figure 9.8a, for example, shows the titration curve when titrating a diprotic weak acid, H2A, with a strong base. Since the analyte is... 

Furfural was first isolated in the eady nineteenth century. Dobereiner is credited with the discovery. He obtained a small amount of a yellow "oil" (too Htde to characterize) as a by-product in the preparation of formic acid (8). Other chemists found that the same "oil" having a charactedstic aroma could be obtained by boiling finely divided vegetable materials such as oats, com, sawdust, bran, etc, with aqueous sulfuric acid or other acids (9,10). The oil was present in the Hquid resulting from condensation of the vapors produced during heating. The empirical formula was determined by Stenhouse... 

Acid—Base Chemistry. Acetic acid dissociates in water, pK = 4.76 at 25°C. It is a mild acid which can be used for analysis of bases too weak to detect in water (26). It readily neutralizes the ordinary hydroxides of the alkaU metals and the alkaline earths to form the corresponding acetates. When the cmde material pyroligneous acid is neutralized with limestone or magnesia the commercial acetate of lime or acetate of magnesia is obtained (7). Acetic acid accepts protons only from the strongest acids such as nitric acid and sulfuric acid. Other acids exhibit very powerful, superacid properties in acetic acid solutions and are thus useful catalysts for esterifications of olefins and alcohols (27). Nitrations conducted in acetic acid solvent are effected because of the formation of the nitronium ion, NO Hexamethylenetetramine [100-97-0] may be nitrated in acetic acid solvent to yield the explosive cycl o trim ethyl en etrin itram in e [121 -82-4] also known as cyclonit or RDX. 

The detergent range alcohols and their derivatives have a wide variety of uses ia consumer and iadustrial products either because of surface-active properties, or as a means of iatroduciag a long chain moiety iato a chemical compound. The major use is as surfactants (qv) ia detergents and cleaning products. Only a small amount of the alcohol is used as-is rather most is used as derivatives such as the poly(oxyethylene) ethers and the sulfated ethers, the alkyl sulfates, and the esters of other acids, eg, phosphoric acid and monocarboxyhc and dicarboxyhc acids. Major use areas are given ia Table 11. 

There are numerous variations of the wet process, but all involve an initial step in which the ore is solubilized in sulfuric acid, or, in a few special instances, in some other acid. Because of this requirement for sulfuric acid, it is obvious that sulfur is a raw material of considerable importance to the fertilizer industry. The acid—rock reaction results in formation of phosphoric acid and the precipitation of calcium sulfate. The second principal step in the wet processes is filtration to separate the phosphoric acid from the precipitated calcium sulfate. Wet-process phosphoric acid (WPA) is much less pure than electric furnace acid, but for most fertilizer production the impurities, such as iron, aluminum, and magnesium, are not objectionable and actually contribute to improved physical condition of the finished fertilizer (35). Impurities also furnish some micronutrient fertilizer elements. 

Health advisories have been issued (269) for diphenamid, metolachlor, pronamide, and propachlor. Other acid amide herbicides include butachlor [23184-66-9] and ethalfluralin [55283-68-6],... 

Make acid yields coumaUc acid when treated with fuming sulfuric acid (19). Similar treatment of malic acid in the presence of phenol and substituted phenols is a facile method of synthesi2ing coumarins that are substituted in the aromatic nucleus (20,21) (see Coumarin). Similar reactions take place with thiophenol and substituted thiophenols, yielding, among other compounds, a red dye (22) (see Dyes and dye intermediates). Oxidation of an aqueous solution of malic acid with hydrogen peroxide (qv) cataly2ed by ferrous ions yields oxalacetic acid (23). If this oxidation is performed in the presence of chromium, ferric, or titanium ions, or mixtures of these, the product is tartaric acid (24). Chlorals react with malic acid in the presence of sulfuric acid or other acidic catalysts to produce 4-ketodioxolones (25,26). 

Other acids, eg, hydrochloric or nitric acid, are more seldom used because of higher costs and corrosion problems. 

The zwitterion (6) can react with protic solvents to produce a variety of products. Reaction with water yields a transient hydroperoxy alcohol (10) that can dehydrate to a carboxyUc acid or spHt out H2O2 to form a carbonyl compound (aldehyde or ketone, R2CO). In alcohoHc media, the product is an isolable hydroperoxy ether (11) that can be hydrolyzed or reduced (with (CH O) or (CH2)2S) to a carbonyl compound. Reductive amination of (11) over Raney nickel produces amides and amines (64). Reaction of the zwitterion with a carboxyUc acid to form a hydroperoxy ester (12) is commercially important because it can be oxidized to other acids, RCOOH and R COOH. Reaction of zwitterion with HCN produces a-hydroxy nitriles that can be hydrolyzed to a-hydroxy carboxyUc acids. Carboxylates are obtained with H2O2/OH (65). The zwitterion can be reduced during the course of the reaction by tetracyanoethylene to produce its epoxide (66). 

Wet-process acid is manufactured by the digestion of phosphate rock (calcium phosphate) with sulfuric acid. Depending on availabiHty, other acids such as hydrochloric may be used, but the sulfuric-based processes are by far the most prevalent. Phosphoric acid is separated from the resultant calcium sulfate slurry by filtration. To generate a filterable slurry and to enhance the P2O5 content of the acid, much of the acid filtrate is recycled to the reactor. 

Many other polymerization processes have been patented, but only some of them appear to be developed or under development ia 1996. One large-scale process uses an acid montmorrillonite clay and acetic anhydride (209) another process uses strong perfiuorosulfonic acid reski catalysts (170,210). The polymerization product ia these processes is a poly(tetramethylene ether) with acetate end groups, which have to be removed by alkaline hydrolysis (211) or hydrogenolysis (212). If necessary, the product is then neutralized, eg, with phosphoric acid (213), and the salts removed by filtration. Instead of montmorrillonite clay, other acidic catalysts can be used, such as EuUer s earth or zeoHtes (214—216). 

---