Alkenes osmium tetroxide oxidation

Although it will be discussed in more detail later, it is important to note that treatment of oxiranes with aqueous acid (H3O ) results in protonation of the oxygen of the epoxide and ring opening in an ""anti-" or an antarafacial fashion with production of the corresponding diol. Thus, in contrast to the results of permanganate (MnOi) and osmium tetroxide (OsOd oxidation of alkenes, this two-step process (epoxidation followed by aqueous acid hydrolysis) yields the (E)- or trans-diol (Equation 6.20). The H NMR and Fourier transform infrared (FT-IR) spectra for cyclohexene and the (E)- and (Z)-diols are shown in Figure 6.4. 

With this reaction, two new asymmetric centers can be generated in one step from an achiral precursor in moderate to good enantiomeric purity by using a chiral catalyst for oxidation. The Sharpless dihydroxylation has been developed from the earlier y -dihydroxylation of alkenes with osmium tetroxide, which usually led to a racemic mixture. 

Osmium tetroxide, reaction with alkenes, 235-236 toxicity of, 235 Oxalic add, structure of, 753 Oxaloacetic acid, structure of, 753 Oxetane, reaction with Grignard reagents, 680 Oxidation, 233, 348 alcohols, 623-626 aldehydes, 700-701 aldoses, 992-994 alkenes, 233-236 biological, 625-626 phenols, 631 sulfides, 670 thiols, 668... 

There are many reagents that add two OH groups to a double bond. Osmium tetroxide (0s04) and alkaline KMn04 give syn addition from the less-hindered side of the double bond. Less substituted double bonds are oxidized more rapidly than more substimted alkenes. Osmium tetroxide adds rather slowly but almost quantitatively. The cyclic ester (78) is an intermediate and can be isolated, but usually decomposed... 

The most widely used reagent for oxidation of alkenes to glycols is osmium tetroxide. Osmium tetroxide is a highly selective oxidant that gives glycols by a stereospecific syn addition.39 The reaction occurs through a cyclic osmate ester that is formed by a [3 + 2] cycloaddition.40... 

Osmium tetroxide used in combination with sodium periodate can also effect alkene cleavage.191 Successful oxidative cleavage of double bonds using ruthenium tetroxide and sodium periodate has also been reported.192 In these procedures the osmium or ruthenium can be used in substoichiometric amounts because the periodate reoxidizes the metal to the tetroxide state. Entries 1 to 4 in Scheme 12.18 are examples of these procedures. Entries 5 and 6 show reactions carried out in the course of multistep syntheses. The reaction in Entry 5 followed a 5-exo radical cyclization and served to excise an extraneous carbon. The reaction in Entry 6 followed introduction of the allyl group by enolate alkylation. The aldehyde group in the product was used to introduce an amino group by reductive alkylation (see Section 5.3.1.2). 

Syn-Dihydroxylation. When the reaction was first discovered, the syn-dihydroxylation of alkenes was carried out by using a stoichiometric amount of osmium tetroxide in dry organic solvent.56 Hoffman made the observation that alkenes could react with chlorate salts as the primary oxidants together with a catalytic quantity of osmium tetroxide, yielding syn-vicinal diols (Eq. 3.11). This catalytic reaction is usually carried out in an aqueous and tetrahydrofuran solvent mixture, and silver or barium chlorate generally give better yields.57... 

A very effective way of carrying out syn-dihydroxylation of alkenes is by using an osmium tetroxide-tertiary amine N-oxide system. This dihydroxylation is usually carried out in aqueous acetone in either one-or two-phase systems, but other solvents may be required to overcome problems of substrate solubility.61... 

Potassium permanganate or osmium tetroxide oxidize alkenes to furnish 1,2-diols (glycols). 

The osmium-catalyzed dihydroxylation reaction, that is, the addition of osmium tetr-oxide to alkenes producing a vicinal diol, is one of the most selective and reliable of organic transformations. Work by Sharpless, Fokin, and coworkers has revealed that electron-deficient alkenes can be converted to the corresponding diols much more efficiently when the pH of the reaction medium is maintained on the acidic side [199]. One of the most useful additives in this context has proved to be citric acid (2 equivalents), which, in combination with 4-methylmorpholine N-oxide (NMO) as a reoxidant for osmium(VI) and potassium osmate [K20s02(0H)4] (0.2 mol%) as a stable, non-volatile substitute for osmium tetroxide, allows the conversion of many olefinic substrates to their corresponding diols at ambient temperatures. In specific cases, such as with extremely electron-deficient alkenes (Scheme 6.96), the reaction has to be carried out under microwave irradiation at 120 °C, to produce in the illustrated case an 81% isolated yield of the pure diol [199]. 

In summary, the reaction of osmium tetroxide with alkenes is a reliable and selective transformation. Chiral diamines and cinchona alkakoid are most frequently used as chiral auxiliaries. Complexes derived from osmium tetroxide with diamines do not undergo catalytic turnover, whereas dihydroquinidine and dihydroquinine derivatives have been found to be very effective catalysts for the oxidation of a variety of alkenes. OsC>4 can be used catalytically in the presence of a secondary oxygen donor (e.g., H202, TBHP, A -methylmorpholine-/V-oxide, sodium periodate, 02, sodium hypochlorite, potassium ferricyanide). Furthermore, a remarkable rate enhancement occurs with the addition of a nucleophilic ligand such as pyridine or a tertiary amine. Table 4-11 lists the preferred chiral ligands for the dihydroxylation of a variety of olefins.61 Table 4-12 lists the recommended ligands for each class of olefins. 

Among oxo-metals, osmium tetroxide is a particularly intriguing oxidant since it is known to oxidize various types of alkenes rapidly, but it nonetheless eschews the electron-rich aromatic hydrocarbons like benzene and naphthalene (Criegee et al., 1942 Schroder, 1980). Such selectivities do not obviously derive from differences in the donor properties of the hydrocarbons since the oxidation (ionization) potentials of arenes are actually less than those of alkenes. The similarity in the electronic interactions of arenes and alkenes towards osmium tetroxide relates to the series of electron donor-acceptor (EDA) complexes formed with both types of hydrocarbons (26). Common to both arenes and alkenes is the immediate appearance of similar colours that are diagnostic of charge-transfer absorp-... 

Further supporting evidence for this type of a mechanism comes from the consideration of an analogous reaction, the oxidation of alkenes by osmium tetroxide, which also produces cis-diols. In this reaction the... 

After the "asymmetric epoxidation" of allylic alcohols at the very beginning of the 80 s, at the end of the same decade (1988) Sharpless again surprised the chemical community with a new procedure for the "asymmetric dihydroxylation" of alkenes [30]. The procedure involves the dihydroxylation of simple alkenes with N-methylmorpholine A -oxide and catalytic amounts of osmium tetroxide in acetone-water as solvent at 0 to 4 °C, in the presence of either dihydroquinine or dihydroquinidine p-chlorobenzoate (DHQ-pClBz or DHQD-pClBz) as the chiral ligands (Scheme 10.3). 

Other functionalized supports that are able to serve in the asymmetric dihydroxylation of alkenes were reported by the groups of Sharpless (catalyst 25) [88], Sal-vadori (catalyst 26) [89-91] and Cmdden (catalyst 27) (Scheme 4.13) [92]. Commonly, the oxidations were carried out using K3Fe(CN)g as secondary oxidant in acetone/water or tert-butyl alcohol/water as solvents. For reasons of comparison, the dihydroxylation of trons-stilbene is depicted in Scheme 4.13. The polymeric catalysts could be reused but had to be regenerated after each experiment by treatment with small amounts of osmium tetroxide. A systematic study on the role of the polymeric support and the influence of the alkoxy or aryloxy group in the C-9 position of the immobilized cinchona alkaloids was conducted by Salvadori and coworkers [89-91]. Co-polymerization of a dihydroquinidine phthalazine derivative with hydroxyethylmethacrylate and ethylene glycol dimethacrylate afforded a functionalized polymer (26) with better swelling properties in polar solvents and hence improved performance in the dihydroxylation process [90]. 

Butyl hydroperoxide,37 barium chlorate,38 or potassium ferricyanide39 can also be used as oxidants in catalytic procedures. Scheme 12.6 provides some examples of oxidations of alkenes to glycols by permanganate and by osmium tetroxide. 

Osmium tetroxide used in combination with sodium periodate can also effect alkene cleavage.135 Successful oxidative cleavage of double bonds using ruthenium tetroxide and sodium periodate has also been reported.136 In these procedures, the osmium or ruthenium can be used in substoichiometric amounts because the periodate reoxidizes the metal to the tetroxide state. Entries 1 4 in Scheme 12.17 are examples of these procedures. 

Using chromium-based oxidants 2,4-Dimethylpentane-2,4-diol chromate(VI) diester, 122 Trimethylsilyl chlorochromate, 327 Using other oxidizing agents Bis(tributyltin) oxide, 41 Hydrogen hexachloroplatinate(IV)-Copper(II) chloride, 145 4-Methoxy-2,2,6,6-tetramethyl-1 -oxopiperidinium chloride, 183 Osmium tetroxide, 222 Potassium nitrosodisulfonate, 258 Samarium(II) iodide, 270 From alkenes by addition or cleavage reactions... 

Further chemistry of alkenes and alkynes is described in this chapter, with emphasis on addition reactions that lead to reduction and oxidation of carbon-carbon multiple bonds. First we explain what is meant by the terms reduction and oxidation as applied to carbon compounds. Then we emphasize hydrogenation, which is reduction through addition of hydrogen, and oxidative addition reactions with reagents such as ozone, peroxides, permanganate, and osmium tetroxide. We conclude with a section on the special nature of 1-alkynes— their acidic behavior and how the conjugate bases of alkynes can be used in synthesis to form carbon-carbon bonds. 

Several oxidizing reagents react with alkenes under mild conditions to give, as the overall result, addition of hydrogen peroxide as HO—OH. Of particular importance are alkaline permanganate (MnO40) and osmium tetroxide (0s04), both of which react in an initial step by a suprafacial cycloaddition mechanism like that postulated for ozone. 

Diols are prepared from alkenes by oxidation with reagents such as osmium tetroxide, potassium permanganate, or hydrogen peroxide (Section 11-7C). However, ethylene glycol is made on a commercial scale from oxacy-clopropane, which in turn is made by air oxidation of ethene at high temperatures over a silver oxide catalyst (Section 11-7D). 

Exercise 16-37 An elegant modification of the two-step procedure to prepare ketones from alkenes by hydroxylation and oxidative cleavage of the diol formed uses a small amount of potassium permanganate (or osmium tetroxide, 0s04) as the catalyst and sodium periodate as the oxidizing agent ... 

Osmium tetroxide is a mild, reliable reagent for the selective oxidation of alkenes to cis- 1,2-glycols. Discovered a long time ago,338,341 this reaction has been widely used for synthetic purposes by organic chemists.290,342... 

The conversion of alkenes to 1,2-diols by osmium tetroxide is also an olefin addition reaction. In this case a hydroxy group is added to each carbon of the olefin group, and the addition is termed an oxidative addition since the diol product is at a higher oxidation level than the alkene reactant. Oxidation of the carbon atoms of the alkene takes place in the first step, which is the reaction with 0s04 to produce the intermediate osmate ester. 

Osmium tetroxide is commonly used to add two OH groups to a double bond.15 The mechanism gives syn addition from the less hindered side of the alkene. Since 0s04 is expensive and highly toxic it is therefore mostly used in a catalytic fashion using stoichiometric cooxidants, like H202 or /V-methylmorpholine-/V-oxide (NMO). 

The reaction of alkenes with osmium tetroxide (0s04) is an example of an oxidation reaction (Following fig.). In this case the alkene is not split, but, a 1,2-diol is obtained which is also called a glycol. The reaction involves the formation of a cyclic intermediate where the osmium reagent is attached to one face of the alkene. On treatment with sodium bisulphite, the intermediate is cleaved such that the two oxygen atoms linking the osmium remain... 

Osmium tetroxide (0s04) is the reactive Os(VIII) species in the cw-vic-dihydroxylation of alkenes. This compound is a solid but is not easy to handle because it has a rather high vapor pressure. Therefore, it is often preferable to prepare the compound in situ. Such a preparation involves the oxidation of the potassium salt K,0s04 2H20 (K2OsO,(OH)4) of osmium(VI) acid with NMO as the oxidizing agent. This salt also is a solid but has a much... 

Osmium tetroxide (0s04, sometimes called osmic acid) reacts with alkenes in a concerted step to form a cyclic osmate ester. Oxidizing agents such as hydrogen peroxide (H202) or tertiary amine oxides (R3N+—O-) are used to hydrolyze the osmate ester and reoxidize osmium to osmium tetroxide. The regenerated osmium tetroxide catalyst continues to hydroxylate more molecules of the alkene. 

---