O-Phenylenediamines

The crude o-phenylenediamine may be converted into the dihydrocliloride and the salt purified in the following manner. Dissolve it in 60 ml. of concentrated hydrochloric acid and 40 ml. of water containing 2 g. of stannous chloride, and treat the hot solution with 2-3 g. of decolourising carbon. Filter, add 100 ml. of concentrated hydrochloric acid to the hot colourless filtrate, and cool in a freezing mixture of ice and salt. Collect the colourless crystals of the dihydrochloride on a Buchner or sintered glass funnel, wash with a small volume of concentrated hydrochloric acid, and dry in a vacuum desiccator over sodium hydroxide. The yield is 61 g. 

Ortho quinones (and also aromatic a-diketones, o-phenylenediamine to yield quinoxalines as follows. 

Place 27 g. of o-phenylenediamine (Section IV,92) in a 250 ml. round-bottomed flask and add 17 -5 g. (16 ml.) of 90 per cent, formic acid (1). Heat the mixture on a water bath at 100° for 2 hours. Cool, add 10 per cent sodium hydroxide solution slowly, with constant rotation of the flask, until the mixture is just alkaline to litmus. Filter off the crude benzimidazole at the pump, wash with ice-cold water, drain well and wash again with 25 ml. of cold water. Dissolve the crude product in 400 ml. of boiling water, add 2 g. of decolourising carbon, and digest for 16 minutes. Filter rapidly at the pump through a pre heated Buchner funnel and flask. Cool the filtrate to about 10°, filter off the benzimidazole, wash with 25 ml. of cold water, and dry at 100°. The yield of pure benzimidazole, m.p. 171-172°, is 26 g. 

This important oxidation - reduction indicator is readily prepared by a double Skraup reaction (compare Section V,l) upon o-phenylenediamine ... 

The dianhydride of 1,4,5,8-naphthalene tetracarboxyhc acid [81-30-1] has been of research interest for the preparation of high temperature polymers, ie, polyimides. The condensation of the dianhydride with o-phenylenediamines gives vat dyes and pigments of the benzimidazole type. 

Pigment Orange 43 [4424-06-0] 71105 Perinone condensation of naphthalene-1,4,5,8-tetracarboxyhc acid dianhydride with o-phenylenediamine, and separation of trans isomer... 

Because of the time and expense involved, biological assays are used primarily for research purposes. The first chemical method for assaying L-ascorbic acid was the titration with 2,6-dichlorophenolindophenol solution (76). This method is not appHcable in the presence of a variety of interfering substances, eg, reduced metal ions, sulfites, tannins, or colored dyes. This 2,6-dichlorophenolindophenol method and other chemical and physiochemical methods are based on the reducing character of L-ascorbic acid (77). Colorimetric reactions with metal ions as weU as other redox systems, eg, potassium hexacyanoferrate(III), methylene blue, chloramine, etc, have been used for the assay, but they are unspecific because of interferences from a large number of reducing substances contained in foods and natural products (78). These methods have been used extensively in fish research (79). A specific photometric method for the assay of vitamin C in biological samples is based on the oxidation of ascorbic acid to dehydroascorbic acid with 2,4-dinitrophenylhydrazine (80). In the microfluorometric method, ascorbic acid is oxidized to dehydroascorbic acid in the presence of charcoal. The oxidized form is reacted with o-phenylenediamine to produce a fluorescent compound that is detected with an excitation maximum of ca 350 nm and an emission maximum of ca 430 nm (81). 

Alloxan forms an oxime (1007) which is the same compound, violuric acid, as that formed by nitrosation of barbituric acid likewise, a hydrazone and semicarbazone. Reduction of alloxan gives first alloxantin, usually formulated as (1008), and then dialuric acid (1004 R = OH) the steps are reversible on oxidation. Vigorous oxidation with nitric acid and alkaline hydrolysis both give imidazole derivatives (parabanic acid and alloxanic acid, respectively) and thence aliphatic products. Alloxan and o-phenylenediamine give the benzopteridine, alloxazine (1009) (61MI21300). 

The more traditional methods of phenazine synthesis falling into the type A synthesis are altogether less satisfactory than the application of the Beirut reaction. Traditionally, Ris prepared phenazine in low yield by heating o-phenylenediamine and catechol in a sealed tube at 200 °C (1886CB2206) however, the method appears to be unsatisfactory at best and gives, in addition to phenazine, 5,10-dihydrophenazine in varying amounts (Scheme 53). Several variants of this procedure exist o-benzoquinone has been used in condensation with 0-phenylenediamine and yields as high as 35% have been reported, and 1,2,3,4-tetrahydrophenazine has been prepared by condensation of o-phenylenediamine with cyclohexane- 1,2-dione. 

The diester (429) has been cyclized with ammonia or primary amines to give the esters (430) (72AP2), whilst the related diester (431) has likewise been converted to (432). Similar reactions starting with TV-substituted o-phenylenediamines have been used as the basis of a synthesis of deazariboflavins (433) (77TL2551). 

Catalytic reduction of 1,2,4-oxadiazoles also breaks the N—O bond e.g. (264) gives (265). Benzofuroxan can be reduced under various conditions to benzofurazan (266), the dioxime (267) or o-phenylenediamine (268) (69AHC(10)l). Reduction by copper and hydrochloric acid produced o-nitroanilines (Scheme 30) (69AHC(lO)l). 

However, there are differences between o-phenylenediamine and 4,5-diaminopyrazoles in the synthesis of [5.5] systems. For example, the formation of pyrazolo[3,4-d]-[l,2,3]triazole (550) is similar to that of benzotriazole, but all attempts to extend the synthesis of benzimidazoles to the preparation of the imidazo[4,5-c]pyrazole system (551) have failed (78TH40400). 

Monochloroacetamides are cleaved (by assisted removal ) by reagents that contain two nucleophilic groups (e.g., o-phenylenediamine, thiourea, 1-piperi-dinethiocarboxamide, 3-nitropyridine-2-thione, 2-aminothiophenol ) ... 

A. a-Methoxyphenasine condensation). Two hundred grams (0.42 mole) of powdered lead dioxide (Note 1) is added to a solution of 10 g. (0.07 mole) of pyrogallol monomethyl ether (p. 90) in 3 1. of dry benzene in a 1-gal. narrow-necked acid bottle. The bottle and contents are placed in a shaking machine and shaken for 10-20 minutes (Note 2). The reddish brown solid is filtered through an 11-cm. Buchner funnel, and the filter cake is washed once with 400 ml. of benzene. To this filtrate there is added, immediately and with mechanical stirring, a solution of 6 g. (0.06 mole) of o-phenylenediamine (Note 3) in a mixture of 80 ml. of glacial acetic acid and 200 ml. of benzene. The solu-... 

If one amino group in o-phenylenediamine is converted to an amide group by formic acid, the intermediate benzimidazole is formed. This reaction, conducted with a wide range of reactants, produces resins (polybenzimidazoles) used as high-temperature adhesives for laminates in the aerospace industry. Heat insulation is made by including tiny bubbles of silica and all... 

Chloronaphthalene 40 Chloronitrobenzenes, 40 Chloropentafluoroethane, 40 Chlorophacinone, 40 4-Chloro-o-phenylenediamine, 40 Chlorophenols, 40 Chlorophenols, Mono, 40 Chloropicrin, 40 Chloroplatinic acid, 41 Chloroprene, 41... 

---