Nitro, acids anilines

The thermal cyclization of o-nitro-i-anilines is considerably facilitated by the presence of mineral acid, when the cyclization proceeds at temperatures sufficiently low to allow the isolation of the... 

The nitration of acetanilide with mixed acid yields nitroacetanilides in which the ortho para ratio is less than 0.1. When the nitration medium is nitric acid, this ratio is 0.7, when acetyl nitrate in acetic anhydride is used, the product is almost entirely o-nitroacetanilide. No satisfactory explanation has been given for these results. The 40-50 per cent yield of m-nitro-aniline that results from the nitration of aniline in mixed acid or in nitric acid can be explained in the following manner. In the strong acids, nitric and sulfuric acid, aniline is largely ionized. 

The lesson this table teaches is, that it is almost impossible to rritrate celltrlose in small quantities, and get uniform results, when the nitration is carried on at high temperatures. As regards the solubility of pyroxyline. Parks found that nitro-benzene, aniline, glacial acetic acid, and camphor, dissolved in the more volatile solvents methyl-alcohol and alcohol-ether, were much the best solvents for producing a plastic, as they are... 

In 1975 McCallum and Pethybridge [422] examined the behavior of strong acids, such as methane sulfonic, sulfuric, and nitric acids, in DMSO and concluded that these acids can be considered to be completely dissociated in dilute solution. Farrell, Terrier, and Schaal [267] later compared the pK s of nitroaromatics in both water and DMSO to examine the effects of solvation on these compounds. For the most part the pK s of the nitro-phenols, -anilines, -toluenes, and -diphenylamines were slightly higher in DMSO than in water, but in some cases this order was reversed. These authors concluded that these compounds undergo only very limited specific solvation in both solvents, and the charges in their anions are largely delocalized. 

Diphenylamines may be prepared by nitro group displacement from o- or p-dinitrobenzenes or from cyano-substituted nitrobenzenes. Thus, reaction with acidic anilines containing electron-withdrawing substituents in DMSO in the presence of potassium carbonate yields [234] products such as (88). Orf/jo-dinitrobenzene will also react with tervalent phosphorus compounds, such as trialkylphosphites, in acetonitrile to give substituted products (89) is formed from trieth-ylphosphite [235]. 

White crystals, m.p. 114" C. Manufactured by reacting aniline with excess ethanoic acid or ethanoic anhydride. Chief use is in the manufacture of dye intermediates such as p-nitro-acetanilide, p-nitroaniline and p-phenylene-diamine, in the manufacture of rubber, and as a peroxide stabilizer. 

N-phenylhydroxylamine, PhNHOH and further reduction can give azoxybenzene, azobenzene, hydrazobenzene and aniline. The most important outlet commercially for the nitro-compounds is the complete reduction to the amines for conversion to dyestufTs. This is usually done in one stage with iron and a small amount of hydrochloric acid. 

Place 24 ml. (24 5 g.) of aniline, 13 ml. (15 5 g.) of nitro-benzene,t and 62 ml. (75 g.) of the anhydrous glycerol in the flask and mix thoroughly. (If the glycerol is still warm from the dehydration, cool the mixture in water.) Now add slowly 36 ml. (66 g.) of concentrated sulphuric acid, shaking the mixture thoroughly during the addition. The mixture at first... 

Various basic substances, such as aromatic amines (naphthyl-amines dissolve with difficulty in dil. HCl, diphenylamine only in cone. HCl, triphenylamine insoluble) nitro-anilines some amino-carboxylic acids. 

Formic acid is a good reducing agent in the presence of Pd on carbon as a catalyst. Aromatic nitro compounds are reduced to aniline with formic acid[100]. Selective reduction of one nitro group in 2,4-dinitrotoluene (112) with triethylammonium formate is possible[101]. o-Nitroacetophenone (113) is first reduced to o-aminoacetophenone, then to o-ethylaniline when an excess of formate is used[102]. Ammonium and potassium formate are also used for the reduction of aliphatic and aromatic nitro compounds. Pd on carbon is a good catalyst[103,104]. NaBH4 is also used for the Pd-catalyzed reduction of nitro compounds 105]. However, the ,/)-unsaturated nitroalkene 114 is partially reduced to the oxime 115 with ammonium formate[106]... 

Attack on the electrophilic C-2 may occur as in the 2-aminothiazoles series, which probably explains the rearrangements observed in acidic medium (121, 711, 712, 723, 724), in aqueous medium with NaOAc (725), or with aqueous NaHCOj (725) (Scheme 232). That the initial attack probably involves the C-2 atom is substantiated by the fact that this rearrangement occurs under extremely mild conditions for 2-iinino-3-substituted-5-nitro-4-thiazolines (725). As the whole mechanism proposed (see p. 92) is reversible, when imino derivatives are submitted to such rearrangement conditions the rearrangement is expected to occur faster if steric interaction between 3- and 4-substituents exists in the 2-imino isomer. Another reaction may occur in acidic medium phenylimino-2-bipheny]-3,4-4-thiazoline hydrolyzed with hydrochloric acid gives the corresponding 4-thiazoline-2-one and aniline (717). 

The reduction of the nitro group to yield aniline is the most commercially important reaction of nitrobenzene. Usually the reaction is carried out by the catalytic hydrogenation of nitrobenzene, either in the gas phase or in solution, or by using iron borings and dilute hydrochloric acid (the Bechamp process). Depending on the conditions, the reduction of nitrobenzene can lead to a variety of products. The series of reduction products is shown in Figure 1 (see Amines byreduction). Nitrosobenzene, /V-pbenylbydroxylamine, and aniline are primary reduction products. Azoxybenzene is formed by the condensation of nitrosobenzene and /V-pbenylbydroxylamine in alkaline solutions, and azoxybenzene can be reduced to form azobenzene and hydrazobenzene. The reduction products of nitrobenzene under various conditions ate given in Table 2. 

Important analogs of aniline include the toluidines, xyUdines, anisidines, phenetidines, and its chloro-, nitro-. A/-acetyl. A/-alkyl. A/-aryl. A/-acyl, and sulfonic acid derivatives. 

Nitroso compounds are formed selectively via the oxidation of a primary aromatic amine with Caro s acid [7722-86-3] (H2SO ) or Oxone (Du Pont trademark) monopersulfate compound (2KHSO KHSO K SO aniline black [13007-86-8] is obtained if the oxidation is carried out with salts of persulfiiric acid (31). Oxidation of aromatic amines to nitro compounds can be carried out with peroxytrifluoroacetic acid (32). Hydrogen peroxide with acetonitrile converts aniline in a methanol solution to azoxybenzene [495-48-7] (33), perborate in glacial acetic acid yields azobenzene [103-33-3] (34). 

In the Bnchamp process, nitro compounds are reduced to amines in the presence of iron and an acid. This is the oldest commercial process for preparing amines, but in more recent years it has been largely replaced by catalytic hydrogenation. Nevertheless, the Bnchamp reduction is still used in the dyestuff industry for the production of small volume amines and for the manufacture of iron oxide pigments aniline is produced as a by-product. The Bnchamp reduction is generally mn as a batch process however, it can also be mn as a continuous (48) or semicontinuous process (49). 

In the reduction of nitro compounds to amines, several of the iatermediate species are stable and under the right conditions, it is possible to stop the reduction at these iatermediate stages and isolate the products (see Figure 1, where R = CgH ). Nitrosoben2ene [586-96-9] C H NO, can be obtained by electrochemical reduction of nitrobenzene [98-95-3]. Phenylhydroxylamine, C H NHOH, is obtained when nitrobenzene reacts with ziac dust and calcium chloride ia an alcohoHc solution. When a similar reaction is carried out with iron or ziac ia an acidic solution, aniline is the reduction product. Hydrazobenzene [122-66-7] formed when nitrobenzene reacts with ziac dust ia an alkaline solution. Azoxybenzene [495-48-7], C22H2QN2O, is... 

The N,]S -dialkyl-/)-PDAs are manufactured by reductively alkylating -PDA with ketones. Alternatively, these compounds can be prepared from the ketone and -lutroaruline with catalytic hydrogenation. The /V-alkyl-/V-aryl- -PDAs are made by reductively alkylating -nitro-, -nitroso-, or /)-aminodipheny1 amine with ketones. The AijAT-dialkyl- PDAs are made by condensing various anilines with hydroquinone in the presence of an acid catalyst (see Amines-aromatic,phenylenediamines). 

Nitro-l-diazo-2-naphthol-4-sulfonic acid prefers the 2-position in spite of the nitro group, and increasing alkalinity favors ortho coupling with diazophenols. 1-Naphthalenesulfamic acid [24344-19-2] (ArNHSO H) and N-nitro-1-naphthylamine [4323-69-7] (ArNHNO ) couple exclusively in the para position. The substitution of resorcinol [108-46-3] and y -phenylenediamine [108-45-2] is compHcated and has been discussed (29,30). The first azo dyes from aniline, eg. Aniline Yellow [60-09-3] (19) (Cl Solvent Yellow 1 Cl 11000) were manufactured in 1861 and Bismark Brown [10114-58-6] (20) (Cl Basic Brown 1 Cl 21000) appeared in 1863. The reaction is as follows ... 

Its production was 621 t and the average price 0.75/kg in 1987. Direct YeUow 44 (64) is prepared by phosgenation of an equimolar mixture of metanilic acid coupled to o-anisidinomethanesulfonic acid (with subsequent hydrolysis of the methanesulfonic acid group) and nitro aniline coupled to sahcychc acid (with subsequent reduction of the nitro group). 

Nitrophenylarsonic acid has been prepared by heating p-nitrobenzenediazonium chloride with arsenious acid in hydrochloric acid, by the action of -nitrobenzenediazonium chloride on sodium arsenite, by the action of sodium arsenite on sodium -nitrobenzeneisodiazo oxide, by the diazotization of -nitro-aniline in acetic acid in the presence of arsenic chloride and cuprous chloride, and by the reaction of -nitrobenzenediazonium borofluoride with sodium arsenite in the presence of cuprous chloride. ... 

The impurities present in aromatic nitro compounds depend on the aromatic portion of the molecule. Thus, benzene, phenols or anilines are probable impurities in nitrobenzene, nitrophenols and nitroanilines, respectively. Purification should be carried out accordingly. Isomeric compounds are likely to remain as impurities after the preliminary purifications to remove basic and acidic contaminants. For example, o-nitrophenol may be found in samples ofp-nitrophenol. Usually, the ri-nitro compounds are more steam volatile than the p-nitro isomers, and can be separated in this way. Polynitro impurities in mononitro compounds can be readily removed because of their relatively lower solubilities in solvents. With acidic or basic nitro compounds which cannot be separated in the above manner, advantage may be taken of their differences in pK values (see Chapter 1). The compounds can thus be purified by preliminary extractions with several sets of aqueous buffers... 

This leaction is lesorted to for the reason that naphthalene forms only the n-nitro-compound with niti icacid. The method, similar to that used for prepaiing aniline from nitiobenzene, cannot, therefore, be employed for the production of /3-n.tphtliyl-.amine. u-Naphthol is mainly used foi the manufacture of yellow and orange colours (Martins and naphthol yellow) by the action of nitric acid, and are similai m constitution to picric acid (see Prep. 107). 

This phenomenon is not possible in p-nitrobenzoic acid hence, p-nitrophenol is a stronger acid with respect to p-nitrobenzoic acid than is expected on the basis of a comparison of substituents in which this resonance delocalization is not an important factor. It was, therefore, recommended that Op = 1.27 be used for p-nitro derivatives of phenols and anilines, rather than the Op = 0.78 given in Table 7-10. These enhanced sigma constants, symbolized a, apply primarily to electron-withdrawing groups in reactions aided by low electron density at the reaction site. 

The first condensation is conducted selectively on a variety of 3-ketoesters and a-formylesters. The first step works well on most simple anilines even when sterically congested and is mostly affected by basicity. Formation of intermediate 3 is problematic when strong electron-withdrawing groups (EWG) are attached to the aniline (e.g., nitro). The cyclization step is promoted thermally in inert solvents as well as using acidic solvents at elevated temperature. When there exists an opportunity to form isomers on cyclization (e.g., m-substituted anilines) a mixture of the 5- and 7-substituted quinolines usually results. 

General Conditions for each step and selectivity of m-substituted anilines As previously mentioned, Hauser and Reynolds reported on factors governing the first step of the Conrad-Limpach reaction but they tvere by no means exhaustive. Other than the conditions reported above for the first step, HClAleOH, CHCI3 or CHCI2 (neat or with acid catalyst), PhMe or PhH with removal of water with or without acid catalyst, or EtOH/AcOH/CaS04 were reported to provide the desired enamino-ester from an aryl amine and 3-keto-ester. Hauser and Reynolds also noted that o-nitroaniline and o-nitro-p-methoxyaniline failed to form the desired enamino-ester under conditions which they reported. 

Nearly every substitution of the aromatic ring has been tolerated for the cyclization step using thermal conditions, while acid-promoted conditions limited the functionality utilized. Substituents included halogens, esters, nitriles, nitro, thio-ethers, tertiary amines, alkyl, ethers, acetates, ketals, and amides. Primary and secondary amines are not well tolerated and poor yield resulted in the cyclization containing a free phenol. The Gould-Jacobs reaction has been applied to heterocycles attached and fused to the aniline. 

---