Nickel oxide, reduction

Figure 9. Enthalpy, entropy diagram of nickel oxide reduction with methane.

The classical reaction of nickel oxide reduction by hydrogen can be considered as a model one. This is because this reaction has been well studied under isothermal conditions, one-step conversion as well as under the diversity of reaction mechanisms. These mechanisms are realized if (i) the nuclei grow with a constant rate (ii) the entire surface of the solid reacts at the same time (iii) in the future, the process is defined by the interface migration rate (iv) an artificial nucleation... 

CaniZZaro Reaction. Both 2- and 4-hydroxybenzaldehydes undergo this self-oxidation—reduction reaction, but much less readily than benzaldehyde the reaction requires metal catalysts such as nickel, cobalt, or silver to yield the corresponding hydroxybenzoic acids and hydroxybenzyl alcohols (47—48). 

In electroless deposition, the substrate, prepared in the same manner as in electroplating (qv), is immersed in a solution containing the desired film components (see Electroless plating). The solutions generally used contain soluble nickel salts, hypophosphite, and organic compounds, and plating occurs by a spontaneous reduction of the metal ions by the hypophosphite at the substrate surface, which is presumed to catalyze the oxidation—reduction reaction. 

Lateritic Ores. The process used at the Nicaro plant in Cuba requires that the dried ore be roasted in a reducing atmosphere of carbon monoxide at 760°C for 90 minutes. The reduced ore is cooled and discharged into an ammoniacal leaching solution. Nickel and cobalt are held in solution until the soflds are precipitated. The solution is then thickened, filtered, and steam heated to eliminate the ammonia. Nickel and cobalt are precipitated from solution as carbonates and sulfates. This method (8) has several disadvantages (/) a relatively high reduction temperature and a long reaction time (2) formation of nickel oxides (J) a low recovery of nickel and the contamination of nickel with cobalt and (4) low cobalt recovery. Modifications to this process have been proposed but all include the undesirable high 760°C reduction temperature (9). 

Methylsuccinic acid has been prepared by the pyrolysis of tartaric acid from 1,2-dibromopropane or allyl halides by the action of potassium cyanide followed by hydrolysis by reduction of itaconic, citraconic, and mesaconic acids by hydrolysis of ketovalerolactonecarboxylic acid by decarboxylation of 1,1,2-propane tricarboxylic acid by oxidation of /3-methylcyclo-hexanone by fusion of gamboge with alkali by hydrog. nation and condensation of sodium lactate over nickel oxide from acetoacetic ester by successive alkylation with a methyl halide and a monohaloacetic ester by hydrolysis of oi-methyl-o -oxalosuccinic ester or a-methyl-a -acetosuccinic ester by action of hot, concentrated potassium hydroxide upon methyl-succinaldehyde dioxime from the ammonium salt of a-methyl-butyric acid by oxidation with. hydrogen peroxide from /9-methyllevulinic acid by oxidation with dilute nitric acid or hypobromite from /J-methyladipic acid and from the decomposition products of glyceric acid and pyruvic acid. The method described above is a modification of that of Higginbotham and Lapworth. ... 

Because of lithium s low density and high standard potential difference (good oxidation reduction characteristics), cells using lithium at the anode have a very high energy density relative to lead, nickel and even zinc. Its high cost limits use to the more sophisticated and expensive electronic equipment. 

Metals are most active when they first deposit on the catalyst. With time, they lose their initial effectiveness through continuous oxidation-reduction cycles. On average, about one third of the nickel on the equilibrium catalyst will have the activity to promote dehydrogenation reactions. 

You might wonder what we would have learned if we had assumed that either of these two cells operates with the reverse reaction. Suppose we had proposed a cell based on oxidation of nickel and reduction of zinc ... 

From the results of other authors should be mentioned the observation of a similar effect, e.g. in the oxidation of olefins on nickel oxide (118), where the retardation of the reaction of 1-butene by cis-2-butene was greater than the effect of 1-butene on the reaction of m-2-butene the ratio of the adsorption coefficients Kcia h/Kwas 1.45. In a study on hydrogenation over C03O4 it was reported (109) that the reactivities of ethylene and propylene were nearly the same (1.17 in favor of propylene), when measured separately, whereas the ratio of adsorption coefficients was 8.4 in favor of ethylene. This led in the competitive arrangement to preferential hydrogenation of ethylene. A similar phenomenon occurs in the catalytic reduction of nitric oxide and sulfur dioxide by carbon monoxide (120a). 

This Study has shown that reasonably uniform platinum crystallites can be made on y-alumlna, and that platinum and palladium can be segregated and maintained In that form for the most part even after exposure to high temperature oxidation-reduction conditions. Highly dispersed clusters of palladium, nickel, cobalt, and Iron can be observed. Cluster size determination could not be accurately made because of the lack of contrast between the cluster and the support. The marginal detectability by EDS for these clusters enabled elemental Identification to be made, however, mass uniformity determinations could not be made. 

In Micro Dumas combustion (CHN analysis) the sample is vaporised and carried by a stream of CO2 over nickel oxide at 1000 °C to oxidise the sample to CO2, H2O and N2. Nickel reduces nitrogen oxides in the heated combustion tube. Carbon monoxide, formed by reduction of CO2 by nickel, is oxidised by passage through hopcalite at 110°C. Traces of... 

The nickel-chromium plating process includes the steps in which a ferrous base material is electroplated with nickel and chromium. The electroplating operations for plating the two metals are basically oxidation-reduction reactions. Typically, the part to be plated is the cathode, and the plating metal is the anode. 

The base was being prepared by distilling a mixture of hydroxylamine hydrochloride and sodium hydroxide in methanol under reduced pressure, and a violent explosion occurred towards the end of distillation [1], probably owing to an increase in pressure above 53 mbar. It explodes when heated under atmospheric pressure [2], Traces of hydroxylamine remaining after reaction with acetonitrile to form acetamide oxime caused an explosion during evaporation of solvent. Traces can be removed by treatment with diacetyl monoxime and ammoniacal nickel sulfate, forming nickel dimethylglyoxime [3], An account of an extremely violent explosion towards the end of vacuum distillation had been published previously [4], Anhydrous hydroxylamine is usually stored at 10°C to prevent internal oxidation-reduction reactions which occur at ambient temperature [5], See other REDOX REACTIONS... 

As in the nickel/silica case, the rate of hydrogen reduction of nickel oxide... 

Morikawa et al. (42) suggest that nickel aluminate itself undergoes hydrogen reduction only to a superficial extent, and then produces extremely small nickel particles as the reduction product. In this circumstance, the nickel particle size distribution in a reduced nickel/alumina catalyst will obviously be much dependent on the preparative details that control the proportions nickel oxide and nickel aluminate and the size of the particles in which these substances exist before reduction. 

Fig. 21. Qualitative analysis of a thermogram recorded during the reduction of nickel oxide by a dose of carbon monoxide at 200°C. The thermogram (1) may be considered as the sum of curves (2), (4), and (5). Curve (3) is the difference between curves (1) and (2). Reprinted from (55) with permission. 

C-C bond formation mediated by silane.6,6a 6f With respect to the development of intramolecular variants, these seminal studies lay fallow until 1990, at which point the palladium- and nickel-catalyzed reductive cyclization of tethered 1,3-dienes mediated by silane was disclosed. As demonstrated by the hydrosilylation-cyclization of 1,3,8,10-tetraene 21a, the /rarcr-divinylcyclopentanes 21b and 21c are produced in excellent yield, but with modest stereoselectivity.46 Bu3SnH was shown to participate in an analogous cyclization.46 Isotopic labeling and crossover experiments provide evidence against a mechanism involving initial diene hydrosilylation. Rather, the collective data corroborate a mechanism involving oxidative coupling of the diene followed by silane activation (Scheme 15). 

---