Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Modeling conditions

Somoza EC, Winhusen TM, Bridge TP, et al An open-label pilot study of methylpheni-date in the treatment of cocaine-dependent patients with adult attention deficit/ hyperactivity disorder. J Addict Dis 23 77—92, 2004 Sora 1, Wichems C, Takahashi N, et al Cocaine reward models conditioned place preference can be established in dopamine- and in serotonin-transporter knockout mice. Proc Natl Acad Sci U S A 95 7699-7704, 1998 Soral, Hall FS, Andrews AM, etal Molecular mechanisms of cocaine reward combined dopamine and serotonin transporter knockouts eliminate cocaine place preference. Proc Nad Acad Sci U S A 98 5300-5305, 2001 Spear J, Alderton D Psychosis associated with prescribed dexamphetamine use 0etter). [Pg.208]

The effects of pH under model conditions (0.6 to 5.5 for 24 hr) were covered by Nielsen et al. for four anthocyanins (3-O-glucoside, glycosylated cyanidin, rutinoside, and delphinidin rutinoside). After 24 hr, over 90% of the anthocyanins were intact up to pH 3.3, while instabihty greatly increased at pH greater than 4.5. [Pg.72]

In later sections, the use of the scaling relationships to design small scale models will be illustrated. For scaling to hold, all of the dimensionless parameters given in Eqs. (36), (37) or (39) must be identical in the scale model and the commercial bed under study. If the small scale model is fluidized with air at ambient conditions, then the fluid density and viscosity are fixed and it will be shown there is only one unique modeling condition which will allow complete similarity. In some cases this requires a model which is too large and unwieldy to simulate a large commercial bed. [Pg.39]

It is worth emphasizing that for the fermionic field, we have antiperi-odic KMS conditions, which when considered in terms of space com-pactification, coincide withthe physical bag-model conditions (A.P.C. Mal-bouisson et.al., 2004 A. Chodos et.ah, 1974 C.A. Lutken et.al., 1988). Such a result will be used in Section 5. Now we will be concerned with the algebraic elements of the thermal theories. [Pg.202]

Molecular-scale micromixing models, conditional scalar Laplacian,... [Pg.44]

Models conditioned on the turbulent dissipation rate attempt to describe non-stationary effects due to the fluctuating strain-rate field, and thus should be adequate for flamelet applications which require a model for the mixture-fraction dissipation rate at the stoichiometric surface. [Pg.291]

This use of Equation 9.10 to relate AUCpo to kdeg is valid under the assumption that only hepatic elimination occurs, well-stirred model conditions and complete absorption occurs in the GI tract. [Pg.220]

Sora 1, Wichems C, Takahashi N, Li XF, Zeng Z, Revay R, Lesch KP, Murphy D L, Uhl GR (1998) Cocaine reward models conditioned place preference can be established in dopamine-and in serotonin-transporter knockout mice. Proc Natl Acad Sci U S A 95 7699-7704... [Pg.111]

Before preparation of any a-halo boronic ester is undertaken, it should be noted that two sets of model conditions are outlined in what follows. If the group R1 of the boronic ester 1 is a typical alkyl group, then the rearrangement of the derived borate complex 2 requires a number of hours at 20 C, but if R1 is aryl or alkenyl, then shorter times and lower temperatures are required in order to avoid epimerization of the product 3 catalyzed by zinc chloride and lithium... [Pg.1086]

O Keeffe (1991Z)) has used bond valences to model the coherent interface that occurs between the semiconductors Si and MSi2 with M = Ni or Co (27139). Although these systems contain Si-Si bonds and therefore do not obey the assumptions of the bond valence model (condition 3.2), the mathematical formalism of the model still works because of the high symmetry. As both Si-Si and Si-Ni bonds are found in NiSi2, the cubic structure is strained (cf. BaTiOs in Section 13.3.2) and this strain affects the structure of the interface. Of the six possible interfacial structures examined, the two with the lowest BSI eqn (12.1) are those that are believed to occur in NiSi2 and CoSi2 respectively, and in both cases the strain introduced at the interface is correctly predicted. [Pg.193]

Motives for the introduction of the new business model Condition of the tendering procedure ... [Pg.90]

Sora, Ichiro, Christine Wichems, Noboyuki Takahashi, Xiao-Fei Li, Zhizhen Zeng, Randal Revay, Klaus-Peter Lesch, Dennis L. Murphy, and George R. Uhl. 1998- "Cocaine Reward Models Conditioned Place Preference can be Established in Dopamine- and in Serotonin-Transporter Knockout Mice." Proceedings of the National Academy of Sciences of the United States of America 95 7699-7704. [Pg.114]

Gol dshtein, V. M., Sobolev, V. A. Yablonskii, G. S. 1986 Relaxation self-oscillations in chemical kinetics a model, conditions for realization. Chem. Engng Sci. 41 (11), 2761-2766. [Pg.306]

Estimates from logistic regression models, conditioned on sex, age, study center, and adjusted for education, alcohol consumption, tobacco smoking, body mass index, and nonalcohol energy intake. b Reference category. [Pg.475]

In Example 2.26, we have obtained the linear regression model for dynamic viscosity y, P, as a function of mixing speed X3, min"1 and mixing time X2, min of composite rocket propellant. To determine the conditions of minimal viscosity, a method of steepest ascent has been applied. This method has defined the local optimum region that has to be described by a second-order model. Conditions of the factor variations are shown in Table 2.146. [Pg.335]

Fig. 9.9. Film mass increment during one cycle. Comparison of modeling results (dashed line) with the experimental data. Modeling conditions correspond to experimental conditions in Ref. [93]. Fig. 9.9. Film mass increment during one cycle. Comparison of modeling results (dashed line) with the experimental data. Modeling conditions correspond to experimental conditions in Ref. [93].
Table 2. Model conditions and assumptions used in the single tube example... Table 2. Model conditions and assumptions used in the single tube example...
Various types of studies exist on the different pesticide regimes applied to genetically modified crops, including field trials and farmer surveys. Field trials represent model conditions and model practices, and would render results for our study that are not fully representative for the impact of GM crops on pesticide usage in practice. Therefore, preference is given to studies on the real-practice use of pesticides in GM crops, including farmer surveys. [Pg.307]

For the monodimensional model, only initial conditions are requested. The following data express the initial model conditions and definition functions for relations (3.49) and (3.50) ... [Pg.56]

These model conditional densities can then be averaged over the alkyl configurations sampled from simulation. The results of Fig. 1.9 show this exercise to be... [Pg.21]


See other pages where Modeling conditions is mentioned: [Pg.269]    [Pg.72]    [Pg.305]    [Pg.78]    [Pg.395]    [Pg.195]    [Pg.63]    [Pg.206]    [Pg.294]    [Pg.602]    [Pg.19]    [Pg.81]    [Pg.226]    [Pg.97]    [Pg.498]    [Pg.35]    [Pg.13]    [Pg.69]    [Pg.390]    [Pg.1]    [Pg.146]    [Pg.54]    [Pg.348]    [Pg.166]    [Pg.294]   


SEARCH



3 conditions 2 growth model

Animal models dosing conditions

Boundary conditions axial-dispersion model

Boundary conditions dilatancy modelling

Boundary conditions dispersion models

Boundary conditions effective diffusivity model

Boundary conditions pseudo homogeneous model

Boundary conditions, axial dispersion model reactors)

Boundary conditions, cylindrical pore model

Case study prediction of permeate flux decay during ultrafiltration performed in pulsating conditions by a hybrid neural model

Case study prediction of permeate flux decay during ultrafiltration performed in pulsating conditions by a neural model

Complex Crystallization Conditions General Models

Computational model boundary conditions

Conditional acceleration models

Conditional diffusion models

Conditional models

Conditional models

Conditional models independence model

Critical thickness condition for the model system

Deterministic models boundary conditions

Dirichlet boundary condition diffusion modeling

Experimental Conditions for Appropriate Kinetic Modeling

Fluid model equations boundary conditions

Fractionation models conditions

Initial conditions, dispersion model

Mass transfer model equations boundary conditions

Mitigation effectiveness, examples modeling conditions

Model Catalysts Under Ambient and Applied Conditions

Model conditioning

Model conditioning

Model conditions

Model conditions

Modeling boundary conditions

Models boundary conditions

Models initial conditions

Multi-environment conditional PDF models

Numerical modelling boundary conditions

Numerical modelling conditions

Operant Conditioning model of environmental processes and their effect on behavior

Periodic Boundary Conditions and Slab Models

Physical model, glass polymers conditioning

Reaction conditions reactor modeling

Resonance condition model components

Segregation model boundary conditions

Site-specific conditions modeling

Site-specific conditions modeling consequence screening

Stability condition EMMS model

Steady-state model boundary conditions

Two-Component Anionic Lipid Models with Sink Condition in the Acceptor Compartment

© 2024 chempedia.info