Ketones from enolates

The selective intermolecular addition of two different ketones or aldehydes can sometimes be achieved without protection of the enol, because different carbonyl compounds behave differently. For example, attempts to condense acetaldehyde with benzophenone fail. Only self-condensation of acetaldehyde is observed, because the carbonyl group of benzophenone is not sufficiently electrophilic. With acetone instead of benzophenone only fi-hydroxyketones are formed in good yield, if the aldehyde is slowly added to the basic ketone solution. Aldols are not produced. This result can be generalized in the following way aldehydes have more reactive carbonyl groups than ketones, but enolates from ketones have a more nucleophilic carbon atom than enolates from aldehydes (G. Wittig, 1968). 

A useful catalyst for asymmetric aldol additions is prepared in situ from mono-0> 2,6-diisopropoxybenzoyl)tartaric acid and BH3 -THF complex in propionitrile solution at 0 C. Aldol reactions of ketone enol silyl ethers with aldehydes were promoted by 20 mol % of this catalyst solution. The relative stereochemistry of the major adducts was assigned as Fischer- /ir o, and predominant /i -face attack of enol ethers at the aldehyde carbonyl carbon atom was found with the (/ ,/ ) nantiomer of the tartaric acid catalyst (K. Furuta, 1991). 

Hydroperoxides have been obtained from the autoxidation of alkanes, aralkanes, alkenes, ketones, enols, hydrazones, aromatic amines, amides, ethers, acetals, alcohols, and organomineral compounds, eg, Grignard reagents (10,45). In autoxidations involving hydrazones, double-bond migration occurs with the formation of hydroperoxy—azo compounds via free-radical chain processes (10,59) (eq. 20). 

The idea of kinetic versus thermodynamic control can be illustrated by discussing briefly the case of formation of enolate anions from unsymmetrical ketones. This is a very important matter for synthesis and will be discussed more fully in Chapter 1 of Part B. Most ketones, highly symmetric ones being the exception, can give rise to more than one enolate. Many studies have shown tiiat the ratio among the possible enolates that are formed depends on the reaction conditions. This can be illustrated for the case of 3-methyl-2-butanone. If the base chosen is a strong, sterically hindered one and the solvent is aptotic, the major enolate formed is 3. If a protic solvent is used or if a weaker base (one comparable in basicity to the ketone enolate) is used, the dominant enolate is 2. Enolate 3 is the kinetic enolate whereas 2 is the thermodynamically favored enolate. 

Interestingly, the product actually isolated from alkyne hydration is not the vinylic alcohol, or enol (ene + ol), but is instead a ketone. Although the enol is an intermediate in the reaction, it immediately rearranges to a ketone by a process called keto-enol tautomerisni. The individual keto and enol forms are said to be tautomers, a word used to describe constitutional isomers that interconvert rapidly. With few exceptions, the keto-enol tautomeric equilibrium lies on the side of the ketone enols are almost never isolated. We ll look more closely... 

The asymmetric Michael addition of chiral nonracemic ketone enolates has most frequently been used as part of the Robinson annulation methodology in the synthesis of natural products171-172. The enolates are then derived from carbocyclic chiral ketones such as (+)-nopinone, (-)-dihydrocarvone, or (-)-3-methylsabinaketone. 

Route (b) offers a short cut since the reaction between (5) and PhCHO under dehydrating conditions needs no control as (3) is the only possible enone from a ketone enolate attacking the more reactive aldehyde (p T 167). The Michael reaction is also better by this route as explained on p T 171, This is the published synthesis. 

After succeeding in the asymmetric reductive acylation of ketones, we ventured to see if enol acetates can be used as acyl donors and precursors of ketones at the same time through deacylation and keto-enol tautomerization (Scheme 8). The overall reaction thus corresponds to the asymmetric reduction of enol acetate. For example, 1-phenylvinyl acetate was transformed to (f )-l-phenylethyl acetate by CALB and diruthenium complex 1 in the presence of 2,6-dimethyl-4-heptanol with 89% yield and 98% ee. Molecular hydrogen (1 atm) was almost equally effective for the transformation. A broad range of enol acetates were prepared from ketones and were successfully transformed into their corresponding (7 )-acetates under 1 atm H2 (Table 19). From unsymmetrical aliphatic ketones, enol acetates were obtained as the mixtures of regio- and geometrical isomers. Notably, however, the efficiency of the process was little affected by the isomeric composition of the enol acetates. 

The equilibrium ratios of enolates for several ketone-enolate systems are also shown in Scheme 1.1. Equilibrium among the various enolates of a ketone can be established by the presence of an excess of ketone, which permits reversible proton transfer. Equilibration is also favored by the presence of dissociating additives such as HMPA. The composition of the equilibrium enolate mixture is usually more closely balanced than for kinetically controlled conditions. In general, the more highly substituted enolate is the preferred isomer, but if the alkyl groups are sufficiently branched as to interfere with solvation, there can be exceptions. This factor, along with CH3/CH3 steric repulsion, presumably accounts for the stability of the less-substituted enolate from 3-methyl-2-butanone (Entry 3). 

The preparation of ketones and ester from (3-dicarbonyl enolates has largely been supplanted by procedures based on selective enolate formation. These procedures permit direct alkylation of ketone and ester enolates and avoid the hydrolysis and decarboxylation of keto ester intermediates. The development of conditions for stoichiometric formation of both kinetically and thermodynamically controlled enolates has permitted the extensive use of enolate alkylation reactions in multistep synthesis of complex molecules. One aspect of the alkylation reaction that is crucial in many cases is the stereoselectivity. The alkylation has a stereoelectronic preference for approach of the electrophile perpendicular to the plane of the enolate, because the tt electrons are involved in bond formation. A major factor in determining the stereoselectivity of ketone enolate alkylations is the difference in steric hindrance on the two faces of the enolate. The electrophile approaches from the less hindered of the two faces and the degree of stereoselectivity depends on the steric differentiation. Numerous examples of such effects have been observed.51 In ketone and ester enolates that are exocyclic to a conformationally biased cyclohexane ring there is a small preference for... 

The first element of stereocontrol in aldol addition reactions of ketone enolates is the enolate structure. Most enolates can exist as two stereoisomers. In Section 1.1.2, we discussed the factors that influence enolate composition. The enolate formed from 2,2-dimethyl-3-pentanone under kinetically controlled conditions is the Z-isomer.5 When it reacts with benzaldehyde only the syn aldol is formed.4 The product stereochemistry is correctly predicted if the TS has a conformation with the phenyl substituent in an equatorial position. 

A similar preference for formation of the syn aldol is found for other Z-enolates derived from ketones in which one of the carbonyl substituents is bulky. Ketone enolates with less bulky substituents show a decreasing stereoselectivity in the order r-butyl > i-propyl > ethyl.2c This trend parallels a decreasing preference for stereoselective formation of the Z-enolate. 

From these and many related examples the following generalizations can be made about kinetic stereoselection in aldol additions of lithium enolates. (1) The chair TS model provides a basis for analyzing the stereoselectivity observed in aldol reactions of ketone enolates having one bulky substituent. The preference is Z-enolate syn aldol /(-enolate anti aldol. (2) When the enolate has no bulky substituent, stereoselectivity is low. (3) Z-Enolates are more stereoselective than /(-enolates. Table 2.1 gives some illustrative data. 

Summary of the Relationship between Diastereoselectivity and the Transition Structure. In this section we considered simple diastereoselection in aldol reactions of ketone enolates. Numerous observations on the reactions of enolates of ketones and related compounds are consistent with the general concept of a chairlike TS.35 These reactions show a consistent E - anti Z - syn relationship. Noncyclic TSs have more variable diastereoselectivity. The prediction or interpretation of the specific ratio of syn and anti product from any given reaction requires assessment of several variables (1) What is the stereochemical composition of the enolate (2) Does the Lewis acid promote tight coordination with both the carbonyl and enolate oxygen atoms and thereby favor a cyclic TS (3) Does the TS have a chairlike conformation (4) Are there additional Lewis base coordination sites in either reactant that can lead to reaction through a chelated TS Another factor comes into play if either the aldehyde or the enolate, or both, are chiral. In that case, facial selectivity becomes an issue and this is considered in Section 2.1.5. 

Scheme 2.11 shows some examples of Robinson annulation reactions. Entries 1 and 2 show annulation reactions of relatively acidic dicarbonyl compounds. Entry 3 is an example of use of 4-(trimethylammonio)-2-butanone as a precursor of methyl vinyl ketone. This compound generates methyl vinyl ketone in situ by (3-eliminalion. The original conditions developed for the Robinson annulation reaction are such that the ketone enolate composition is under thermodynamic control. This usually results in the formation of product from the more stable enolate, as in Entry 3. The C(l) enolate is preferred because of the conjugation with the aromatic ring. For monosubstituted cyclohexanones, the cyclization usually occurs at the more-substituted position in hydroxylic solvents. The alternative regiochemistry can be achieved by using an enamine. Entry 4 is an example. As discussed in Section 1.9, the less-substituted enamine is favored, so addition occurs at the less-substituted position. 

Lead tetraacetate can effect oxidation of carbonyl groups, leading to formation of a-acetoxy ketones,215 but the yields are seldom high. Boron trifluoride can be used to catalyze these oxidations. It is presumed to function by catalyzing the formation of the enol, which is thought to be the reactive species.216 With unsymmetrical ketones, products from oxidation at both a-methylene groups are found.217... 

A lower molecular weight methyl ketone and an olefin are isolated as products of this reaction. That the enol is formed as a primary product which rearranges to the ketone follows from its detection in the IR spectrum of gaseous 2-pentanone upon photolysis. 3 In addition to the ketone and olefinic products, one usually obtains varying amounts of cyclobutanols. 

A convenient and general method has been developed for the synthesis of alkylpyrroles starting from ketones and nitroalkenes via reduction of the intermediate acetic nitronic anhydride as shown in Eq. 10.1. Ketone enolates react with a variety of nitroalkenes to yield the Michael adducts, lithium nitronates, which are trapped with acetic anhydride to give the corresponding acetic nitronic anhydrides. The acetic nitronic anhydrides are easily converted into alkylpyrroles by reduction with Zn(Cu).3... 

Interestingly, we were intrigued by the ESI mass spectrum of the compound, as the observed base peak consisted of [M-S02+Na]+. This led us to explore a thermal retro-Diels-Alder reaction that could afford the desired enone 69. It is noteworthy that the chemistry of cyclic enol-sulfites would appear to be an under-explored area with a few references reporting their isolation being found [57]. At last, we were also able to prepare epoxy ketone 70 from 69 in three steps, albeit epoxidation did not take place unless the TES group was removed. Spartan models reaffirmed our initial conformational assessment of enone 69 and epoxy ketone 70, which contain sp3-hybridized C8a and s/r-hybridized C8b (p s e u d o-. v/r - h y b r i d i zed C8b for 70) at the AB-ring junction (Fig. 8.12) and displayed the desired twisted-boat conformation in A-ring. 

Toullec, 1982). The values of log/C in water at 25°C have been estimated for acetone as —7.02 and acetophenone as —6.63 (Guthrie, 1979). However, the pKa-values of the ketones ionizing from the ketone to the enolate according to (4) have been measured, using either an acidity function method... 

In reactions with azides, ketones are directly converted to 5-hydroxytriazolines. Ketone enolate 247, generated by treatment of norbornanone 246 with LDA at 0°C, adds readily to azides to provide hydroxytriazolines 248 in 67-93% yield. Interestingly, l-azido-3-iodopropane subjected to the reaction with enolate 247 gives tetracyclic triazoline derivative 251 in 94% yield. The reaction starts from an electrophilic attack of the azide on the ketone a-carbon atom. The following nucleophilic attack on the carbonyl group in intermediate 249 results in triazoline 250. The process is completed by nucleophilic substitution of the iodine atom to form the tetrahydrooxazine ring of product 251 (Scheme 35) <2004JOC1720>. 

A jy -diastereoselective aldol reaction based on titanium enolates from (A)-l-benzyloxy-2-methyl-3-pentanone was developed by Solsona et al. (Equation (12)).64 The titanium enolate of this chiral ketone afforded the corresponding syn-syn aldol adducts in high yields and diastereomeric ratios with a broad range of aldehydes. 

TABLE 3 5. Reaction of Aldehydes with the Enolate from Diethyl Ketone and Bromoborane (R,R)-55b... 

---