Iron complexes transition

Aminoboranes have been used as ligands in complexes with transition metals (66) in one instance giving a rare example of two-coordinate, non-t/ transition-metal complexes. The molecular stmcture of the iron complex Fe[N(Mes)B(Mes)2]2 where Mes = is shown in Figure 1. The... 

Other Reactions. Due to the highly reactive conjugated double bonds, butadiene can undergo many reactions with transition metals to form organometaHic complexes. For instance, iron pentacarbonyl reacts with butadiene to produce the tricarbonyl iron complex (10) (226). This and many other organometaHic complexes have been covered (227). 

Figure 4. The calculated spectrum of the complex after a Lorentzian band convolution. Region I is dominated by bridging-sulfur-to-iron CT transitions, while region II is mostly due to organic-sulfur-to-iron electron transitions. Regions I and II are explained in a MO diagram. The vertical lines correspond to the experimental bands observed in the absorption spectrum of the [Fe2 (J. - S2) P o - CqH4S) ) ] complex, from Reference 1.

This chapter treats iron complexes with Fe-H bond(s). An H ligand on a transition metal is named in two ways, hydride and hydrido. The term hydrido is recommended to be used for hydrogen coordinating to all elements by lUPAC recommendations 2005 [1], However, in this chapter, the term hydride is used because it has been widely accepted and used in many scientific reports. 

Table 2 Comparison of iron complexes with transition precious-metal catalysts for the hydrogenation of 1-hexene...

Transition-metal catalyzed photochemical reactions for hydrogen generation from water have recently been investigated in detail. The reaction system is composed of three major components such as a photosensitizer (PS), a water reduction catalyst (WRC), and a sacrificial reagent (SR). Although noble-metal complexes as WRC have been used [214—230], examples for iron complexes are quite rare. It is well known that a hydride as well as a dihydrogen (or dihydride) complex plays important roles in this reaction. 

Cycloaddition of aUcynes catalysed by transition metals is one of the most efficient and valuable ways to prepare benzene and pyridine systems [12], Among the possible catalytic systems able to catalyse this reaction, cobalt and iron complexes containing NHCs as ligands have shown high catalytic activity in the intramolecular cyclotrimerisation of triynes 36 (Scheme 5.10) [13]. The reaction was catalysed with low loading of a combination of zinc powder and CoC or FeClj with two or three equivalents of IPr carbene, respectively. 

A unique situation is encountered if Fe-M6ssbauer spectroscopy is applied for the study of spin-state transitions in iron complexes. The half-life of the excited state of the Fe nucleus involved in the Mossbauer experiment is tj/2 = 0.977 X 10 s which is related to the decay constant k by tj/2 = ln2/fe. The lifetime t = l//c is therefore = 1.410 x 10 s which value is just at the centre of the range estimated for the spin-state lifetime Tl = I/Zclh- Thus both the situations discussed above are expected to appear under suitable conditions in the Mossbauer spectra. The quantity of importance is here the nuclear Larmor precession frequency co . If the spin-state lifetime Tl = 1/feLH is long relative to the nuclear precession time l/co , i.e. Tl > l/o) , individual and sharp resonance lines for the two spin states are observed. On the other hand, if the spin-state lifetime is short and thus < l/o) , averaged spectra with intermediate values of quadrupole splitting A q and isomer shift 5 are found. For the intermediate case where Tl 1/cl , broadened and asymmetric resonance lines are obtained. These may be the subject of a lineshape analysis that will eventually produce values of rate constants for the dynamic spin-state inter-conversion process. The rate constants extracted from the spectra will be necessarily of the order of 10 -10 s"F... 

The nitrosyl iron complex Fe( J-mph) NO shows a spin-state transition between the S = f and S = ground states. The structure of the complex is characterized by ... 

In summary, the fragmentary evidence at hand suggests that sulfur was the primordial iron complexing material and that this ligand system was selectively modified by stepwise transition to a mixed sulfur-nitrogen and sulfur-oxygen and, finally, to an all-oxygen type of coordination. 

Copper catalyzes the decomposition of sulphonyl azides in benzene very slowly. When methanesulphonyl azide was boiled under reflux in benzene solution in the presence of an excess of freshly reduced copper powder, some decomposition occurred to give methanesulphonamide and azide was recovered 78>. Transition metal complexes have been found to exert a marked effect upon the yields of products and isomer ratios formed in the thermal decomposition of methanesulphonyl azide in methyl benzoate and in benzotrifluoride 36>. These results will be discussed in detail in the section on the properties of sulphonyl nitrenes and singlet and triplet behaviour. A sulphonyl nitrene-iron complex has recently been isolated 37> and more on this species will be reported soon. 

A suitable model for the oxygen carrier protein hemerythrin is [Fe2(Et-HPTB)(OBz)](BF4)2 (Et-HPTB = AWAT,iV -tetrakis[(N-ethyl-2-benzimidazolyl)methyl]-2-hydroxy-l,3-diaminopropane, OBz = benzoate). It can mimic the formation of a binuclear peroxo iron complex in the natural system (101). The measured value of -12.8 cm3 mol1 for the activation volume of the oxidation reaction together with the negative value of the activation entropy confirm the highly structured nature of the transition state. 

We do not know exactly where the hydrogen binds at the active site. We would not expect it to be detectable by X-ray diffraction, even at 0.1 nm resolution. EPR (Van der Zwaan et al. 1985), ENDOR (Fan et al. 1991b) and electron spin-echo envelope modulation (ESEEM) (Chapman et al. 1988) spectroscopy have detected hyperfine interactions with exchangeable hydrous in the NiC state of the [NiFe] hydrogenase, but have not so far located the hydron. It could bind to one or both metal ions, either as a hydride or H2 complex. Transition-metal chemistry provides many examples of hydrides and H2 complexes (see, for example. Bender et al. 1997). These are mostly with higher-mass elements such as osmium or ruthenium, but iron can form them too. In order to stabilize the compounds, carbonyl and phosphine ligands are commonly used (Section 6). 

---