Interiors coated fabrics

Water-borne adhesives are preferred because of restrictions on the use of solvents. Low viscosity prepolymers are emulsified in water, followed by chain extension with water-soluble glycols or diamines. As cross-linker PMDI can be used, which has a shelf life of 5 to 6 h in water. Water-borne polyurethane coatings are used for vacuum forming of PVC sheeting to ABS shells in automotive interior door panels, for the lamination of ABS/PVC film to treated polypropylene foam for use in automotive instmment panels, as metal primers for steering wheels, in flexible packaging lamination, as shoe sole adhesive, and as tie coats for polyurethane-coated fabrics. PMDI is also used as a binder for reconstituted wood products and as a foundry core binder. 

ORIGIN/INDUSTRY SOURCES/USES nitrocellulose lacquers elastomers explosives nail polish solid rocket propellants makes plastics soft and flexible shower curtains raincoats food wraps bowls car interiors vinyl fabrics floor tiles perfume fixative textile lubricating agent safety glass insecticides printing inks paper coatings adhesives organic chemical industry... 

The fogging characteristics of rubber or plastics coated fabrics for the use in the interior of motor vehicles can be determined. The procedure excludes materials which produce condensates of low surface tension, which coalesce into a thin transparent film and materials which contain very large concentrations of volatiles, which causes the droplets to coalesce and form a clear film. Flat-bottomed glass beakers closed on the top with ground... 

ISO. ISO 6452 2007—Rubber- or plashcs-coated fabrics—Determinahon of fogging characterishes of trim materials in the interior of automobiles. Geneva International Organi-zahon for Standardizahon 2007. 

Automotive interior door panels often use PVC latex as a binder for a high-loft fabric bonded to a backing board. This is then covered with vinyl-coated fabric, and the entire assembly placed in a dielectric sealing press, where it is both heat-sealed and embossed. PVC latex-coated paperboard stock also finds use in various packaging applications. When PVC latex is used to saturate, rather than coat, paper-board, the products are suitable for preparation of molded mats. 

Reduction of liquid coatings All interior skins, coated fabrics —Originate in German OEMs (e.g., Audi) —Unfavorable for TPO skins... 

Elydrocarbon emission reduction Interior skins, coated fabrics —Favors non-PVC skins/coated fabrics —Adjustment of spray PU and TPU formulas... 

Recommended for products films, coated fabrics, car interiors ... 

Quadraxially oriented (four directional layer) glass fabric-TS vinyl ester polyester RP sheet panels with a foam core and gel coating are used. Most of the panels are 3 mm thick with molded-in rib structure supports. Body skins are bonded to the chassis with a double-stick acrylic tape developed by 3M Co. as well as mechanical fasteners. Unlike most steel designs, no B-pillar structural component between the front and rear doors is required thus providing more interior space and easy entry since doors open in opposite directions. 

Capillary column A small-diameter chromatographic column for GC or HPLC, fabricated of metal, glass, or fused silica. For GC, the stationary phase is a thin coating of liquid on the interior wall of the tube for HPLC, capillary columns are often packed. Capillary constant The product where m is the mass of... 

---