Laser-induced fluorescence emission

The mby fluorescence emission is induced by laser excitation and can be revealed through a monochromator and a CCD detector. The wavelength and the power of the laser excitation are not restrictive at low pressure, and even few milliwatts of the 647.1-nm excitation line of a Kr ion laser can induce an easily detectable fluorescence emission. Any lower wavelength can be used as well. Typical exciting laser fines used are the 488- and 514.5-nm emissions of an Ar ion laser. Things are more complicated at pressures of 100 GPa, where the mby signal decreases in intensity and the two components are unresolved [235, 248-251]. Recently, it has been demonstrated by means of x-ray diffraction that... 

Another technique that uses the fluorescence properties of trivalent lanthanides is that of the detection of fluorescence emission decay induced by pulsed dye laser excitation. Horrocks and Sudnick (17) have applied this technique to the study of water molecules bound to metal ions in small complexes and proteins. In one study they found that the exponential decay of Tb3+ fluorescence is altered when H20 is replaced by D20 and that this change can be used to determine the number of coordinated water molecules on the metal ion. With thermolysin, bound Tb3+ had 1-2 water molecules in the first coordination shell. This number is consistent with the x-ray structure. 

In this section, some case studies will be presented on the characterization of CMP pad and slurry [17-20] using such advanced analytical techniques as dynamic mechanical analysis (DMA), modulated differential scanning calorimetry (MDSC), thermal gravimetric analysis (TGA), thermal mechanical analysis (TMA), dynamic rheometry, dual emission laser induced fluorescence (DELIF), and the dynamic nuclear magnetic resonance (DNMR). More specifically, these techniques were used to characterize (a) the effect of heat... 

Pad-Wafer Contact and Slurry Transport Dual Emission Laser Induced Fluorescence... 

Graphite furnace AAS Atomic fluorescence spectroscopy Inductively-coupled-plasma optical-emission spectroscopy Glow-discharge optical-emission spectroscopy Laser-excited resonance ionization spectroscopy Laser-excited atomic-fluorescence spectroscopy Laser-induced-breakdown spectroscopy Laser-induced photocoustic spectroscopy Resonance-ionization spectroscopy... 

In laser vaporisation experiments, generating a plume , the laser s frequency may be synchronised with the resonance line of the element (analyte) to be analysed. The basic principles are (i) absorption of the radiation by the analyte (LAAS laser atomic absorption spectrometry) (ii) fluorescence (LIE, laser-induced fluorescence LEAFS) or (Hi) production of ionisation products (ions and electrons). LIF is an analytical method of high precision that is suitable for the measurement of diatomic species in the plume. Excitation spectroscopy or laser-excited fluorescence is not concerned with the spectral composition of the fluorescence but with how the overall intensity of emission varies with the wavelength of excitation. 

The most widely employed optical method for the study of chemical reaction dynamics has been laser-induced fluorescence. This detection scheme is schematically illustrated in the left-hand side of figure B2.3.8. A tunable laser is scanned tlnough an electronic band system of the molecule, while the fluorescence emission is detected. This maps out an action spectrum that can be used to detemiine the relative concentrations of the various vibration-rotation levels of the molecule. 

Neutron Activation Analysis X-Ray Fluorescence Particle-Induced X-Ray Emission Particle-Induced Nuclear Reaction Analysis Rutherford Backscattering Spectrometry Spark Source Mass Spectrometry Glow Discharge Mass Spectrometry Electron Microprobe Analysis Laser Microprobe Analysis Secondary Ion Mass Analysis Micro-PIXE... 

In order to relate material properties with plasma properties, several plasma diagnostic techniques are used. The main techniques for the characterization of silane-hydrogen deposition plasmas are optical spectroscopy, electrostatic probes, mass spectrometry, and ellipsometry [117, 286]. Optical emission spectroscopy (OES) is a noninvasive technique and has been developed for identification of Si, SiH, Si+, and species in the plasma. Active spectroscopy, such as laser induced fluorescence (LIF), also allows for the detection of radicals in the plasma. Mass spectrometry enables the study of ion and radical chemistry in the discharge, either ex situ or in situ. The Langmuir probe technique is simple and very suitable for measuring plasma characteristics in nonreactive plasmas. In case of silane plasma it can be used, but it is difficult. Ellipsometry is used to follow the deposition process in situ. 

The general principle of detection of free radicals is based on the spectroscopy (absorption and emission) and mass spectrometry (ionization) or combination of both. An early review has summarized various techniques to detect small free radicals, particularly diatomic and triatomic species.68 Essentially, the spectroscopy of free radicals provides basic knowledge for the detection of radicals, and the spectroscopy of numerous free radicals has been well characterized (see recent reviews2-4). Two experimental techniques are most popular for spectroscopy studies and thus for detection of radicals laser-induced fluorescence (LIF) and resonance-enhanced multiphoton ionization (REMPI). In the photochemistry studies of free radicals, the intense, tunable and narrow-bandwidth lasers are essential for both the detection (via spectroscopy and photoionization) and the photodissociation of free radicals. 

In addition to measuring total recombination coefficients, experimentalists seek to determine absolute or relative yields of specific recombination products by emission spectroscopy, laser induced fluorescence, and optical absorption. In most such measurements, the products suffer many collisions between their creation and detection and nothing can be deduced about their initial translational energies. Limited, but important, information on the kinetic energies of the nascent products can be obtained by examination of the widths of emitted spectral lines and by... 

Figure 11.26. Alexandrite fluorescence intensity vs. temperature. = data for fluorescence emission at low-energy broadband X > 695 nm) induced by 670-nm laser diode.

Fig. 6 Free-solution CE separation of PNA/DNA hybrid from excess PNA probe. M13 mpl8 ssDNA 4.2 X 10-8 M, and PNA probe 1.3 X 10-7 M. Detection LIF 488/520 nm. Buffer TBE, 7 M urea (pH 8.0). CE conditions 50-mm-i.d. polyacrylamide-coated capillary (27 cm in length and 20 cm to detector), 10 s gravity injection, separation voltage — 10 kV. Laser-induced fluorescence detection with excitation at 488 nm and emission at 520 nm. The buffer contained Triszborate (pH 8.0) with 7 M urea buffer. (From Ref. 37.)...

Time-resolved luminescence spectroscopy may be extremely effective in minerals, many of which contain a large amount of emission centers simultaneously. With the steady state technique only the mostly intensive centers are detected, while the weaker ones remain unnoticed. Fluorescence in minerals is observed over time range of nanoseconds to milliseconds (Table 1.3) and this property was used in our research. Thus our main improvement is laser-induced time-resolved spectroscopy in the wide spectral range from 270 to 1,500 nm, which enables us to reveal new luminescence centers in minerals previously hidden by more intensive centers. 

Relatively recently, AIS Sommer GmbH of Germany delivered a laser-induced fluorescence (LIP) analyzer for quality control in minerals and mineral processing (Broicher 2000). The LIP analyzer includes two light detector systems with three photomultipliers each, which evaluate three spectral bands in two time windows each. It was done in the Kiruna phosphorous iron ore mine, Sweden. The limitation of LIP analysis is that its accuracy depends on the complexity of the composition of the ore and the concentration and fluorescence properties of the critical minerals in relation to all the other minerals present. The phosphorous iron ore in Kiruna is ideal for LIP analyzes, because its iron minerals are practically non-luminescent, while magmatic apatite is strongly fluorescent with intensive emissions of Ce and Eu ". ... 

Laser-induced fluorescence or detection of fluorescence emission in the packing is utilized in capillary LC. 

Some of the most powerful tools for in situ discharge diagnostics are optical (62). Plasma-induced emission spectroscopy, laser-induced fluorescence, laser absorption, and laser optogalvanic spectroscopy have all been... 

---