Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Evaluation of parameters

Evaluation of Parameters.—The quantitymay be calculated from the rate of polymerization and the concentrations of monomer and initiator, for according to Eq. (12) [Pg.122]

If the rate constant kd for the spontaneous decomposition of the inhibitor is known, and its efficiency has been established, the important ratio kl/kt may then be evaluated. With greater generality, Eq. (8) may be combined with (12) to give [Pg.122]

Ri may be evaluated from the rate of decomposition of the initiator supplemented by knowledge of the efficiency /, or from the rate of consumption of an inhibitor when added to the system under conditions otherwise identical with those giving the rate Rp in the absence [Pg.122]

Monomer Initiator Method for assigning initiation rate Temp. C kl/k,)XW l./mole/sec. Bef. [Pg.122]

Expressing the rate constant according to the Arrhenius equation, [Pg.123]

There exist several methods or lines of evidence to demonstrate whether or not natural attenuation is occurring. Because sites can vary dramatically in their complexity and amount of effort required, the level of documentation that can be reasonably obtained will vary. What is important is that because many impacted sites will be or are difficult to clean up completely to the satisfaction of all parties, the use of natural attenuation will likely be at minimum considered at some stage of the project or remedial action. It is thus prudent to generate evidence and documentation to assess the suitability of natural attenuation as part of the site subsurface characterization process. [Pg.411]

The fundamental parameters for evaluation of natural attenuation can be divided into four general groups (Table 13.3)  [Pg.411]

Primary Parameters for Evaluation of Natural Attenuation as a Remedial Strategy [Pg.412]

Moisture content/field capacity Depth to impacted (contaminated) area Groundwater depth Dissolved oxygen Soil gas [Pg.412]

Extent of contamination/plume stability Hydrocarbon type Chromatographic evidence Hydrocarbon concentration Soil pH [Pg.412]


Because of the diversity of the used equipment for the evaluation of parameters setting, we can ask about the testing conditions allowing a reproducibility of the results and the obtaining... [Pg.635]

E. Rohde, A. J. Tomlinson, D. H. Johnson and S. Naylor, Protein analysis by membrane preconcenti ation-capillaiy electi ophoresis systematic evaluation of parameters affecting preconcenti ation and separation , 7. Chromatogr. 6 713 301-311 (1998). [Pg.301]

ILLUSTRATION 6.2 EVALUATION OF PARAMETERS IN A MATHEMATICAL MODEL OF POROUS CATALYSTS... [Pg.194]

Reproductive Effects. No studies of reproductive effects in humans were located. In animals, hexachloroethane adversely affected fertility following oral exposure, but no effects were reported following inhalation exposure (Weeks et al. 1979). The absence of quantitative data on reproductive parameters, as well as evaluation of parameters that are pertinent to the assessment of reproductive risk, precludes any meaningful determination of the potential for hexachloroethane to cause adverse effects on human reproduction. [Pg.92]

K23. Koltringer, P., and Jurgens, G., A dominant role of lipoprotein(a) in the investigation and evaluation of parameters indicating the development of cervical atherosclerosis. Atherosclerosis (Shannon, Irel.) 58, 187-198 (1985). [Pg.123]

We compare results of the present treatment of GaH with those published elsewhere. From measurements of absorption spectra of Ga H and Ga H [91], parameters of type A i were evaluated for separate isotopic variants. After further measurements of also Ga H and Ga H, parameters of type for the latter species and of types Bki and A i common to all four variants were reported [92]. Our first analysis [101] of spectra of GaH was based on only absorption spectra, 208 lines reported in two papers [91,92] although it resulted in evaluation of parameters of essentially empirical radial functions, similar to V(z), V (z) and gj.(z) in formula 29, the treatment was hampered by both paucity of data and incompletely developed theory. After publication of data from emission spectra [93], a subsequent reanalysis [89] demonstrated the possibility of evaluation of... [Pg.284]

S.P.A. Sauer, J. Oddershede, J.F. Ogilvie, Evaluation of parameters in radial functions from rotational and vibration-rotational spectra and calculation of rotational and vibrational g... [Pg.316]

Aside a few specimens with predominantly kinematical scattering, many specimens investigated by EDSA show pronounced d5mamical scattering. In these cases suitable corrections must be applied to link lOhki I and observed Ihki- For the latter case one has to use successive approximations, i.e. evaluation of parameters from weak kinematical reflections which are then used to apply dynamical corrections to strong dynamical reflections. Without such corrections the residual / -factor of the structure amplitudes is usually about 20 % or more, while suitable corrections lead to / -factors in the range of 5 - 2 %. [Pg.104]

Jansson, B. (1984b) Evaluation of parameters in thermochemical models using different types of experimental data simultaneously , TRITA-MAC-0234, Division of Physical Metallurgy, Royal Institute of Technology, Stockholm, Sweden. [Pg.312]

In the next section of Addnl Ref O, Evaluation of Parameters , it is stated that the parameters, y, a, and B/Q, which appear in the LSZK equation of state, must be evaluated by using experimental data and it is explained how this is done on pp 9 10. As an example, compressed TNT of various densities was investigated. Detonation velocities determined by LSZK expression (34) proved to be in good agreement with those detd by the empirical formula ... [Pg.286]

Although theoretical advances are being made, the current state of the art of crystallization requires pilot plant evaluation of parameters of equations and of such operating variables as... [Pg.523]

Figure 3.1 Reactor combination for gaining maximum information concerning the evaluation of parameters exemplarily for partial oxidation of o-xylene. MZ = measuring cell ... Figure 3.1 Reactor combination for gaining maximum information concerning the evaluation of parameters exemplarily for partial oxidation of o-xylene. MZ = measuring cell ...
The a,j are of two types pure-species parameters (like subscripts) and intera parameters (unlikcsubscripts). The bt are parameters for the pure species. One procedure for evaluation of parameters is a generalization of Eqs. (3 and (3.41) ... [Pg.251]

The transport properties of porous solids can be obtained by evaluation of parameters of a suitable simple model applied to experimental results of a simple gas-transport process that takes place in the porous solid in question. The model parameters are material constants of the porous solids and are, thus, independent of temperature, pressure, kind and concentration of gases. [Pg.475]

Evaluation of Parameters from Constant-Rate Data... [Pg.272]

JT becomes important. Because of mixing of ground and excited state, the ground state distorts. However, the structureless broad bands in the spectra prevent the evaluation of parameters. [Pg.376]

These equations assume that only the lowest energy state mixes with the ground state, that the potential energy surfaces are harmonic and have the same force constants, and that the displacement of the ground state potential energy surface compensates for the stabilization and destabilization of the states that mix [116]. The use of electrochemical data in the evaluation of parameters that contribute to hvmax leads to a significant correction term in strongly coupled donor-acceptor systems since the excited state species is not involved in the electrochemical processes [9, 116]. The optical and electrochemical processes are related by means of the electron-transfer equilibrium in Eq. 29. [Pg.341]

The transition of even a well developed, laboratory method of analysis into a continuous monitor is often, and erroneously, regarded as a simple matter. Good laboratory work is only preliminary to testing with legitimate samples and to evaluation of parameters affecting ondine operation. The task becomes more complex when the analyte is as unstable as chlorine. [Pg.777]

Sheu M-T, Sokoloski TD. Entrapment of bioactive compounds within native albumin beads IB evaluation of parameters affecting drug release. / Parenter Sci Technol 1986 40 259—265. [Pg.475]


See other pages where Evaluation of parameters is mentioned: [Pg.99]    [Pg.170]    [Pg.138]    [Pg.670]    [Pg.391]    [Pg.39]    [Pg.411]    [Pg.417]    [Pg.445]    [Pg.451]    [Pg.187]    [Pg.16]    [Pg.318]    [Pg.59]    [Pg.417]    [Pg.470]    [Pg.345]    [Pg.327]    [Pg.133]    [Pg.440]    [Pg.417]    [Pg.417]   
See also in sourсe #XX -- [ Pg.190 ]




SEARCH



Direct evaluation of the order parameter fluctuations

Evaluation of Adsorption Parameters

Evaluation of Interaction Parameters

Evaluation of Intrinsic Reaction Parameters

Evaluation of Kinetic Parameters in Enzyme Reactions

Evaluation of Mechanical Parameters

Evaluation of Molecular Interaction Parameters

Evaluation of Monod Kinetic Parameters

Evaluation of Parameter Consistency in Rate Expressions for Ideal Surfaces

Evaluation of Rate Parameters

Evaluation of kinetic parameters

Evaluation of magnetic parameters

Evaluation of model parameters

Evaluation of spectral and other experimental parameters using Hartree-Fock-Roothaan calculations

Evaluation of the Parameters

Evaluation of the Racah B parameters

Evaluation of the Rate Law Parameters

Evaluation of the adsorption parameters

Evaluation of the cross-termination parameter

Evaluation of the order parameter

Kinetic Data Analysis and Evaluation of Model Parameters for Uniform (Ideal) Surfaces

Transfer in Undiluted Monomer Evaluation of Parameters

© 2024 chempedia.info