Esters, detection hydrolysis

Searching for a method of synthesis of enantiopure lamivudine 1, the compound having a monothioacetal stereogenic centre, Rayner et al. investigated a lipase-catalysed hydrolysis of various racemic a-acetoxysulfides 2. They found out that the reaction was both chemoselective (only the acetate group was hydrolysed with no detectable hydrolysis of the other ester moieties) and stereoselective. As a result of the kinetic resolution, enantiomerically enriched unreacted starting compounds were obtained. However, the hydrolysis products 3 were lost due to decomposition." In this way, the product yields could not exceed 50% (Equation 1). The product 2 (R = CH2CH(OEt)2) was finally transformed into lamivudine 1 and its 4-epimer. ... 

In chymotrypsin and other serine proteases the imidazole moiety of histidine acts as a general base not as a nucleophile as is probably the case in the catalysis of activated phenyl ester hydrolysis by (26). With this idea in mind, Kiefer et al. 40) studied the hydrolysis of 4-nitrocatechol sulfate in the presence of (26) since aryl sulfatase, the corresponding enzyme, has imidazole at the active center. Dramatic results were obtained. The substrate, nitrocatechol sulfate, is very stable in water at room temperature. Even the presence of 2M imidazole does not produce detectable hydrolysis. In contrast (26) cleaves the substrate at 20°C. Michaelis-Menten kinetics were obtained the second-order rate constant for catalysis by (26) is 10 times... 

The compound (III) can however lose ethanol by an internal Claisen ester condensation (p. 264) to give the cyclohexane derivative (IV), which, being the ester of a (3-keto acid, in turn readily undergoes hydrolysis and decarboxylation to give 5,5Hiimethyl cyclohexan-i,3Hiione (V) or Dimedone, a valuable reagent for the detection and estimation of formaldehyde. 

Hydrolysis (or saponification) of n-butyl acetate. Boil 4-5 g. of n-butyl acetate (Section 111,95) with 50 ml. of 10 per cent, sodium hydroxide solution under reflux until the odour of the ester can no longer be detected (about 1 hour). Set the condenser for downward distiUation and coUect the first 10 ml. of distillate. Saturate it with potassium carbonate, aUow to stand for 5 minutes, and withdraw all the Uquid into a small pipette or dropper pipette. AUow the lower layer of carbonate solution to run slowly into a test-tube, and place the upper layer into a small test-tube or weighing bottle. Dry the alcohol with about one quarter of its buUr of anhydrous potassium carbonate. Remove the alcohol with a dropper pipette and divide it into two parts use one portion for the determination of the b.p. by the Siwoloboff method (Section 11,12) and convert the other portion into the 3 5-dinitrobenzoate (Section III, 27) and determine the m.p. 

The experimental details already given for the detection and characterisation of aliphatic esters (determination of saponification equivalents h3 diolysis Section 111,106) apply equally to aromatic esters. A sfight modification in the procediu-e for isolating the products of hydrolysis is necessary for i)henolic (or phenyl) esters since the alkaline solution will contain hoth the alkali phenate and the alkali salt of the organic acid upon acidification, both the phenol and the acid will be hberated. Two methods may be used for separating the phenol and the acid ... 

Instead of immobilizing the antibody onto the transducer, it is possible to use a bare (amperometric or potentiometric) electrode for probing enzyme immunoassay reactions (42). In this case, the content of the immunoassay reaction vessel is injected to an appropriate flow system containing an electrochemical detector, or the electrode can be inserted into the reaction vessel. Remarkably low (femtomolar) detection limits have been reported in connection with the use of the alkaline phosphatase label (43,44). This enzyme catalyzes the hydrolysis of phosphate esters to liberate easily oxidizable phenolic products. 

The hydrolysis of seven alkyl arenesulfinylalkanoates by the bacterium Corynebacterium equi IFO 3730 studied by Ohta and coworkers34 are recent examples of kinetic resolutions which give sulfoxides of high enantiomeric purity and in reasonable yield. Compounds 16a, 16b and 16c were recovered in 30 to 43% yield and in 90 to 97% e.e. The S enantiomers underwent hydrolysis more rapidly than the R isomers. Sulfoxide 17 was isolated in 22% yield and 96% e.e., but sulfoxide 18 was completely metabolized. Esters other than methyl gave inferior results. The acids formed upon hydrolysis, although detected, were for the most part further metabolized by the bacterium. 

The amount of residual sulfonate ester remaining after hydrolysis can be determined by a procedure proposed by Martinsson and Nilsson [129], similar to that used to determine total residual saponifiables in neutral oils. Neutrals, including alkanes, alkenes, secondary alcohols, and sultones, as well as the sulfonate esters in the AOS, are isolated by extraction from an aqueous alcoholic solution with petroleum ether. The sulfonate esters are separated from the sultones by chromatography on a silica gel column. Each eluent fraction is subjected to saponification and measured as active matter by MBAS determination measuring the extinction of the trichloromethane solution at 642 nra. (a) Sultones. Connor et al. [130] first reported, in 1975, a very small amount of skin sensitizer, l-unsaturated-l,3-sultone, and 2-chloroalkane-l,3-sultone in the anionic surfactant produced by the sulfation of ethoxylated fatty alcohol. These compounds can also be found in some AOS products consequently, methods of detection are essential. 

The high simple diastereoselectivities observed running the [4-1-3] cycloadditions raised the question concerning the induction of chirality. Preliminary experiments involving chiral menthyloxy Fischer carbenes 169 (R = (-)-men-thyl) resulted in the formation of the diastereomeric lactim ethers 173-1 and 173-2 in a 7 3 ratio, which could be separated by means of a crystallization. A final acidic hydrolysis gave the enantiomerically pure e-caprolactams 175 and ent-175 and the acyclic esters, respectively. No signs of racemization have been detected,Eqs. (18,19) [39b]. 

A number of biochemical markers not associated with the cell envelope allow the specific detection of individual microorganisms in environmental samples. These include secondary alcohols. For example, Mycobacterium xenopi can be detected through the hydrolysis of wax ester mycolates, which liberates 2-docosanol, a characteristic and dominant secondary alcohol, which can be detected at low levels by GC-MS. This biomarker was found to be very useful for the rapid detection of M. xenopi in drinking water (159,160). Results from the GC-MS detection of 2-docosanol were obtained within 2 days compared to the 12 weeks required for culturable detection of M. xenopi. The detection limit for this type of approach was found to be 10 colony-forming units (CFU) ml" drinking water. 

Desilylation model studies were carried out on both the silylated monomer and polymer to develop suitable reaction conditions. The desilylation of the TMSEMA was instantaneous as indicated with GC by the increase in the retention time of the monomer. The desilylation the PTMSEMA was equally facile as determined by NMR spectroscopy Figure 1 shows the disappearance of the -Si(CH3)3 resonance at 0.1 ppm and the appearance of the -OH resonance at 3.3 ppm without detectible ester hydrolysis even after four days. 

The monomeric metaphosphate ion itself commands a fair amount of attention in discussions of metaphosphates. It is postulated as an intermediate of numerous hydrolysis reactions of phosphoric esters 52 S4,S5) and also of phosphorylation reactions S6> kinetic and mechanistic studies demonstrate the plausibility of such an assumption. In addition, the transient formation of ester derivatives of meta-phosphoric acid — in which the double-bonded oxygen can also be replaced by thio and imino — has also been observed they were detected mainly on the basis of the electrophilic nature of the phosphorus. 

The use of mesitoate esters in the elucidation of reaction mechanisms has been pioneered by Burrows and Topping (1969,1970). This system has been used to suppress the competitive intermolecular reaction by steric bulk effects and to detect participation by the identification of the products formed. Under identical conditions (pH 11.28 at 30°C in 9.5% ethanol-water), 2-acetylphenyl mesitoate [41]is hydrolysed 130 times more readily than 4-acetylphenyl mesitoate, clearly indicating intramolecular catalysis. However, the products of hydrolysis provided no clue to the mechanism of... 

Acridinium esters have also been utilized for chemiluminescent detection of cDNA probes (Fig. 5) [9-11], The hydrolysis rate is much faster when the ester is conjugated to single-stranded DNA, rather than to double-stranded DNA. This means that the chemiluminescence from unhybridized acridinium ester-labeled probe is rapidly lost, whereas the chemiluminescence from the hybridized probe is minimally affected. This permits discrimination between hybridized and unhybridized acridinium ester-labeled DNA probes without separation steps. 

The acridinium ester (AE) in an AE-labeled cDNA probe hybridized to target DNA is less likely to be hydrolyzed than in the unhybridized conformation (Fig. 10) [9-11]. Single-base mismatches in the duplex adjacent to the site of AE attachment disrupt this protection, resulting in rapid AE hydrolysis [11]. Hydrolysis by a weak base renders AE permanently nonchemiluminescent. After hydrolysis, it is possible to use the remaining chemiluminescence as a direct measure of the amount of hybrid present. This selective degradation process is a highly specific chemical hydrolysis reaction, which is sensitive to the local environment of the acridinium ester. The matched duplex can be detected and quantified readily, whereas the mismatched duplex produces a minimal signal. 

Figure 10 Mismatch detection by using a chemiluminescent AE-labeled cDNA probe. Procedure [9, 11] Acridinium ester-labeled probes specific for either wild-type or mutant sequence corresponding to a target DNA are hybridized with the sample DNA for 1.0 h at 60°C in a hybridization buffer (pH 5.2). Hybridized and nonhybridized probes are discriminated by the hydrolysis reaction for 12 min at 62.5°C in the presence of Na2B407 (pH 8.5) and Triton X-100. The chemiluminescence of each sample is then measured in a luminometer.

---