Equilibrium constants acid-base

K. See Equilibrium constant Ka. See Acid equilibrium constant See Base equilibrium constant Kc. See Equilibrium constant Kf. See Formation equilibrium constant Kr See Equilibrium constant K,p. See Solubility product constant K . See Water ion product constant K-electron capture The natural radioactive process in which an inner electron (n = 1) enters the nucleus, converting a proton to a neutron, 514 Kelvin, Lord, 8... 

One could go on with examples such as the use of a shirt rather than sand reduce the silt content of drinking water or the use of a net to separate fish from their native waters. Rather than that perhaps we should rely on the definition of a chemical equilibrium and its presence or absence. Chemical equilibria are dynamic with only the illusion of static state. Acetic acid dissociates in water to acetate-ion and hydrated hydrogen ion. At any instant, however, there is an acid molecule formed by recombination of acid anion and a proton cation while another acid molecule dissociates. The equilibrium constant is based on a dynamic process. Ordinary filtration is not an equilibrium process nor is it the case of crystals plucked from under a microscope into a waiting vial. 

It is recommended to use only the term acid constant to avoid mistakes with the term acidity, which is different from the equilibrium constant Ka based on the mass effect law (Chapter 4.1.4). 

These equilibria are in aqueous solution, so we will use equilibrium-constant expressions based on concentrations. Because H2O is the solvent, it is omitted from the equilibrium-constant expression, ogo (Section 15.4) Further, we add a subscript a on the equilibrium constant to indicate that it is an equilibrium constant for the ionization of an acid. Thus, we can write the equilibriimi-constant expression as either ... 

If an alkane loses a proton to a powerful base, the only available hydrogen atoms are connected to a carbon, and the C-H bond is a rather strong bond. If the C-H unit in 2 loses a proton as an acid, the conjugate base would be 7. It can be stated categorically that the equilibrium for this reaction lies far to the left (Ka is very small), which means there is an extremely low concentration of 7. The equilibrium constant (acidity constant. Kg) is less than 10 °, for a pKa of >40. The actual value of will depend on the base that is used, but this generic value indicates that 2 is an extremely weak acid. If 7 were to form, it would be a remarkably strong base (very reactive and rather unstable). As noted, 2 does not contain a lone electron pair, and all electrons are tied up in covalent bonds, so it is not a base. 

Nonaqueous titrations are frequently desirable or required because of the increased sensitivity, improved selectivity, or greater solubility achieved with nonaqueous solvents. A far greater number of acids and bases can be determined in nonaqueous solvents than in aqueous media. This is primarily true because of the numerous organic acids and bases that require organic solvents. Properties such as dissolving or solvating, diffusion or equilibrium constants, acidity or basicity, and dielectric constant or polarity extend the capability of titrimetry to a far wider range when nonaqueous solvents are used. 

One can write acid-base equilibrium constants for the species in the inner compact layer and ion pair association constants for the outer compact layer. In these constants, the concentration or activity of an ion is related to that in the bulk by a term e p(-erp/kT), where yp is the potential appropriate to the layer [25]. The charge density in both layers is given by the algebraic sum of the ions present per unit area, which is related to the number of ions removed from solution by, for example, a pH titration. If the capacity of the layers can be estimated, one has a relationship between the charge density and potential and thence to the experimentally measurable zeta potential [26]. 

According to the Arrhenius definitions an acid ionizes m water to pro duce protons (H" ) and a base produces hydroxide ions (HO ) The strength of an acid is given by its equilibrium constant for ionization m aqueous solution... 

The carbon-metal bonds of organolithium and organomagnesium compounds have appreciable carbamomc character Carbanions rank among the strongest bases that we 11 see m this text Their conjugate acids are hydrocarbons—very weak acids indeed The equilibrium constants for ionization of hydrocarbons are much smaller than the s for water and alcohols thus hydrocarbons have much larger pA s... 

Several types of reactions are commonly used in analytical procedures, either in preparing samples for analysis or during the analysis itself. The most important of these are precipitation reactions, acid-base reactions, complexation reactions, and oxidation-reduction reactions. In this section we review these reactions and their equilibrium constant expressions. 

A species that can serve as both a proton donor and a proton acceptor is called amphiprotic. Whether an amphiprotic species behaves as an acid or as a base depends on the equilibrium constants for the two competing reactions. For bicarbonate, the acid dissociation constant for reaction 6.8... 

The equilibrium constant for equation 6.13 is K. Since equation 6.13 is obtained by adding together reactions 6.11 and 6.12, may also be expressed as the product of Ka for CH3COOH and Kb for CH3COO-. Thus, for a weak acid, HA, and its conjugate weak base, A-,... 

Besides equilibrium constant equations, two other types of equations are used in the systematic approach to solving equilibrium problems. The first of these is a mass balance equation, which is simply a statement of the conservation of matter. In a solution of a monoprotic weak acid, for example, the combined concentrations of the conjugate weak acid, HA, and the conjugate weak base, A , must equal the weak acid s initial concentration, Cha- ... 

Acid-base reactions occur when an acid donates a proton to a base. The equilibrium position of an acid-base reaction is described using either the dissociation constant for the acid, fQ, or the dissociation constant for the base, K, . The product of and Kb for an acid and its conjugate base is K (water s dissociation constant). 

In a simple liquid-liquid extraction the solute is partitioned between two immiscible phases. In most cases one of the phases is aqueous, and the other phase is an organic solvent such as diethyl ether or chloroform. Because the phases are immiscible, they form two layers, with the denser phase on the bottom. The solute is initially present in one phase, but after extraction it is present in both phases. The efficiency of a liquid-liquid extraction is determined by the equilibrium constant for the solute s partitioning between the two phases. Extraction efficiency is also influenced by any secondary reactions involving the solute. Examples of secondary reactions include acid-base and complexation equilibria. 

Since the position of an acid-base equilibrium depends on the pH, the distribution ratio must also be pH-dependent. To derive an equation for D showing this dependency, we begin with the acid dissociation constant for HA. 

Although not commonly used, thermometric titrations have one distinct advantage over methods based on the direct or indirect monitoring of plT. As discussed earlier, visual indicators and potentiometric titration curves are limited by the magnitude of the relevant equilibrium constants. For example, the titration of boric acid, ITaBOa, for which is 5.8 X 10 °, yields a poorly defined equivalence point (Figure 9.15a). The enthalpy of neutralization for boric acid with NaOlT, however, is only 23% less than that for a strong acid (-42.7 kj/mol... 

Equilibrium Constants Another application of acid-base titrimetry is the determination of equilibrium constants. Consider, for example, the titration of a weak acid, HA, with a strong base. The dissociation constant for the weak acid is... 

Determination of Equilibrium Constants Another important application of molecular absorption is the determination of equilibrium constants. Let s consider, as a simple example, an acid-base reaction of the general form... 

In developing this treatment for determining equilibrium constants, we have considered a relatively simple system in which the absorbance of HIn and Im were easily measured, and for which it is easy to determine the concentration of H3O+. In addition to acid-base reactions, the same approach can be applied to any reaction of the general form... 

Although this experiment is written as a dry-lab, it can be adapted to the laboratory. Details are given for the determination of the equilibrium constant for the binding of the Lewis base 1-methylimidazole to the Lewis acid cobalt(II)4-trifluoromethyl-o-phenylene-4,6-methoxysalicylideniminate in toluene. The equilibrium constant is found by a linear regression analysis of the absorbance data to a theoretical equilibrium model. 

The equilibrium constant for an acid-base indicator is determined by preparing three solutions, each of which has a total indicator concentration of 1.35 X lQ-5 M. The pH of the first solution is adjusted until it is acidic enough to ensure that only the acid form of the indicator is present, yielding an absorbance of 0.673. The absorbance of the second solution, whose pH was adjusted to give only the base form of the indicator, was measured at 0.118. The pH of the third solution was adjusted to 4.17 and had an absorbance of 0.439. What is the acidity constant for the acid-base indicator ... 

PK. — the negative logarithm of the equilibrium constant for acids or bases. This parameter is an indicator of the strength of an acid or base. Strong acids, such as H2SO4, and HCl, have low pK s (i.e., -1.0) while strong bases such as KOH and NaOH, have pK s close to 14.0. Weak acids and weak bases fall in the intermediate range. 

Hydration (Section 17.6) Can be either acid- or base-catalyzed. Equilibrium constant is normally unfavorable for hydration of ketones unless R, R, or both are strongly electron-withdrawing. 

The sensitivity of the equilibrium constant to temperature, therefore, depends upon the enthalpy change AH . This is usually not a serious limitation, because most reaction enthalpies are sufficiently large and because we commonly require that the perturbation be a small one so that the linearization condition is valid. If AH is so small that the T-jump is ineffective, it may be possible to make use of an auxiliary reaction in the following way Suppose the reaction under study is an acid-base reaction with a small AH . We can add a buffer system having a large AH and apply the T-jump to the combined system. The T-jump will alter the Ka of the buffer reaction, resulting in a pH jump. The pH jump then acts as the forcing function on the reaction of interest. 

Table 4-1 lists some rate constants for acid-base reactions. A very simple yet powerful generalization can be made For normal acids, proton transfer in the thermodynamically favored direction is diffusion controlled. Normal acids are predominantly oxygen and nitrogen acids carbon acids do not fit this pattern. The thermodynamicEilly favored direction is that in which the conventionally written equilibrium constant is greater than unity this is readily established from the pK of the conjugate acid. Approximate values of rate constants in both directions can thus be estimated by assuming a typical diffusion-limited value in the favored direction (most reasonably by inspection of experimental results for closely related... 

Estimate the rate constants for the acid-base equilibrium of formic acid in water. 

An inflection point in a pH-rate profile suggests a change in the nature of the reaction caused by a change in the pH of the medium. The usual reason for this behavior is an acid-base equilibrium of a reactant. Here we consider the simplest such system, in which the substrate is a monobasic acid (or monoacidic base). It is pertinent to consider the mathematical nature of the acid-base equilibrium. Let HS represent a weak acid. (The charge type is irrelevant.) The acid dissociation constant, = [H ][S ]/[HS], is taken to be appropriate to the conditions (temperature, ionic strength, solvent) of the kinetic experiments. The fractions of solute in the conjugate acid and base forms are given by... 

A frequently encountered pH-rate profile exhibits a bell-like shape or hump, with two inflection points. This graphical feature is essentially two sigmoid curves back-to-back. By analogy with the earlier analysis of the sigmoid pH-rate curve, where the shape was ascribed to an acid-base equilibrium of the substrate, we find that the bell-shaped curve can usually be accounted for in terms of two acid-base dissociations of the substrate. The substrate can be regarded, for this analysis, as a dibasic acid H2S, where the charge type is irrelevant we take the neutral molecule as an example. The acid dissociation constants are... 

When a Br nsted plot includes acids or bases with different numbers of acidic or basic sites, statistical corrections are sometimes applied in effect, the rate and equilibrium constants are corrected to a per functional group basis. If an acid has p equivalent dissociable protons and its conjugate base has q equivalent sites for proton addition, the statistically corrected forms of the Br insted relationships are... 

If the rate equation contains the concentration of a species involved in a preequilibrium step (often an acid-base species), then this concentration may be a function of ionic strength via the ionic strength dependence of the equilibrium constant controlling the concentration. Therefore, the rate constant may vary with ionic strength through this dependence this is called a secondary salt effect. This effect is an artifact in a sense, because its source is independent of the rate process, and it can be completely accounted for by evaluating the rate constant on the basis of the actual species concentration, calculated by means of the equilibrium constant appropriate to the ionic strength in the rate study. 

Sn2 reactions with anionic nucleophiles fall into this class, and observations are generally in accord with the qualitative prediction. Unusual effects may be seen in solvents of low dielectric constant where ion pairing is extensive, and we have already commented on the enhanced nucleophilic reactivity of anionic nucleophiles in dipolar aprotic solvents owing to their relative desolvation in these solvents. Another important class of ion-molecule reaction is the hydroxide-catalyzed hydrolysis of neutral esters and amides. Because these reactions are carried out in hydroxy lie solvents, the general medium effect is confounded with the acid-base equilibria of the mixed solvent lyate species. (This same problem occurs with Sn2 reactions in hydroxylic solvents.) This equilibrium is established in alcohol-water mixtures ... 

As the titration begins, mostly HAc is present, plus some H and Ac in amounts that can be calculated (see the Example on page 45). Addition of a solution of NaOH allows hydroxide ions to neutralize any H present. Note that reaction (2) as written is strongly favored its apparent equilibrium constant is greater than lO As H is neutralized, more HAc dissociates to H and Ac. As further NaOH is added, the pH gradually increases as Ac accumulates at the expense of diminishing HAc and the neutralization of H. At the point where half of the HAc has been neutralized, that is, where 0.5 equivalent of OH has been added, the concentrations of HAc and Ac are equal and pH = pV, for HAc. Thus, we have an experimental method for determining the pV, values of weak electrolytes. These p V, values lie at the midpoint of their respective titration curves. After all of the acid has been neutralized (that is, when one equivalent of base has been added), the pH rises exponentially. 

Equilibrium Constants for Weak Acids and Their Conjugate Bases... 

---