Enzyme catalytic efficiency

A detailed understanding of the mechanism of enzyme catalysis and of the reasons for enzyme catalytic efficiency requires knowledge of the... 

In recent years attention has focused on the role of intrinsic binding energy and entropic factors as major contributors to enzyme catalytic efficiency (Page and Jencks, 197l Jencks, 1975,1981). The ribonuclease mechanism conforms to expectations based on these ideas. In particular, distortion occurs to raise the ground state of the substrate in the S complex, and the bound substrate interacts with the enzyme in a manner such that the enzyme becomes complementary to the transition state of the reaction during the catalytic cycle. 

When two soluble enzymes catalyze consecutive reactions, the product formed by the first enzyme must leave and diffuse to the second enzyme. Catalytic efficiency is substantially increased if both active sites are in close proximity in the same enzyme molecule. A similar advantage is obtained when consecutive enzymes are held close to each other in multienzyme complexes. 

Besides the aforementioned competitive stq>pression of self-coupling by cross-coupling, lignin may introduce additional siq>pression effects on NEP-foimation by competitive inhibition of enzyme catalytic efficiency. Lignin contains phenolic fimctionalities in its monomeric stmcture, and these may serve as additional substrates for the HRP enzyme despite some steric huubaiKes. Such effects would lead to apparent reduction of enzyme catalytic efficiency, particularly at high lignin concentrations. 

Interestingly, at very low concentrations of micellised Qi(DS)2, the rate of the reaction of 5.1a with 5.2 was observed to be zero-order in 5.1 a and only depending on the concentration of Cu(DS)2 and 5.2. This is akin to the turn-over and saturation kinetics exhibited by enzymes. The acceleration relative to the reaction in organic media in the absence of catalyst, also approaches enzyme-like magnitudes compared to the process in acetonitrile (Chapter 2), Cu(DS)2 micelles accelerate the Diels-Alder reaction between 5.1a and 5.2 by a factor of 1.8710 . This extremely high catalytic efficiency shows how a combination of a beneficial aqueous solvent effect, Lewis-acid catalysis and micellar catalysis can lead to tremendous accelerations. 

Km for an enzymatic reaction are of significant interest in the study of cellular chemistry. From equation 13.19 we see that Vmax provides a means for determining the rate constant 2- For enzymes that follow the mechanism shown in reaction 13.15, 2 is equivalent to the enzyme s turnover number, kcat- The turnover number is the maximum number of substrate molecules converted to product by a single active site on the enzyme, per unit time. Thus, the turnover number provides a direct indication of the catalytic efficiency of an enzyme s active site. The Michaelis constant, Km, is significant because it provides an estimate of the substrate s intracellular concentration. 

Elucidating Mechanisms for the Inhibition of Enzyme Catalysis An inhibitor interacts with an enzyme in a manner that decreases the enzyme s catalytic efficiency. Examples of inhibitors include some drugs and poisons. Irreversible inhibitors covalently bind to the enzyme s active site, producing a permanent loss in catalytic efficiency even when the inhibitor s concentration is decreased. Reversible inhibitors form noncovalent complexes with the enzyme, thereby causing a temporary de-... 

Engineering Substrate Specificity. Although the serine proteases use a common catalytic mechanism, the enzymes have a wide variety of substrate specificities. For example, the natural variant subtiHsins of B. amyloliquefaciens (subtiHsin BPN J and B. licheniformis (subtiHsin Carlsberg) possess very similar stmctures and sequences where 86 of 275 amino acids are identical, but have different catalytic efficiencies, toward tetraamino acid -nitroanilide substrates (67). 

The characteristics of enzymes are their catalytic efficiency and their specificity. Enzymes increase the reaction velocities by factors of at least one million compared to the uncatalyzed reaction. Enzymes are highly specific, and consequendy a vast number exist. An enzyme usually catalyzes only one reaction involving only certain substrates. For instance, most enzymes acting on carbohydrates are so specific that even the slightest change in the stereochemical configuration is sufficient to make the enzyme incompatible and unable to effect hydrolysis. 

A final important area is the calculation of free energies with quantum mechanical models [72] or hybrid quanmm mechanics/molecular mechanics models (QM/MM) [9]. Such models are being used to simulate enzymatic reactions and calculate activation free energies, providing unique insights into the catalytic efficiency of enzymes. They are reviewed elsewhere in this volume (see Chapter 11). 

That is, k t/K,n is an apparent second-order rate constant ior the reaction of E and S to form product. Because A , is inversely proportional to the affinity of the enzyme for its substrate and is directly proportional to the kinetic efficiency of the enzyme, A , provides an index of the catalytic efficiency of an enzyme operating at substrate concentrations substantially below saturation amounts. 

But k must always be greater than or equal to k h / (A i + kf). That is, the reaction can go no faster than the rate at which E and S come together. Thus, k sets the upper limit for A ,. In other words, the catalytic effieiency of an enzyme cannot exceed the diffusion-eontroUed rate of combination of E and S to form ES. In HgO, the rate constant for such diffusion is approximately (P/M - sec. Those enzymes that are most efficient in their catalysis have A , ratios approaching this value. Their catalytic velocity is limited only by the rate at which they encounter S enzymes this efficient have achieved so-called catalytic perfection. All E and S encounters lead to reaction because such catalytically perfect enzymes can channel S to the active site, regardless of where S hits E. Table 14.5 lists the kinetic parameters of several enzymes in this category. Note that and A , both show a substantial range of variation in this table, even though their ratio falls around 10 /M sec. 

Certain substances known as competitive inhibitors, symbolized I, may lower the catalytic efficiency of the enzyme (or other catalyst) by binding to it. Consider that the E I complex has a dissociation constant K. ... 

In the enzyme design approach, as discussed in the first part of this chapter, one attempts to utilize the mechanistic understanding of chemical reactions and enzyme structure to create a new catalyst. This approach represents a largely academic research field aiming at fundamental understanding of biocatalysis. Indeed, the invention of functional artificial enzymes can be considered to be the ultimate test for any theory on enzyme mechanisms. Most artificial enzymes, to date, do not fulfill the conditions of catalytic efficiency and price per unit necessary for industrial applications. 

From the results of the urease activity test summarized in Figure 15, it is clear that the deposition procedure preserved to a certain extent the enzyme catalytic activity. Heating the sample before testing decreased the enzyme in the film by about 30% but did not eliminate it completely. The results of the activity test of two samples are summarized in Table 1 together with reference values for a spontaneous reaction without enzyme. It is necessary to underline that enzymatic activity on spherical supports was higher than the respective value in flat films, which could indicate that apparent catalytic efficiency was improved due to an increased area-to-volume ratio. 

The catalytic efficiency of an enzyme is usually expressed by the ratio of its rate constant or turnover number (moles of substrate reacted per mol of... 

While many diseases have long been known to result from alterations in an individual s DNA, tools for the detection of genetic mutations have only recently become widely available. These techniques rely upon the catalytic efficiency and specificity of enzyme catalysts. For example, the polymerase chain reaction (PCR) relies upon the ability of enzymes to serve as catalytic amplifiers to analyze the DNA present in biologic and forensic samples. In the PCR technique, a thermostable DNA polymerase, directed by appropriate oligonucleotide primers, produces thousands of copies of a sample of DNA that was present initially at levels too low for direct detection. 

The catalytic capacity of the rate-fimiting reaction in a metabolic pathway is the product of the concentration of enzyme molecules and their intrinsic catalytic efficiency. It therefore follows that catalytic capacity can be... 

Protein phosphorylation-dephosphorylation is a highly versatile and selective process. Not all proteins are subject to phosphorylation, and of the many hydroxyl groups on a protein s surface, only one or a small subset are targeted. While the most common enzyme function affected is the protein s catalytic efficiency, phosphorylation can also alter the affinity for substrates, location within the cell, or responsiveness to regulation by allosteric ligands. Phosphorylation can increase an enzyme s catalytic efficiency, converting it to its active form in one protein, while phosphorylation of another converts it into an intrinsically inefficient, or inactive, form (Table 9—1). 

In previous papers it was shown that the enzymatic pool of Pectolyase Y23 possesses high catalytic efficiency either as free or immobilized form in solution of pectins [28, 29] and of fresh vegetable tissues [30]. According to Baldwin and Pressor [31] the following enzymatic activities were detected in the preparation PL, PG and PE. The amount of the different enzyme detected per mg of Pectolyase Y23 and the main enzyme characteristic are quoted in Table 1... 

Important inherent characteristics of an enzyme that should be considered are the substrate affinity, characterized by the Michaelis constant the rate of turnover fecat> providing the catalytic efficiency fecat/ M. and the catalytic potential. Several attempts to compare enzyme catalysis with that of platinum have been published. Direct comparisons are difficult, because enzyme electrodes must be operated in aqueous electrolyte containing dissolved substrate, whereas precious metal electrodes aie often supplied with a humidified gaseous stream of fuel or oxidant, and produce water as steam. It is not straightforward to compare tme optimal turnover rates per active site, as it is often unclear how many active sites are being engaged in a film of enzyme on an electrode. 

---