Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Chemiluminescence energy transfer

The kinetics of the thermal decomposition of 1,2-dioxetanes and a-peroxylactones are first order and are usually unimolecular. A variety of experimental methods can be used to monitor the rates. These include direct chemiluminescence of the excited carbonyl product,energy-transfer chemiluminescence of the chemienergized excited carbonyl product to an efficient fluorescer, dioxetane consumption or carbonyl product formation by nmr spectroscopy iodometry of the cyclic... [Pg.386]

Most of these excitation yields have been determined by energy-transfer chemiluminescence using 9,10-diphenylanthracene (JJPA) and 9,10-dibromo-anthracene DBA) as fluorescers. [Pg.392]

The fluorescer of choice for counting chemienergized triplet states via triplet-singlet energy-transfer chemiluminescence has been 9,10-dibromoanthracene (DBA). Like DP A, it is readily available and easily purified unlike DPA it has a relatively low fluorescence quantum yield, that is, 0dba about 0.10 and is temperature- and solvent-dependent. For reliable triplet yields, the fluorescence quantum yields of DBA should be measured under the conditions at which the chemienergized carbonyl product K is generated. [Pg.398]

In summary, control of the chemiluminescence efficiency as well as the emitter by the terminal substituents was demonstrated for the chemiluminescence reactions of 4-styrylphthalhydrazides. The strongly electron-donating character of the terminal substituents is coincident with the increase in the d>F values of the corresponding phthalate ions by a contribution of an electronic pull-push system, which provides an efficient chemiluminescence with the excited phthalate ions being the emitters. On the other hand, the energy transfer chemiluminescence takes place when the fluorescence of the phthalate ions is weak. [Pg.174]

The use of molecular and atomic beams is especially useful in studying chemiluminescence because the results of single molecular interactions can be observed without the complications that arise from preceding or subsequent energy-transfer coUisions. Such techniques permit determination of active vibrational states in reactants, the population distributions of electronic, vibrational, and rotational excited products, energy thresholds, reaction probabihties, and scattering angles of the products (181). [Pg.270]

Electronic excitation from atom-transfer reactions appears to be relatively uncommon, with most such reactions producing chemiluminescence from vibrationaHy excited ground states (188—191). Examples include reactions of oxygen atoms with carbon disulfide (190), acetylene (191), or methylene (190), all of which produce emission from vibrationaHy excited carbon monoxide. When such reactions are carried out at very low pressure (13 mPa (lO " torr)), energy transfer is diminished, as with molecular beam experiments, so that the distribution of vibrational and rotational energies in the products can be discerned (189). Laser emission at 5 p.m has been obtained from the reaction of methylene and oxygen initiated by flash photolysis of a mixture of SO2, 2 2 6 (1 )-... [Pg.271]

Excited states may be formed by (1) light absorption (photolysis) (2) direct excitation by the impact of charged particles (3) ion neutralization (4) dissociation from ionized or superexcited states and (5) energy transfer. Some of these have been alluded to in Sect. 3.2. Other mechanisms include thermal processes (flames) and chemical reaction (chemiluminescence). It is instructive to consider some of the processes generating excited states and their inverses. Figure 4.3 illustrates this following Brocklehurst (1970) luminescence (l— 2)... [Pg.78]

The second label also may be a fluorescent compound, but doesn t necessarily have to be. As long as the second label can absorb the emission of the first label and modulate its signal, binding events can be observed. Thus, the two labeled DNA probes interact with each other to produce fluorescence modulation only after both have bound target DNA and are in enough proximity to initiate energy transfer. Common labels utilized in such assay techniques include the chemiluminescent probe, N-(4-aminobutyl)-N-ethylisoluminol, and reactive fluorescent derivatives of fluorescein, rhodamine, and the cyanine dyes (Chapter 9). For a review of these techniques, see Morrison (1992). [Pg.1000]

If the emitting species is not a reaction-product molecule directly formed by the exergonic reaction (as is the case in the luminol reaction, for example), chemiluminescence can occur via energy transfer processes ... [Pg.68]

These energy-transfer processes are especially interesting in those chemiluminescence reactions where the primary electronically excited product is formed in its triplet state (autoxidation reactions, radical-ion recombination reactions see Sections III and VIII), although some reactions have been reported to involve direct emission from the excited triplet state 14>. [Pg.68]

The rather stable diacyl peroxides such as dibenzoyl or phthaloyl peroxide have attracted special interest as some of their reactions, mostly not chain reactions, are chemiluminescent. Triplet-singlet energy transfer is very often involved, and emission generally occurs only when a fluorescer is present since the primary excited products cannot emit in the visible range of the spectrum. [Pg.80]

DPA) in dimethylphthalate at about 70°, yields a relatively strong blue Umax =435 nm) chemiluminescence the quantum yield is about 7% that of luminol 64>. The emission spectrum matches that of DPA fluorescence so that the available excitation energy is more than 70 kcal/mole. Energy transfer was observed on other fluorescers, e.g. rubrene and fluorescein. The mechansim of the phthaloyl peroxide/fluorescer chemiluminescence reaction very probably involves radicals. Luminol also chemiluminesces when heated with phthaloyl peroxide but only in the presence of base, which suggests another mechanism. The products of phthaloyl peroxide thermolysis are carbon dioxide, benzoic acid, phthalic anhydride, o-phenyl benzoic acid and some other compounds 65>66>. It is not yet known which of them is the key intermediate which transfers its excitation energy to the fluorescer. [Pg.81]

A peculiar effect was observed in the decomposition of 19 a with anthracene as fluorescer when oxygen was carefully removed from the solutions an increase of the chemiluminescence decay rate and of the dioxetane cleavage resulted. It was suggested that this was due to a catalytic effect of triplet anthracene (formed by energy transfer from triplet formate) on the decomposition of the dioxetane. When oxygen is present, triplet anthracene is quenched. Whether such a catalytic effect of triplet anthracene or similar compounds on dioxetane cleavage actually exists has not yet been fully established positive effects were observed by M. M. Rauhut and coworkers 24> in oxalate chemiluminescence and by S. Mazur and C. S. Foote 80> in the chemiluminescent decomposition of tetramethoxy-dioxetane, where zinc tetraphenylporphy-rin seems to exert a catalytic effect. However, the decomposition of trimethyl dioxetane exhibits no fluorescer catalysis 78h... [Pg.88]

Hydrazide chemiluminescence has been investigated very intensively during recent years (for reviews, see 1>, p. 63, 2>, 90>). Main topics in this field are synthesis of highly chemiluminescent cyclic diacyl hydrazides derived from aromatic hydrocarbons, relations between chemiluminescence quantum yield and fluorescence efficiency of the dicarboxylates produced in the reaction, studies concerning the mechanism of luminol type chemiluminescence, and energy-transfer problems. [Pg.92]

E. Intramolecular Energy Transfer in Luminol-Type Hydrazide Chemiluminescence... [Pg.109]

It was concluded, therefore, that intramolecular energy transfer is involved in the chemiluminescence of 58. The rate of energy transfer was calculated to be 2.3 X 107 sec-1 12 ). [Pg.109]

Intermolecvlax energy transfer is apparently involved in the anomalous chemiluminescence of phthalic hydrazide in aprotic solvent (DMSO/tert.BuOK/Og) 124) the energy of excited phthalated ianion is transferred to phthal-hydrazide monoanion which then emits at 525 nm with relatively low quantum yield. This phenomenon has not been observed in aqueous systems 2>. [Pg.110]

Lucigenin 71 chemiluminescence is more complicated than that of luminol and related compounds due to the presence in the reaction mixture of several species capable of emission 135>. N-Methylacridone 72, however, has been established as the primary excited product (for references see 0 p. 90) from which energy transfer occurs to the other species 3>. [Pg.113]

Chemiluminescence also occurs during electrolysis of mixtures of DPACI2 99 and rubrene or perylene In the case of rubrene the chemiluminescence matches the fluorescence of the latter at the reduction potential of rubrene radical anion formation ( — 1.4 V) at —1.9 V, the reduction potential of DPA radical anion, a mixed emission is observed consisting of rubrene and DPA fluorescence. Similar results were obtained with the dibromide 100 and DPA and/or rubrene. An energy-transfer mechanism from excited DPA to rubrene could not be detected under the reaction conditions (see also 154>). There seems to be no explanation yet as to why, in mixtures of halides like DPACI2 and aromatic hydrocarbons, electrogenerated chemiluminescence always stems from that hydrocarbon which is most easily reduced. A great number of aryl and alkyl halides is reported to exhibit this type of rather efficient chemiluminescence 155>. [Pg.122]

CL reactions are commonly divided into two classes. In the type I (direct) reaction the oxidant and reductant interact with rate constant kr to directly form the excited product whose excited singlet state decays with the first (or pseudofirst)-order rate constant ks = kf+ kd. In the type II (indirect) reaction the oxidant and reactant interact with the formation of an initially excited product (kr) followed by the formation of an excited secondary product, either by subsequent chemical reaction or by energy transfer, with rate constant kA. The secondary product then decays from the lowest excited singlet state with rate constant kt. Type II reactions are generally denoted as complex or sensitized chemiluminescence. [Pg.76]

HTAC cationic micelles also markedly enhance the CL intensity of fluorescein (FL) in the oxidation of hydrogen peroxide catalyzed by horseradish peroxidase (HRP) [39], However, no CL enhancement was observed when anionic micelles of sodium dodecyl sulphate (SDS) or nonionic micelles of polyoxyethylene (23) dodecanol (Brij-35) were used (Fig. 9). CL enhancement is attributed to the electrostatic interaction of the anionic fluorescein with the HTAC micelles. The local concentration of fluorescein on the surface of the micelle increases the efficiency of the energy transferred from the singlet oxygen (which is produced in the peroxidation catalyzed by the HRP) to fluorescein. This chemiluminescent enhancement was applied to the determination of traces of hydrogen peroxide. The detection limit was three times smaller than that obtained in aqueous solution. [Pg.298]

It has been proposed that this reaction intermediate could decompose to produce HCN and CH3 [55], Chemiluminescence from alkanes can be greatly enhanced by addition of HC1. The proposed explanation is that energy transfer from active nitrogen dissociates HC1 to produce chlorine atoms, which have rapid hydrogen-atom abstraction reactions with alkanes,... [Pg.364]

Huang XY, Li L, Qian HF, Dong CQ, Ren CJ (2006). A resonance energy transfer between chemiluminescent donors and luminescent quantum-dots as acceptors (CRET). Angew. Chem. Int. Ed. 45 5140-5143. [Pg.216]


See other pages where Chemiluminescence energy transfer is mentioned: [Pg.44]    [Pg.352]    [Pg.394]    [Pg.396]    [Pg.404]    [Pg.413]    [Pg.414]    [Pg.173]    [Pg.185]    [Pg.44]    [Pg.352]    [Pg.394]    [Pg.396]    [Pg.404]    [Pg.413]    [Pg.414]    [Pg.173]    [Pg.185]    [Pg.263]    [Pg.265]    [Pg.140]    [Pg.244]    [Pg.103]    [Pg.45]    [Pg.159]    [Pg.1000]    [Pg.77]    [Pg.82]    [Pg.110]    [Pg.76]    [Pg.106]    [Pg.110]    [Pg.395]    [Pg.71]    [Pg.10]   
See also in sourсe #XX -- [ Pg.75 , Pg.76 ]

See also in sourсe #XX -- [ Pg.75 , Pg.76 ]




SEARCH



Chemiluminescence energy transfer quantum yields

Chemiluminescence resonance energy transfer

Energy Transfer in Luminol Type Chemiluminescence

Energy chemiluminescence)

© 2024 chempedia.info