Ejection

Due to the absorbed photon energy in the moment of the beam admission the particles and the substrate surface warm up very fast. As a consquence of the thermal induced stresses between the relative brittle hard particles, some particles brake apart and, because of the released impulse energy, they are ejected out of the effective beam zone, transmission... 

Fig. 11-19. The drop ejection process in an inkjet printer (a) bubble nucleation (b) bubble growth and drop ejection (c) refill. [From J. H. Bohoiquez, B. P. Canfield, K. J. Courian, F. Drogo, C. A. E. Hall, C. L. Holstun, A. R. Scandalis, and M. E. Shepard, Hewlett-Packard J. 45(1), 9-17 (Feb. 1994). Copyright 1994, Hewlett-Packard Company. Reproduced with permission.]...

Fig. IV-20. Film pressure-area plots for cerebronic acid (a long-chain a-hydroxy carboxylic acid) and cholesterol (see insert) and for an equimolar mixture. At low pressures the r-a plot is close to that of the average (dashed line), an unanticipated kink then appears, and finally, the horizontal portion probably represents ejection of the cholesterol. (From Ref. 239.)...

PED Photoelectron diffraction [107-109] x-rays (40-1500 eV) eject photoelectrons intensity measured as a function of energy and angle Surface structure... 

SXES spectroscopy [111] ejects K electrons and the spectrum of the resulting x-rays is measured Spectroscopy of Emitted Electrons state of adsorbed molecules surface composition... 

AES ARABS Auger electron spectroscopy [77, 112-114, 117] Angle-resolved AES [85, 115] An incident high-energy electron ejects an inner electron from an atom an outer electron (e.g., L) falls into the vacancy and the released energy is given to an ejected Auger electron Surface composition... 

XPS X-ray photoelectron spectroscopy [131-137] Monoenergetic x-rays eject electrons from various atomic levels the electron energy spectrum is measured Surface composition, oxidation state... 

INS Ion neutralization An inert gas hitting surface is spectroscopy [147] neutralized with the ejection of an Auger electron from a surface atom Spectroscopy of Emitted Ions or Molecules Kinetics of surface reactions chemisorption... 

ESD Electron-stimulated (impact) desorption [148, 149] An electron beam (100-200) eV) ejects ions from a surface Surface sites and adsorbed species... 

ESDIAD Electron-stimulated desorption ion angular distribution [150-152] A LEED-like pattern of ejected ions is observed Orientation of adsorbed species... 

PSD Photon-stimulated desorption [149, 162-165] Incident photons eject adsorbed molecules Desorption mechanisms and dynamics... 

SIMS Secondary-ion mass spectroscopy [106, 166-168] (L-SIMS liquids) [169, 170] Ionized surface atoms are ejected by impact of -1 keV ions and analyzed by mass spectroscopy Surface composition... 

Atom abstraction occurs when a dissociation reaction occurs on a surface in which one of the dissociation products sticks to the surface, while another is emitted. If the chemisorption reaction is particularly exothennic, the excess energy generated by chemical bond fomiation can be chaimelled into the kinetic energy of the desorbed dissociation fragment. An example of atom abstraction involves the reaction of molecular halogens with Si surfaces [27, 28]. In this case, one halogen atom chemisorbs while the other atom is ejected from the surface. 

Molecular rotation has two competing influences on the dissociation of diatomics [, and ]. A molecule will only be able to dissociate if its bond is oriented correctly with respect to the plane of the surface. If the bond is parallel to the plane, then dissociation will take place, whereas if the molecule is end-on to the surface, dissociation requires one atom to be ejected into the gas phase. In most cases, this reverse Eley-RideaF process is energetically very... 

Figure Bl.6.12 Ionization-energy spectrum of carbonyl sulphide obtained by dipole (e, 2e) spectroscopy [18], The incident-electron energy was 3.5 keV, the scattered incident electron was detected in the forward direction and the ejected (ionized) electron detected in coincidence at 54.7° (angular anisotropies cancel at this magic angle ). The energy of the two outgoing electrons was scaimed keeping the net energy loss fixed at 40 eV so that the spectrum is essentially identical to the 40 eV photoabsorption spectrum. Peaks are identified with ionization of valence electrons from the indicated molecular orbitals.

As with the quadmpole ion trap, ions with a particular m/z ratio can be selected and stored in tlie FT-ICR cell by the resonant ejection of all other ions. Once isolated, the ions can be stored for variable periods of time (even hours) and allowed to react with neutral reagents that are introduced into the trapping cell. In this maimer, the products of bi-molecular reactions can be monitored and, if done as a fiinction of trapping time, it is possible to derive rate constants for the reactions [47]. Collision-induced dissociation can also be perfomied in the FT-ICR cell by tlie isolation and subsequent excitation of the cyclotron frequency of the ions. The extra translational kinetic energy of the ion packet results in energetic collisions between the ions and background... 

Coincidence experiments explicitly require knowledge of the time correlation between two events. Consider the example of electron impact ionization of an atom, figure Bl.10.7. A single incident electron strikes a target atom or molecule and ejects an electron from it. The incident electron is deflected by the collision and is identified as the scattered electron. Since the scattered and ejected electrons arise from the same event, there is a time correlation... 

Figure Bl.10.7. Electron impact ionization coincidence experiment. The experiment consists of a source of incident electrons, a target gas sample and two electron detectors, one for the scattered electron, the other for the ejected electron. The detectors are coimected tlirough preamplifiers to the inputs (start and stop) of a time-to-amplitiide converter (TAC). The output of the TAC goes to a pulse-height-analyser (PHA) and then to a nuiltichaimel analyser (MCA) or computer.

Figure Bl.10.11. Electron impact double ionization triple coincidence experiment. Shown are the source of electrons, target gas, tluee electron detectors, one for the scattered electron and one for each of the ejected...

A number of surface-sensitive spectroscopies rely only in part on photons. On the one hand, there are teclmiques where the sample is excited by electromagnetic radiation but where other particles ejected from the sample are used for the characterization of the surface (photons in electrons, ions or neutral atoms or moieties out). These include photoelectron spectroscopies (both x-ray- and UV-based) [89, 9Q and 91], photon stimulated desorption [92], and others. At the other end, a number of methods are based on a particles-in/photons-out set-up. These include inverse photoemission and ion- and electron-stimulated fluorescence [93, M]- All tirese teclmiques are discussed elsewhere in tliis encyclopaedia. 

Dodonoy A I, Mashkova E S and Molchanov V A 1989 Medium-energy ion scattering by solid surfaces. Ill ejection of fast recoil atoms from solids under ion bombardment Rad. Eff. Def Sol. 110 227-341... 

Figure Bl.24.14. A schematic diagram of x-ray generation by energetic particle excitation, (a) A beam of energetic ions is used to eject inner-shell electrons from atoms in a sample, (b) These vacancies are filled by outer-shell electrons and the electrons make a transition in energy in moving from one level to another this energy is released in the fomi of characteristic x-rays, the energy of which identifies that particular atom. The x-rays that are emitted from the sample are measured witli an energy dispersive detector.

---