Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Efficiency horizontal

Prevalence of CWD in captive and wild herds is remarkably high and efficient horizontal transmission is driving it to epidemic proportions. [Pg.58]

There are many ways in which CWD prions could reach the soil and remain there. One possible route of soil contamination could be from decomposition of cervids infected with CWD. Though deer do not consume carcasses, they do forage on foliage that grows in abundance around the decomposition site [33], Prolonged exposure to fecal matter could also indicate efficient horizontal transmission. [Pg.59]

Keywords compressibility, primary-, secondary- and enhanced oil-recovery, drive mechanisms (solution gas-, gas cap-, water-drive), secondary gas cap, first production date, build-up period, plateau period, production decline, water cut, Darcy s law, recovery factor, sweep efficiency, by-passing of oil, residual oil, relative permeability, production forecasts, offtake rate, coning, cusping, horizontal wells, reservoir simulation, material balance, rate dependent processes, pre-drilling. [Pg.183]

Horizontal or multi-lateral wells can also be used to cost efficiently access remaining oil in mature fields. [Pg.213]

Easily interpretable patterns are observable the first one is an horizontal pattern, located around 15 Hz, and is due to Pilgrim noise. Four regularly spaced vertical patterns are also observable, and shows the detection efficiency. They are due to the presence of the 4 inner circonferential notchs of successive 60%, 40% 20% and 10% deepness notchs. [Pg.363]

Horizontally Mixing Aspirator Aerators. An aerator using a horizontally mixing aspirator has a marine propeller, submerged under water, attached to a soHd or a hoUow shaft. The other end of the shaft is out of the water and attached to an electric motor. When the propeller is rotated at high velocity, at either 1800 or 3600 rpm, a pressure drop develops around the propeller. Air is then aspirated under the water and mixed with the water, and moved out. This type of aerator, shown ia Figure 3g, is very efficient ia mixing wastewater. [Pg.342]

The saddle-shaped configuration (Fig. 22c) is the most efficient configuration for linear channels. The two saddle shaped cods are located parallel to each other the MHD channel is located in the gap between the two cods. The longitudinal part of the conductors Hes parallel to the direction of flow in the MHD channel, the direction of the field being transverse to the flow in the horizontal plane. This configuration is the most efficient in its use of magnetic... [Pg.434]

One of the most efficient implementations of the slurry process was developed by Phillips Petroleum Company in 1961 (Eig. 5). Nearly one-third of all HDPE produced in the 1990s is by this process. The reactor consists of a folded loop with four long (- 50 m) vertical mns of a pipe (0.5—1.0 m dia) coimected by short horizontal lengths (around 5 m) (58—60). The entire length of the loop is jacketed for cooling. A slurry of HDPE and catalyst particles in a light solvent (isobutane or isopentane) circulates by a pump at a velocity of 5—12 m/s. This rapid circulation ensures a turbulent flow, removes the heat of polymeriza tion, and prevents polymer deposition on the reactor walls. [Pg.384]

Phillips Petroleum Company developed an efficient slurry process used for the production of both HDPE and LLDPE (Eig. 6). The reactor is built as a large folder loop containing long mns of pipe from 0.5 to 1 m ia diameter coimected by short horizontal stretches of pipe. The reactor is filled with a light solvent (usually isobutane) which circulates through the loop at high speed. A mixed stream containing ethylene and comonomers (1-butene,... [Pg.401]

Gravity override of low density steam leads to poor volumetric sweep efficiency and low oil recovery in steam floods. Nonchemical methods of improving steam volumetric sweep efficiency include completing the injection well so steam is only injected in the lower part of the oil-bearing zone (181), alternating the injection of water and steam (182), and horizontal steam injection wells (183,184). Surfactants frequently are used as steam mobihty control agents to reduce gravity override (185). Field-proven surfactants include alpha-olefin sulfonates (AOS), alkyltoluene sulfonates, and neutralized... [Pg.193]


See other pages where Efficiency horizontal is mentioned: [Pg.316]    [Pg.535]    [Pg.201]    [Pg.154]    [Pg.161]    [Pg.88]    [Pg.316]    [Pg.535]    [Pg.201]    [Pg.154]    [Pg.161]    [Pg.88]    [Pg.95]    [Pg.43]    [Pg.407]    [Pg.408]    [Pg.114]    [Pg.64]    [Pg.144]    [Pg.101]    [Pg.398]    [Pg.398]    [Pg.400]    [Pg.407]    [Pg.544]    [Pg.544]    [Pg.67]    [Pg.188]    [Pg.513]    [Pg.513]    [Pg.251]    [Pg.413]    [Pg.414]    [Pg.415]    [Pg.436]    [Pg.182]    [Pg.119]    [Pg.184]    [Pg.169]    [Pg.244]    [Pg.245]    [Pg.158]    [Pg.158]    [Pg.158]    [Pg.472]    [Pg.902]    [Pg.1093]   
See also in sourсe #XX -- [ Pg.587 ]




SEARCH



Horizontal separator separation efficiency

© 2024 chempedia.info