Diethyl ether activation

Note 2. It is advisable to add first about 15 g of the chlorocyclohexane in one portion. After 5-15 min the diethyl ether should again begin to reflux. If this does not occur, one should not add more, since the magnesium apparently has not been sufficiently activated. 

An organozmc compound that occupies a special niche m organic synthesis is lodo methyhinc iodide (ICH2ZnI) It is prepared by the reaction of zinc-copper couple [Zn(Cu) zinc that has had its surface activated with a little copper] with diiodomethane m diethyl ether... 

Methyllithium. MethyUithium [917-54 ] CH Li, crystallizes from benzene or hexane solution giving cubic crystals that have a salt-hke constitution (128). Crystalline methyllithium molecules exist as tetrahedral tetramers (129). Solutions of methyllithium are less reactive than those of its higher homologues. Methyllithium is stable for at least six months in diethyl ether at room temperature. A one-molar solution of methyllithium in tetrahydrofuran (14 wt %) and cumene (83 wt %) containing 0.08 M dimethyknagnesium as stabilizer loses only 0.008% of its activity per day at 15°C and is nonpyrophoric (117). 

Benzoquinoline (phenanthridine) [229-87-8] M 179.2, m 108-109 , b 350 , pK 4.61. Chromatographed on activated alumina from benzene soln, with diethyl ether as eluent. Evapn of ether gave crystalline material which was freed from residual solvent under vacuum, then further purified by fractional crystn under N2, from its melt. Sublimes in vacuo. See also p. 324. 

Refluxed with activated charcoal in CHjClj, followed by recrystn from diethyl ether/pet ether or pet ether [Koolar and Kochi J Org Chem 52 4545 1987]. 

Under irradiation in diethyl ether, the dextrorotary enantiomer of 3,6-hexanooxepin-4-carb-oxylic acid rearranges to the oxabicyclo[3.2.0]heptadiene system with retention of the optical activity.36... 

Benzylzinc requires activation by copper(l) cyanidc/boron trifluoride-diethyl ether complex for rapid carbonyl addition29. Little information is available on the reactivity of benzyltitani-um derivatives30,31. 

Several reviews cover hetero-substituted allyllic anion reagents48-56. For the preparation of allylic anions, stabilized by M-substituents, potassium tm-butoxide57 in THF is recommended, since the liberated alcohol does not interfere with many metal exchange reagents. For the preparation of allylic anions from functionalized olefins of medium acidity (pKa 20-35) lithium diisopropylamide, dicyclohexylamide or bis(trimethylsilyl)amide applied in THF or diethyl ether are the standard bases with which to begin. Butyllithium may be applied advantageously after addition of one mole equivalent of TMEDA or 1,2-dimethoxyethane for activation when the functional groups permit it, and when the presence of secondary amines should be avoided. 

A solution of potassium naphthalenide is prepared from 2.0 g (50 mmol) of potassium and 6.4 g (50 mmol) of naphthalene in 40 mL ofTHF. After 1 h at r.t. this mixture is diluted with 10 mL of diethyl ether and 10 mL of petroleum ether (bp 40-60 °C) and cooled to — 120 °C. 4.5 g (25 mmol) of ( )-l-methoxy-3-phenylthio-1-propcne arc added followed by 3.36 g (25 mmol) of chlorobis(l-dimethylamino)borane. This mixture is allowed to warm to r.t. over 3 h the solvents are removed in vacuo and the residue is carefully distilled through a 5-cm column at 10 2 Torr. The distillate, containing also naphthalene, is dissolved in 30 mL of diethyl ether and treated with 2.95 g (25 mmol) of pinacol for 3 h. The crude product is chromatographed over 30 g of basic alumina (activity 1) using petroleum ether (bp 40 -60°C) giving 9.2 g of a mixture of product and naphthalene the yield of product (89% E) is determined to be 60% by H-NMR analysis. Similarly prepared is ... 

Much better results are achieved in the addition of butyllithium to oxime ethers 4a, 4b and 4c activated by boron trifluoride-diethyl ether complex (BF3 OEt2) at — 78 °C (above a reaction temperature of — 30 °C complex mixtures of products are obtained) using toluene as the solvent. Furthermore, the stereoselectivity depends on the E/Z ratio of the starting oxime ethers. The reaction appears to be highly stereoselective, with the diastereoselectivity of the... 

The dinitrophenylhydrazones were separated from the reaction mixture by thin-layer chromatography (silica gel G developed with benzene) and further purified by thin-layer chromatography on aluminum oxide G (petroleum ether-diethyl ether (96 to 4), silica gel G (chloroform), and silica gel G (diethyl ether)). In all cases, the specific activities of the dinitrophenylhydrazones remained constant over the course of the last two purifications. 

LP-DE has a weaker catalytic activity than BF3-Et20, AICI3 and TiCU because the Lewis acidity of the lithium cation is moderated by complex-ing with diethyl ether and perchlorate anion [37], but it becomes a highly oxophilic Lewis acid when concentrated solutions are used [38]. The concentration of LP-DE is therefore sometimes essential for the success of the reaction. 

Aqueous solutions are not suitable solvents for esterifications and transesterifications, and these reactions are carried out in organic solvents of low polarity [9-12]. However, enzymes are surrounded by a hydration shell or bound water that is required for the retention of structure and catalytic activity [13]. Polar hydrophilic solvents such as DMF, DMSO, acetone, and alcohols (log P<0, where P is the partition coefficient between octanol and water) are incompatible and lead to rapid denaturation. Common solvents for esterifications and transesterifications include alkanes (hexane/log P=3.5), aromatics (toluene/2.5, benzene/2), haloalkanes (CHCI3/2, CH2CI2/I.4), and ethers (diisopropyl ether/1.9, terf-butylmethyl ether/ 0.94, diethyl ether/0.85). Exceptionally stable enzymes such as Candida antarctica lipase B (CAL-B) have been used in more polar solvents (tetrahydrofuran/0.49, acetonitrile/—0.33). Room-temperature ionic liquids [14—17] and supercritical fluids [18] are also good media for a wide range of biotransformations. 

The enzymatic synthesis of polyesters from activated diesters was achieved under mild reaction conditions. The polymerization of bis(2,2,2-trichloroethyl) glutarate and 1,4-butanediol proceeded in the presence of PPL at room temperature in diethyl ether to produce the polyesters with molecular weight of 8.2 x 10. Vacuum was applied to shift the equilibrium forward by removal of the activated alcohol formed, leading to the production of high molecular weight polyesters. The polycondensation of bis(2,2,2-trifluoroethyl) sebacate and aliphatic diols took place using lipases BC, CR, MM, and PPL as catalyst in diphenyl ether. Under the... 

PPF catalyzed an enantioselective polymerization of bis(2,2,2-trichloroethyl) tra 5-3,4-epoxyadipate with 1,4-butanediol in diethyl ether to give a highly optically active polyester (Scheme 9). °° The molar ratio of the diester to the diol was adjusted to 2 1 to produce the (-) polymer with enantiomeric purity of >96%. The polymerization of racemic bis(2-chloroethyl) 2,5-dibromoadipate with excess of 1,6-hexanediol using lipase A catalyst produced optically active trimer and pentamer. The polycondensation of 1,4-cyclohexanedimethanol with fumarate esters using PPL catalyst afforded moderate diastereoselectivity for the cis/trans monocondensate and markedly increased diastereoselectivity for the dicondensate product. 

---