Cyclohexanone-4-carbonic acid

As pointed out by Stork and coworkers in their definitive 1963 paper3, the reaction with electrophilic alkenes is especially successful since reaction at nitrogen is reversible. Reaction at the /2-carbon is (usually) rendered irreversible by, in the case of cyclohexanone enamines, internal proton transfer of the axial C-/2 proton to the anionic centre of the initially formed zwitterionic intermediate (34), under conditions of stereoelectronic control (Scheme 22). When this intramolecular proton transfer cannot occur in aprotic solvents, or when the product produced in protic solvents is a stronger carbon acid than adduct 35 (i.e. when Z = COR, N02), then carbon alkylation is also reversible and surprising changes in the regioselectivity of reaction may be observed (vide infra see also Section VI.D and Chapter 26). Cyclobutanes (36) and, in the case of a,/ -unsaturated... 

Unlike the side products of cyclohexanone, acetic acid the reaction product of the MEK (corrosive ) will be removed from the activated carbon during steam desorption. Adsorption performance is thus maintained even after a number of cycles. 

They also studied tiie structure-catalyst activity relationship of phenol-based multiple carbon acids for the VMA reaction of cyclohexanone 115a (Table 1) [84]. By this study, triple carbon acid 117d was foxmd as one of the powerful but easy-to-handle acid catalysts. That is, in the presence of only 0.05 mol% of 117d, the VMA reaction of 115a with 109a gave the desired products 116-H and 116-Si in 83% yield. 

TABLE 1 Structure-catalyst activity Relationship of Phenol-based Multiple carbon Acids for the VMA reaction of Cyclohexanone 115a... 

Many chemical reactions are catalyzed by acids but on a large-scale can generate significant amoimts of acid waste, which requires neutralization and/ or disposal. In principle, CO dissolved in water is mildly acidic, due to formation of carbonic acid and should be capable of catalyzing a range of reactions. Simple pressure release at the end of the reaction brings the pH back to levels, which require minimal neutralization. Hydrolysis of ketal to cyclohexanone and ethylene glycol and epoxides to diols are a few examples where CO in presence of water have been used as a catalyst [322]. 

Required Cyclohexanone, 20 g. hydroxylamine hydrochloride, 17 g. anhydrous sodium carbonate, 13 g. concentrated sulphuric acid, 50 ml. 25% aqueous potassium hydroxide solution, approx. 200 ml. chloroform, 120 ml. 

The product (6 hexanohde) is a cyclic ester or lactone (Section 19 15) Like the Baeyer-Vilhger oxidation an oxygen atom is inserted between the carbonyl group and a carbon attached to it But peroxy acids are not involved m any way the oxidation of cyclohexanone is catalyzed by an enzyme called cyclohexanone monooxygenase with the aid of certain coenzymes... 

Furfuryl alcohol alone, or in combination with other cross-linkable binders such as phenoHc reins, chemical by-products and pitch, catalyzed with acid, gives carbon yields of 35—56%. Furfural together with cyclohexanone, pitch, or phenoHc resins gives, under acid catalysis, yields of 35—55% carbon under basic catalysis yields of 5—50% are achieved. FurfuryHdeneacetone resins (13 and 14), catalyzed by acid or base, give carbon yields of 48—56 and... 

Thermal decomposition of hydroxyalkyl hydroperoxyalkyl peroxides produces mixtures of starting carbonyl compounds, mono- and dicarboxyHc acids, cycHc diperoxides, carbon dioxide, and water. One specific hydroxyalkyl hydroperoxyalkyl peroxide from cyclohexanone (2, X = OH, Y = OOH) is a soHd that is produced commercially as a free-radical initiator and bleaching agent (see Table 5). On controlled decomposition, it forms 1,12-dodecanedioic acid (150). 

Allied-Signal Process. Cyclohexanone [108-94-1] is produced in 98% yield at 95% conversion by liquid-phase catal57tic hydrogenation of phenol. Hydroxylamine sulfate is produced in aqueous solution by the conventional Raschig process, wherein NO from the catalytic air oxidation of ammonia is absorbed in ammonium carbonate solution as ammonium nitrite (eq. 1). The latter is reduced with sulfur dioxide to hydroxylamine disulfonate (eq. 2), which is hydrolyzed to acidic hydroxylamine sulfate solution (eq. 3). 

N-Cyclohex-l-enylpyrrolidine (9 g 0 06 mol) was dissolved in pentane with A -ethyldiisopropylamine (7.8 g 0.06 mol). Perfluorohexyl iodide (13.4 g, 0.03 mol) IS added to the solution. Aprecipitate of A-ethyldiisopropylamine hydroiodide IS formed instantly After 3 h, the precipitate is filtered off, and the solution is evaporated The crude liquid is hydrolyzed with 6 mL of 40% sulfuric acid The mixture is stirred for 3 h and extracted with ether. The ether layer is neutralized with aqueous sodium hydrogen carbonate, washed with water, and dried over magnesium sulfate. The solvent is evaporated, and the residue is distilled. A second distillation with a spinning-band column yields 7 9 g (63%) of pure 2-(perfluoro-hexyl)cyclohexanone (bp, 71 -73 °C at 0 4 mm of Hg). 

The reactions of pyrrolidinocyelohexenes with acid have also been Considered from a stereochemical point of view. Deuteration of the 2-methylcyclohexanone enamine gave di-2-deuterio-6-methylcyclohexanone under conditions where ds-4-/-butyI-6-methyIpyrrolidinocycIohexene was not deuterated (2J4). This experiment supported the postulate of Williamson (2JS), which called for the axial attack of an electrophile and axial orientation of the 6 substituent on an aminocyclohexene in the transition state of such enamine reactions. These geometric requirements explain the more difficult alkylation of a cyclohexanone enamine on carbon 2, when it is substituted at the 6 position, as compared with the unsubstituted case. 

A mixture of cyclohexanone (11.8 g, 0.12 mole), ethylene glycol (8.2 g, 0.13 mole), /j-toluenesulfonic acid monohydrate (0.05 g), and 50 ml of benzene is placed in a 250-ml round-bottom flask fitted with a water separator and a condenser (drying tube). The flask is refluxed (mantle) until the theoretical amount of water (approx. 2.2 ml) has collected in the separator trap. The cooled reaction mixture is washed with 20 ml of 10 % sodium hydroxide solution followed by five 10-ml washes with water, dried over anhydrous potassium carbonate, and filtered. The benzene is removed (rotary evaporator) and the residue is distilled, affording l,4-dioxaspiro[4.5]decane, bp 65-67713 mm, 1.4565-1.4575, in about 80% yield. 

Laube and Hollenstein [21, 61] studied the single crystal structures of cyclohexanone derivatives complexed with a Lewis acid and found pyramidalization of the carbonyl carbon (4, Fig. 4), in agreement with the observed selectivity [61]. 

Classical Aldol. Aldol reaction is an important reaction for creating carbon-carbon bonds. The condensation reactions of active methylene compounds such as acetophenone or cyclohexanone with aryl aldehydes under basic or acidic conditions gave good yields of aldols along with the dehydration compounds in water.237 The presence of surfactants led mainly to the dehydration reactions. The most common solvents for aldol reactions are ethanol, aqueous ethanol, and water.238 The two-phase system, aqueous sodium hydroxide-ether, has been found to be excellent for the condensation reactions of reactive aliphatic aldehydes.239... 

In an attempt to form orally active penicillins unrelated to ampicillin, use was made of the fact that certain spiro a-aminoacids, such as 9, are well absorbed orally and transported like normal amino acids. Reaction of cyclohexanone with ammonium carbonate and KCN under the conditions of the Bucherer-Bergs reaction led to hydantoin 10. On acid hydrolysis, a-amino acid 11 resulted. Treatment with phosgene... 

---