Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Corrosion paints

An MS tank with a wall thickness of 3 mm is adequate, otherwise the thickness can be similar to that for the degreasing lank but without the healing arrangement. It may also be coated with an anti-corrosive paint to enhance its life. [Pg.401]

To rinse, wash the surface in clear, continuous running water to remove all traces of soluble salts which may cause blistering on the surface. The tank can be similar to the phosphating lank. It may, however, be coated with an anti-corrosive paint to extend its life. [Pg.404]

This is similar to that for phosphating. It may, however, be coaled with an anti-corrosive paint to extend its life. [Pg.404]

The selection of an anti-corrosion paint-coating scheme should be undertaken by a qualified expert. [Pg.909]

Improvements in process and quality control made significant contributions to the transition from iron to steel as the major ferrous construction material over a century and a half ago. For most of that time red lead was relied upon, and not without a remarkable degree of success, as the rust-inhibitive pigment in anti-corrosive paints. In the last twenty years, however, there has been a similar dramatic change from such simple paints as red lead to synthetic polymer coatings which have as complex a technology as steel manufacture itself. [Pg.1153]

Annually Sprinklers free from corrosion, paint, and obstructions pipe free from corrosion control valves lubricated, closed and opened trip test on dry-pipe, pre-action, and deluge systems... [Pg.352]

Anti-fouling tests were carried out on brush coated plastic laminate panels which had been given a primary coating of anti-corrosion paint. Performance was measured by visual observations of the panels after prolonged immersion (4 - 12 months) in a known high-fouling estuarine environment. [Pg.332]

Such a result brings up the question of paint. Most exposed metal structures are painted to delay corrosion. Paint is the ultimate corrosion inhibitor.8... [Pg.187]

This primer can be applied by brush, spray, or dipping and it functions by both improving the adhesion of subsequently apphed top coatings and by reducing the risk of underfilm corrosion. Paints used as the final coats are referred to as finishes or top coats. They are based on binders selected to withstand the conditions likely ... [Pg.243]

The tanks shall be placed on I-beams which are fixed on civil foundations. The tank bottom plates shall have anti-corrosive paint. [Pg.238]

Anti-corrosive pigments may be used in etch primer formulations (see above), or as components of the closely related anti-corrosive paints which are based on alkyd resins or other organic binders. Among the compounds used for the latter are [22]... [Pg.1069]

The action of these anti-corrosive paints is believed in most cases to result from the release of acid phosphate anions, caused by slow water penetration. [Pg.1070]

Corrosion-inhibiting paint See anti-corrosion paint or composition. [Pg.232]

Micaceous iron oxide n. Naturally occurring iron ore which resembles mica only in appearance and not chemically. It is converted to a grayish pigment, which has value as a constituent of anti-corrosive paints and protective coatings. Density, 4.90 g/cm (40.8lb/gal) O.A., 11/200 lb hardness (Mohs), 6.0 ph, 7.7. [Pg.618]

Procure only anti-skid gratings, in removable section for making work platforms (to enable maintenance/replacement of equipment etc.). They should be obtained with coating of anti-corrosive paints. Rubber coating may be employed and workers instmcted to use shoes with rabber soles to avoid sparking when explosive or inflammable vapours are present neaiby. [Pg.228]

Material to be dried per tray. (Capacity of each tray as dry material in kilogram.) MOC of trays and internals. In case of evolution of acidic vapours, the inside should have acid-resistant coating of fibre reinforced plastic or special anti corrosive paint. [Pg.246]

Make sure that mating surfaces of grounding and bonding cormections are clean, smooth, and free of corrosion, paint, and other insulating substances. [Pg.16]

The electrodes were divided into three categories namely, 3 untreated electrodes, 3 electrodes painted with anti-corrosion paint and 12 electrodes treated according with system I and system II. [Pg.187]

When in contact with other metals, the ratio of exposed aluminum to that of the more cathodic metal should be kept as high as possible. This reduces the current density on the aluminum. To minimize corrosion, paints and other coatings may be applied to both the aluminum and cathodic metal or... [Pg.511]

Rust-Inhibiting Paint See Anti-Corrosion Paint (Hare CH (2001) Paint film degradation - mechanisms and control. Steel Structures Paint Council, Pittsburg, Pennsylvania Baboian R (2002) Corrosion engineer s handbook, 3rd edn. NACE International - The Corrosion Society, Houston, TX Weismantal GF (1981) Paint handbook. McGraw-Hill, New York Keane JD (1970) Surface preparation new trends in anticorrosion coatings. International Congress, Milan, Italy). [Pg.642]


See other pages where Corrosion paints is mentioned: [Pg.922]    [Pg.157]    [Pg.401]    [Pg.902]    [Pg.903]    [Pg.157]    [Pg.199]    [Pg.147]    [Pg.922]    [Pg.477]    [Pg.120]    [Pg.121]    [Pg.214]    [Pg.1025]    [Pg.1069]    [Pg.854]    [Pg.847]    [Pg.229]    [Pg.226]    [Pg.385]    [Pg.795]    [Pg.774]    [Pg.43]    [Pg.298]    [Pg.284]   
See also in sourсe #XX -- [ Pg.33 , Pg.35 ]




SEARCH



Anti-Corrosive Paints

Corrosion Control by Coatings and Paint

Corrosion Protection by Painting

Corrosion inhibiting paints

Corrosion of Painted Materials

Corrosion paint coatings

Corrosion paints resistant

Crevice corrosion forming paints

Paint for corrosion

Paint scratch corrosion

Paint, for corrosion prevention

© 2024 chempedia.info