Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Mixtures column chromatography

The nitration of the 2-anilino-4-phenylselenazole (103) is much more complicated. Even careful nitration using the nitrate-sulfuric acid method leads to the formation of a mixture of variously nitrated compounds in an almost violent reaction. By the use of column chromatography as well as thin-layer chromatography a separation could be made, and the compounds could be partly identified by an independent synthesis. Scheme 33 shows a general view of the substances prepared. Ring fission was not obser ed under mild conditions. [Pg.243]

Mixtures passed through special columns (chromatography) in the gas phase (GC) or liquid phase (LC) can be separated into their individual components and analyzed qualitatively and/or quantitatively. Both GC and LC analyzers can be directly coupled to mass spectrometers, a powerful combination that can simultaneously separate and identify components of mixtures. [Pg.252]

Nltroestrone (2)/ Claylen was prepared from a mixture of Fe(N03)3 H2O (45 g Oil mol), K 10 bentonite clay and MeaCO (750 mL) Freshly prepared Claylen" (2 0 g) was added to estrone 1 (0 54 g 2 mmol) and PhMe (150 mL) The suspension was slirred overnight at 20° and filtered under vacuum The yellow liltraie was purified by column chromatography on sdica gel (n-hexane ElOAc 8 2] Evaporation of the corresponding fraction afforded 0 347 g of 2 (55%) mp 178 180°C... [Pg.255]

Prymnesin (toxic protein from phytoflagellate Pyrymnesium parvum) [11025-94-8]. Purified by column chromatography, differential soln and pptn in solvent mixtures and differential partition between diphasic mixtures. The product has at least 6 components as observed by TLC. [Ulitzur and Shilo Biochim Biophys Acta 301 350 1970.]... [Pg.563]

Toluene is a useful co-solvent in metal-ammonia reductions as first reported by Chapman and his colleagues. The author has found that a toluene-tetrahydrofuran-ammonia mixture (1 1 2) is a particularly useful medium for various metal-ammonia reductions. Procedure 8a (section V) describes the reduction of 17-ethyl-19-nortestosterone in such a system. Ethylene dibromide is used to quench excess lithium. Trituration of the total crude reduction product with methanol affords an 85% yield of 4,5a-dihydro-17-ethyl-19-nortestosterone, mp 207-213° (after sintering at 198°), reported mp 212-213°. For the same reduction using Procedure 5 (section V), Bowers et al obtained a 60% yield of crude product, mp, 196-199°, after column chromatography of the total reduction product. A similar reduction of 17-ethynyl-19-nortestosterone is described in Procedure 8b (section V). The steroid concentration in the toluene-tetrahydrofuran-ammonia system is 0.05 M whereas in the ether-dioxane-ammonia system it is 0.029 M. [Pg.44]

Into a suspension of 8 g of sodium acetate m 400 mL of a solution of 1 part acetic acid and 10 parts fluorotnchloromethane is passed at -75 C a stream of fluonne diluted to 10% with nitrogen The reacuon is stirred with a Vibromixer A solution of 4-methylacetanilide (20 mmol) in a mixture of dichloromethane and fluorotnchloromethane cooled to -75 °C i s added to 20 mmol of acetyl hypofluonte as determined by titration with potassium iodide After 5 min the mixture is poured into water, and the orgamc layer is washed with sodium bicarbonate soluaon and dried over anhydrous magnesium sulfate After concentrauon and column chromatography over silica gel and elution with chloroform, 2-fluoro-4-methylacetanilide IS obtained m 85% yield... [Pg.166]

Reaction of 5n,6,7,8,9,l l-hexahydropyrido[2,l-f ][l,3]benzothiazine-7,l 1-dione (47, X = S, R = H) and 2-amino-6-fluorobenzamidine dihydrochloride in boiling EtOH yielded a diastereomeric mixture of spiro derivatives 48 (X = S, R = H), which were separated by flash column chromatography (OOMIPl). [Pg.192]

This was converted to its imine with methylamine catalyzed by titanium tetrachloride and then sodium borohydride reduction produced 17 as a mixture of diastereomers. This was resolved by column chromatography to give sertraline [5]. Dextrorotatory cis sertraline is substantially more potent than its isomers. [Pg.57]

Column Chromatography Column Chromatography is a useful separation technique for mixtures resulting from intermediate to small scale synthetic processes. For example, nitroferrocene is conveniently isolated from a mixture of the product, ferrocene, and l,r-dinitroferrocene by chromatography on Activity I basic alumina at about the 100-g scale (Chapter 7, Section XI). [Pg.185]

A mixture of 22 parts of 1 -ethyl-1,4-dihydro-5H-tetrazol-5-one,45 parts of 1 -bromo-2-chloro-ethane,26 parts of sodium carbonate,0.3 part of potassium iodide and 240 partsof 4-methyl-2 pentanone is stirred and refluxed overnight with water-separator. The reaction mixture is cooled, water is added and the layers are separated. The aqueous phase is extracted three times with dichloromethane. The combined organic phases are dried, filtered and evaporated. The residue is purified by column-chromatography over silica gel using trichloromethane as eluent. The pure fractions are collected and the eluent is evaporated, yielding 28.4 parts (80%) of 1-(2-chloroethyi)-4-ethyl-1,4-dihydro-5H-tetrazol-5-one as a residue. [Pg.38]

To this solution was added at one time the above-obtained ethyl acetate solution at -15°C, and the resulting mixture was stirred for 1 hour at -10°C to -15°C. The reaction mixture was cooied to -30°C, and water (80 ml) was added thereto. The aqueous layer was separated, adjusted to pH 4.5 with sodium bicarbonate and subjected to column chromatography on Diaion HP-20 resin (Mitsubishi Chemical Industries Ltd.) using 25% aqueous solution of isopropyl alcohol as an eluent. The eluate was lyophilized to give 7-[2-methoxyimino-2-(2-amino-1,3-thiazol-4-yl)acetamido] cephalosporanic acid (syn isomer) (1.8 g), MP 227°C (decomp.). [Pg.274]

Synthesis of 16,16-dimethyl-trans-A -PGEi 2.35 g of the bis-tetrahydropyranyl ether were dissolved in 6 ml of tetrahydrofuran and 60 ml of 65%-acetic acid aqueous solution and the solution stirred at 60°C to 70°C for 20 minutes. The reaction mixture was extracted with ethyl acetate, and the organic layer was washed with water, dried and concentrated under reduced pressure. The residue was purified by column chromatography on silica gel using ethyl acetate-cyclohexane (2 3) as eluent to yield 270 mg of the title compound. [Pg.719]

A mixture of 4.98 g of acetoacetic acid N-benzyl-N-methylaminoethyl ester, 2.3 g of aminocrotonic acid methyl ester, and 3 g of m-nitrobenzaldehyde was stirred for 6 hours at 100°C in an oil bath. The reaction mixture was subjected to a silica gel column chromatography (diameter 4 cm and height 25 cm) and then eluted with a 20 1 mixture of chloroform and acetone. The effluent containing the subject product was concentrated and checked by thin layer chromatography. The powdery product thus obtained was dissolved in acetone and after adjusting the solution with an ethanol solution saturated with hydrogen chloride to pH 1 -2, the solution was concentrated to provide 2 g of 2,6-dimethyl-4-(3 -nitrophenyl)-1,4-dihydropyridlne-3,5-dicarboxylic acid 3-methylester-5- -(N-benzyl-N-methylamino)ethyl ester hydrochloride. The product thus obtained was then crystallized from an acetone mixture, melting point 136°Cto 140°C (decomposed). [Pg.1070]

Ben2yloxyindolyl-3)-Q -acetvlamino-Q -methylthiopropionic acid methanethiol ester (449 mg) was added to 10 ml of ethanol and further 1 ml of triethylamine was added to the mixture. Then, the reaction mixture was refluxed for 17 hours, after condensation under reduced pressure and subsequent separation of the residue by column chromatography (silica gel, ethyl acetate), 353 mg of methyl -(5-benzyloxyindolyl-3)-Q -acetylamino-Q -methylthio-propionate was obtained as colorless glasslike substance in the yield of 81.5%. Recrystallization of the substance from methanol water afforded 287 mg of crystals. [Pg.1138]

Raney nickel (3.5 cc) was suspended in 10 ml of ethanol and 356 mg of methyl -(5-ben2yl-oxyindolyl-3)-a -aminoacetyl-a -methylthiopropionate was added to the mixture together with 20 ml of ethanol. Then, the reaction mixture was stirred for 1 hour at room temperature and thereafter filtered to remove insoluble substances. The residue was washed with 100 ml of ethanol and 50 ml of acetone and both the filtrate and the wash liquid were combined and concentrated under reduced pressure. By column chromatography (silica gel and acetone), 210 mg of methyl -(5-hydroxyindolyl-3)-0 -acetylaminopropionate as colorless glasslike substance in the yield of 90%. [Pg.1138]

Careful chromatographic and detailed HNMR spectroscopic analysis of the products from the thermolyses of ethyl azidoformate in o-, m- and p-xylene revealed in all cases a mixture of 1 //-azepines.80 In o-xylene, only two of the four possible isomers were separated and characterized, namely, ethyl 4,5-dimethy 1-1 //-azepine-1 -carboxylate (9 %) and ethyl 3,4-dimethyl-l H-azepine-1-carboxylate (7 %). w-Xylene yielded a 2 3 mixture of ethyl 3,5-dimethyl-l//-azepine-1-carboxylate and ethyl 2,4-dimethyl-l//-azepine-l-carboxylate. The 2,4-dimethyl isomer (20 %) can be isolated from the mixture by removal of the 3,5-dimethyl isomer as its Diels-Alder cycloadduct with ethenetetracarbonitrile. p-Xylene gave a mixture of the two possible isomeric azepines which were partially separated by column chromatography. A pure sample of ethyl 2,5-dimethyl-1//-azepine-1-carboxylate (26%) was obtained from the mixture by selective decomposition of the 3,6-dimethyl isomer with refluxing alcoholic potassium hydroxide. [Pg.139]

A mixture of the arylsulfonyl chloride (5 mmol), benzene (2.56 mol), NaN3 (5 mmol), NaHCO, (20 mmol), and methyltrioctylammonium chloride (0.5 mmol), under N2 in an autoclave, was stirred al 40 C for 3 h. The mixture was then heated slowly to 125 C and maintained at this temperature for another 3 h, during which time the pressure in the vessel rose to 31 -54 atm. The mixture was allowed to cool and the autoclave was depressurized. The residual mass was filtered, and the residue washed thoroughly with cold H20. The benzene solution was separated from the aqueous filtrate, dried, and evaporated to give the crude product as a reddish yellow mass which was purified by column chromatography (neutral alumina, hexane/ benzene 3 2). The 1-(arylsulfonyl)-l//-azepines 16 were crystallized from light petroleum ether (bp 60-80 LC). [Pg.142]


See other pages where Mixtures column chromatography is mentioned: [Pg.97]    [Pg.132]    [Pg.51]    [Pg.99]    [Pg.178]    [Pg.179]    [Pg.1530]    [Pg.28]    [Pg.38]    [Pg.432]    [Pg.130]    [Pg.247]    [Pg.486]    [Pg.487]    [Pg.315]    [Pg.316]    [Pg.223]    [Pg.228]    [Pg.478]    [Pg.19]    [Pg.183]    [Pg.303]    [Pg.38]    [Pg.536]    [Pg.809]    [Pg.1129]    [Pg.1397]    [Pg.1432]    [Pg.90]    [Pg.432]    [Pg.122]   
See also in sourсe #XX -- [ Pg.462 , Pg.474 , Pg.479 ]




SEARCH



Column chromatography

Column chromatography columns

Further purification of the microbubble surfactant mixture by gel-filtration column chromatography

© 2024 chempedia.info