Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Codes international

Umfiorm Building Code, International Conference of Building Inspectors, Whittier, Calif., 1994. [Pg.340]

J.M. McGlaun and S.L. Thompson, CTH A Three-Dimensional Shock Wave Physics Code, Internal. J. Impact Engrg. 10 (1990). [Pg.349]

RID, deutsche Fassung, Bundesgesetzblatt, verschiedene Verlage IMDG Code, International Maritime Organization (IMO), London, 2002... [Pg.400]

Eor groove welds, height is the lesser of the measurements made from the surfaces of the adjacent components both reinforcement and internal protrusion are permitted in a weld. Eor fillet welds, height is measured from the theoretical throat defined by the code internal protrusion does not apply... [Pg.131]

The International Code Council (ICC) was formed by the consolidation of three formerly separate fire code organizations International Conference of Building Officials (ICBO), which had published the Uniform Fire Code under its fire service arm, the International Fire Code Institute (IFCI) Building Officials and Code Administrators (BOCA), which had published the National Fire Prevention Code and Southern Building Congress Code International (SBCCI), which had published the Standard Fire Prevention Code. When the three groups merged in 2000, in part to develop a common fire code, the individual codes became obsolete however, they are noted above since references to them may periodically surface. The consolidated code is IFC-2006, International Fire Code. [Pg.141]

IEC 60695-2-13 Fire Hazard Testing—Part 2-13 Glowing/Hot-Wire Based Test Methods—Glow-Wire Ignitability Test Method for Materials. International Electrotechnical Commission, Geneva, Switzerland. IMO FTP Code International Code for Application of Fire Test Procedures, Annex 1. Part 2. International Maritime Organization London, U.K. [Pg.382]

IMO FTP Code International Code for Application of Fire Test Procedures, Annex 1. Part 5. International Maritime Organization London, U.K. [Pg.382]

International Code of Safety for High-Speed Craft (HSC Code), International Maritime Organization, London, U.K. [Pg.662]

UMC, Uniform Mechanical Code, International Association of Plumbing and Mechanical Officials (IAPMO), Ontario, CA. [Pg.666]

Code International Map of the World. Maps from the US Geological Survey. Washington. Scale 1 250,000, 1968. [Pg.316]

FI. Ferguson, D. R., and D. M. ver Planck SIMULATE, Reactor Simulator Code, internal document, Yankee Atomic Electric Co., Westboro, Mass., 1972. [Pg.153]

International Air Transport Association International Civil Aviation Organization International Maritime Dangerous Goods Code International Maritime Organization International Organization for Standardization International Ship and Port Facility Security Inherently Safer Technology Information Technology... [Pg.188]

International Maritime Dangerous Goods Code, International Maritime Organization London 1997... [Pg.265]

ROTS Recommendations on the Safe Use of Pesticides in Ships, Supplement to the International Maritime Dangerous Goods Code, International Maritime Organization London 1997... [Pg.270]

Wee H.L. 2002. Oil well perforator design using 2D Eul-erian code. International Journal of Impact Engineering, 27 535-559. [Pg.170]

ICC (1999) International Fire Code, International Code Council, Inc., Falls Church, VA. [Pg.228]

The Southern Building Code, Southern Building Code International, Birmingham, AL, 1997. [Pg.121]

V.9] INTERNATIONAL MARITIME ORGANIZATION, International Code for the Safe Carriage of Irradiated Nuclear Fuel, Plutonium and High Level Radioactive Wastes in Elasks on Board Ships (INF code). International Maritime Dangerous Goods Code, Supplement 1994, IMO, London (1994). [Pg.327]

Auditing will be an integral part of the proposed TSMS. Internal and external audits will be incorporated, in a manner similar to audits associated with the ISM Code. Internal audits would be conducted by or on behalf of an organization s management, and external audits are to be conducted by an approved third-party auditor. Before an external audit, an operator must notify USCG, which may require one of its representatives to be present during the audit and could require an audit of its own. The results of any external audit must be submitted to USCG. [Pg.58]

G. E. Hansen and W. H. Roach, Sixteen Group Cross Sections for the Sq Code, Internal Los Alamos Report N-2-753. [Pg.54]

There are national fire codes, international fire codes, state codes and more. Most states have building codes that also address fire safety issues. Right now, most current state building codes address use and occupancy issues, building heights and building egress issues that are tied closely to the state fire codes. [Pg.92]


See other pages where Codes international is mentioned: [Pg.451]    [Pg.239]    [Pg.478]    [Pg.602]    [Pg.638]    [Pg.589]    [Pg.234]    [Pg.857]    [Pg.127]    [Pg.706]    [Pg.63]    [Pg.104]    [Pg.252]    [Pg.280]   


SEARCH



Building Officials and Code Administration International, Inc.

Building Officials and Code Administrators International

Code of Practice, International

International Building Code

International Code Council

International Code Council building

International Code Council mechanical

International Code of Medical Ethics

International Cyanide Management Code

International Energy Conservation Code

International Federation Associations , Code

International Fragrance Association Code

International Fragrance Association Code Practice

International Maritime Dangerous Goods Code

International Maritime Organization Code

International Safety Management Code

International Zeolite Association three-letter coding

International codes of conduct

SBCCI Code Congress International

Southern Building Code Congress International

Southern Building Code Congress International SBCCI)

© 2024 chempedia.info