Co-catalyzed

Holden et al. [27] reported the first Raman results on nanotubes produced from a Co-catalyzed carbon arc. Thread-like material removed from the chamber was encapsulated in a Pyrex ampoule in -500 Torr of He gas for Raman scattering measurements. Sharp first-order lines were observed at 1566 and 1592 cm and second-order lines al 2681 and 3180 cm , but only when cobalt was present in the core of the anode. These sharp lines had not been observed previously in... 

Fig. 10. (a) Raman spectra (T = 300 K) of arc-derived carbons from a dc arc cobalt was absent (dotted line) and cobalt was present (solid line) in the carbon anode, (b) the difference spectrum calculated from (a), emphasbjng the contribution from Co-catalyzed nanolubes, the inset to (b) depicts a Lorentzian fit to the first-order spectrum (after ref. [27]). 

In Fig. 11 we show the Raman speetrum of earbo-naeeous soot eontaining l-2 nm diameter, singlewall nanotubes produeed from Co/Ni-eatalyzed carbon plasma[28). These samples were prepared at MER, Inc. The sharp line components in the spectrum are quite similar to that from the Co-catalyzed carbons. Sharp, first-order peaks at 1568 cm and 1594 cm , and second-order peaks at -2680 cm" and -3180 cm are observed, and identified with single-wall nanotubes. Superimposed on this spectrum is the contribution from disordered sp carbon. A narrowed, disorder-induced D-band and an increased intensity in the second-order features of this sample indicate that these impurity carbons have been partially graphitized (i.e., compare the spectrum of carbon black prepared at 850°C, Fig. Id, to that which has been heat treated at 2820°C, Fig. Ic). 

Fig. 11. Raman spectrum (T = 300 K) of arc-derived carbons containing single-wall nanotubes generated in a Ni/Co-catalyzed dc arc (after ref. [42 ).

Finally, in second order, the Raman feature at — 3180 cm" observed in Co- and Ni/Co-catalyzed single-wall nanotube corresponds to a significantly downshifted 2 x fjg mode, where E g represents the mid-zone (see Figs, la and lb) frequency maximum of the uppermost optic branch seen in graphite at 3250 cm". ... 

Scheme 6. Otsuka and Tani s (+)-DIOP-Co-catalyzed asymmetric isomerization of diethylnerylamine (21) and cyclohexylgeranylamine (24).. ...

Jacobsen has utilized [(salen)Co]-catalyzed kinetic resolutions of tenninal epoxides to prepare N-nosyl aziridines with high levels of enantioselectivity [72], A range of racemic aryl and aliphatic epoxides are thus converted into aziridines in a four-step process, by sequential treatment with water (0.55 equivalents), Ns-NH-BOC, TFA, Ms20, and carbonate (Scheme 4.49). Despite the apparently lengthy procedure, overall yields of the product aziridines are excellent and only one chromatographic purification is required in the entire sequence. 

An impressive application of the (salen) Co-catalyzed intramolecular ARO of meso-epoxy alcohols in the context of total synthesis was reported recently by Danishefsky [33], Enantioselective desymmetrization of intermediate 9 by use of the cobalt acetate catalyst 8 at low temperatures afforded compound 10, which was obtained in 86% ee and >86% yield (Scheme 7.18). Straightforward manipulation of 10 eventually produced an intermediate that intersected Danishefsky s previ-... 

Two recent reports described addition of nitrogen-centered nucleophiles in usefully protected fonn. Jacobsen reported that N-Boc-protected sulfonamides undergo poorly selective (salen) Co-catalyzed addition to racemic epoxides. However, by performing a one-pot, indirect kinetic resolution with water first (HKR, vide infra, Table 7.1) and then sulfonamide, it was possible to obtain highly enantiomer-ically enriched addition products (Scheme 7.39) [71]. These products were transformed into enantioenriched terminal aziridines in straightforward manner. 

Although these reactions indicated the great potenhal of transihon metal-catalyzed reachons of organosulfides with C-C unsaturated organic compounds, little attenhon has been paid to such a combination of reactions for many years since then. In 1960, Holmquist and Carnaham reported the Co-catalyzed reachon of thiol with CO (1000 atm) at 250-300°C to afford thioester 3 in up to 46% yield with ca. 1-5 wt% of catalyst (Eq. 7.3) [14]. 

Thiol is acting as a co-catalyst in this transformation. In 1997, Alper et al. reported the reaction of thiols, propargyl alcohol, and CO catalyzed by Pd(PPli3)4 (Eq. 7.20)... 

Scheme 36.1. Co -catalyzed chain transfer of methacrylate free radical polymerization.

Given the absenee (or near absenee) of Mel in these reaetions, we sought to demonstrate the proeess on a eontinuous proeess. We purposely ehose to employ the same vapor take-off (vapor stripped) reaetor we used in om earher studies of the Rh/Mel co-catalyzed carbonylation of methanol (3) since the vapor stripping procedure used in the process would force any Mel formed in situ overhead where we could detect it in the effluent. This would represent the most rigorous test of the new non-Mel process we could contrive. 

After the initial two reports of Rh- and Co-catalyzed reductive aldol couplings, further studies did not appear in the literature until the late 1990s. Beyond 1998, several stereoselective and enantioselective reductive aldol reactions were developed, which are catalyzed by a remarkably diverse range of metal complexes, including those based upon Pd, Cu, Ir, and In. In this chapter, transition metal-catalyzed aldol, Michael, and Mannich reactions that proceed via transition metal hydride-promoted conjugate reduction are reviewed. 

In 1989, Isayama and Mukaiyama reported a related Co-catalyzed coupling reaction that employs a,b-unsaturated nitriles, amides, and esters with PhSiLb as a hydrogen source [9]. Cobalt-bis(diketonato) complex, Co(II)(dpm)2 [dpm = bis(dipivaloylmethanato)] (5mol%), exhibited high catalytic activity at 20 °C in the coupling of excess acrylonitrile and ben-zaldehyde to provide b-hydroxy nitrile 4 in 93% yield (syn anti = 50 50) (Scheme 5). N,N-Dimethylacrylamide and methyl cinnamate both reacted... 

Polymer-supported catalysts often have lower activities than the soluble catalysts because of the intraparticle diffusion resistance. In this case the immobilization of the complexes on colloidal polymers can increase the catalytic activity. Catalysts bound to polymer latexes were used in oxidation reactions, such as the Cu-catalyzed oxidation of ascorbic acid,12 the Co-catalyzed oxidation of tetralin,13 and the CoPc-catalyzed oxidation of butylphenol14 and thiols.1516 Mn(III)-porphyrin bound to colloidal anion exchange resin was... 

Havel Sb. Ved. Praci, Vysoka Chem. Tech-nol, Pardubice 1 (83), 1965] has suggested the following chain reaction mechanism for the Co+ + + catalyzed oxidation of aldehyde to peracetic acid. 

The combination of pericyclic transformations as cycloadditions, sigmatropic rearrangements, electrocydic reactions and ene reactions with each other, and also with non-pericyclic transformations, allows a very rapid increase in the complexity of products. As most of the pericyclic reactions run quite well under neutral or mild Lewis acid acidic conditions, many different set-ups are possible. The majority of the published pericyclic domino reactions deals with two successive cycloadditions, mostly as [4+2]/[4+2] combinations, but there are also [2+2], [2+5], [4+3] (Nazarov), [5+2], and [6+2] cycloadditions. Although there are many examples of the combination of hetero-Diels-Alder reactions with 1,3-dipolar cycloadditions (see Section 4.1), no examples could be found of a domino all-carbon-[4+2]/[3+2] cycloaddition. Co-catalyzed [2+2+2] cycloadditions will be discussed in Chapter 6. 

Co-catalyzed transformations are concerned mainly with the [2+2+2] cycloadditions of three alkyne groups to give arenes. Another important reaction is the [2+2+1] cycloaddition of alkynes, alkenes and CO to give cyclopentenones, which is the well-known as Pauson-Khand reaction [272]. 

The forerunner in the Co-catalyzed [2+2+2] cycloaddition domino processes was that identified by Vollhardt and colleagues [273], with their excellent synthesis of steroids. Reaction of 6/4-1 with [CpCo(CO)2] gave compound 6/4-3 with an aromatic ring B via the intermediate 6/4-2. In this process, trimerization of the three alkyne moieties first takes place, and this is followed by an electrocyclic ring opening of the formed cyclobutene to give o-quinodimethane. This then undergoes a Diels-Alder reaction to provide the steroid 6/4-3 (Scheme 6/4.1). 

Malacria and coworkers [274] used an intermolecular trimerization of alkynes to gain efficient access to the skeleton of the phyllocladane family. Thus, the Co-cata-lyzed reaction of the polyunsaturated precursor 6/4-4 gave 6/4-5 in 42% yield. Here, six new carbon-carbon bonds and four stereogenic centers are formed. The first step is formation of the cyclopentane derivative 6/4-6 by a Co-catalyzed Conia-ene-type reaction [275] which, on addition o f his( Iri me ill y I si ly 1) e thy ne (btmse), led to the benzocyclobutenes 6/4-7 (Scheme 6/4.2). The reaction is terminated by the addition of dppe and heating to reflux in decane to give the desired products 6/4-5 by an electrocyclic ring opening, followed by [4+2] cycloaddition. 

It is not quite clear which step takes place first - the Co-catalyzed [2+2+1] cycloaddition of the outer alkyne moiety, or the Diels-Alder reaction of the diene with the inner alkyne to form a 1,4-cyclohexadiene, which then undergoes a Pauson-Khand reaction with the remaining alkyne. Recently, it has been shown that a domino reaction can also be performed using 1 mol of a 1,7-diphenyl-1,6-diyne 6/4-20 and a 1,3-diene 6/4-21 in the presence of Co/C at 150 °C under 30 atm CO, to give the polycyclic compounds 6/4-22 as sole product (Scheme 6/4.7) [282]. 

Scheme 6/4.7. Co-catalyzed domino reactions of a 1,7-diyne with a 1,3-diene...

Metal Complexes as Catalysts for Oxygen, Nitrogen, and Carbon-atom Transfer Reactions 9.4.7.1.4 Co-catalyzed cyclopropanation... 

Usually the stronger acids are also the more effective co-catalysts, but exceptions to this rule are known. Trichloroacetic acid, but not the equally strong picric acid, will co-catalyze the system isobutene-titanium tetrachloride in hexane.2 8 Some Lewis acid-olefin systems will not polymerize at all in the absence of a co-catalyst, an example being isobutene with boron trifluoride.2 4 This fact, together with the markedly slower reaction usual with carefully dried materials, has nourished the current suspicion that a co-catalyst may be necessary in every Lewis acid-olefin polymerization. It is very difficult to eliminate small traces of water which could act as a co-catalyst or generate mineral acid, and it may well be that the reactions which are slower when drier would not go at all if they could be made completely dry. 

Palladium-catalyzed oxidation of hydrocarbons has been a matter of intense research for about four decades. The field was initiated by the development of the aerobic oxidation of ethylene to acetaldehyde catalyzed by palladium chloride and co-catalyzed by cupric chloride (the Wacker process, equation l)1. 

Table 2 [Ru"(TTP)(CO)]-catalyzed amidation of aromatic heterocycles with Phl=NTs...

On the other hand, for the Ru catalyzed water-gas shift reaction co-catalyzed by acid, Scheme 47 was proposed. 

---