As single substances

Curare was first examined by Roulin and Boussingalt, who isolated a syrupy body, which they named curarine much later a similar substance was obtained by Buchner, - and in 1865 Preyer announced that he had obtained curarine and its salts in a well-crystallised condition, and by analysis of the platinichloride, ascertained its composition to be C10H35N. Sachs - was only able to obtain an amorphous alkaloid, to which he assigned the formula CigHjjN. The work of Boehm explained to some extent these discrepant results he examined all three varieties and showed that they differed in composition, and that the isolation of the various curarines as single substances required special processes. 

The most important clinical question remains to evaluate the nephrotoxic potential of different analgesic ingredients, when used as single substance. 

A prerequisite for experimental determination of the anisotropic electrooptic properties (Ae, An) is the occurrence of a nematic phase with a defined order parameter S [4]. As single substances, many commercially used liquid crystalline materials have either no mesophase or a smectic phase only. As components of nematic basic mixtures on the other hand, they behave like typical liquid crystals. 

Of the infinitely large number of theoretically possible conformations, only some will be energetically favorable. These conformational isomers are called conformers, rotational isomers, or rotamers. However, they can only be isolated as single substances when the rotational barrier exceeds about 65-85 kJ/mol bond. The existence of conformers of lower rotational barriers was first presumed, however, in the 1930s on the basis of differences between calculated and observed entropies. 

Many scientifically and teclmologically important substances caimot be prepared as single-crystals large enough to be studied by single crystal diffraction of x-rays and, especially, neutrons. If a sample composed of... 

Place 16-20 ml. of the liquid mixture in a 50 ml. distilhng flask arranged for distillation (Fig. II, 13, 2), and heat the flask on a boiling water bath until no more liquid passes over redistil the distillate and if it is a single substance, identify it in the usual manner. Dissolve the residue (R) in ether and employ the same proportions as given for a sohd mixture. 

In dynamic FAB, this solution is the eluant flowing from an LC column i.e., the target area is covered by a flowing liquid (dynamic) rather than a static one, as is usually the case where FAB is used to examine single substances. The fast atoms or ions from the gun carry considerable momentum, and when they crash into the surface of the liquid some of this momentum is transferred to molecules in the liquid, which splash back out, rather like the result of throwing a stone into a pond (Figure 13.2). This is a very simplistic view of a complex process that also turns the ejected particles into ions (see Chapter 4 for more information on FAB/LSIMS ionization). 

If samples are largely pure, single substances, then the sample inlet can be quite simple, as with a direct insertion probe or a gas inlet. However, most analyses require assessment of the number of components, their relative proportions, and their chemical structures. This level... 

Evaporated milk is a Hquid product obtained by the partial removal of water only from milk. It has a minimum milk-fat content of 7.5 mol % and a minimum milk-solids content of 25.0 mol %. Evaporated skimmed milk is a Hquid product obtained by the partial removal of water only from skimmed milk. It has a minimum milk-solids content of 20.0 mol %. Sweetened condensed milk is a product obtained by the partial removal of water only from milk with the addition of sugars. It has a minimum milk-fat content of 8.0 mol % and a minimum milk-solids content of 28.0 mol %. Skimmed sweetened condensed milk is a product obtained by the partial removal of water only from skimmed milk with the addition of sugars. It has a minimum milk-solids content of 24.0 mol %. AH may contain food additives (qv) as stabilizers, in maximum amounts, including sodium, potassium, and calcium salts of hydrochloric acid at 2000 mg/kg singly citric acid, carbonic acid, orthophosphoric acid, and polyphosphoric acid at 3000 mg/kg in combination, expressed as anhydrous substances and in the evaporated milk carrageenin may be added at 150 mg/kg. 

Numerous toxicological studies have been conducted on a variety of plasticizers. However, because di-(2-ethylhexyl) phthalate (DEHP) is the most widely used plasticizer and is a well-defined single substance, it is the plasticizer that has been most thoroughly investigated in terms of its toxicology and has often been considered as a model for the other phthalates (36). 

By virtue of the nature of the paraffinic feedstocks readily available, commercial chlorinated paraffins are mixtures rather than single substances. The degree of chlorination is a matter of judgment by the manufacturers on the basis of their perception of market requirements as a result, chlorine contents may vary from one manufacturer to another. However, customers purchasing requirements often demand equivalent products from different suppHers and hence similar products are widely available. 

When a substance is transparent to visible light, such as single crystals of simple inorganic solids which do not contain uansition metal ions, or some glasses, anotlier significant component in the thermal conductivity is the transmission of photons in the infra-red region, which becomes more important with... 

Chemicals may be encountered as reactants, solvents, catalysts, inhibitors, as starting materials, finished products, by-products, contaminants, or off-specification products. They may vary from pure, single substances to complex proprietary formulations. 

In short, we may say that there is evidence that the deviations from the relations predicted by the characteristic equations may be due to chemical changes in the substances, which are not taken into consideration in the kinetic deduction of the equations. Weinstein loc. cit.) considers that it is possible to deduce an equation which takes account of these chemical changes as well. It will be sufficient here to re-einphasise the fact that there is at present no characteristic equation known which agrees accurately with the behaviour of a single substance, let alone various substances, over a wide range of temperature. 

As we saw in Section 5.1, a single substance can exist in different phases, or physical forms. The phases of a substance include its solid, liquid, and gaseous forms and its different solid forms, such as the diamond and graphite phases of carbon. In one case—helium—two liquid phases are known to exist. The conversion of a substance from one phase into another, such as the melting of ice, the vaporization of water, and the conversion of graphite into diamond, is called a phase transition (recall Section 6.11). 

As a result of its unique chemical and physical properties, silica gel is probably the most important single substance involved in liquid chromatography today. Without silica gel, it is doubtful whether HPLC could have evolved at all. Silica gel is an amorphous, highly porous, partially hydrated form of silica which is a substance made from the two most abundant elements in the earth s crust, silicon and oxygen. Silica, from which silica gel is manufactured, occurs naturally, either in conjunction with metal oxides in the form of silicates, such as clay or shale, or as free silica in the form of quartz, cristobalite or tridymite crystals. Quartz is sometimes found clear and colorless, but more often in an opaque form, frequently colored... 

LAs are not often used as a single substance, but are mixed preparations with adrenaline and preservatives. This has to be differentiated by the diagnostic procedure [9]. Pharmacologic effects of adrenaline (paleness, tachycardia, hypertension, feeling of fear) have to be differentiated from anaphylactic reactions to the LA substance [10]. 

Matter is anything that has mass and occupies space. A sample of matter can contain a single substance or any number of different substances. As already described, the building blocks of most substances are molecules, which in turn are composed of atoms. It is convenient to classify samples of matter according to the complexity of their composition, both at the atomic level and at the macroscopic level. 

Identify any mixture as homogeneous or heterogeneous. If the picture represents a single substance, tell whether it is an element or a chemical compound. 

---