Amination reactions double bonds

The reaction of diamines and bisdichloromaleimides proceeds with the displacement of one chlorine. The resulting poly(maleimide-amine) contain double bonds as well as chlorine in the backbone. The presence of double bonds in the backbone of these polymers also makes them susceptible to cross-linking reactions which may be initiated by heat. 

Note that for 4.42, in which no intramolecular base catalysis is possible, the elimination side reaction is not observed. This result supports the mechanism suggested in Scheme 4.13. Moreover, at pH 2, where both amine groups of 4.44 are protonated, UV-vis measurements indicate that the elimination reaction is significantly retarded as compared to neutral conditions, where protonation is less extensive. Interestingy, addition of copper(II)nitrate also suppresses the elimination reaction to a significant extent. Unfortunately, elimination is still faster than the Diels-Alder reaction on the internal double bond of 4.44. 

The Birch reductions of C C double bonds with alkali metals in liquid ammonia or amines obey other rules than do the catalytic hydrogenations (D. Caine, 1976). In these reactions regio- and stereoselectivities are mainly determined by the stabilities of the intermediate carbanions. If one reduces, for example, the a, -unsaturated decalone below with lithium, a dianion is formed, whereof three different conformations (A), (B), and (C) are conceivable. Conformation (A) is the most stable, because repulsion disfavors the cis-decalin system (B) and in (C) the conjugation of the dianion is interrupted. Thus, protonation yields the trans-decalone system (G. Stork, 1964B). 

Primary and secondary amines also react with epoxides (or in situ produced episulfides )r aziridines)to /J-hydroxyamines (or /J-mercaptoamines or 1,2-diamines). The Michael type iddition of amines to activated C—C double bonds is also a useful synthetic reaction. Rnally unines react readily with. carbonyl compounds to form imines and enamines and with carbo-tylic acid chlorides or esters to give amides which can be reduced to amines with LiAlH (p. Ilf.). All these reactions are often applied in synthesis to produce polycyclic alkaloids with itrogen bridgeheads (J.W. Huffman, 1967) G. Stork, 1963 S.S. Klioze, 1975). 

The reaction conditions applied are usually heating the amine with a slight excess of aldehyde and a considerable.excess of 2d-30hydrochloric acid at 100 °C for a few hours, but much milder ( physiological ) conditions can be used with good success. Diols, olefinic double bonds, enol ethers, and glycosidic bonds survive a Pictet-Spengler reaction very well, since phenol and indole systems are much more reactive than any of these acid sensitive functional groups (W.M. Whaley, 1951 J.E.D. Barton, 1965 A.R. Battersby, 1969). 

Allylic phosphates are used for carbonylation in the presence of amines under pressure. Carbonylation of diethyl neryl phosphate (389) affords ethyl homonerate (390), maintaining the geometric integrity of the double bond[244]. The carbonylation of allyl phosphate in the presence of the imine 392 affords the /3-lactam 393. The reaction may be explained by the formation of the ketene 391 from the acyl phosphate, and its stereoselective (2 + 2] cycloaddition to the imine 392 to give the /3-lactam 393(247],... 

Reactions between vinyl ethers or vinyl acetate and ethyleneimine have not been satisfactory (198), but ethyleneimine does add onto the double bond of /V,/V-dimethy1 vinyl amine to give 1-dimethyl amino-1-ethyleneiminoethane [5498-98-6] (217). 

Isocyanates are Hquids or soHds which are highly reactive and undergo addition reactions across the C=N double bond of the NCO group. Reactions with alcohols, carboxyUc acids, and amines have been widely exploited ia developiag a variety of commercial products. Cycloaddition reactions involving both the C=N and the C=0 double bond of the NCO group have been extensively studied and used for product development (1 9). 

Nucleophilic Addition Reactions. Many nucleophiles, including amines, mercaptans, and alcohols, undergo 1,4-conjugate addition to the double bond of methacrylates (12—14). 

Environmental Impact of Ambient Ozone. Ozone can be toxic to plants, animals, and fish. The lethal dose, LD q, for albino mice is 3.8 ppmv for a 4-h exposure (156) the 96-h LC q for striped bass, channel catfish, and rainbow trout is 80, 30, and 9.3 ppb, respectively. Small, natural, and anthropogenic atmospheric ozone concentrations can increase the weathering and aging of materials such as plastics, paint, textiles, and mbber. For example, mbber is degraded by reaction of ozone with carbon—carbon double bonds of the mbber polymer, requiring the addition of aromatic amines as ozone scavengers (see Antioxidants Antiozonants). An ozone decomposing polymer (noXon) has been developed that destroys ozone in air or water (157). 

Protonated /V-chloroalkyl amines under the influence of heat or uv light rearrange to piperidines or pyrroHdines (Hofmann-Lriffler reaction) (88). The free-radical addition of alkyl and dialkyl-/V-chloramines to olefins and acetylenes yields P-chloroalkji-, P-chloroalkenyl-, and 8-chloroalkenylamines (89). Various N-hiomo- and N-chloropolyfluoroaLkylarnines have been synthesized whose addition products to olefinic double bonds can be photolyzed to fluoroazaalkenes (90). 

These effects can be attributed mainly to the inductive nature of the chlorine atoms, which reduces the electron density at position 4 and increases polarization of the 3,4-double bond. The dual reactivity of the chloropteridines has been further confirmed by the preparation of new adducts and substitution products. The addition reaction competes successfully, in a preparative sense, with the substitution reaction, if the latter is slowed down by a low temperature and a non-polar solvent. Compounds (12) and (13) react with dry ammonia in benzene at 5 °C to yield the 3,4-adducts (IS), which were shown by IR spectroscopy to contain little or none of the corresponding substitution product. The adducts decompose slowly in air and almost instantaneously in water or ethanol to give the original chloropteridine and ammonia. Certain other amines behave similarly, forming adducts which can be stored for a few days at -20 °C. Treatment of (12) and (13) in acetone with hydrogen sulfide or toluene-a-thiol gives adducts of the same type. 

If the bismaleimide-amine reaction is carried out with a deficiency of amine the polymer will have terminal double bonds which allows a cure site to give a thermosetting polymer via a double bond polymerisation mechanism. This approach was developed by Ciba-Geigy with their product P13N (Figure 18.42). 

Secondary amines cannot form imines, and dehydration proceeds to give carbon-carbon double bonds bearing amino substituents (enamines). Enamines were mentioned in Chapter 7 as examples of nucleophilic carbon species, and their synthetic utility is discussed in Chapter 1 of Part B. The equilibrium for the reaction between secondary amines and carbonyl compounds ordinarily lies far to the left in aqueous solution, but the reaction can be driven forward by dehydration methods. 

The original compound, maleimide (2,5-dioxo-A -pyrroline), is synthesized by the cyclo-condensation of ammonia and maleic acid. Similarly, primary amine is added to maleic anhydride, followed by cyclocondensation, to form N-substituted maleimide (Fig. 2). This reaction is applied to the preparation of bis-maleimides (BMl) [1]. At first, BMI was used as a crosslinking agent for natural rubber (NR). An o-dichlorobenzene solution of NR was crosslinked by BMI at I08-150°C in the presence of peroxides. The radicals generated from peroxides react with the double bonds of both BMI and NR [ 1 ]. 

Generally, isolated olefinic bonds will not escape attack by these reagents. However, in certain cases where the rate of hydroxyl oxidation is relatively fast, as with allylic alcohols, an isolated double bond will survive. Thepresence of other nucleophilic centers in the molecule, such as primary and secondary amines, sulfides, enol ethers and activated aromatic systems, will generate undesirable side reactions, but aldehydes, esters, ethers, ketals and acetals are generally stable under neutral or basic conditions. Halogenation of the product ketone can become but is not always a problem when base is not included in the reaction mixture. The generated acid can promote formation of an enol which in turn may compete favorably with the alcohol for the oxidant. 

In some reactions intramolecular chalcogen nitrogen interactions may lead to stereochemical control. For example, selenenyl bromides react with C=C double bonds, providing a convenient method of introducing various functional groups. The reaction proceeds readily, but affords a racemic mixture. The modified reagent 15.22 contains a chiral amine in close interaction with the selenium atom. It reacts with olefins affording up to 97% ee of isomer A (Scheme 15.2). ... 

Although the emphasis in this chapter has been on tbe synthesis and mechanism of formation of simple enamines, brief mention will be made of the addition of amines to activated acetylenes to indicate the interest and activity in this area of substituted enamines. Since such additions tend to be stereospecific, inclusion in this section seems apropos. The addition of amines to acetylenes has been much studied 130), but the assigning of the stereochemistry about the newly formed double bond could not be done unequivocally until the techniques of NMR spectroscopy were well developed. In the research efforts described below, NMR spectroscopy was used to determine isomer content and to follow the progress of some of the reactions. 

Two different sets of experimental conditions have been used. Buu-Hoi et al. and Hansen have employed the method introduced by Papa et using Raney nickel alloy directly for the desulfurization in an alkaline medium. Under these conditions most functional groups are removed and this method is most convenient for the preparation of aliphatic acids. The other method uses Raney nickel catalysts of different reactivity in various solvents such as aqueous ammonia, alcohol, ether, or acetone. The solvent and activity of the catalyst can have an appreciable influence on yields and types of compounds formed, but have not yet been investigated in detail. In acetic anhydride, for instance, desulfurization of thiophenes does not occur and these reaction conditions have been employed for reductive acetylation of nitrothiophenes. Even under the mildest conditions, all double bonds are hydrogenated and all halogens removed. Nitro and oxime groups are reduced to amines. 

Depending on the electronic state of azafulvalene and the reaction conditions, simple nucleophiles such as amines or alcohols show a different behavior. Upon heating methanol reacted with azafulvalenes as electron-rich olefins by addition to the central double bond (64BSF2857 67LA155). Using the TAF 77 (Ar = Ph), the addition reaction in a neutral benzene-ethanol solution required several days to obtain a minor amount of 147, while the reaction proceeded rapidly in the presence of a catalytic amount of potassium hydroxide (79JOC1241). Tlie yellow-colored adduct 147 can be reconverted to the quinoid starting material by irradiation (Scheme 58). 

The ketocarbene 4 that is generated by loss of Na from the a-diazo ketone, and that has an electron-sextet, rearranges to the more stable ketene 2 by a nucleophilic 1,2-shift of substituent R. The ketene thus formed corresponds to the isocyanate product of the related Curtius reaction. The ketene can further react with nucleophilic agents, that add to the C=0-double bond. For example by reaction with water a carboxylic acid 3 is formed, while from reaction with an alcohol R -OH an ester 5 is obtained directly. The reaction with ammonia or an amine R -NHa leads to formation of a carboxylic amide 6 or 7 ... 

---