Alkenes Sharpless oxidation

The conversion of alkenes into epoxides is important not only because it is one of the most reliable routes leading from oxidation level 1 to level 2, but also because reactions of non-symmetrical epoxides with nucleophiles invariably proceed as an attack at the less substituted carbon with inversion of configuration. Thus, hydride reduction of epoxides represents an additional option for the preparation of alcohols (Scheme 2.62), especially valuable for the synthesis of optically pure isomers from epoxides obtained by the Sharpless oxidation. It is also of merit that as a result of alkene-epoxide conversion, a nucleophilic moiety (double bond) is transformed into an electrophilic epoxy ring. The latter... 

In contrast to the developments in the areas of arene oxidation, a general method for the controlled epoxidation of alkenes has not been found. There have been reports that indicate that terminal alkenes can be converted into optically active epoxides, but there is nothing yet to rival the Sharpless oxidation of allylic alcohols using a chiral titanium catalyst (Scheme 4.27) as a general synthetic method. However, it should be... 

With this reaction, two new asymmetric centers can be generated in one step from an achiral precursor in moderate to good enantiomeric purity by using a chiral catalyst for oxidation. The Sharpless dihydroxylation has been developed from the earlier y -dihydroxylation of alkenes with osmium tetroxide, which usually led to a racemic mixture. 

Asymmetric epoxidation is another important area of activity, initially pioneered by Sharpless, using catalysts based on titanium tetraisoprop-oxide and either (+) or (—) dialkyl tartrate. The enantiomer formed depends on the tartrate used. Whilst this process has been widely used for the synthesis of complex carbohydrates it is limited to allylic alcohols, the hydroxyl group bonding the substrate to the catalyst. Jacobson catalysts (Formula 4.3) based on manganese complexes with chiral Shiff bases have been shown to be efficient in epoxidation of a wide range of alkenes. 

Fig. 12.4. Successive models of the transition state for Sharpless epoxidation. (a) the hexacoordinate Ti core with uncoordinated alkene (b) Ti with methylhydroperoxide, allyl alcohol, and ethanediol as ligands (c) monomeric catalytic center incorporating t-butylhydroperoxide as oxidant (d) monomeric catalytic center with formyl groups added (e) dimeric transition state with chiral tartrate model (E = CH = O). Reproduced from J. Am. Chem. Soc., 117, 11327 (1995), by permission of the American Chemical Society. 

The osmium-catalyzed dihydroxylation reaction, that is, the addition of osmium tetr-oxide to alkenes producing a vicinal diol, is one of the most selective and reliable of organic transformations. Work by Sharpless, Fokin, and coworkers has revealed that electron-deficient alkenes can be converted to the corresponding diols much more efficiently when the pH of the reaction medium is maintained on the acidic side [199]. One of the most useful additives in this context has proved to be citric acid (2 equivalents), which, in combination with 4-methylmorpholine N-oxide (NMO) as a reoxidant for osmium(VI) and potassium osmate [K20s02(0H)4] (0.2 mol%) as a stable, non-volatile substitute for osmium tetroxide, allows the conversion of many olefinic substrates to their corresponding diols at ambient temperatures. In specific cases, such as with extremely electron-deficient alkenes (Scheme 6.96), the reaction has to be carried out under microwave irradiation at 120 °C, to produce in the illustrated case an 81% isolated yield of the pure diol [199]. 

Also fifteen years of painstaking work and the gradual improvement of the system, the Sharpless team announced that asymmetric dihydroxylation (AD) of nearly every type of alkene can be accomplished using osmium tetraoxide, a co-oxidant such as potassium ferricyanide, the crucial chiral ligand based on a dihydroquinidine (DHQD) (21) or dihydroquinine (DHQ) (22) and metha-nesulfonamide to increase the rate of hydrolysis of intermediate osmate esters 1811. 

A wide range of alkenes undergo the Sharpless AD reaction and the stereochemistry of the product diols can be predicted with a high degree of certainty, in most cases, through a simple mnemonic device (Figure 1.2). Thus the DHQD derivatives supplied with the oxidant have become known as AD-mix (3 while the DHQ derivatives (with oxidant) comprise AD-mix a[81]. Chosen from the... 

Diketones. The Sharpless procedure for oxidation of alkenes with NaIO catalyzed by Ru02 (11,462-463) is equally efficient for oxidation of alkynes to 1,2-diones. In fact, alkenes and alkynes react at a similar rate, but ether, epoxide, and ester groups are stable to the reagent. A 1-silylacetylene is oxidized to an acylsilane. Yields are moderate to high.1... 

In the case of prochiral alkenes the dihydroxylation reaction creates new chiral centers in the products and the development of the asymmetric version of the reaction by Sharpless was one of the very important accomplishments of the last years. He received the Nobel Price in Chemistry 2001 for the development of catalytic oxidation reactions to alkenes. 

The reaction mechanisms of these transition metal mediated oxidations have been the subject of several computational studies, especially in the case of osmium tetraoxide [7-10], where the controversy about the mechanism of the oxidation reaction with olefins could not be solved experimentally [11-20]. Based on the early proposal of Sharpless [12], that metallaoxetanes should be involved in alkene oxidation reactions of metal-oxo compounds like Cr02Cl2, 0s04 and Mn04" the question arose whether the reaction proceeds via a concerted [3+2] route as originally proposed by Criegee [11] or via a stepwise [2+2] process with a metallaoxetane intermediate [12] (Figure 2). 

Chromylchloride, Cr02Cl2, the main subject of the publication which led to the original discussion about the mechanism [12], shows a very different reactivity compared to the other transition metal oxides discussed above. Even in the absence of peroxides, it yields epoxides rather than diols in a complex mixture of products, which also contains cis-chlorohydrine and vicinal dichlorides. Many different mechanisms have been proposed to explain the great variety of products observed, but none of the proposed intermediates could be identified. Stairs et al. have proposed a direct interaction of the alkene with one oxygen atom of chromylchloride [63-65], while Sharpless proposed a chromaoxetane [12] formed via a [2+2] pathway. 

Further variations on the epoxyketone intermediate theme have been reported. In the first (Scheme 9A) [78], limonene oxide was prepared by Sharpless asymmetric epoxidation of commercial (S)-(-)- perillyl alcohol 65 followed by conversion of the alcohol 66 to the crystalline mesylate, recrystallization to remove stereoisomeric impurities, and reduction with LiAlH4 to give (-)-limonene oxide 59. This was converted to the key epoxyketone 60 by phase transfer catalyzed permanganate oxidation. Control of the trisubstituted alkene stereochemistry was achieved by reaction of the ketone with the anion from (4-methyl-3-pentenyl)diphenylphosphine oxide, yielding the isolable erythro adduct 67, and the trisubstituted E-alkene 52a from spontaneous elimination by the threo adduct. Treatment of the erythro adduct with NaH in DMF resulted... 

Sharpless stoichiometric asymmetric dihydroxylation of alkenes (AD) was converted into a catalytic reaction several years later when it was combined with the procedure of Upjohn involving reoxidation of the metal catalyst with the use of N-oxides [24] (N-methylmorpholine N-oxide). Reported turnover numbers were in the order of 200 (but can be raised to 50,000) and the e.e. for /rara-stilbene exceeded 95% (after isolation 88%). When dihydriquinidine (vide infra) was used the opposite enantiomer was obtained, again showing that quinine and quinidine react like a pair of enantiomers, rather than diastereomers. 

After the "asymmetric epoxidation" of allylic alcohols at the very beginning of the 80 s, at the end of the same decade (1988) Sharpless again surprised the chemical community with a new procedure for the "asymmetric dihydroxylation" of alkenes [30]. The procedure involves the dihydroxylation of simple alkenes with N-methylmorpholine A -oxide and catalytic amounts of osmium tetroxide in acetone-water as solvent at 0 to 4 °C, in the presence of either dihydroquinine or dihydroquinidine p-chlorobenzoate (DHQ-pClBz or DHQD-pClBz) as the chiral ligands (Scheme 10.3). 

Other functionalized supports that are able to serve in the asymmetric dihydroxylation of alkenes were reported by the groups of Sharpless (catalyst 25) [88], Sal-vadori (catalyst 26) [89-91] and Cmdden (catalyst 27) (Scheme 4.13) [92]. Commonly, the oxidations were carried out using K3Fe(CN)g as secondary oxidant in acetone/water or tert-butyl alcohol/water as solvents. For reasons of comparison, the dihydroxylation of trons-stilbene is depicted in Scheme 4.13. The polymeric catalysts could be reused but had to be regenerated after each experiment by treatment with small amounts of osmium tetroxide. A systematic study on the role of the polymeric support and the influence of the alkoxy or aryloxy group in the C-9 position of the immobilized cinchona alkaloids was conducted by Salvadori and coworkers [89-91]. Co-polymerization of a dihydroquinidine phthalazine derivative with hydroxyethylmethacrylate and ethylene glycol dimethacrylate afforded a functionalized polymer (26) with better swelling properties in polar solvents and hence improved performance in the dihydroxylation process [90]. 

Asymmetric epoxidation of olefins is an effective approach for the synthesis of enan-tiomerically enriched epoxides. A variety of efficient methods have been developed [1, 2], including Sharpless epoxidation of allylic alcohols [3, 4], metal-catalyzed epoxidation of unfunctionalized olefins [5-10], and nucleophilic epoxidation of electron-deficient olefins [11-14], Dioxiranes and oxazirdinium salts have been proven to be effective oxidation reagents [15-21], Chiral dioxiranes [22-28] and oxaziridinium salts [19] generated in situ with Oxone from ketones and iminium salts, respectively, have been extensively investigated in numerous laboratories and have been shown to be useful toward the asymmetric epoxidation of alkenes. In these epoxidation reactions, only a catalytic amount of ketone or iminium salt is required since they are regenerated upon epoxidation of alkenes (Scheme 1). 

By far the most commonly used - though not the most environmentally friendly -solvent is CCl (or more usually water-CCl ). In a classic paper Sharpless et al. showed that oxidation reactions of RuO (and other some Ru-based oxidants) were accelerated by addition of a little acetonitrile to the conventional water-CCl biphasic mixture. It was suggested that the CH3CN might function as a mild donor stabilising a lower oxidation state carboxylato Ru species which could be involved in the catalytic process [260]. A comparative study of CCl, acetone, ethyl acetate, cyclohexane and acetone for cleavage of alkenes and alkynes by RuClg/aq. IO(OH)3/solvent showed that cyclohexane was the most effective [216]. Other solvents sometimes... 

The first observation of the c/x-dihydroxylation reaction with RuO was made by Sharpless et al. in 1976, who noted that E and Z-cyclododecene were oxidised by stoich. RuO /EtOAc/-78 C to the threo and erythro diols [299]. Later RuCyaq. Na(IO )/EtOAc-CH3CN/0 C was used and reaction conditions optimised for many alkenes [300] a useful paper with good practical examples discusses the scope and limitations of the procedure (Table 3.2) [301]. Later oxidations were done with stoich. RuOyaq. acetone/-70 C [302] the same reagent converted A, and A steroids to cw-diols, ketones or acids [303], while RuO /aq. Na(10 )/acetone gave diones and acids [304]. 

A catalytic method for the allylic oxidation of alkenes was first reported by Umbreit and Sharpless in 1977, who utilized TBFIP as oxidant and Se02 as catalyst for selective aUylic oxidation. Yields were moderate providing aUylic alcohols or ketones with 54-86% yield. The reaction did not proceed under strictly anhydrous conditions but with one equivalent of water present the oxidation proceeds smoothly at room temperature. In... 

---