Alkenes ruthenium tetroxide

Ruthenium tetroxide can also be used in the oxidation of alkenes. Conditions that are selective for formation of ketols have been developed.36 Use of 1 mol % of RuC13 and five equivalents of KHS05 (Oxone ) in an ethyl acetate-acetonitrile-water mixture gives mainly hydroxymethyl ketones from terminal alkenes. 

Osmium tetroxide used in combination with sodium periodate can also effect alkene cleavage.191 Successful oxidative cleavage of double bonds using ruthenium tetroxide and sodium periodate has also been reported.192 In these procedures the osmium or ruthenium can be used in substoichiometric amounts because the periodate reoxidizes the metal to the tetroxide state. Entries 1 to 4 in Scheme 12.18 are examples of these procedures. Entries 5 and 6 show reactions carried out in the course of multistep syntheses. The reaction in Entry 5 followed a 5-exo radical cyclization and served to excise an extraneous carbon. The reaction in Entry 6 followed introduction of the allyl group by enolate alkylation. The aldehyde group in the product was used to introduce an amino group by reductive alkylation (see Section 5.3.1.2). 

The ruthenium tetroxide dioxide catalytic system is effective for the oxidation of alkanols, although it will also react with any alkene groups or amine substituents that are present. The catalyst can be used in aqueous acetonitrile containing tetra-butylammonium hydroxide with platinum electrodes in an undivided cell Primary alcohols are oxidised to the aldehyde and secondary alcohols to the ketone [30]. Anodic oxidation of ruthenium dioxide generates the tetroxide, which is the effective oxidising agent. 

Osmium tetroxide used in combination with sodium periodate can also effect alkene cleavage.135 Successful oxidative cleavage of double bonds using ruthenium tetroxide and sodium periodate has also been reported.136 In these procedures, the osmium or ruthenium can be used in substoichiometric amounts because the periodate reoxidizes the metal to the tetroxide state. Entries 1 4 in Scheme 12.17 are examples of these procedures. 

Ruthenium tetroxide is a four-electron oxidant which directly transforms alkenic compounds into oxidative cleavage products, i.e. carbonyl compounds and carboxylic acids.288 The reaction can be visualized as proceeding according to a [4 + 2] cycloaddition of the cis-dioxo moiety with the alkene, resulting in the formation of a RuVI cyclic diester which decomposes to ruthenium(IV) dioxide and oxidative cleavage products (equation 114).288 This reaction can be made catalytic... 

Oxidation of organic compounds by ruthenium tetraoxide has been reviewed. The oxidation of various types of organic compounds such as alkanes, alkenes, allenes, aromatic rings, alcohols, amines, and sulfides has been discussed The cyclic oxoruthe-nium(VI) diesters that are formed in the initial step of the oxidation of alkenes are considered to be intermediates in the formation of 1,2-diols.70 The development of new and selective oxidative transformations under ruthenium tetroxide catalysis during the past 10 years has been reviewed. The state of research in this field is summarized and a systematic overview of the reactivity and the reaction mode of ruthenium tetroxide is given.71... 

The oxidation of alkenes by ruthenium tetroxide is another example of a metal-oxo oxidation reaction where the mechansim was discussed. This compound is known to dihydroxylate alkenes and several groups have investigated its reactivity.59-67... 

Trithioles and 1,3,2-dioxathiolanes. 1,2,3-Trithiolanes are prepared by reaction of alkenes with elemental sulfur . The synthesis of 1,3,2-dioxathiolane -oxides (cyclic sulfites) and 1,3,2-dioxathiolane S, -dioxides (cyclic sulfates) is discussed in comprehensive reviews <1997AHC(68)89, 2000T7051>. The most widely used method for the preparation of 1,3,2-dioxathiolane A-oxides 557 is the reaction of the corresponding 1,2-diols 556 with thionyl chloride in the presence of pyridine or triethylamine (Scheme 251). More reactive 1,3,2-dioxathiolane S,A-dioxides 558 are usually obtained by oxidation of sulfites 557 with sodium periodate, which is mediated by ruthenium tetroxide generated in situ from a catalytic amount of ruthenium trichloride <1997AHC89, 2000T7051, CHEC-III(6.05.10.3)183>. 

A two-phase system (carbon tetrachloride and water) is often used for these reactions. It q>pears that contact between ruthenium tetroxide and the alkene takes place in the oiganic phase where they are both most soluble. The ruthenium dioxide produced when oxidation occurs is insoluble in all solvents and migrates to the interphase where it contacts the cooxidant (in the aqueous phase) and is reoxidized, as summarized in Scheme 3. Because good contact between all components is essential, best results are obtained when the mixture is shaken or stirred vigorously throughout the course of the reaction. Sharp-less and his coworkers have also found that the addition of acetonitrile to the two-phase mixture improves yields. 

Where functional groups are present which are more readily oxidized than the ether group, multiple reactions can occur. For example, in their total synthesis of (-i-)-tutin and (-i-)-asteromurin A, Yamada et al. observed concomitant oxidation of a secondary alcohol function in the oxidation of the ether (30) with ruthenium tetroxide (equation 24). The same group successfully achieved the simultaneous oxidation of both ether functions of the intermediate (31) in their related stereocontrolled syntheses of (-)-picrotox-inin and (-i-)-coriomyrtin (equation 25). Treatment of karahana ether (32) with excess ruthenium tetroxide resulted in the formation of the ketonic lactone (33) via oxidation of both the methylene group adjacent to the ether function and the exocyclic alkenic group (equation 26). In contrast, ruthenium tetroxide oxidation of the steroidal tetral drofuran (34) gave as a major product the lactone (35) in which the alkenic bond had been epoxidized. A small amount of the 5,6-deoxylactone (17%) was also isolated (equation 27). This transformation formed the basis of a facile introduction of the ecdysone side chain into C-20 keto steroids. 

Sodium periodate (sodium metaperiodate), NaI04 (mp 300 °C dec), which is commercially available, is applied mainly in aqueous or aqueous-alcoholic solutions. Like the free periodic acid, sodium periodate cleaves vicinal diols to carbonyl compounds [762], This reaction is especially useful in connection with potassium permanganate [763, 764] or osmium tetroxide [765], Such mixed oxidants oxidize alkenes to carbonyl compounds or carboxylic acids, evidently by way of vicinal diols as intermediates. Sulfides are transformed by sodium periodate into sulfoxides [322, 323, 766, 767, 768, 769, 770, 771, 772], and selenides are converted into selenoxides [773]. Sodium periodate is also a reoxidant of lower valency ruthenium in oxidations with ruthenium tetroxide [567, 774],... 

The applications of ruthenium tetroxide range from the common types of oxidations, such as those of alkenes, alcohols, and aldehydes to carboxylic acids [701, 774, 939, 940] of secondary alcohols to ketones [701, 940, 941] of aldehydes to acids (in poor yields) [940] of aromatic hydrocarbons to quinones [942, 943] or acids [701, 774, 941] and of sulfides to sulfoxides and sulfones [942], to specific ones like the oxidation of acetylenes to vicinal dicarbonyl compounds [9JS], of ethers to esters [940], of cyclic imines to lactams [944], and of lactams to imides [940]. 

The oxidative cleavage of alkenes resulting in the formation of carboxylic acids is also accomplished with chromium trioxide in sulfuric acid or acetic acid [567, 569] with potassium dichromate in sulfuric acid [1111] and with ruthenium tetroxide, generated in situ from ruthenium trichloride... 

A.iii. Ruthenium Reagents. Ruthenium compounds are powerful oxidizing agents that are capable of cleaving alkenes. In Table 3.1, ruthenium tetroxide (RuOq) showed a reduction potential of 0.59 V in the following reaction ... 

The phase-transfer-assisted permanganate oxidation of alkynes and alkenes has been reviewed. Terminal and internal alkynes are oxidized to 1,2-dicarbonyl compounds by the combined action of diphenyl disulphide, ammonium peroxidisulphate and water or by sodium periodate in the presence of ruthenium dioxide (equation 34). Other reagents for the conversion of acetylenes into 1,2-dicarbonyl compounds are hydrogen peroxide in the presence of (2,6-dicarboxylatopyridine)iron(II), the complex oxo(A, A -ethylenebissalicylideneiminato)chromium(V) trifluoromethanesulphonate (216)and ruthenium tetroxide as a mediator in electrooxidation. l-Acetoxyalkan-2-ones 217 are obtained by the oxidation of terminal acetylenes with sodium perborate and mercury(II) acetate in acetic acid ". Terminal alkynes give a-ketoaldehydes 218 on treatment with dilute hydrogen peroxide, combined with mercury(II) acetate and sodium molybdate or sodium tungstate under phase-transfer conditions. ... 

---