Alcohols metal catalyzed oxidations with

Two other examples of metal-catalyzed oxidations with RO2H which involve an oxometal pathway are the 0s04 catalyzed dihydroxylation of olefins [22] and the RuCls catalyzed oxidation of alcohols [23]. OSO4 catalyzed dihydroxylation is believed to involve a 2 -r 2 cycloaddition of oxoosmium(VIII) to the olefinic double bond followed by... 

The uncatalyzed hydroboration-oxidation of an alkene usually affords the //-Markovnikov product while the catalyzed version can be induced to produce either Markovnikov or /z/z-Markovnikov products. The regioselectivity obtained with a catalyst has been shown to depend on the ligands attached to the metal and also on the steric and electronic properties of the reacting alkene.69 In the case of monosubstituted alkenes (except for vinylarenes), the anti-Markovnikov alcohol is obtained as the major product in either the presence or absence of a metal catalyst. However, the difference is that the metal-catalyzed reaction with catecholborane proceeds to completion within minutes at room temperature, while extended heating at 90 °C is required for the uncatalyzed transformation.60 It should be noted that there is a reversal of regioselectivity from Markovnikov B-H addition in unfunctionalized terminal olefins to the anti-Markovnikov manner in monosubstituted perfluoroalkenes, both in the achiral and chiral versions.70,71... 

Metal-catalyzed oxidation of alcohols to aldehydes and ketones is a subject that has received significant recent attention [21,56,57]. One such method that utilizes NHC ligands is an Oppenauer-type oxidation with an Ir or Ru catalyst [58-62]. These alcohol oxidation reactions consist of an equilibrium process involving hydrogen transfer from the alcohol substrate to a ketone, such as acetone (Eq. 5), or an alkene. Because these reactions avoid the use of a strong oxidant, the potential oxidative instability of NHC ligands is less problematic. Consequently, these reactions represent an important target for future research into the utility of NHCs. 

The platinum-catalyzed oxidation with oxygen can also be applied for selective oxidation of secondary alcohols if no primary alcohol is present [73]. Like the tin-bromine method, axial secondary hydroxy groups will undergo preferential oxidation over equatorial hydroxy groups. However, as described above large amounts of platinum metal are required for these oxidations. Some improvement in catalyst activity has been achieved by promotion of platinum with bismuth or lead [76]. This also causes a change in selectivity and makes it possible in... 

One method of bypassing the stoichiometry problem involves the deliberate addition of a sacrificial reagents, which accept one of the 0-atom equivalents. Examples are metal-catalyzed oxidations of alkenes with O2 in the presence of alcohols, aldehydes etc. as co-reductants. While this approach is acceptable on a small-scale [32], it is impracticable for the production of bulk chemicals. More practicable co-reductants are molecular hydrogen and carbon monoxide, provided that Reactions 13 and 14 are appropriately mediated by a catalyst. 

Periodic acid can be applied as the stoichiometric oxidant in several transition metal catalyzed oxidations. Particularly useful are the chromium-catalyzed oxidations. In the presence of catalytic chromoyl diacetate, tertiary C—H bonds are oxidized to produce tertiary alcohols in moderate yields with retention of the original C—H stereochemistry, as exemplified in Scheme 3.369 [1320]. 

Metal-catalyzed oxidations of alcohols with peroxide reagents can be conveniently divided into two categories involving peroxometal and oxometal species, respectively, as the active oxidant (Figure 5.6). In the peroxometal pathway the metal ion remains in the same oxidation state throughout the catalytic cycle, and no stoichiometric oxidation is observed in the absence of the peroxide. In contrast, oxometal pathways involve a two-electron change in the oxidation state of the metal ion, and a stoichiometric oxidation is observed, with the oxidized form of the catalyst, in the... 

An innovative method is described in this case, which combines the use of a metal-catalyzed oxidation of propargylic alcohols with subsequent iminium-catalyzed sequence involving an original allenamine intermediate (Scheme 7.34) [52]. 

Epoxidation reactions have been widely utilized for over 100 years with peradds, peroxides and, more recently, metal catalysts [7]. However, direct metal-catalyzed aerobic epoxidations are rare and generally require an aldehyde coreductant. In this case, the metal is proposed to catalyze radical formation (A-C, Scheme 5.2) followed by O2 insertion to form acyl peroxide D. Metal-catalyzed aerobic oxidation of aldehydes to peradds has previously been observed [8]. With the formation of species D, either an outer-sphere path similar to a peracid-type oxidation occurs (Path 1) or an inner-sphere metal-catalyzed oxidation in which the metal-based oxidant and substrate interact during oxygen transfer (Path 2 or 3). Mu-kaiyama and coworkers were the first to report an aerobic epoxidation of olefins catalyzed by transition metals using either a primary alcohol or an aldehyde as coreductants [9]. The role of the metal was probed through parallel studies of peracid and metal-catalyzed epoxidations of 2 which yielded different stereochemical outcomes. Therefore, a metal-centered mechanism for olefin epoxidation was proposed which implicates an oxygenase system. Path 2 or 3 (Table 5.1) [10]. 

The first, and so far only, metal-catalyzed asymmetric 1,3-dipolar cycloaddition reaction of nitrile oxides with alkenes was reported by Ukaji et al. [76, 77]. Upon treatment of allyl alcohol 45 with diethylzinc and (l ,J )-diisopropyltartrate, followed by the addition of diethylzinc and substituted hydroximoyl chlorides 46, the isoxazolidines 47 are formed with impressive enantioselectivities of up to 96% ee (Scheme 6.33) [76]. 

Zinc-tartrate complexes were applied for reactions of both nitrones and nitrile oxides with allyl alcohol and for both reaction types selectivities of more than 90% ee were obtained. Whereas the reactions of nitrones required a stoichiometric amount of the catalyst the nitrile oxide reactions could be performed in the presence of 20 mol% of the catalyst. This is the only example on a metal-catalyzed asymmetric 1,3-dipolar cycloaddition of nitrile oxides. It should however be no-... 

Dioxygen is a cheap and ideal source of oxygen but it is very difficult to activate and there are relatively few examples of 02 oxidations catalyzed by zeolite-encapsulated complexes. Encapsulated CoPc is active for the oxidation of propene to aldehyde, whereas the free complex is inactive.104 A triple catalytic system, Pd(OAc)2, benzoquinone, and a metal macrocycle, was used to oxidize alkenes with molecular oxygen at room temperature.105 Zeolite-encapsulated FePc106-108 and CoSalophen (Scheme 7.5)107109 complexes were used as oxygen-activating catalysts. With the use of a Ru complex instead of Pd(OAc)2 in the triple catalytic system, primary alcohols can be oxidized selectively to aldehydes.110... 

During the past few years, increasing numbers of reports have been published on the subject of domino reactions initiated by oxidation or reduction processes. This was in stark contrast to the period before our first comprehensive review of this topic was published in 1993 [1], when the use of this type of transformation was indeed rare. The benefits of employing oxidation or reduction processes in domino sequences are clear, as they offer easy access to reactive functionalities such as nucleophiles (e. g., alcohols and amines) or electrophiles (e. g., aldehydes or ketones), with their ability to participate in further reactions. For that reason, apart from combinations with photochemically induced, transition metal-catalyzed and enzymatically induced processes, all other possible constellations have been embedded in the concept of domino synthesis. 

Wilkinson s catalyst has also been utilized for the hydroboration of other alkenes. Sulfone derivatives of allyl alcohol can be hydroborated with HBcat and subsequently oxidized to give the secondary rather than primary alcohol. This reactivity proves to be independent of substituents on the sulfur atom.36 Similarly, thioalkenes undergo anti-Markovnikoff addition to afford a-thioboronate esters.37 The benefits of metal-catalyzed reactions come to the fore in the hydroboration of bromoalkenes (higher yields, shorter reaction times), although the benefits were less clear for the corresponding chloroalkenes (Table 3).38,39 Dienes can be hydroborated using both rhodium and palladium catalysts [Pd(PPh3)4] reacts readily with 1,3-dienes, but cyclic dienes are more active towards [Rh4(CO)i2].40... 

Hydrogen transfer reactions from an alcohol to a ketone (typically acetone) to produce a carbonyl compound (the so-caUed Oppenauer-type oxidation ) can be performed under mild and low-toxicity conditions, and with high selectivity when compared to conventional methods for oxidation using chromium and manganese reagents. While the traditional Oppenauer oxidation using aluminum alkoxide is accompanied by various side reactions, several transition-metal-catalyzed Oppenauer-type oxidations have been reported recently [27-29]. However, most of these are limited to the oxidation of secondary alcohols to ketones. 

Asymmetric epoxidation of olefins is an effective approach for the synthesis of enan-tiomerically enriched epoxides. A variety of efficient methods have been developed [1, 2], including Sharpless epoxidation of allylic alcohols [3, 4], metal-catalyzed epoxidation of unfunctionalized olefins [5-10], and nucleophilic epoxidation of electron-deficient olefins [11-14], Dioxiranes and oxazirdinium salts have been proven to be effective oxidation reagents [15-21], Chiral dioxiranes [22-28] and oxaziridinium salts [19] generated in situ with Oxone from ketones and iminium salts, respectively, have been extensively investigated in numerous laboratories and have been shown to be useful toward the asymmetric epoxidation of alkenes. In these epoxidation reactions, only a catalytic amount of ketone or iminium salt is required since they are regenerated upon epoxidation of alkenes (Scheme 1). 

---