Addition reactions derivatives

Discuss Frontier Molecular Orbital (F.M.O.) method of analysing cyclic addition reactions. Derive selection rules for cyclic addition reactions. 

The Michael Addition Reaction consists in the addition of the sodio-derivative of ethyl acetoacetate, ethyl malonate or ethyl cyanoacetate to an olefine group... 

Finally a general approach to synthesize A -pyrrolines must be mentioned. This is tl acid-catalyzed (NH4CI or catalytic amounts of HBr) and thermally (150°C) induced tea rangement of cyclopropyl imines. These educts may be obtained from commercial cyan> acetate, cyclopropyl cyanide, or benzyl cyanide derivatives by the routes outlined below. Tl rearrangement is reminiscent of the rearrangement of 1-silyloxy-l-vinylcyclopropancs (p. 7 83) but since it is acid-catalyzed it occurs at much lower temperatures. A -Pyrrolines constitut reactive enamines and may be used in further addition reactions such as the Robinson anei lation with methyl vinyl ketone (R.V. Stevens, 1967, 1968, 1971). 

The organotin maleate and maleate half-ester derivatives also exhibit this bleaching effect reportedly by a Diels-Alder addition reaction (18). The reaction is specific to the organotin maleates other organotin carboxylates containing normal dieneopltiles fail to produce similar results (19). 

Iodine adds to carbon—carbon double bonds to form polyiodine derivatives. These addition reactions are reversible, however, and do not go to completion. 

Methacryhc acid and its ester derivatives are Ctfjy -unsaturated carbonyl compounds and exhibit the reactivity typical of this class of compounds, ie, Michael and Michael-type conjugate addition reactions and a variety of cycloaddition and related reactions. Although less reactive than the corresponding acrylates as the result of the electron-donating effect and the steric hindrance of the a-methyl group, methacrylates readily undergo a wide variety of reactions and are valuable intermediates in many synthetic procedures. 

Chemical Properties. Higher a-olefins are exceedingly reactive because their double bond provides the reactive site for catalytic activation as well as numerous radical and ionic reactions. These olefins also participate in additional reactions, such as oxidations, hydrogenation, double-bond isomerization, complex formation with transition-metal derivatives, polymerization, and copolymerization with other olefins in the presence of Ziegler-Natta, metallocene, and cationic catalysts. All olefins readily form peroxides by exposure to air. 

Quinone Methides. The reaction between aldehydes and alkylphenols can also be base-cataly2ed. Under mild conditions, 2,6-DTBP reacts with formaldehyde in the presence of a base to produce the methylol derivative (22) which reacts further with base to eliminate a molecule of water and form a reactive intermediate, the quinone methide (23). Quinone methides undergo a broad array of transformations by way of addition reactions. These molecules ate conjugated homologues of vinyl ketones, but are more reactive because of the driving force associated with rearomatization after addition. An example of this type of addition is between the quinone methide and methanol to produce the substituted ben2yl methyl ether (24). 

Rifamycin S also undergoes conjugate addition reactions to the quinone ring by a variety of nucleophiles including ammonia, primary and secondary amines, mercaptans, carbanions, and enamines giving the C-3 substituted derivatives (38) of rifamycin SV (117,120,121). Many of the derivatives show excellent antibacterial properties (109,118,122,123). The 3-cycHc amino derivatives of rifamycin SV also inhibit the polymerase of RNA tumor vimses (123,124). 

Polyether Polyols. Polyether polyols are addition products derived from cyclic ethers (Table 4). The alkylene oxide polymerisation is usually initiated by alkah hydroxides, especially potassium hydroxide. In the base-catalysed polymerisation of propylene oxide, some rearrangement occurs to give aHyl alcohol. Further reaction of aHyl alcohol with propylene oxide produces a monofunctional alcohol. Therefore, polyether polyols derived from propylene oxide are not truly diftmctional. By using sine hexacyano cobaltate as catalyst, a more diftmctional polyol is obtained (20). Olin has introduced the diftmctional polyether polyols under the trade name POLY-L. Trichlorobutylene oxide-derived polyether polyols are useful as reactive fire retardants. Poly(tetramethylene glycol) (PTMG) is produced in the acid-catalysed homopolymerisation of tetrahydrofuran. Copolymers derived from tetrahydrofuran and ethylene oxide are also produced. 

The NOBS system undergoes an additional reaction that forms a diacyl peroxide as a result of the nucleophilic attack of the peracid anion on the NOBS precursor as shown in equation 21. This undesirable side reaction can be minimized by the use of an excess molar quantity of hydrogen peroxide (91,96) or by the use of shorter dialkyl chain acid derivatives. However, the use of these acid derivatives also appears to result in less efficient bleaching. The dependence of the acid group on the side product formation is apparentiy the result of the proximity of the newly formed peracid to unreacted NOBS in the micellar environment (91). A variety of other peracid precursor stmctures can be found (97—118). 

Alkylation of isobutylene and isobutane in the presence of an acidic catalyst yields isooctane. This reaction proceeds through the same mechanism as dimerization except that during the last step, a proton is transferred from a surrounding alkane instead of one being abstracted by a base. The cation thus formed bonds with the base. Alkylation of aromatics with butylenes is another addition reaction and follows the same general rules with regard to relative rates and product stmcture. Thus 1- and 2-butenes yield j -butyl derivatives and isobutylene yields tert-huty derivatives. 

Cyclopentadiene contains conjugated double bonds and an active methylene group and can thus undergo a Diels-Alder diene addition reaction with almost any unsaturated compound, eg, olefins, acetylene, maleic anhydride, etc. The number of its derivatives is extensive only the reactions and derivatives considered most important are discussed. 

As a result of the diene addition reaction, CPD has been converted into innumerable derivatives, some of which are tabulated in Table 3. The products obtained from the diene addition reaction are extremely versatile chemicals suitable as intermediates for the production of plasticizers, pharmaceuticals, pesticides, resins, paint driers, perfumes, and many other products. 

Studies on covalent hydration of N-heterocycles (67AG(E)919,76AHC(20)117) have revealed the diagnostic value of alkyl substituents in structural assignments due to their steric hindrance effects in addition reactions. C-Methyl substituents are therefore also considered as molecular probes to solve fine-structural problems in the pteridine field. The derivatives... 

The use of carbon nucleophiles in Michael-type addition reactions with pteridine and its derivatives leads to a quite complicated and divergent pattern. These reactions are strongly dependent on the nature of the carbon nucleophile and can be divided into various categories. 

Furan and thiophene undergo addition reactions with carbenes. Thus cyclopropane derivatives are obtained from these heterocycles on copper(I) bromide-catalyzed reaction with diazomethane and light-promoted reaction with diazoacetic acid ester (Scheme 41). The copper-catalyzed reaction of pyrrole with diazoacetic acid ester, however, gives a 2-substituted product (Scheme 42). 

Azirine, trans-2-methyl-3-phenyl-racemization, 7, 33, 34 1-Azirine, 2-phenyl-reactions, 7, 69 with carbon disulfide, S, 153 1-Azirine, 3-vinyl-rearrangements, 7, 67 Azirines, 7, 47-93 cycloaddition reactions, 7, 26 fused ring derivatives, 7, 47-93 imidazole synthesis from, 5, 487-488 photochemical addition reactions to carbonyl compounds, 7, 56 photolysis, 5, 780, 7, 28 protonated... 

A number of other natural rubber derivatives may be prepared by addition reaction at the double bond. 

Newer silicone adhesives having solids levels up to 97% are also commercially available [109]. Instead of using silanol condensation reactions, they rely on addition chemistry between vinyl functional silicone oligomers and silicon hydride terminated silicones. This addition reaction is typically facilitated with platinum derived catalysts. This hydrosilation process can be run at reduced oven temperatures, but the finished products typically do not yield the same balance of properties as seen for condensation cure materials. 

The regiochemistry is determined by the regiochemistry of the fluoride ion addition reaction, that is, via the most stable perfluorocarbanion intermediate Von Werner used a similar reaction to prepare silver compounds from perfluoro-2-methyl-2-butene and perfluoro 2 methyl-2-pentene [271] Silver(I) fluoride adds to bis(ttitluoromethyl)ketene in DMF without fluoride ion catalysis [270] The analogous trifluorovinylsulfurpentafluoride reacts similarly to give the isolable pentafluorosulfur derivative [272] (equation 187)... 

The classification of hydrocar bons as aliphatic or ar omatic took place in the 1860s when it was aheady apparent that there was something special about benzene, toluene, and their- derivatives. Their molecular- for-mulas (benzene is CgHg, toluene is CyKj ) indicate that, like alkenes and alkynes, they are unsaturated and should undergo addition reactions. Under conditions in which bromine, for example, reacts rapidly with alkenes and alkynes, however, benzene proved to be inert. Benzene does react with Br-2 in the presence of iron(III) bromide as a catalyst, but even then addition isn t observed. Substitution occurs instead ... 

Pyrazole and its 3,5-dimethyl and 3,4,5-trimethyl derivatives combined with two moles of dimethyl acetylenedicarboxylate giving products of similar ultraviolet absorption spectra to the parent pyrazoles. These products [e.g., (69)] do not possess the strong broad absorption at ca. 3.20 /u, characteristic of the bonded N—H group which is present in the parent pyrazoles and are formed by two successive Michael addition reactions. In the case of 3,5-dimethylpyra-zole, the initial fumarate (68) has been isolated and possessed a more conjugated type of absorption spectrum to those of the dipyrazolyl-... 

The triple bond in pyrazole derivatives gives, as do other acetylene derivatives, typical addition reactions. 

Reduction of 3,5,5-tris-aryl-2(5// )-furanones 115 (R, R, R = aryl) with dimethyl sulfide-borane led to the formation of the 2,5-dihydrofurans 116 in high yields. However, in the case of 3,4-diaryl-2(5//)-furanones 115 (R, R = aryl R = H or r = H R, R = aryl), the reduction led to a complicated mixture of products of which only the diarylfurans 117 could be characterized (Scheme 36) (88S68). It was concluded that the smooth conversion of the tris-aryl-2(5//)-furanones to the corresponding furan derivatives with the dimethylsulfide-borane complex in high yields could be due to the presence of bulky aryl substituents which prevent addition reaction across the double bond (88S68). 

---