Isomerization double-bond

The presence of a variety of reaction intermediates described above can be clearly demonstrated by detailed tracer studies in the case of deuterium exchange of propylene, which is dosely related to double-bond isomerization of olelins.  

Double-bond isomerization of n-butene is described in more detaU in relation to the acid-base properties of catalysts. The rate usually increases either with increasing acid strength and acid amount or with increasing base strength and base amount. As for the selectivity there are apparent correlations with the acidity or basicity of catalysts as summarized in Table 4.1. However, since the correlation is not one-to-one cor- 

Catalyst Selectivity Reaction intermediate Type of 1,3— hydrogen shift 

S102 AI2O3 1 7 2-Butyl cation H, inter molecular 

The isomerization between the three isomers of n-butene may be characterized by six rate constants in the scheme given below. Provided that the reaction orders are the same, the following relations hold for these rate constants. 

---

Cyclic alkenes give different regioisomers depending on the reaction conditions owing to double bond isomerization caused by syii elimination of Pd—H species and its readdition. The following three reaction conditions were tested for the reaction of cycloheptene (35)[18,38] ... 

Addition of Ag2C03 cleanly suppresses the double bond isomerization[20]. Thus, with procedure B, no isomerization of double bond is observed. Addition of TlO.Ac also suppresses the double bond isomerization[23]. 

Pd hydride. Subsequent enolate formation, double bond isomerization, and carbonylation give the butenolide 582. 

Conditions of hydrogenation also determine the composition of the product. The rate of reaction is increased by increases in temperature, pressure, agitation, and catalyst concentration. Selectivity is increased by increasing temperature and negatively affected by increases in pressure, agitation, and catalyst. Double-bond isomerization is enhanced by a temperature increase but decreased with increasing pressure, agitation, and catalyst. Trans isomers may also be favored by use of reused (deactivated) catalyst or sulfur-poisoned catalyst. 

Chemical Properties. Higher a-olefins are exceedingly reactive because their double bond provides the reactive site for catalytic activation as well as numerous radical and ionic reactions. These olefins also participate in additional reactions, such as oxidations, hydrogenation, double-bond isomerization, complex formation with transition-metal derivatives, polymerization, and copolymerization with other olefins in the presence of Ziegler-Natta, metallocene, and cationic catalysts. All olefins readily form peroxides by exposure to air. 

Positionalisomeri tion occurs most often duting partial hydrogenation of unsaturated fatty acids it also occurs ia strongly basic or acidic solution and by catalysis with metal hydrides or organometaUic carbonyl complexes. Concentrated sulfuric or 70% perchloric acid treatment of oleic acid at 85°C produces y-stearolactone from a series of double-bond isomerizations, hydration, and dehydration steps (57). 

Alkali fusion of oleic acid at about 350°C ia the Varrentrapp reaction causes double-bond isomerization to a conjugated system with the carboxylate group followed by oxidative cleavage to form palmitic acid (75). In contrast, alkaU fusion of riciaoleic acid is the commercial route to sebacic acid [111 -20-6] ... 

G-19 Dicarboxylic Acids. The C-19 dicarboxyhc acids are generally mixtures of isomers formed by the reaction of carbon monoxide on oleic acid. Since the reaction produces a mixture of isomers, no single chemical name can be used to describe them. Names that have been used include 2-nonyldecanedioic acid, 2-octylundecanedioic acid, l,8-(9)-heptadecanedicarboxyhc acid, and 9-(10)-carboxystearic acid. The name 9-(10)-carboxystearic acid can be used correctiy if the product is made with no double bond isomerization (rhodium triphenylphosphine catalyst system). 

Clay-catalyzed dimerization of unsaturated fatty acids appears to be a carbonium ion reaction, based on the observed double bond isomerization, acid catalysis, chain branching, and hydrogen transfer (8,9,11). 

Because the integrity of the dihydrothiazine ring and its C-4 carboxyl substituent is crucial to useful antimicrobial activity, reactions involving this part of the cephalosporin molecule are usually undesirable. The possibilities for sulfur oxidation or alkylation, substitution at C-2 which is adjacent to both sulfur and a double bond, double bond isomerization and addition reactions, and the influence of a free carboxylic acid must all be considered in designing reactions to selectively modify other cephalosporin functionalities. 

This process accounts for most of the observations relating to product stereochemistry, double bond isomerism, deuterium exchange and other features encountered in the hydrogenation and deuteration of olefins. 140-142,144 addition of hydrogen to the double bond proceeds in... 

Note. Both the rearrangement In t-ButanoI) and the double bond isomerization of (114) (In Benzene) are quenched in a diffusion-controlled process by suitable triplet acceptors e.g., naphthalene or 2,5-dimethylhexa-2,4-diene). The rearrangement (114) (118) -I- (120) is also observed on irradiation in... 

The rearrangement proceeds from the Si-state of the 1,4-diene 1. The Ti-state would allow for different reactions like double bond isomerization. Rigid systems like cyclic dienes, where EfZ -isomerization of a double bond is hindered for steric reasons, can react through the Ti-state. When the rearrangement proceeds from the Si-state, it proves to be stereospecific at C-1 and C-5 no -isomerization is observed. Z-l,l-Diphenyl-3,3-dimethyl-l,4-hexadiene 5 rearranges to the Z-configured vinylcyclopropane 6. In this case the reaction also is regiospecific. Only the vinylcyclopropane 6 is formed, but not the alternative product 7. ... 

A variant of the Nazarov reaction is the cyclization of allyl vinyl ketones 8. These will first react by double bond isomerization to give divinyl ketones, and then cyclize to yield a cyclopentenone 9 bearing an additional methyl substituent ... 

The extent of double-bond isomerization over homogeneous catalysts is influenced by choice of solvent. Saturation of the double bond in 4-(4-me-thoxyphenyl)-3-(2 nitro-4-methoxyphenyl)-l-pentene was achieved smoothly by reduction over RhCl(Ph3P)j in benzene wiihout any hydrogenation of the nitro function. If the solvent were benzene-ethanol, isomerization of the double bond to a conjugated position also occurred ihis styryl bond was inert to reduction under these conditions (77). 

The stereoisomers of olefin saturation are often those derived by cis addition of hydrogen to the least hindered side of the molecule (99). But there are many exceptions and complications (97), among which is the difficulty of determining which side of the molecule is the least hindered. Double-bond isomerization frequently occurs, and the hydrogenation product is the resultant of a number of competing reactions. Experimentally, stereochemistry has been found to vary, sometimes to a marked degree, with olefin purity, reaction parameters, solvent, and catalyst 30,100). Generalizing, it is expedient, when unwanted products arise as a result of prior isomerization, to avoid those catalysts and conditions that are known to favor isomerization. 

The double-bond isomerization of maleoylacetoacetate to fumaroyl acetoacetate is catalyzed by practically any nucleophile, Nu-. Propose a mechanism. 

THF/liq. NH3, followed sequentially by oxidation and base-induced double bond isomerization, provides butenolide 33, a compound that possesses the lactone system of the steroidal cardiac aglycones. 

Deprotonation and then reprotonation of enantiomerically pure 1-alkenyl sulfoxide ( )-( +)-23 produces no double bond isomerization and no racemization, whereas similar treatment of (Z)-( —)-23 causes complete double bond isomerization and some racemization (equations 20 and 21)59d. 

Not only the linear Cl0-Cl8 a-olefins but also the linear C10-Cl8 olefins with internal double bonds, the so-called -v /-olefins, are of great importance in surfactant chemistry, n-a-Olefins and n-y-olefins have the same suitability for the manufacture of linear alkylbenzenes, the most important synthetic anionic surfactants, by alkylation of benzene. Nowadays medium molecular weight n- /-olefins are industrially produced by two processes the catalytic dehydrogenation of the corresponding n-alkanes [4,28] and the cometathesis of low and high molecular weight n-v /-olefins, obtained by double-bond isomerization of the isomeric n-a-olefins [29]. 

Table 9 shows the composition of /i-i /-olefin mixtures obtained by the double-bond isomerization cometathesis reaction sequence of the SHOP process. 

If cobalt carbonylpyridine catalyst systems are used, the formation of unbranched carboxylic acids is strongly favored not only by reaction of a-olefins but also by reaction of olefins with internal double bonds ( contrathermo-dynamic double-bond isomerization) [59]. The cobalt carbonylpyridine catalyst of the hydrocarboxylation reaction resembles the cobalt carbonyl-terf-phos-phine catalysts of the hydroformylation reaction. The reactivity of the cobalt-pyridine system in the hydrocarboxylation reaction is remarkable higher than the cobalt-phosphine system in the hydroformylation reaction, especially in the case of olefins with internal double bonds. This reaction had not found an industrial application until now. 

Double-bond isomerization can also take place in other ways. Nucleophilic allylic rearrangements were discussed in Chapter 10 (p. 421). Electrocyclic and sigmatropic rearrangements are treated at 18-27-18-35. Double-bond migrations have also been accomplished photochemically, and by means of metallic ion (most often complex ions containing Pt, Rh, or Ru) or metal carbonyl catalysts. In the latter case there are at least two possible mechanisms. One of these, which requires external hydrogen, is called the nwtal hydride addition-elimination mechanism ... 

No matter which of the electrophilic methods of double-bond shifting is employed, the thermodynamically most stable alkene is usually formed in the largest amount in most cases, though a few anomalies are known. However, there is another, indirect, method of double-bond isomerization, by means of which migration in the other direction can often be carried out. This involves conversion of the alkene to a borane (15-16), rearrangement of the borane (18-11), oxidation and hydrolysis of the newly formed borane to the alcohol (12-28), and dehydration of the alcohol (17-1) ... 

Therefore, Markovnikov s mle is followed, and carbon skeleton rearrangements and double-bond isomerizations (prior to attack by CO) are frequent. 

Tetrahydrocarbazoles have been prepared in one-flask syntheses from indoles, ketones and maleic anhydride, with acid catalysis. The reactions involve a condensation of the indole 121 with the ketone or aldehyde, followed by in situ trapping of the vinylindole 122 with maleic anhydride to afford tetrahydrocarbazoles 123 after double bond isomerization <96T4555>. 

A series of anchored Wilkinson s catalysts were prepared by reacting the homogeneous Wilkinson catalyst with several alumina/heteropoly acid support materials. These catalysts were used to promote the hydrogenation of 1-hexene. The results were compared with those obtained using the homogeneous Wilkinson and a l%Rh/Al203 catalyst with respect to catalyst activity and stabihty as well as the reaction selectivity as measured by the amount of double bond isomerization observed. The effect which the nature of the heteropoly acid exerted on the reaction was also examined. 

---