Kinetic isotope effects addition

All these observations indicate that prediction of likely changes when two heavy isotopes are substituted in an organism is not possible. Simple assumptions of linear additive kinetic isotope effects cannot account for the variations seen in this study. The second conclusion, that substitution Of 33c for 32c in deuterated organisms tends to decrease the magnitude of the abnormality produced after adaptation to a... 

Bromination has been shown not to exhibit a primary kinetic isotope effect in the case of benzene, bromobenzene, toluene, or methoxybenzene. There are several examples of substrates which do show significant isotope effects, including substituted anisoles, JV,iV-dimethylanilines, and 1,3,5-trialkylbenzenes. The observation of isotope effects in highly substituted systems seems to be the result of steric factors that can operate in two ways. There may be resistance to the bromine taking up a position coplanar with adjacent substituents in the aromatization step. This would favor return of the ff-complex to reactants. In addition, the steric bulk of several substituents may hinder solvent or other base from assisting in the proton removal. Either factor would allow deprotonation to become rate-controlling. 

However, measurements of substituent effects supported the hypothesis that the aryl cation is a key intermediate in dediazoniations, provided that they were interpreted in an appropriate way (Zollinger, 1973a Ehrenson et al., 1973 Swain et al., 1975 a). We will first consider the activation energy and then discuss the influence of substituents, as well as additional data concerning the aryl cation as a metastable intermediate (kinetic isotope effects, influence of water acitivity in hydroxy-de-di-azoniations). Finally, the cases of dediazoniation in which the rate of reaction is first-order with regard to the concentration of the nucleophile will be critically evaluated. 

Important additional evidence for aryl cations as intermediates comes from primary nitrogen and secondary deuterium isotope effects, investigated by Loudon et al. (1973) and by Swain et al. (1975 b, 1975 c). The kinetic isotope effect kH/ki5 measured in the dediazoniation of C6H515N = N in 1% aqueous H2S04 at 25 °C is 1.038, close to the calculated value (1.040-1.045) expected for complete C-N bond cleavage in the transition state. It should be mentioned, however, that a partial or almost complete cleavage of the C — N bond, and therefore a nitrogen isotope effect, is also to be expected for an ANDN-like mechanism, but not for an AN + DN mechanism. 

What concerns us here are three topics addressing the fates of bromonium ions in solution and details of the mechanism for the addition reaction. In what follows, we will discuss the x-ray structure of the world s only known stable bromonium ion, that of adamantylideneadamantane, (Ad-Ad, 1) and show that it is capable of an extremely rapid degenerate transfer of Br+ in solution to an acceptor olefin. Second, we will discuss the use of secondary a-deuterium kinetic isotope effects (DKie) in mechanistic studies of the addition of Br2 to various deuterated cyclohexenes 2,2. Finally, we will explore the possibility of whether a bromonium ion, generated in solution from the solvolysis of traAU -2-bromo-l-[(trifluoromethanesulfonyl)oxy]cyclohexane 4, can be captured by Br on the Br+ of the bromonium ion, thereby generating olefin and Br2. This process would be... 

In addition to the magnetic differences between the deuteron and proton, however, their mass difference may also cause observable effects. A well known example is found in the theory of chemical reactions, where the so called kinetic isotope effects (KIE s) are an important source of information about reaction mechanisms. Also in the field of ESR, such effects may arise, although these have been much less studied than the KIE s. 

Interest has been shown by several groups on the effect of solvent and of added anions upon the oxidation of alcohols. The oxidation of isopropanol proceeds 2500 times faster in 86.5 % acetic acid than in water at the same hydrogen ion concentration . The kinetics and primary kinetic isotope effect are essentially the same as in water. Addition of chloride ion strongly inhibits the oxidation and the spectrum of chromic acid is modified. The effect of chloride ion was rationalised in terms of the equilibrium,... 

The first term was found to correspond to the rate of enolisation (measured by an NMR study of hydrogen-deuterium exchange at the methylene group). The second term predominates at [Cu(II)] > 10 M and is characterised by a primary kinetic isotope effect of 7.4 (25 °C) and a p value of 1.24. Addition of 2,2 -bipridyl (bipy) caused an increase in 2 up to a bipy Cu(II) ratio of 1 1 but at ratios greater than this 2 fell gradually until the enolisation term dominated. The oxidation of a-methoxyacetophenone is much slower but gives a similar rate... 

The mechanistic proposal of rate-limiting hydrogen atom transfer and radical recombination is based on the observed rate law, the lack of influence of CO pressure, kinetic isotope effects [studied with DMn(CO)s] and CIDNP evidence. In all known cases, exclusive formation of the overall 1,4-addition product has been observed for reaction of butadiene, isoprene and 2,3-dimethyl-l,3-butadiene. The preferred trapping of allyl radicals at the less substituted side by other radicals has actually been so convincing that its observation has been taken as a mechanistic probe78. 

Song and Beak161 have used intramolecular and intermolecular hydrogen-deuterium kinetic isotope effects to investigate the mechanism of the tin tetrachloride catalysed ene-carbonyl enophile addition reaction between diethyloxomalonate and methylenecy-clohexane (equation 105). These ene reactions with carbonyl enophiles can occur by a concerted (equation 106) or a stepwise mechanism (equation 107), where the formation of the intermediate is either fast and reversible and the second step is slow k- > k-i), or where the formation of the intermediate (the k step) is rate-determining. 

Song and Beak found intramolecular and intermolecular hydrogen-deuterium kinetic isotope effects of 1.1 0.2 and 1.2 0.1, respectively, for the tin tetrachloride catalysed ene reaction. Since significant intramolecular and intermolecular primary deuterium kinetic isotope effects of between two and three have been found for other concerted ene addition reactions161, the tin-catalysed reaction must proceed by the stepwise pathway with the k rate determining step (equation 107). 

The strategy above provides a means to understand the competition between H-atom transfer and electron transfer + protonation in general. Additionally, it may be used to gather values for H-atom abstraction rate constants and kinetic isotope effects that are not readily accessible otherwise. It also provides guidelines for optimizing deuterium incorporation reactions. 

Table 3 collects the results obtained by different authors on the reaction of 0s04(NH3) with ethylene. Though the methods were not identical, the results are very similar, and in all cases there is a clear preference of the [3+2] over the [2+2] pathway. Additional confirmation was provided by a combined experimental and theoretical study using kinetic isotope effects (KIEs) to compare experiment and theory. Kinetic isotope effects were measured by a new NMR technique [25] and compared to values, which are available from calculated transition states. It showed that indeed only the [3+2] pathway is feasible [10]. 

The most recent addition to Shine s extensive study of the benzidine-type rearrangements41 involved remeasuring the nitrogen and the carbon-13 and carbon-14 kinetic isotope effects at the 4- and at the 4- and 4 -carbons as well as determining the carbon-13 and carbon-14 isotope effects at the 1- and at the 1- and l -carbons in the benzidine rearrangement of hydrazobenzene (equation 30). The reaction, which was carried out in 75% aqueous ethanol that was 0.1 M in hydrochloric acid and 0.3 M in lithium chloride at 0°C, gave an 86% yield of benzidine (11) and a 14% yield of diphenyline (12). The kinetic isotope effects found for the formation of benzidine and diphenyline under these reaction conditions are presented in Table 5. 

Initially, it was thought more likely that the electron poor metal atom would be involved in the electrophilic attack at the alkene and also the metal-carbon bond would bring the alkene closer to the chiral metal-ligand environment. This mechanism is analogous to alkene metathesis in which a metallacyclobutane is formed. Later work, though, has shown that for osmium the actual mechanism is the 3+2 addition. Molecular modelling lends support to the 3+2 mechanism, but also kinetic isotope effects support this (KIEs for 13C in substrate at high conversion). Oxetane formation should lead to a different KIE for the two alkene carbon atoms involved. Both experimentally and theoretically an equal KIE was found for both carbon atoms and thus it was concluded that an effectively symmetric addition, such as the 3+2 addition, is the actual mechanism [22] for osmium. 

As for all trace-level analyses, sample preparation and handling are of crucial importance. In addition to all the usual problems of GC-MS, measurements of isotope ratios must ensure that none of these steps introduce any isotope discrimination. Any chemical reactions, including conversion of the organic sample molecules to the simple gases which are those actually analyzed, must be quantitative (100% conversion) to avoid kinetic isotope effects [627]. Until relatively recently, all gas IRMS experiments employed a dual-inlet system to permit switching between sample and standard C02 contained in two bellows containers. The pressures in the two bellows are adjusted to be equal and,... 

Isotope effects on both the carbon and hydrogen of the breaking C-H bond have been measured. However, for this reaction both forward and reverse commitments are sizable so the three equations corresponding to Equation 11.48 have four unknowns the forward and reverse commitments and two intrinsic isotope effects. Measurements of the secondary deuterium kinetic isotope effect (at position 4 of nicotinamide ring of NADP+) and the carbon kinetic isotope effect with the secondary position deuterated introduce two additional equations, but only one more unknown ... 

Equation 11.74 allows for an explicit solution for all five unknowns. The intrinsic values obtained are listed in Table 11.2 together with the experimental ones. In addition to these intrinsic values of kinetic isotope effects to be used in further analysis of the transition state structure, the commitments were calculated as Cf = 0.8 0.3 and cr = 0.5 0.3. 

---