A nitril

Amidines are best made in two stages a nitrile reacts with dry HCl and anhydrous alcohols to give an imidic ester (imino-ether) which yields an amidine with NH3. 

Claisen condensation Condensation of an ester with another ester, a ketone or a nitrile in the presence of sodium ethoxide, sodium or sodamidc, with the elimination of an alcohol. The result is the formation of a / -ketonic ester, ketone, or nitrile respectively, e.g. 

In organic chemistry the term is used to describe the conversion of an ester to an acid and an alcohol (saponification), the addition of the elements of water to a molecule, e.g. the conversion of a nitrile to an amide... 

This Reaction should be carefully distinguished from the Claisen Conden-tation, which is the condensation of an ester, under the influence of sodium ethoxide, with (i) another ester, (ii) a ketone, or (iii) a nitrile, with the elimination of alcohol. For details of this condensation, see Ethyl Acetoacetate, p. 264. 

AUphatic nitriles are usually liquids or low melting point sohds. The most important reaction of a nitrile is its hydrolysis either by an alkaU or by an acid to the corresponding ahphatic acid characterisation of the acid enables the identity of the original nitrile to be established. 

By the condensation of a nitrile with a phenol or phenol ether in the presence of zinc chloride and hydrogen chloride a hydroxyaryl- or alkoxyaryl-ketone is produced. The procedure is termed the Hoesch reaction and is clearly an extension of the Gattermann aldehyde reaction (Section IV,121). The reaction gives the best results with polyhydric phenols and their ethers with simple monohydric phenols the imino ester hydrochloride is frequently the sole product for example ... 

Hydrolysis of a nitrile to an acid. Reflux 1 g. of the nitrile with 6 ml. of 30-40 per cent, sodium hydroxide solution until ammonia ceases to be evolved (2-3 hours). Dilute with 5 ml. of water and add, with coohng, 7 ml. of 50 per cent, sulphuric acid. Isolate the acid by ether extraction, and examine its solubility and other properties. 

Hydrolysis of a nitrile to an amide. Warm a solution of 1 g. of the nitrile benzyl cyanide) in 4 ml. of concentrated sulphuric acid to 80-90°, and allow the solution to stand for 5 minutes. Cool and pour the solution cautiously into 40 ml. of cold water. Filter oflT the precipitate stir it with 20 ml. of cold 5 per cent, sodium hydroxide solution and filter again. RecrystaUise the amide from dilute alcohol, and determine its m.p. Examine the solubility behaviour and also the action of warm sodium hydroxide solution upon the amide. 

Analysis There are two general ones based on reduction of nitrile or nitro compound (a) nitrile route... 

The most general methods for the syntheses of 1,2-difunctional molecules are based on the oxidation of carbon-carbon multiple bonds (p. 117) and the opening of oxiranes by hetero atoms (p. 123fl.). There exist, however, also a few useful reactions in which an a - and a d -synthon or two r -synthons are combined. The classical polar reaction is the addition of cyanide anion to carbonyl groups, which leads to a-hydroxynitriles (cyanohydrins). It is used, for example, in Strecker s synthesis of amino acids and in the homologization of monosaccharides. The ff-hydroxy group of a nitrile can be easily substituted by various nucleophiles, the nitrile can be solvolyzed or reduced. Therefore a large variety of terminal difunctional molecules with one additional carbon atom can be made. Equally versatile are a-methylsulfinyl ketones (H.G. Hauthal, 1971 T. Durst, 1979 O. DeLucchi, 1991), which are available from acid chlorides or esters and the dimsyl anion. Carbanions of these compounds can also be used for the synthesis of 1,4-dicarbonyl compounds (p. 65f.). 

A classical way to achieve regioselectivity in an (a -i- d -reaction is to start with a-carbanions of carboxylic acid derivatives and electrophilic ketones. Most successful are condensations with 1,3-dicarbonyl carbanions, e.g. with malonic acid derivatives, since they can be produced at low pH, where ketones do not enolize. Succinic acid derivatives can also be de-protonated and added to ketones (Stobbe condensation). In the first example given below a Dieckmann condensation on a nitrile follows a Stobbe condensation, and selectivity is dictated by the tricyclic educt neither the nitrile group nor the ketone is enolizable (W.S. Johnson, 1945, 1947). 

Thus a second method was envisaged, the reaction of a nitrile, hydrogen selenide, and an a-halogenated ketone in the presence of a condensation catalyst, which can be POCl, or POCI3 with a Lewis acid such as PCI3 or anhydrous ZnCl. The use of fresh AICI3 leads to the formation of tarry side-products. 

The reaction of phosphorus pentasulfide with a-acylamino carbonyl compounds of type Ilia also yields thiazoles. Even more commonly, a mercaptoketone is condensed with a nitrile of type IVa or a-mercaptoacids or their esters with Schiff bases. This ring closure is limited to the thiazolidines. In the Va ring-closure type, /3-mercaptoalkylamines serve as the principal starting materials, and ethylformate is the reactant that supplies the carbon at the 2-position of the ring. These syntheses constitute the most important route for the preparation of many thiazolidines and 2-thiazohnes. In the Vb t3fpe of synthesis, one of the reactant supplies only the carbon at the 5-position of the resultant thiazole. Then in these latter years new modern synthetic methods of thiazole ring have been developed (see Section 7 also Refs. 515, 758, 807, 812, 822). 

Among the methods for preparing carboxylic acids carboxylation of a Grignard reagent and preparation and hydrolysis of a nitrile convert RBr to RCO2H The malonic ester synthesis converts RBr to RCH2CO2H... 

Reduction of an azide a nitrile or a nitro compound furnishes a primary amine A method that provides access to primary secondary or tertiary amines is reduction of the carbonyl group of an amide by lithium aluminum hydride... 

The preparation of amines by the methods described m this section involves the prior synthesis and isolation of some reducible material that has a carbon-nitrogen bond an azide a nitrile a nitro substituted arene or an amide The following section describes a method that combines the two steps of carbon-nitrogen bond formation and reduction into a single operation Like the reduction of amides it offers the possibility of prepar mg primary secondary or tertiary amines by proper choice of starting materials... 

Nitdles may be prepared by several methods (1). The first nitrile to be prepared was propionitdle, which was obtained in 1834 by distilling barium ethyl sulfate with potassium cyanide. This is a general preparation of nitriles from sulfonate salts and is referred to as the Pelou2e reaction (2). Although not commonly practiced today, dehydration of amides has been widely used to produce nitriles and was the first commercial synthesis of a nitrile. The reaction of alkyl hahdes with sodium cyanide to produce nitriles (eq. 1) also is a general reaction with wide appHcabiUty ... 

Stannous fluoride probably was first prepared by Scheele in 1771 and was described by Gay-Lussac and Thenard in 1809. Commercial production of stannous fluoride is by the reaction of stannous oxide and aqueous hydrofluoric acid, or metallic tin and anhydrous hydrogen fluoride (5,6). Snp2 is also produced by the reaction of tin metal, HP, and a halogen in the presence of a nitrile (7). 

A variation of the Pd/Cu Wacker-Hoechst process, termed OK Technology, has been proposed by Catalytica Associates (40—46). This process avoids the use of chlorides and uses a Pd/Cu catalyst system which incorporates a polyoxoanion and a nitrile ligand. 

With solvents having a nitrile group like acetonitrile, the selectivity of y-butyrolactone is increased, resulting in a yield of 60%. 

Method 5. Nitrile reduction reaction of a nitrile with hydrogen over a hydrogenation catalyst. 

Fats, Oils, or Fatty Acids. The primary products produced direcdy from fats, oils, or fatty acids without a nitrile iatermediate are the quatemized amidoamines, imidazolines, and ethoxylated derivatives (Fig. 3). Reaction of fatty acids or tallow with various polyamines produces the iatermediate dialkylarnidoarnine. By controlling reaction conditions, dehydration can be continued until the imidazoline is produced. Quaternaries are produced from both amidoamines and imidazolines by reaction with methyl chloride or dimethyl sulfate. The amidoamines can also react with ethylene oxide (qv) to produce ethoxylated amidoamines which are then quaternized. 

In the first synthesis of T, the diphenyl ether was formed from -methoxyphenol and 3,4,5-triiodonitrobenzene. The nitro group was replaced by a nitril which was then built up into the alanyl side chain by a series of steps (10). 

Fig. 1. Retention of elongation of vulcanized elastomers at 150°C. A, nitrile mbber, NBR B, ethylene—propylene—diene mbber, EPDM C, acryflc...

The citrate salt of isoaminile [77-51-0] (50) is a nitrile used as an antitussive in numerous European countries. In clinical trials it was shown to be as effective as codeine or chlophedianol, with few mild side effects. Isoaminile citrate is longer acting than chlophedianol and does not cause the respiratory depression of codeine (68). 

JCS(C)2613) systems, and in many cases the starting materials are available via oxazine intermediates (e.g. 113), or by in situ hydrolysis of a nitrile (74GEP2365302). 

Cyclization reactions effected by intramolecular attack of the heteroatom on a nitrile group provide a useful source of 2-amino heterocycles. Some illustrative examples are depicted in Scheme 16. 

The comparatively ready accessibility of selenocarboxamides has encouraged the use of this procedure for the synthesis of selenazoles (1889LA(250)294). Reaction of the a-chloro-carbonyl compound (73) with the selenocarboxamide (74) provided a ready synthesis of a variety of substituted selenazoles (75). Useful variations of this general procedure are described in detail in Chapter 4.20, and particularly attractive is the reaction of hydrogen selenide with a mixture of a nitrile and the a-halogenoketone to afford the selenazole (48YZ191, 79S66). 

Unsubstituted 3-alkyl- or 3-aryl-isoxazoles undergo ring cleavage reactions under more vigorous conditions. In these substrates the deprotonation of the H-5 proton is concurrent with fission of the N—O and C(3)—-C(4) bonds, giving a nitrile and an ethynolate anion. The latter is usually hydrolyzed on work-up to a carboxylic acid, but can be trapped at low temperature. As shown by Scheme 33, such reactions could provide useful syntheses of ketenes and /3-lactones (79LA219). 

Hi) Preparation of isoxazoles from nitrile N-oxides The reaction between a nitrile //-oxide and an alkyne is so facile that it is usually sufficient to leave an ether solution of the reactants at room temperature to obtain the desired isoxazole in good yield. The reaction is in general sensitive to the size of the substituent on the alkyne but not on the nitrile -oxide. In the case of poorly reactive alkynes, the difficulty may be overcome by generating the nitrile -oxide in situ and keeping its concentration low. 

The reaction of alkyl nitro compounds with acetyl chloride in the presence of an alkenic compound produced a 2-isoxazoline. The mechanism is believed to proceed via a nitrile oxide and is illustrated in Scheme 112 (B-79MI41613). 

Rahman and Clapp decomposed dinitromethane derivatives in DMF in the presence of alkenes to obtain 2-isoxazolines. Without any alkene present, an acid and KNO2 were obtained. They proposed a mechanism which proceeded via a three-membered ring or a nitrocarbene which rearranged to a nitrile oxide (76JOC122, 75MI41612). 

---