Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Water standing

It is important to mix the mandelonitrile with hydrochloric acid immediately it has been separated from the water. Standing results in rapid conversion to the acetal of benzaldehyde and mandelonitrile C(H,CH[OCH(CN)C H,] and/or the iso-nitrile the yield of mandelic acid will, in consequence, be reduced. [Pg.774]

The layer of dirty water standing in bilges is usually so small that protection with anodes of the usual dimensions is not possible. Experiments with very flat... [Pg.412]

Jackson, C.J., Alignment Using Water Stands and Eddy-Current Proximity Probes, Proceedings of the 9tli Turbomacliinery Symposium, Texas A M University, pp. 137-146, 1980. [Pg.632]

Design of hot and cold water services to avoid water standing undisturbed for long periods. Use of covered tanks and cisterns with approved fittings and materials. [Pg.406]

Place 200 g of ion exchange resin Dowex 50W-X8, 100-200 mesh, hydrogen form into a 1-L beaker and add 600 ml of 1 M hydrochloric acid solution. Allow to stand for 24 h with occasional swirling. Decant off the liquid and filter off the resin using filter funnel and paper. Place the resin in a beaker and add 600 ml of distilled water. Stand for 24 h with occasional swirling. Decant off the liquid and repeat the washing procedure until the wash water is neutral to pH paper. [Pg.441]

Now add a half a glass of water and stir. The salt disappears as it dissolves in the water. Now all you have to do is to separate the paint thinner and water by carefully pouring off the paint thinner, which has floated on the top. Then you just need to let the water stand for a couple of days and evaporate. In the bottom of the glass youVe got nearly all the salt you started with. [Pg.29]

Let the picric acid/water stand it will keep indefinitely at room temperature. Do not let the picric acid dry since the powder is explosive. [Pg.351]

An agate marble is placed in a graduated cylinder containing 35.0 ml of water. After the marble is added, the surface of the water stands at 37.5 ml. Find the diameter and surface area of the marble. [Pg.39]

Two facts concerning the corrosion behavior of metals in sea water stand out ... [Pg.32]

Several phases associated with sediments are evaluated for their toxic potential as Tables 10 and 11 indicate. Whole sediment and pore water stand out as phases that are most frequently investigated (Tab. 13). Because sediments act as contaminant... [Pg.25]

Follow this procedure Let the glasses of water stand until the water appears to be perfectly still and motionless. Drop the crystal of potassium permanganate into one, the crystal of salt in the next, and a drop of India ink into the third. Do not stir, touch or move the water in the glasses. Watch them for several minutes and notice what happens. Allow them to stand overnight, and then check the appearance of the three solutions. Using a glass rod, taste a drop of the sodium chloride solution in the second glass. [Pg.52]

The water in the slurry should be intimately mixed, and the solid particles in the slurry should not be segregated. For this reason, free water is measured immediately after the slurry is mixed in the blender and before it is placed in the slurry cup of the consistometer. It is poured in a graduated glass cylinder, and the cylinder is kept at an angle of 45° for 2 h. The free water standing above the slurry is then decanted and measured. [Pg.184]

Sprinkler systems and water stand pipes were purposely omitted in the Chemistry wing to avoid accidental contact of water with active metals or metal hydrides. Cylinders supplying specialty gases or compressed air to laboratories are stored in the central hall in locked chambers located between the utility chases and identical to them in outward appearance. [Pg.245]

Constants deemed fundamental are those that emerge from the core of the overarching theories of physics they are constants whose values determine the magnitudes of the basic interactions of nature and finally, they are the constants whose values are linked to and help establish the values of other significant physical constants. The melting point of water stands alone as an important property of water, but its import does not extend beyond water. The speed of sound is different for every medium in which... [Pg.197]

Now we know that while water stands as it were on the dividing line between metal and non-metal hydroxides, and is a perfectly neutral compound, there are other hydroxides which may be placed on either side, i,e., they may form either bases or acids. The elements whose hydroxides are of this nature may be illustrated by the element aluminium. Toward strong bases aluminium hydroxide acts as an acid and forms salts in which the aluminium plays the part of a non-metal. [Pg.102]

The colloidal gold should be diluted in PBS without calcium and magnesium containing 1% BSA or 0.01% polyethylene glycol (mol wt 20,000), or in TBS plus 1% BSA or 0.01% polyethylene glycol (mol wt 20,000). Let the picric acid/water stand it will keep indefinitely at room temperature. Do not let the picric acid dry since the powder is explosive. [Pg.326]

The chemicals leached from these surfaces depend on the corrosive properties of the particular water as well as the chemical nature of the surface. Hard water tends to deposit a mineral layer on the inside of pipes and on other surfaces that essentially limits the access of water to the surfaces. On the other hand, soft water, particularly at lower pHs, can actively dissolve toxic metals such as lead or cadmium from pipes or solder. Copper in pipes is also frequently leached from pipes at high concentrations when the water has corrosive properties. Asbestos-cement has been used widely in water mains. The extraction of the asbestos fibers from these surfaces is also very much increased at lower pH and with soft water. The use of lead pipe and solder in household pipes has pretty much been abandoned in the United States. However, alloys of lead are still utilized in many faucets and brass fixtures (e.g., submersible pumps). Rather high concentrations of lead can result if water stands in these fixtures overnight. As a result it is always wise to avoid using the water first drawn from the tap in the morning for human consumption. Low levels of lead exposure in utero or in the first few years of life have been associated with delayed CNS development in humans and experimental animals. [Pg.2086]

In the center of the element water stands a Banyan Tree called Ma. [Pg.26]

The Determination of Taste and Odour in Potable Water, Standing Committee of Analysts, HMSO, London, 1994. [Pg.1366]

However, two different aspects must be distinguished with respect to the decline of Fucus stands. Disappearance of shallow water stands are in most of the cases related to ice scouring or exposition to mechanical stress in general, so loss of these shallow water stands must be separated from changes in depth distribution (Eriksson, 2002 Schories et al., 2006a). With respect to shifts in depth distribution as observed especially in the western parts of the Baltic Sea and the Baltic proper, a link to changes in the nutrient regime are very likely. [Pg.505]

Before anointing with balsam or oil, the hands should be well washed, preferably with Hyssop Hyssop plus 1 pint hot water. Stand infusion for 15 minutes or, the hands are perfumed with high-quality soap and water—then perfume-oiled afterwards. [Pg.82]

Let the picric acid/water stand it will keep indefinitely at room temperature. [Pg.393]

To two spatulafuls of sugar (C12H22O11) in a test tube add an equal volume of water. Stand the test tube in the rack, add to it 10 drops of concentrated sulphuric acid and if no visible action takes place within one minute add 10 drops more of acid. Cautiously smell at the mouth of the test tube. (4) What is the insoluble substance formed (5) What has probably happened to the hydrogen and oxygen of the sugar (6) What property of sulphuric acid caused the action to take place (7) What substance did you recognize by its odor as being formed (8) How do you account for its formation ... [Pg.144]

Water standing in spring boxes, wells, eovered tanks, or eisterns (closed reservoirs) also experienees some losses dne to evaporation. However, sinee less air is in eontaet with the water nnder these eonditions, smaller losses are inenrred. [Pg.6]


See other pages where Water standing is mentioned: [Pg.20]    [Pg.279]    [Pg.106]    [Pg.121]    [Pg.78]    [Pg.66]    [Pg.179]    [Pg.157]    [Pg.74]    [Pg.270]    [Pg.270]    [Pg.197]    [Pg.400]    [Pg.59]    [Pg.279]    [Pg.263]    [Pg.317]    [Pg.149]    [Pg.256]    [Pg.207]   
See also in sourсe #XX -- [ Pg.228 ]




SEARCH



In standing water

Standing Bodies of Water

Stands

Water acoustic standing waves

© 2024 chempedia.info