Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Steric hindrance reactions

If, however, the rate of direct addition is slowed down by steric hindrance, reaction with the Grignard reagent will form the conjugate addition product because conjugate addition then becomes the faster reaction. [Pg.835]

The attack by a reagent of a molecule might be hampered by the presence of other atoms near the reaction site. The larger these atoms and the more are there, the higher is the geometric restriction, the steric hindrance, on reactivity. Figure 3-6e illustrates this for the attack of a nucleophile on the substrate in a nucleophilic aliphatic substitution reaction. [Pg.178]

The usual directive influences are not operative in this and similar reactions for ortho - para substitution occurs (this may be modified by steric hindrance) irrespective of the nature of R in the aromatic liquid CsHjR, e.g. phenyldlazo hydroxide and nitrobenzene yield 4-nitrodiphenyl this supports the assumption that neutral free radicals are formed. [Pg.928]

The Peterson reaction has two more advantages over the Wittig reaction 1. it is sometimes less vulnerable to sterical hindrance, and 2. groups, which are susceptible to nucleophilic substitution, are not attacked by silylated carbanions. The introduction of a methylene group into a sterically hindered ketone (R.K. Boeckman, Jr., 1973) and the syntheses of olefins with sulfur, selenium, silicon, or tin substituents (D. Seebach, 1973 B.T. Grdbel, 1974, 1977) illustrate useful applications. The reaction is, however, more limited and time consuming than the Wittig reaction, since metallated silicon derivatives are difficult to synthesize and their reactions are rarely stereoselective (T.H. Chan, 1974 ... [Pg.33]

Syntheses of alkenes with three or four bulky substituents cannot be achieved with an ylide or by a direct coupling reaction. Sterical hindrance of substituents presumably does not allow the direct contact of polar or radical carbon synthons in the transition state. A generally applicable principle formulated by A. Eschenmoser indicates a possible solution to this problem //an intermolecular reaction is complex or slow, it is advisable to change the educt in such a way. that the critical bond formation can occur intramolecularly (A. Eschenmoser, 1970). [Pg.34]

There also exists an acidregioselective condensation of the aldol type, namely the Mannich reaction (B. Reichert, 1959 H. Hellmann, 1960 see also p. 291f.). The condensation of secondary amines with aldehydes yields Immonium salts, which react with ketones to give 3-amino ketones (=Mannich bases). Ketones with two enolizable CHj-groupings may form 1,5-diamino-3-pentanones, but monosubstitution products can always be obtained in high yield. Unsymmetrical ketones react preferentially at the most highly substituted carbon atom. Sterical hindrance can reverse this regioselectivity. Thermal elimination of amines leads to the a,)3-unsaturated ketone. Another efficient pathway to vinyl ketones starts with the addition of terminal alkynes to immonium salts. On mercury(ll) catalyzed hydration the product is converted to the Mannich base (H. Smith, 1964). [Pg.57]

The Michael reaction is of central importance here. This reaction is a vinylogous aldol addition, and most facts, which have been discussed in section 1.10, also apply here the reaction is catalyzed by acids and by bases, and it may be made regioselective by the choice of appropriate enol derivatives. Stereoselectivity is also observed in reactions with cyclic educts. An important difference to the aldol addition is, that the Michael addition is usually less prone to sterical hindrance. This is evidenced by the two examples given below, in which cyclic 1,3-diketones add to o, -unsaturated carbonyl compounds (K. Hiroi, 1975 H, Smith, 1964). [Pg.71]

Another widely used route to cyclopropanes involves the addition of sulfoniutn ylides to a,/3-unsaturated carbonyl compounds (S.R. Landor, 1967 R. Sowada, 1971 C.R. Johnson, I973B, 1979 B.M. Trost, 1975 A). Non-activated double bonds are not attacked. Sterical hindrance is of little importance in these reactions because the C—S bond is extraordinarily long... [Pg.75]

A major difficulty with the Diels-Alder reaction is its sensitivity to sterical hindrance. Tri- and tetrasubstituted olefins or dienes with bulky substituents at the terminal carbons react only very slowly. Therefore bicyclic compounds with polar reactions are more suitable for such target molecules, e.g. steroids. There exist, however, several exceptions, e. g. a reaction of a tetrasubstituted alkene with a 1,1-disubstituted diene to produce a cyclohexene intermediate containing three contiguous quaternary carbon atoms (S. Danishefsky, 1979). This reaction was assisted by large polarity differences between the electron rich diene and the electron deficient ene component. [Pg.86]

Phosphites, such as triisopropyl and triphenyl phosphite, are weaker electron donors than the corresponding phosphines, but they are used in some reactions because of their greater rr-accepting ability. The cyclic phosphite trimethylol-propane phosphite (TMPP) or 4-ethyl-2,6,7-trioxa-l-phosphabicyclo[2.2.2]oc-tane (8), which has a small cone angle and small steric hindrance, shows high catalytic activity in some reactions It is not commercially available, but can be prepared easily[27]. [Pg.4]

The rather unreactive chlorine of vinyl chloride can be displaced with nucleophiles by the catalytic action of PdCb. The conversion of vinyl chloride to vinyl acetate (797) has been studied extensively from an industrial standpoint[665 671]. DMF is a good solvent. 1,2-Diacetoxyethylene (798) is obtained from dichloroethylene[672]. The exchange reaction suffers steric hindrance. The alkenyl chloride 799 is displaced with an acetoxy group whereas 800 and 801 cannot be displaccd[673,674]. Similarly, exchange reactions of vinyl chloride with alcohols and amines have been carried out[668]. [Pg.246]

The sensitivity of the reaction to ortho steric hindrance shows that the transition state is probably angular (894). [Pg.392]

The most frequently used organocuprates are those m which the alkyl group is pri mary Steric hindrance makes secondary and tertiary dialkylcuprates less reactive and they tend to decompose before they react with the alkyl halide The reaction of cuprate reagents with alkyl halides follows the usual 8 2 order CH3 > primary > secondary > tertiary and I > Br > Cl > F p Toluenesulfonates are somewhat more reactive than halides Because the alkyl halide and dialkylcuprate reagent should both be primary m order to produce satisfactory yields of coupled products the reaction is limited to the formation of RCH2—CH2R and RCH2—CH3 bonds m alkanes... [Pg.603]

Because of the rapid ring opening by the nucleophile, ayiridinium salts cannot usually be isolated. However, in a few cases it is possible to isolate such compounds (54), eg, at low temperatures, when the ayiridinium salts ate sparingly soluble or where there is steric hindrance to substitution. Stable ethyleneiminium salts can be prepared by reaction of ethyleneimine with acids not containing nucleophilic anions, for example HBF (55). [Pg.3]

Methacryhc acid and its ester derivatives are Ctfjy -unsaturated carbonyl compounds and exhibit the reactivity typical of this class of compounds, ie, Michael and Michael-type conjugate addition reactions and a variety of cycloaddition and related reactions. Although less reactive than the corresponding acrylates as the result of the electron-donating effect and the steric hindrance of the a-methyl group, methacrylates readily undergo a wide variety of reactions and are valuable intermediates in many synthetic procedures. [Pg.246]

This synthesis method can be utilised by any alkene or alkyne, but steric hindrance on internal double bonds can cause these reactions to be quite slow. Conjugated dienes and aromatic alkenes are not suited for the ultraviolet light-initiated process. The use of other free-radical initiators is required in free-radical-initiated reactions involving these species. [Pg.11]

Oxidation. Disulfides are prepared commercially by two types of reactions. The first is an oxidation reaction uti1i2ing the thiol and a suitable oxidant as in equation 18 for 2,2,5,5-tetramethyl-3,4-dithiahexane. The most common oxidants are chlorine, oxygen (29), elemental sulfur, or hydrogen peroxide. Carbon tetrachloride (30) has also been used. This type of reaction is extremely exothermic. Some thiols, notably tertiary thiols and long-chain thiols, are resistant to oxidation, primarily because of steric hindrance or poor solubiUty of the oxidant in the thiol. This type of process is used in the preparation of symmetric disulfides, RSSR. The second type of reaction is the reaction of a sulfenyl haUde with a thiol (eq. 19). This process is used to prepare unsymmetric disulfides, RSSR such as 4,4-dimethyl-2,3-dithiahexane. Other methods may be found in the Hterature (28). [Pg.12]

The polyaddition reaction is influenced by the stmcture and functionaHty of the monomers, including the location of substituents in proximity to the reactive isocyanate group (steric hindrance) and the nature of the hydroxyl group (primary or secondary). Impurities also influence the reactivity of the system for example, acid impurities in PMDI require partial neutralization or larger amounts of the basic catalysts. The acidity in PMDI can be reduced by heat or epoxy treatment, which is best conducted in the plant. Addition of small amounts of carboxyHc acid chlorides lowers the reactivity of PMDI or stabilizes isocyanate terrninated prepolymers. [Pg.342]

The azo coupling reaction proceeds by the electrophilic aromatic substitution mechanism. In the case of 4-chlorobenzenediazonium compound with l-naphthol-4-sulfonic acid [84-87-7] the reaction is not base-catalyzed, but that with l-naphthol-3-sulfonic acid and 2-naphthol-8-sulfonic acid [92-40-0] is moderately and strongly base-catalyzed, respectively. The different rates of reaction agree with kinetic studies of hydrogen isotope effects in coupling components. The magnitude of the isotope effect increases with increased steric hindrance at the coupler reaction site. The addition of bases, even if pH is not changed, can affect the reaction rate. In polar aprotic media, reaction rate is different with alkyl-ammonium ions. Cationic, anionic, and nonionic surfactants can also influence the reaction rate (27). [Pg.428]

Addition to cis- and /n t-2-butene theiefoie yields different optical isomers (10,11). The failure of chlorine to attack isobutylene is attributed to the high degree of steric hindrance to approach by the anion. The reaction intermediate stabilizes itself by the loss of a proton, resulting in a very rapid reaction even at ambient temperature (12). [Pg.363]

Chemical Properties. Neopentanoic acid [75-98-9] undergoes reactions typical of carboxyUc acids. Reactions often proceed less readily than with straight-chain acids because of the steric hindrance around the carbonyl group. However, this steric hindrance at the a-carbon results ia derivatives that are typically more resistant to hydrolysis and oxidation. [Pg.102]

Studies on covalent hydration of N-heterocycles (67AG(E)919,76AHC(20)117) have revealed the diagnostic value of alkyl substituents in structural assignments due to their steric hindrance effects in addition reactions. C-Methyl substituents are therefore also considered as molecular probes to solve fine-structural problems in the pteridine field. The derivatives... [Pg.265]

As these condensation reactions can occur at the two ortho and the para positions in phenol, w-cresol and 3,5-xylenol, cross-linked structures will be formed. It has been pointed out by Megson that because of steric hindrance the amount of cross-linking that can take place is much less than would involve the three reactive groups of all the phenolic molecules. It is now generally considered that the amount of cross-linking that actually takes place is less than was at one time believed to be the case. [Pg.642]

In the El cb mechanism, the direction of elimination is governed by the kinetic acidity of the individual p protons, which, in turn, is determined by the polar and resonance effects of nearby substituents and by the degree of steric hindrance to approach of base to the proton. Alkyl substituents will tend to retard proton abstraction both electronically and sterically. Preferential proton abstraction from less substituted positions leads to the formation of the less substituted alkene. This regiochemistry is opposite to that of the El reaction. [Pg.384]


See other pages where Steric hindrance reactions is mentioned: [Pg.180]    [Pg.205]    [Pg.180]    [Pg.205]    [Pg.279]    [Pg.336]    [Pg.487]    [Pg.411]    [Pg.134]    [Pg.443]    [Pg.257]    [Pg.50]    [Pg.70]    [Pg.386]    [Pg.337]    [Pg.72]    [Pg.288]    [Pg.297]    [Pg.49]    [Pg.268]    [Pg.245]    [Pg.531]    [Pg.53]    [Pg.483]    [Pg.882]    [Pg.68]    [Pg.224]    [Pg.225]   
See also in sourсe #XX -- [ Pg.25 , Pg.27 ]




SEARCH



Aldol reaction steric hindrance

Hindrance, 25.

Hindrance, sterical

Nucleophilic addition reaction steric hindrance

Nucleophilic carbonyl addition reaction steric hindrance

Sn2 reaction steric hindrance

Steric Hindrance of SN2 Reactions

Steric hindrance in elimination reactions

© 2024 chempedia.info