Solvate ions

Ion-Exchange Equilibrium. Retention differences among cations with an anion exchanger, or among anions with a cation exchanger, are governed by the physical properties of the solvated ions. The stationary phase will show these preferences ... 

The reaction medium plays a very important role in all ionic polymerizations. Likewise, the nature of the ionic partner to the active center-called the counterion or gegenion-has a large effect also. This is true because the nature of the counterion, the polarity of the solvent, and the possibility of specific solvent-ion interactions determines the average distance of separation between the ions in solution. It is not difficult to visualize a whole spectrum of possibilities, from completely separated ions to an ion pair of partially solvated ions to an ion pair of unsolvated ions. The distance between the centers of the ions is different in... 

Ionic polymers may exist as undissociated, unsolvated ion pairs undissociated ion pairs solvated to some extent solvated ions dissociated to some extent or some combination of these. The propagation rate constant kp and the dissociation equilibrium constant K of the lithium salt of anionic... 

Figure 1 shows the mechanistic picture developed by C. M. Starks (1,2) for Hquid—Hquid PTC in a graphical form. The catalyst cation extracts the more hpholilic anion Y from the aqueous to the nonpolar organic phase where it is present in the form of a poorly solvated ion pair Y ]. This then reacts rapidly with RX, and the newly formed ion pair X ] returns to the aqueous phase for another exchange process X — Y . In practice most catalyst cations used are rather lipophilic and do not extract strongly into the aqueous phase so that the anions are exchanged at the phase boundary. 

This equation is a reasonable model of electrokinetic behavior, although for theoretical studies many possible corrections must be considered. Correction must always be made for electrokinetic effects at the wall of the cell, since this wall also carries a double layer. There are corrections for the motion of solvated ions through the medium, surface and bulk conductivity of the particles, nonspherical shape of the particles, etc. The parameter zeta, determined by measuring the particle velocity and substituting in the above equation, is a measure of the potential at the so-called surface of shear, ie, the surface dividing the moving particle and its adherent layer of solution from the stationary bulk of the solution. This surface of shear ties at an indeterrninate distance from the tme particle surface. Thus, the measured zeta potential can be related only semiquantitatively to the curves of Figure 3. 

It is also of significance that in the dilute gas phase, where the intrinsic orientating properties of pyrrole can be examined without the complication of variable phenomena such as solvation, ion-pairing and catalyst attendant on electrophilic substitution reactions in solution, preferential /3-attack on pyrrole occurs. In gas phase t-butylation, the relative order of reactivity at /3-carbon, a-carbon and nitrogen is 10.3 3.0 1.0 (81CC1177). 

To estimate the values of coefficients ny we write dij = pi fSUyXy as above. For a 1 M solution we have fSUyXy 1500ny-. Thus for I Uy 1 and a radius of solvated ions of 0.5 nm ay must be of the order of unity. In what follows... 

Fig. 20.11 Two types of arrangement of ions at a metal/solution interface, (a) Arrangement O solvated ions in the O.H.P. and surface of electrode covered with water dipoles, (b) Arrangement I desolvated ions in the I.H.P. (after Bockris and Reddy )...

Since the term hydration refers to aqueous solutions only, the word solvation was introduced as a general term for the process of forming a solvate in solution. The terms solvation and heat of solvation were introduced at a time when little or nothing was known about polar molecules. We know now that, when an atomic ion is present in a solvent, the molecular dipoles are subject to the ionic field, whose intensity falls off in 1/r2. We cannot draw a sphere round the ion and say that molecules within this sphere react with the ion to form a solvated ion, while molecules outside do not. The only useful meaning that can now be attached to the term solvation is the total interaction between ion and solvent. As already mentioned, this is the sense in which the term is used in this book. 

In conclusion, it seems that solvents appropriate for lithium-ion batteries employing a graphite anode must have high solvation energy, high E°, and high /0 for reduction in order to slow the cointercalation of the solvated ion, and to enhance the formation of the SEI at the most positive potential (far from the Li/Li+ potential). 

According to Eigen and Tamm [87,88], ion-pair formation proceeds stepwise, starting from separated solvated ions which form a solvent-separated ion pair [C+SSA ]°, followed by a solvent-shared ion pair [C+SA ]° and finally a contact ion pair, [C+A ]° [Eqs. (4)-(6)]. All these species are solvated. The types of ion pair formed depend on the relative strength of the interaction of the involved species. 

Chemical models of electrolytes take into account local structures of the solution due to the interactions of ions and solvent molecules. The underlying information stems from spectroscopic, kinetic, and electrochemical experiments, as well as from dielectric relaxation spectroscopy. The postulated structures include ion pairs, higher ion aggregates, and solvated and selectively solvated ions. 

The association of solvated ions can be described by the overall equilibrium reaction... 

For attempts in the literature to rationalize the maximum, with reference to solvation, ion association, or viscosity of the electrolyte, see Ref. [15]. 

The results of an investigation performed upon various salts in PC [207] or MeOH [15] can be summarized as follows. Both the maximum conductivity and the appertaining concentration 41 are determined by the viscosity and ionic radii (nonsolvated ions) or Stokes radii (solvated ions), meaning that electrolytes show a Stokes-Walden behavior, entailing... 

Figure 5. (a) The ( A, SO,) anion symmetric streching mode of polypropylene glycol)- LiCF,SO, for 0 M ratios of 2000 1 and 6 1. Solid symbols represent experimental data after subtraction of the spectrum corre-ponding to the pure polymer. Solid curves represent a three-component fit. Broken curves represent the individual fitted components, (b) Relative Raman intensities of the fitted profiles for the ( Aj, SO,) anion mode for this system, plotted against square root of the salt concentration, solvated ions ion pairs , triple ions, (c) The molar conductivity of the same system at 293 K. Adapted from A. Ferry, P. Jacobsson, L. M. Torell, Electrnchim. Acta 1995, 40, 2369 and F. M. Gray, Solid State Ionics 1990, 40/41, 637. 

The mass spectrometry of diazo compounds was reviewed by Zeller (1983) and by Lebedev (1991). It is difficult to record mass spectra of diazonium salts using conventional techniques. With the water thermospray method, however, Schmelzeisen-Redeker et al. (1985) observed the diazonium ion and various fragments such as [Ar+ - N2 + 2H]+ and [Ar + N2 + H20]+. Ambroz et al. (1988) applied the fast atom bombardment (FAB) technique using a 3-nitrobenzylalcohol matrix. Peaks for ArNJ, Ar+, and [M + ArN2]+ and further peaks due to solvated ions were found. 

The inner layer (closest to the electrode), known as the inner Helmholtz plane (IHP), contains solvent molecules and specifically adsorbed ions (which are not hilly solvated). It is defined by the locus of points for the specifically adsorbed ions. The next layer, the outer Helmholtz plane (OHP), reflects the imaginary plane passing through the center of solvated ions at then closest approach to the surface. The solvated ions are nonspecifically adsorbed and are attracted to the surface by long-range coulombic forces. Both Helmholtz layers represent the compact layer. Such a compact layer of charges is strongly held by the electrode and can survive even when the electrode is pulled out of the solution. The Helmholtz model does not take into account the thermal motion of ions, which loosens them from the compact layer. 

In any solvent system, the essential factors required for dissolution of cellulose include adequate stabihty of the electrolyte/solvent complex cooperative action of the solvated ion-pair on hydrogen bonding of cellu-... 

It should be born in mind, however, that the activation parameters calculated refer to the sum of several reactions, whose enthalpy and/or entropy changes may have different signs from those of the decrystalUzation proper. Specifically, the contribution to the activation parameters of the interactions that occur in the solvent system should be taken into account. Consider the energetics of association of the solvated ions with the AGU. We may employ the extra-thermodynamic quantities of transfer of single ions from aprotic to protic solvents as a model for the reaction under consideration. This use is appropriate because recent measurements (using solvatochromic indicators) have indicated that the polarity at the surface of cellulose is akin to that of aliphatic alcohols [99]. Single-ion enthalpies of transfer indicate that Li+ is more efficiently solvated by DMAc than by alcohols, hence by cellulose. That is, the equilibrium shown in Eq. 7 is endothermic ... 

The potential of reversed micelles needs to be evaluated by theoretical analysis of the metal ion distribution within micelles, by evaluation of the free energy of the solvated ions in the reversed micelle organic solution and the bulk aqueous water, and by the experimental characterization of reversed micelles by small-angle neutron and x-ray scattering. 

---