Sodium periodate, reaction with

Chemical degradation studies carried out on streptovaricias A and C, which are the primary components of the cmde complex, yielded substances shown ia Figure 1. Streptovaricia A (4), consumes two moles of sodium periodate to yield variciaal A [21913-68-8] (1), 0 2 200, which accounts for the ahphatic portion of the molecule, and prestreptovarone [58074-37-6] (2), C2C)H2C)N02, which accounts for the aromatic chromophore of the streptovaricias (Fig. 2). Streptovaricia G (9) is the only other streptovaricia that yields prestreptovaroae upoa treatmeat with sodium periodate. Treatmeat of streptovaricias A (4), B (5), C (6), E (8), and G (9) with sodium periodate and osmium tetroxide yields streptovarone [36108-44-8] (3), C24H23NO2, which is also produced by the reaction of prestreptovarone with sodium periodate and osmium tetroxide (4,65). A number of aliphatic products were isolated from the oxidation of streptovaricia C and its derivatives (66). 

Early Synthesis. Reported by Kolbe in 1859, the synthetic route for preparing the acid was by treating phenol with carbon dioxide in the presence of metallic sodium (6). During this early period, the only practical route for large quantities of sahcyhc acid was the saponification of methyl sahcylate obtained from the leaves of wintergreen or the bark of sweet bitch. The first suitable commercial synthetic process was introduced by Kolbe 15 years later in 1874 and is the route most commonly used in the 1990s. In this process, dry sodium phenate reacts with carbon dioxide under pressure at elevated (180—200°C) temperature (7). There were limitations, however not only was the reaction reversible, but the best possible yield of sahcyhc acid was 50%. An improvement by Schmitt was the control of temperature, and the separation of the reaction into two parts. At lower (120—140°C) temperatures and under pressures of 500—700 kPa (5—7 atm), the absorption of carbon dioxide forms the intermediate phenyl carbonate almost quantitatively (8,9). The sodium phenyl carbonate rearranges predominately to the ortho-isomer. sodium sahcylate (eq. 8). 

In a 3-I. three-necked, round-bottomed flask fitted with a mechanical stirrer, reflux condenser, and separatory funnel is placed 400 cc. of absolute alcohol (Note i). Through the condenser tube is added slowly, 23 g. (i gram atom) of dean sodium cut into thin slices. The completion of the reaction is hastened by heating the flask on a steam bath. When the sodium has dissolved completely, 143 g. (i.i moles) of ethyl acetoacetate is introduced slowly. Alter starting the mechanical stirrer, 123 g. (i mole) of ethyl chloroacetate (Note 2) is added slowly over a period of an hour, and the reaction mixture is refluxed for five to six hours. At this point the reaction mixture should no longer give an alkaline reaction with moist litmus. 

The solution of sodium methyl sulfide in absolute alcohol is transferred to a 3-I. three-necked flask, which is placed on a steam bath and fitted with a dropping funnel, a reflux condenser, and a mechanical stirrer. The solution is heated until the alcohol begins to boil. Heating is then discontinued and 302 g. (3.7s moles) of ethylene chlorohydrin (Note 5) is added dropwise with efficient stirring over a period of about two hours (Note 6). The reaction mixture is concentrated by distilling as much of the alcohol as possible on the steam bath. The mixture is then allowed to cool and the sodium chloride removed by filtration. The flask is rinsed, and the sodium chloride washed with three loo-cc. portions of 95 per cent alcohol. The combined filtrate and washings are concentrated on the steam bath under reduced pressure until no further distillate passes over. The residue is then transferred to a modified Claisen flask (Org. Syn. Coll. Vol. i, 125) and fractionally distilled under reduced pressure. The yield is 238-265 g. (74-82 per cent of the theoretical amount based on the sodium used) of a product boiling at 68-7o°/20 mm. 

Alicyclic hydroxamic acids undergo several specific oxidative cleavage reactions which may be of diagnostic or preparative value. In the pyrrolidine series compounds of type 66 have been oxidized with sodium hypobromite or with periodates to give y-nitroso acids (113). Ozonolysis gives the corresponding y-nitro acids. The related cyclic aldonitrone.s are also oxidized by periodate to nitroso acids, presumably via the hydroxamic acids.This periodate fission was used in the complex degradation of J -nitrones derived from aconitine. 

A 1-liter three-necked flask equipped with a mechanical stirrer and two dropping funnels is charged with a solution of 42 g (0.176 mole) of sodium periodate in 145 ml of acetone and 180 ml of water. To the stirred solution, camphene (6.7 g, 0.049 mole) is added in small portions. The reaction vessel is then flushed with nitrogen and is main-... 

Reaction with Alkyl Halides The gas inlet tube is replaced by an addition funnel, and 10 ml of HMPT is added rapidly with stirring. The mixture is cooled to 10-15°, and a solution of the alkyl halide (0.1 mole) in 20 ml of THF is added dropwise over a period of 30-40 minutes. The mixture is then heated to 40° for 2-3 hours. The thick white suspension of the sodium halide is cooled and dilute cold hydrochloric acid is carefully added until the mixture is clear. The organic layer is separated, and the aqueous layer is extracted three times with 20-ml portions of ether, the ethereal extracts then being combined with the organic material. The ethereal solution is washed twice with saturated sodium chloride solution and dried. The ether and THF are removed under reduced pressure (rotary evaporator), and the alkyne is distilled. 

The Cg-amine, originally obtained by the methanolysis of kasugamycin, on treatment with lead tetraacetate or sodium periodate afforded a nitrile amine, with evolution of carbon dioxide, showing a maximum at 2200 cm.-1. This reaction is explained only by the structure (13). The -N-C=N group of the product can be formed by oxidative decarboxylation and can be easily rationalized by the present understanding of such reagents (2, 13) as shown below. On the other hand, the treatment... 

We examined the reaction of triose reductone with both periodate and iodate (55,56), and found that, whereas iodine was invariably set free from both sodium periodate and sodium iodate if the concentration of the reductone were greater than 10 3M, no iodine was liberated at lower concentrations (e.g. 6 x 10 4M) of substrate, even in the presence of relatively large amounts of the oxidants. 

The oxidation of diethyl 3,6-hexanooxepin-4,5-dicarboxylate with a mixture of sodium periodate and potassium permanganate as oxidizing agent gives diethyl 3-[(formyioxy)methylene]-l 0-oxocyclodec-l-en-l,2-dicarboxylate (2) in 91 % yield.130 A minor modification of the reaction conditions gives two products 2 (35 %) and a product which retains the oxepin structure (23 %) identified as the same lactone described in Section 1.2.1.1.129... 

Herrmann et al. reported for the first time in 1996 the use of chiral NHC complexes in asymmetric hydrosilylation [12]. An achiral version of this reaction with diaminocarbene rhodium complexes was previously reported by Lappert et al. in 1984 [40]. The Rh(I) complexes 53a-b were obtained in 71-79% yield by reaction of the free chiral carbene with 0.5 equiv of [Rh(cod)Cl]2 in THF (Scheme 30). The carbene was not isolated but generated in solution by deprotonation of the corresponding imidazolium salt by sodium hydride in liquid ammonia and THF at - 33 °C. The rhodium complexes 53 are stable in air both as a solid and in solution, and their thermal stability is also remarkable. The hydrosilylation of acetophenone in the presence of 1% mol of catalyst 53b gave almost quantitative conversions and optical inductions up to 32%. These complexes are active in hydrosilylation without an induction period even at low temperatures (- 34 °C). The optical induction is clearly temperature-dependent it decreases at higher temperatures. No significant solvent dependence could be observed. In spite of moderate ee values, this first report on asymmetric hydrosilylation demonstrated the advantage of such rhodium carbene complexes in terms of stability. No dissociation of the ligand was observed in the course of the reaction. 

Osmium tetroxide used in combination with sodium periodate can also effect alkene cleavage.191 Successful oxidative cleavage of double bonds using ruthenium tetroxide and sodium periodate has also been reported.192 In these procedures the osmium or ruthenium can be used in substoichiometric amounts because the periodate reoxidizes the metal to the tetroxide state. Entries 1 to 4 in Scheme 12.18 are examples of these procedures. Entries 5 and 6 show reactions carried out in the course of multistep syntheses. The reaction in Entry 5 followed a 5-exo radical cyclization and served to excise an extraneous carbon. The reaction in Entry 6 followed introduction of the allyl group by enolate alkylation. The aldehyde group in the product was used to introduce an amino group by reductive alkylation (see Section 5.3.1.2). 

Figure 1.102 The reaction of sodium periodate with sugar residues can produce aldehydes for conjugation reactions.

---