Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Sodium carbonyl compounds

SchifT s bases A -Arylimides, Ar-N = CR2, prepared by reaction of aromatic amines with aliphatic or aromatic aldehydes and ketones. They are crystalline, weakly basic compounds which give hydrochlorides in non-aqueous solvents. With dilute aqueous acids the parent amine and carbonyl compounds are regenerated. Reduction with sodium and alcohol gives... [Pg.353]

The carbonyl compound may be mixed with an aqueous solution of sodium or potassium cyanide and mineral acid is added, or the bisulphite compound may be treated with an equivalent quantity of sodium cyanide, for example ... [Pg.341]

The reaction between sodium acetylide in liquid ammonia solution and carbonyl compounds gives a-acetylenyl carbinols (compare Section 111,148), for example ... [Pg.896]

Triethylammonium formate is another reducing agent for q, /3-unsaturated carbonyl compounds. Pd on carbon is better catalyst than Pd-phosphine complex, and citral (49) is reduced to citronellal (50) smoothly[55]. However, the trisubstituted butenolide 60 is reduced to the saturated lactone with potassium formate using Pd(OAc)2. Triethylammonium formate is not effective. Enones are also reduced with potassium formate[56]. Sodium hypophosphite (61) is used for the reduction of double bonds catalyzed by Pd on charcoal[57]. [Pg.520]

Sodium borohydride and lithium aluminum hydride react with carbonyl compounds in much the same way that Grignard reagents do except that they function as hydride donors rather than as carbanion sources Figure 15 2 outlines the general mechanism for the sodium borohydride reduction of an aldehyde or ketone (R2C=0) Two points are especially important about this process... [Pg.629]

The addition of hydrogen cyanide is catalyzed by cyanide ion but HCN is too weak an acid to provide enough C=N for the reaction to proceed at a reasonable rate Cyanohydrins are therefore normally prepared by adding an acid to a solution containing the carbonyl compound and sodium or potassium cyanide This procedure ensures that free cyanide ion is always present m amounts sufficient to increase the rate of the reaction... [Pg.718]

A variation of the classical reductive amination procedure uses sodium cyanoboro hydride (NaBH3CN) instead of hydrogen as the reducing agent and is better suited to amine syntheses m which only a few grams of material are needed All that is required IS to add sodium cyanoborohydride to an alcohol solution of the carbonyl compound and an amine... [Pg.935]

Acrolein (H2C=CHCH=0) undergoes conjugate addition with sodium azide in aqueous solution to give N3CH2CH2CH=0 Propanal is not an a 3 unsaturated carbonyl compound and cannot undergo conjugate addition... [Pg.1234]

Acetaldehyde can be isolated and identified by the characteristic melting points of the crystalline compounds formed with hydrazines, semicarbazides, etc these derivatives of aldehydes can be separated by paper and column chromatography (104,113). Acetaldehyde has been separated quantitatively from other carbonyl compounds on an ion-exchange resin in the bisulfite form the aldehyde is then eluted from the column with a solution of sodium chloride (114). In larger quantities, acetaldehyde may be isolated by passing the vapor into ether, then saturating with dry ammonia acetaldehyde—ammonia crystallizes from the solution. Reactions with bisulfite, hydrazines, oximes, semicarb azides, and 5,5-dimethyl-1,3-cyclohexanedione [126-81 -8] (dimedone) have also been used to isolate acetaldehyde from various solutions. [Pg.53]

The g-methylene group of butyrolactone condenses easily with a number of different types of carbonyl compounds eg, sodium alkoxides cataly2e self-condensation to a-dibutyrolactone (155), ben2aldehyde gives a-ben2yhdenebutyrolactone (156), and ethyl acetate gives a-acetobutyrolactone (157). [Pg.110]

Sodium hydride, sodium amide, or other strong bases also can be used. The reagent can be generated in the presence of an appropriate carbonyl compound that reacts direcdy. [Pg.381]

The behaviour of /S-oxovinylazides is quite similar to those above. The Z isomer (556), formed from the /S-halo carbonyl compound and sodium azide, is unstable losing N2 and forming the isoxazole (557) in an anchimerically assisted concerted reaction (75AG(E)775, 78H(9)1207). At moderate temperatures (50-80 °C) the E isomer formed acylazirines which at higher temperatures rearranged to oxazoles and isoxazoles. [Pg.163]

Polymerization of olefins such as styrene is promoted by acid or base or sodium catalysts, and polyethylene is made with homogeneous peroxides. Condensation polymerization is catalyzed by acid-type catalysts such as metal oxides and sulfonic acids. Addition polymerization is used mainly for olefins, diolefins, and some carbonyl compounds. For these processes, initiators are coordination compounds such as Ziegler-type catalysts, of which halides of transition metals Ti, V, Mo, and W are important examples. [Pg.2095]

Two classes of charged radicals derived from ketones have been well studied. Ketyls are radical anions formed by one-electron reduction of carbonyl compounds. The formation of the benzophenone radical anion by reduction with sodium metal is an example. This radical anion is deep blue in color and is veiy reactive toward both oxygen and protons. Many detailed studies on the structure and spectral properties of this and related radical anions have been carried out. A common chemical reaction of the ketyl radicals is coupling to form a diamagnetic dianion. This occurs reversibly for simple aromatic ketyls. The dimerization is promoted by protonation of one or both of the ketyls because the electrostatic repulsion is then removed. The coupling process leads to reductive dimerization of carbonyl compounds, a reaction that will be discussed in detail in Section 5.5.3 of Part B. [Pg.681]

The azlactones of a-benzoylaminocinnamic acids have traditionally been prepared by the action of hippuric acid (1, Ri = Ph) and acetic anhydride upon aromatic aldehydes, usually in the presence of sodium acetate. The formation of the oxazolone (2) in Erlenmeyer-Plochl synthesis is supported by good evidence. The method is a way to important intermediate products used in the synthesis of a-amino acids, peptides and related compounds. The aldol condensation reaction of azlactones (2) with carbonyl compounds is often followed by hydrolysis to provide unsaturated a-acylamino acid (4). Reduction yields the corresponding amino acid (6), while drastic hydrolysis gives the a-0X0 acid (5). ... [Pg.229]

Several improved methods for the preparation of known unsaturated azlactones as well as some interesting new compounds of this type have been reported. Crawford and Little observed that the direct use of 2-phenyl-5-oxazolone (1) in the Erlenmeyer reaction gave much improved yields (35-74%) of unsaturated azlactones with aliphatic aldehydes and with ketones such as acetone and cyclohexanone [Eq, (1)], The usual procedure of mixing a carbonyl compound, hippuric acid, acetic anhydride, and sodium (or lead) acetate affords poor yields in the aliphatic series. [Pg.76]

Reactions in liquid ammonia (cf. Chapter 3, Section III) require a certain amount of care, since the solvent is low boiling (—33 ) and its fumes are noxious. Nevertheless, with reasonable caution, the preparation of an ammonia solution of sodium acetylide can be carried out as described. The reagent so prepared can then be directly used for displacements on alkyl halides or for additions to suitable carbonyl compounds. Examples of both reactions are given. [Pg.121]

Methylsulfinyl carbanion (dimsyl ion) is prepared from 0.10 mole of sodium hydride in 50 ml of dimethyl sulfoxide under a nitrogen atmosphere as described in Chapter 10, Section III. The solution is diluted by the addition of 50 ml of dry THF and a small amount (1-10 mg) of triphenylmethane is added to act as an indicator. (The red color produced by triphenylmethyl carbanion is discharged when the dimsylsodium is consumed.) Acetylene (purified as described in Chapter 14, Section I) is introduced into the system with stirring through a gas inlet tube until the formation of sodium acetylide is complete, as indicated by disappearance of the red color. The gas inlet tube is replaced by a dropping funnel and a solution of 0.10 mole of the substrate in 20 ml of dry THF is added with stirring at room temperature over a period of about 1 hour. In the case of ethynylation of carbonyl compounds (given below), the solution is then cautiously treated with 6 g (0.11 mole) of ammonium chloride. The reaction mixture is then diluted with 500 ml of water, and the aqueous solution is extracted three times with 150-ml portions of ether. The ether solution is dried (sodium sulfate), the ether is removed (rotary evaporator), and the residue is fractionally distilled under reduced pressure to yield the ethynyl alcohol. [Pg.124]

A. number of rutro compounds used m ndturdl product synthesis have been prepared by the n of alkyl halides Some recent examples are summarized m Table 2 4 fi-Nitro carbonyl compounds are important for synthesis of natural products The reaction of alkyl vinyl ketones with sodium nitrite and acetic acid in THF gives thecorrespondmgfi-nitro carbonyl compounds in42-82% ""rhis method is better for the preparation of fi-nitro carbonyl compounds than the nitration of the corresponclmg halides... [Pg.20]

The tosylhydrazone is prepared from the carbonyl compound and then reduced with lithium aluminium hydride, sodium borohydride or potassium borohydride. In this way D-glucose tosylhydrazone was converted into crystalline 1-deoxyglucitol by reduction with potassium borohydride... [Pg.152]

Because carbonyl compounds are only weakly acidic, a strong base is needed for enolate ion formation. If an alkoxide such as sodium ethoxide is used as base, deprotonation takes place only to the extent of about 0. l% because acetone is a weaker acid than ethanol (pKa - 16). If, however, a more powerful base such as sodium hydride (NaH) or lithium diisopropylamide ILiNO -CjHy ] is used, a carbonyl compound can be completely converted into its enolate ion. Lithium diisopropylamide (LDA), which is easily prepared by reaction of the strong base butyllithium with diisopropylamine, is widely used in the laboratory as a base for preparing enolate ions from carbonyl compounds. [Pg.851]

On the other hand, carbonyl condensation reactions require only a catalytic amount of a relatively weak base rather than a full equivalent so that a small amount of enolate ion is generated in the presence of unreacted carbonyl compound. Once a condensation has occurred, the basic catalyst is regenerated. To carry out an aldol reaction on propanal, for instance, we might dissolve the aldehyde in methanol, add 0.05 equivalent of sodium methoxide, and then warm the mixture to give the aldol product. [Pg.881]

To a solution of the lithium dialkylamide (1.1 mmol) in THF (2 ml) cooled to -78°C was added a solution to TMSC1 (5-10mmoI) in THF (2ml), also cooled to -78 °C. This was followed by dropwise addition of the carbonyl compound (lmmol) in THF (2ml). After lmin, triethylamine (2ml) was added, followed by quenching with saturated sodium hydrogen carbonate solution. The product was extracted into pentane, and these extracts were... [Pg.60]

Reaction of a-sulphinyl carboxylic esters 421 with carbonyl compounds has usually been performed using a Grignard reagent as a base. No condensation products are obtained using t-butyllithium or sodium hydride367,496,497 (equation 251). The condensation products formed are convenient starting materials for the synthesis of a, p-unsaturated esters and /1-ketones497. [Pg.329]


See other pages where Sodium carbonyl compounds is mentioned: [Pg.918]    [Pg.168]    [Pg.712]    [Pg.53]    [Pg.551]    [Pg.504]    [Pg.99]    [Pg.116]    [Pg.109]    [Pg.311]    [Pg.125]    [Pg.589]    [Pg.177]    [Pg.470]    [Pg.162]    [Pg.712]    [Pg.296]    [Pg.119]    [Pg.31]    [Pg.658]    [Pg.331]    [Pg.614]   
See also in sourсe #XX -- [ Pg.109 ]

See also in sourсe #XX -- [ Pg.8 , Pg.109 ]

See also in sourсe #XX -- [ Pg.8 , Pg.109 ]




SEARCH



Carbonyl compounds by sodium borohydride

Carbonyl compounds condensations, sodium hydride

Carbonyl compounds reaction with sodium borohydrid

Carbonyl compounds reaction with sodium borohydride

Carbonyl compounds reduction by sodium borohydride

Carbonyl compounds sodium cyanoborohydride

Hydroxy carbonyl compounds Sodium borohydride

Sodium amalgam unsaturated carbonyl compounds

Sodium bis aluminum hydride carbonyl compounds

Sodium bisulfite, reaction with carbonyl compounds

Sodium borohydride carbonyl compound reduction

Sodium borohydride carbonyl compounds

Sodium borohydride unsaturated carbonyl compounds

Sodium borohydride, reduction of carbonyl compounds

Sodium carbonyl compound reduction

Sodium compounds

Sodium cyanoborohydride unsaturated carbonyl compounds

Sodium periodate synthesis of carbonyl compounds

Sodium trimethoxyborohydride unsaturated carbonyl compounds

Sodium unsaturated carbonyl compounds

© 2024 chempedia.info