Sodium borohydride acetate reactions

Reduction. Quinoline may be reduced rather selectively, depending on the reaction conditions. Raney nickel at 70—100°C and 6—7 MPa (60—70 atm) results in a 70% yield of 1,2,3,4-tetrahydroquinoline (32). Temperatures of 210—270°C produce only a slightly lower yield of decahydroquinoline [2051-28-7]. Catalytic reduction with platinum oxide in strongly acidic solution at ambient temperature and moderate pressure also gives a 70% yield of 5,6,7,8-tetrahydroquinoline [10500-57-9] (33). Further reduction of this material with sodium—ethanol produces 90% of /ra/ j -decahydroquinoline [767-92-0] (34). Reductions of the quinoline heterocycHc ring accompanied by alkylation have been reported (35). Yields vary widely sodium borohydride—acetic acid gives 17% of l,2,3,4-tetrahydro-l-(trifluoromethyl)quinoline [57928-03-7] and 79% of 1,2,3,4-tetrahydro-l-isopropylquinoline [21863-25-2]. This latter compound is obtained in the presence of acetone the use of cyanoborohydride reduces the pyridine ring without alkylation. 

However, it has turned out that there are a few synthetic methods having broad scope, that is, (a) for the synthesis of dioxepins and dithiepins (i) transacetalization of the corresponding diol or dithiol, respectively, with an open chain acetal (ii) treatment of the corresponding diol or dithiol with sodium borohydride and reaction of the resulting dianion with a gem-dihalogen derivative. The latter method is particularly useful for the synthesis of dioxepins and dithiepins unsubstituted in the 2-position (b) for the synthesis of 4,5-dihydro-l,3-dioxepins (i) metal- or base-catalyzed double-bond isomerization and (ii) Heck vinylation or arylation, respectively, for the synthesis of 6-substituted 4,5-dihydro-l,3-dioxepins. 

Sometimes the reaction conditions used in this reaction are too harsh since heating is involved and rearrangement reactions can occur. A milder method that gives better results is to treat the alkene with mercuric acetate [Hg(OAc)2] then sodium borohydride. The reaction involves electrophilic addition of the mercury reagent to form an intermediate mercuronium ion. This reacts with water to give an organomercury intermediate. Reduction with sodium... 

The reaction of butyllithium with 1-naphthaldehyde cyclohexylimine in the presence of (/C )-l,2-diphenylethane-1,2-diol dimethyl ether in toluene at —78 °C, followed by treatment with acetate buffer, gave 2-butyl-1,2-dihydronaphthalene-l-carbaldehyde, which was then reduced with sodium borohydride in methanol to afford (1 R,2.S)-2-butyl-1 -hydroxymcthyl-1,2-dihydronaphthalene in 80% overall yield with 91 % ee83. Similarly, the enantioselective conjugate addition of organolithium reagents to several a,/J-unsaturated aldimines took place in the presence of C2-symmetric chiral diethers, such as (/, / )-1,2-butanediol dimethyl ether and (/, / )- ,2-diphenylethane-1,2-diol dimethyl ether. 

The reaction of the aldehyde 174, prepared from D-glucose diethyl dithio-acetal by way of compounds 172 and 173, with lithium dimethyl methyl-phosphonate gave the adduct 175. Conversion of 175 into compound 176, followed by oxidation with dimethyl sulfoxide-oxalyl chloride, provided diketone 177. Cyclization of 177 with ethyldiisopropylamine gave the enone 178, which furnished compounds 179 and 180 on sodium borohydride reduction. 0-Desilylation, catalytic hydrogenation, 0-debenzyIation, and acetylation converted 179 into the pentaacetate 93 and 5a-carba-a-L-ido-pyranose pentaacetate (181). 

Catecholborane or sodium borohydride in acetic acid can also be used as a reducing reagent in this reaction.281... 

Another synthetic route to 3-methylhasubanan (43), proposed by Lattes et al. (74), consists of the intramolecular aminomercuration (75) of amino-ethylphenanthrene 27. The key intermediate 27 was treated with mercury(II) acetate in THF/water to yield 9-acetoxymercury-3-methoxyhasubanan (46), as depicted in Scheme 3, and then the reaction product 46 was successively treated with benzyltriethylammonium chloride, sodium hydroxide, and sodium borohydride to furnish the target, 3-methylhasubanan (43) (74). 

Air (particulate lead) Collection of sample onto cellulose acetate filter dissolution in HN03 with heat addition of HCI / H202 and reaction in hydride generator with sodium borohydride to generate lead hydride AAS 8 ng/L 100-101 Nerin et al. 1989... 

Nitromethylation of aldehydes has been carried out in a one pot procedure consisting of the Henry reaction, acetylation, and reduction with sodium borohydride, which provides a good method for the preparation of l-nitroalkanes.16b 79 It has been improved by several modifications. The initial condensation reaction is accelerated by use of KF and 18-crown-6 in isopropanol. Acetylation is effected with acetic anhydride at 25 °C and 4-dimethylaminopyridine (DMAP) as a catalyst. These mild conditions are compatible with various functional groups which are often... 

A cobalt complex containing this type of ligand is effective in the sodium borohydride-mediated enantioselective reduction of a variety of a,/ -unsaturated carboxylates. As can be seen from Scheme 6-8, in the presence of a catalytic amount of a complex formed in situ from C0CI2 and chiral ligand 11, reduction proceeds smoothly, giving product with up to 96% ee. The chiral ligand can easily be recovered by treating the reaction mixture with acetic acid. 

Dihydrocorynantheine was obtained via similar steps from normal cyanoacetic ester 319 (172). Stereoselective transformation of the alio cyanoacetic ester 315 to the normal stereoisomer 319 was achieved by utilizing a unique epimerization reaction of the corresponding quinolizidine-enamine system (174). Oxidation of alio cyanoacetic ester 315 with lead tetraacetate in acetic acid medium, followed by treatment with base, yielded the cis-disubstituted enamine 317, which slowly isomerized to the trans isomer 318. It has been proved that this reversible eipmerization process occurs at C-15. The ratio of trans/cis enamines (318/317) is about 9 1. The sodium borohydride reduction of 318 furnished the desired cyanoacetic ester derivative 319 with normal stereo arrangement. The details of the C-15 epimerization mechanism are discussed by B rczai-Beke etal. (174). 

Heat 3-nitrophthalic anhydride with ammonium carbonate to get 3-nitrophthalimide (I). Dissolve 4.3 g (I) in 50 ml 90% methanol and add 1.9 g sodium borohydride over 30 minutes while stirring vigorously at room temperature. Stir 2 hours, acidify with 20% HCI, evaporate in vacuum and treat the dry residue with acetone. Evaporate in vacuum to get 3.9 g (88%) 3-OH-4-nitrophthal-imidine (II) (recrystallize from acetone). Dissolve 3.9 g (II) in 40 ml 20% HCI and stir for 10 hours on water bath at 80-90°. Distill off HCI and stir residue with acetone. Filter and evaporate in vacuum to get 3.4 g 3-OH-4-nitrophthalide (III) (recrystallize from CHC 3 and can purify on column). Prepare an ether solution of CH2N2 and add to 1.93 g (III) in a 100 ml flask until a reaction is no longer evident. Add acetic acid to decompose excess diazomethane and evaporate in vacuum to get about 2 g of 2-methoxycarbonyl-6-nitrostyrene oxide (IV) (can purify on column). Dissolve 560 mg (IV) in 50 ml absolute methanol, add 50 mg Pt02 and hydrogenate as described elsewhere here (other reducing methods should work). Filter,... 

Addition of lithiated heterocycles to aldonolactones yields carbon-linked nucleosides (56). Thus, the reaction of 2,3 5,6-di-O-isopropylidene-L-gu-lono-1,4-lactone (9b) or 2,3-O-isopropylidene-D-ribono-l,4-lactone (16a) with various lithiated heterocycles gave gulofuranosyl derivatives 53a-g or ribofuranosyl derivatives 54b,c. Gulonolactols 53a-g and ribonolactols 54b,c were acetylated with acetic anhydride in pyridine to yield their acetyl derivatives. The stereochemistry of compounds 53a-g and 54b,c was discussed in terms of the Cotton effect of circular-dichroism curves of the ring-opened alcohols formed upon reduction by sodium borohydride. The configuration at C-l of 53g was proved by means of X-ray analysis (57,58). 

C. 7-Methoxyphthalide (4). The crude product from Step B (26.9 g), in a 1-L, one-necked, round-bottomed flask with a magnetic stirring bar, is dissolved in 465 mL of absolute methanol (Note 12). To this solution, cooled to 0°C, is added 7.4 g (0.20 mol) of powdered sodium borohydride, in small portions (Note 13), and the mixture is stirred at room temperature for 18 hr. The reaction mixture is cooled in an ice water bath and taken to pH 4-5 with about 35 mL of 6 M aqueous hydrochloric acid. A further 48 mL (0.288 mol) of 6 M hydrochloric acid is added, the flask is fitted with a reflux condenser and the reaction mixture is heated under reflux for 12 hr. The reaction mixture is then allowed to cool to room temperature and most of the methanol is evaporated under aspirator pressure. The residue is dissolved in 400 mL of methylene chloride, the phases are separated, and the organic fraction is washed with saturated ammonium chloride (3 x 200 mL) and water (1 x 100 mL), dried over anhydrous magnesium sulfate, and concentrated under reduced pressure. The pale yellow solid is recrystallized from ethyl acetate-hexane (1 1) (Note 10) to give 15.4 g... 

The neutralization values were influenced by reduction with strong reducing agents, lithium aluminum hydride, sodium borohydride, and amalgamated zinc plus hydrochloric acid (35, 46). For the most part, the consumption of NajCOj and of NaOEt decreased in equivalent amounts. This is further confirmation of the assumption that lactones of the fluorescein type or of the lactol type are present. The reaction with sodium ethoxide was shown to be no true neutralization, that is, exchange of H+for Na+, at all, but an addition reaction w ith the formation of the sodium salt of a semi-acetal or ketal ... 

The chemical reduction of the same 4-cyano-3-phenylcinnoline in the presence of oxygen in air leads to quite different products when compared to the electrode process. The reactions were carried out in a dilute solution in which the chemicals were evenly distributed. On action of zinc dust in acetic acid at 25°C, the parent compound gives 3-cyano-2-phenylindole in quantitative yield. Reaction of the same starting material with sodium borohydride in ethanol under reflux provides 3-phenylcinnoline at almost quantitative yields (Matsubara et al. 2000, Ref. 13). The products mentioned are depicted in Scheme 2.32. 

The CD fragment 1s synthesized starting with resolved bicyclic acid 129. Sequential catalytic hydrogenation and reduction with sodium borohydride leads to the reduced hydroxy acid 1. The carboxylic acid function is then converted to the methyl ketone by treatment with methyl-lithium and the alcohol is converted to the mesylate. Elimination of the latter group with base leads to the conjugated olefin 133. Catalytic reduction followed by equilibration of the ketone in base leads to the saturated methyl ketone 134. Treatment of that intermediate with peracid leads to scission of the ketone by Bayer Villiger reaction to afford acetate 135. The t-butyl protecting... 

---