Sodium amide, reaction with alcohols

Nowhere, perhaps, is this phenomenon better illustrated than in the phenothiazine class. The earlier volume devoted a full chapter to the discussion of this important structural class, which was represented by both major tranquilizers and antihistamines. The lone phenothiazine below, flutiazin (130), in fact fails to show the activities characteristic of its class. Instead, the ring system is used as the aromatic nucleus for a nonsteroidal antiinflammatory agent. Preparation of 130 starts with formylation of the rather complex aniline 123. Reaction with alcoholic sodium hydroxide results in net overall transformation to the phenothiazine by the Smiles rearrangement. The sequence begins with formation of the anion on the amide nitrogen addition to the carbon bearing sulfur affords the corresponding transient spiro intermediate 126. Rearomatization... 

What does all of this mean The reaction of 2-pentanone with LDA in THF at -78°C constitutes typical kinetic control conditions. Therefore, formation of the kinetic enolate and subsequent reaction with benzaldehyde to give 34 is predictable based on the kinetic versus thermodynamic control arguments. In various experiments, the reaction with an unsymmetrical ketone under what are termed thermodynamic conditions leads to products derived from the more substituted (thermodynamic) enolate anion. Thermodynamic control conditions typically use a base such as sodium methoxide or sodium amide in an alcohol solvent at reflux. The yields of this reaction are not always good, as when 2-butanone (37) reacts with NaOEt in ethanol for 1 day. Self-condensation at the more substituted carbon occurs to give the dehydrated aldol product 38 in 14% yield. Note that the second step uses aqueous acid and, under these conditions, elimination of water occurs. 

To drive the equilibrium between alcohol and alkoxide to the side of the conjugate base, it is necessary to use a base stronger than the alkoxide formed (i.e., a base derived from a conjugate acid weaker than the alcohol see also Section 9-1). An example is the reaction of sodium amide, NaNH2, with methanol to furnish sodium methoxide and ammonia... 

The formation of the above anions ("enolate type) depend on equilibria between the carbon compounds, the base, and the solvent. To ensure a substantial concentration of the anionic synthons in solution the pA" of both the conjugated acid of the base and of the solvent must be higher than the pAT -value of the carbon compound. Alkali hydroxides in water (p/T, 16), alkoxides in the corresponding alcohols (pAT, 20), sodium amide in liquid ammonia (pATj 35), dimsyl sodium in dimethyl sulfoxide (pAT, = 35), sodium hydride, lithium amides, or lithium alkyls in ether or hydrocarbon solvents (pAT, > 40) are common combinations used in synthesis. Sometimes the bases (e.g. methoxides, amides, lithium alkyls) react as nucleophiles, in other words they do not abstract a proton, but their anion undergoes addition and substitution reactions with the carbon compound. If such is the case, sterically hindered bases are employed. A few examples are given below (H.O. House, 1972 I. Kuwajima, 1976). 

The reaction with sodium sulfite or bisulfite (5,11) to yield sodium-P-sulfopropionamide [19298-89-6] (C3H7N04S-Na) is very useful since it can be used as a scavenger for acrylamide monomer. The reaction proceeds very rapidly even at room temperature, and the product has low toxicity. Reactions with phosphines and phosphine oxides have been studied (12), and the products are potentially useful because of thek fire retardant properties. Reactions with sulfide and dithiocarbamates proceed readily but have no appHcations (5). However, the reaction with mercaptide ions has been used for analytical purposes (13)). Water reacts with the amide group (5) to form hydrolysis products, and other hydroxy compounds, such as alcohols and phenols, react readily to form ether compounds. Primary aUphatic alcohols are the most reactive and the reactions are compHcated by partial hydrolysis of the amide groups by any water present. 

Condensation of the anion obtained on reaction of acetonitrile with sodium amide, with o-chlorobenzophenone (36), affords the hydroxynitrile, 37. Catalytic reduction leads to the corresponding amino alcohol (note that the benzhydryl alcohol is not hydrogenolyzed). Reductive alkylation with formaldehyde and hydrogen in the presence of Raney nickel gives the antitussive a-gent, chlorphedianol (39). °... 

Two years later, the same group reported a formal synthesis of ellipticine (228) using 6-benzyl-6H-pyrido[4,3-f>]carbazole-5,ll-quinone (6-benzylellipticine quinone) (1241) as intermediate (716). The optimized conditions, reaction of 1.2 equivalents of 3-bromo-4-lithiopyridine (1238) with M-benzylindole-2,3-dicarboxylic anhydride (852) at —96°C, led regioselectively to the 2-acylindole-3-carboxylic acid 1233 in 42% yield. Compound 1233 was converted to the corresponding amide 1239 by treatment with oxalyl chloride, followed by diethylamine. The ketone 1239 was reduced to the corresponding alcohol 1240 by reaction with sodium borohydride. Reaction of the alcohol 1240 with f-butyllithium led to the desired 6-benzylellipticine quinone (1241), along with a debrominated alcohol 1242, in 40% and 19% yield, respectively. 6-Benzylellipticine quinone (1241) was transformed to 6-benzylellipticine (1243) in 38% yield by treatment with methyllithium, then hydroiodic acid, followed... 

Tertiary benzylic nitriles are useful synthetic intermediates, and have been used for the preparation of amidines, lactones, primary amines, pyridines, aldehydes, carboxylic acids, and esters. The general synthetic pathway to this class of compounds relies on the displacement of an activated benzylic alcohol or benzylic halide with a cyanide source followed by double alkylation under basic conditions. For instance, 2-(2-methoxyphenyl)-2-methylpropionitrile has been prepared by methylation of (2-methoxyphenyl)acetonitrile using sodium amide and iodomethane. In the course of the preparation of a drug candidate, the submitters discovered that the nucleophilic aromatic substitution of aryl fluorides with the anion of a secondary nitrile is an effective method for the preparation of these compounds. The reaction was studied using isobutyronitrile and 2-fluoroanisole. The submitters first showed that KHMDS was the superior base for the process when carried out in either THF or toluene (Table I). For example, they found that the preparation of 2-(2-methoxyphenyl)-2-methylpropionitrile could be accomplished h... 

The lactams 2-pyrrolidinone and lV-methyl-2-pyrrolidinone may be used to increase the solubility of carbohydrates in alcoholic reaction media. However, they cannot be used in the preparation of metal halide adducts, because of their tendency to associate, perhaps by complexing, with metal halide adducts.1 Amides are known to form complexes with metal halides. For example, sodium iodide combines with N, N-dimethylformamide to give Nal 3 N,N-dimethylformamide. Acetamide can form NaBr 2 acetamide and NaI-2 acetamide. 7... 

---